Recycling of Post-Consumer Packaging Materials into New Food Packaging Applications—Critical Review of the European Approach and Future Perspectives

The European strategy for plastics, as part of the EU’s circular economy action plan, should support the reduction in plastic waste. One key element in this action plan is the improvement of the economics and quality of recycled plastics. In addition, an important goal is that by 2030, all plastics packaging placed on the EU market must either be reusable or can be recycled in a cost-effective manner. This means that, at the end, a closed-loop recycling of food packaging materials should be established. However, the use of recyclates must not result in less severe preventive consumer protection of food packaging materials. This may lead to a conservative evaluation of authorities on post-consumer recyclates in food packaging applications. On the other hand, over-conservatism might over-protect the consumer and generate insurmountable barriers to the application of post-consumer recyclates for food packaging and, hence, counteract the targets of circular economy. The objective of this review is to provide an insight into the evaluation of post-consumer recyclates applied in direct contact to food. Safety assessment criteria as developed by the European Food Safety Authority EFSA will be presented, explained, and critically discussed.

Asphalt Binder Modification with Plastomeric Compounds Containing Recycled Plastics and Graphene

Polymer-modified bitumens are usually employed for enhancing the mixture performance against typical pavement distresses. This paper presents an experimental investigation of bitumens added with two plastomeric compounds, containing recycled plastics and graphene, typically used for asphalt concrete dry modification. The goal was to study the effects of the compounds on the rheological response of the binder phase, as well the adhesion properties, in comparison with a reference plain bitumen. The blends (combination of bitumen and compounds) were evaluated through dynamic viscosity tests, frequency sweep tests, and multiple stress creep recovery (MSCR) tests. Moreover, the bitumen bond strength (BBS) test was performed to investigate the behavior of the systems consisting of blends and aggregate substrates (virgin and pre-coated). The rheological tests indicated that both blends performed better than the plain bitumen, especially at high temperature, showing an enhanced rutting resistance. In terms of bond strength, comparable results were found between the blends and reference bitumen. Moreover, no performance differences were detected between the two types of blends.

Resistance to Opportunities of Plastic Recycling

Plastics present a vast and pressing issue in modern society. Currently recycling efforts fall dangerously short of dealing with even a small percent of the millions of tons of plastic waste produced yearly across the globe. This article investigates resistance toward plastic recycling in three areas from both a contemporary and a historical context, highlighting the magnitude of the problem and the insufficient nature of current solutions. The three primary areas covered are the plastics problem from (1) a design perspective, (2) a material science perspective, and (3) a systems perspective. Solutions are proposed that emphasize a synergistic collaboration across disciplines and research modes. Ultimately, the conclusions point to a need for stronger engagement at the level of people (both consumers and decision makers) and reintegrating reused and recycled plastics into everyday life to build a solid foundation for success.

ASSESSMENT OF THE DEGREE AND SOURCE OF POLYOLEFIN RECYCLATES CONTAMINATION

This study has the aim of analysing the degree of contamination of recycled polyolefin purchased from the market by focusing on the content of polycyclic aromatic hydrocarbons (PAHs). Additionally, the impact of the mechanical recycling process on the polyolefin chemical quality was investigated. Results indicated that recycled polyethylene (PE) had higher PAHs concentrations by 10 to 20 folds in comparison to the pristine PE. Similarly, recycled polypropylene (PP) indicated higher PAHs concentrations in comparison to the virgin polypropylene, yet with lower degree of difference. Analysing the 8 indicators assigned by the Regulation EU 1272/2013 amending REACH Annex XVII, all recycled specimens showed concentrations lower than the limit of 0.5 mg kg-1, which indicates that there is no restriction in material’s utilisation. This study functioned as a preliminary assessment to check the suitability of recycled plastics for their further utilisation. Additionally, the study indicates that polyolefin can experience quality deterioration when uncontrolled recycling conditions are applied.

AI and essential labor

With the onset of the COVID-19 pandemic in the United States, "essential work" became a calling card for the labor that kept the country running. But the activity of essential workers often occurs out of sight. For example, the products of waste workers are everywhere---clean floors, sanitized tables, objects made from recycled plastics---though workers themselves are often behind the scenes.

Towards Higher Quality of Recycled Plastics: Limitations from the Material’s Perspective

The increasing consumption of plastics and plastic products results in correspondingly substantial volumes of waste, which poses considerable environmental burdens. With the ongoing environmental actions, the application of circular economy on this waste stream is becoming inevitable. In this paper, the topics of plastics recycling, circular economy on plastics, and challenges to plastic waste recycling are critically reviewed. In the first part of this paper, the development of research on plastic recycling was viewed from 1950 until 2020 using the scientific database Web of Science, and 682 related studies were found and used to assess the changing research priorities along that timeline. The following sections discuss the potentials and requirements to enhance the quality of the produced recycled plastic, in connection with the factors that currently limit it. In conclusion, the quality of recycled plastic is generally determined by the homogeneity of the recovered plastic feed. There are various strategies which could be implemented to overcome the hindrances identified in the paper and to improve the quality of the recycled plastic, such as working on enhanced product designs for minimised waste heterogeneity and controlling the materials’ degree of contamination by applying advanced sorting.

The Management of Agriculture Plastic Waste in the Framework of Circular Economy. Case of the Almeria Greenhouse (Spain)

In recent decades, ecosystems have suffered diverse environmental impacts caused by anthropogenic activities, including the dumping of plastic waste. This situation has prompted the European Union to introduce a new policy based on the circular economy. In this study, the present state and future perspectives on the generation and treatment of plastic waste in the intensive agriculture of Almeria (Spain) are analyzed. This activity generates 1503.6 kg·ha−1·year−1, on average, of plastic waste with an approximate treatment cost of 0.25 €/kg. The present study shows that the volume of plastic waste from intensive agriculture in Almeria is constantly increasing (48,948.2 tons in 2020/21) and it is suggested that the current management system does not meet the needs of the sector. Although it presents great opportunities for improvement under the framework of the circular economy. Furthermore, this work reports a direct relationship between the price of the raw materials needed for the production of plastic and the volume of recycled plastics. For this reason, it would be advisable for the administration to consider the implementation of a tax rebate system for the sector and specifically when the petroleum derivatives used to manufacture plastic are less expensive, and the recycling option is not so attractive.