Chitosan/gelatin porous bone scaffolds made by crosslinking treatment and freeze-drying technology: Effects of crosslinking durations on the porous structure, compressive strength, and in vitro cytotoxicity

2015 ◽  
Vol 132 (17) ◽  
Author(s):  
Ching-Wen Lou ◽  
Shih-Peng Wen ◽  
Jia-Horng Lin
2013 ◽  
Vol 712-715 ◽  
pp. 415-419
Author(s):  
Ming Hua Huang ◽  
Qing Hua Chen ◽  
Li Lei ◽  
Duan Cheng Wang ◽  
Ting Ting Yan

Sol-gel method and freeze-drying method were adopted to prepare the porous HAPw/KGM composite bone scaffolds and ammonia was used as a crosslinking agent. The porosity, average pore diameter, compressive strength and degradation rate in vitro were measured according to the related standard. The curves of each factor and lever affecting comprehensive properties were drew through the orthogonal design L9 (34) experiment. SEM and XRD were applied in characterization. The results show that the optimal preparation program of the composite scaffolds is KGM (2g), HAPw (4.5g), ammonia (0.1 ml) and the freeze temperature (-20 ° C); the prepared scaffolds are porous three-dimensional network structures; the porosity of optimal scaffold is more than 90%; the average pore diameter is between 200-300μm; the compressive strength is about 0.8Mpa and the degradation rate is about 50% within 9 weeks.


2021 ◽  
Vol 11 (19) ◽  
pp. 9066
Author(s):  
Ahmed A. H. Abdellatif ◽  
Mashari A. Aldhafeeri ◽  
Waleed H. Alharbi ◽  
Fahad H. Alharbi ◽  
Waleed Almutiri ◽  
...  

The aim of this study was to improve the solubility of etoposide–ethylcellulose (ET–ETO) microparticles using the freeze-drying technique. Ethylcellulose (EC) microparticles loaded with etoposide (ETO) were prepared with different drug–polymer molar ratios of 1:1, 1:3, 1:6, and 1:20 by the solvent evaporation method. The size of the prepared microparticles was 0.088 µm. The results showed that the amount of ETO encapsulated into the microparticles was 387.3, 365.0, 350.0, and 250 µg/50 mg microparticles for microparticles with drug–polymer ratios of 1:1, 1:3, 1:6, and 1:20, respectively. The FT-IR spectra showed no chemical interaction between ETO and the polymer in the solid state. The results obtained from the dissolution experiment showed that the freeze-dried microparticles were stable in 0.1 N HCl (gastric pH) for 2 h. At pH 7.4, the ETO release was 60 to 70% within the first 15 min and approximately 100% within 30 min. Results from the application of different dissolution models showed that the equations that best fit the dissolution data for the ET–ETO microparticles at pH 7.4 were the Higuchi and Peppas model equations. The in vitro cytotoxicity assay of free ETO and freeze-dried microspheres prepared in this study with a drug–polymer ratio of 1:1 was performed in two mammalian cancer cell lines, MCF-7 (for bone cancer of the mammary organ) and Caco-2 (for mammalian epithelial colorectal adenocarcinoma). The results showed that the half-maximal inhibitory concentrations (IC50 values) for ETO and freeze-dried ET–ETO microparticles were 18.6 µM and 27.1 µM, respectively. In conclusion, freeze-dried ET–ETO is a promising formulation for developing a fast-dissolving form of ETO with a significant antiproliferative activity against the tested cell lines used in this study. It is a promising formulation for local duodenal area targeting.


2019 ◽  
Vol 13 (2) ◽  
pp. 149-156
Author(s):  
Ángel Villalpando-Reyna ◽  
Dora Cortés-Hernández ◽  
Jose Granjeiro ◽  
Marcelo Prado ◽  
Alexander Gorokhovsky ◽  
...  

Bioactive and biocompatible composites were successfully prepared by reactive sintering of mixtures of a crystalline titanate precursor and 45S5 Bioglass?. The polytitanate/glass precursor ratios were 20/80, 40/60, 60/40 or 80/20 (wt.%). The powder mixtures were uniaxially pressed and heat treated at 1000 ?C for 1 h. During sintering, intensive interactions between raw materials occurred. The formed main crystalline phases were: potassium hexatitanate (K2Ti6O13), calcium titanate (CaTiO3), calcium silicate (CaSiO4) and sodium-calcium silicate (Na6Ca3Si6O18). Additionally, a Si-rich glassy phase was also observed. The mechanism of apatite formation indicated that both crystalline and amorphous phases play important roles in this process. A homogeneous apatite layer was formed on Si-OH, Ti-OH-rich interfaces. In vitro bioactivity was assessed using simulated body fluid (SBF K-9). The in vitro cytotoxicity behaviour was evaluated using a human osteoblastlike cells model and compressive strength by ASTM C-773 standard. All the composites demonstrated high bioactivity as cytotoxicity assays indicated a biocompatibility similar to that of the negative control. The samples showed high cell adherence and elongation cell characteristics similar to those observed on biocompatible systems. The compressive strength of the sintered samples decreased as the polytitanate content precursor was increased. The results obtained indicate that these materials are highly promising composites for medical applications.


2013 ◽  
Vol 747 ◽  
pp. 123-126 ◽  
Author(s):  
Eko Pujiyanto ◽  
Alva Edy Tontowi ◽  
Muhammad Waziz Wildan ◽  
Widowati Siswomihardjo

This study prepared porous hydroxyapatite (porous HA) as synthetic scaffold and find out chemical properties, porosity, compressive strength and cytotoxicity properties. Porous HA was prepared by powder deposition and sintering from HA-PMMA mixed powder. Porous HA characterizations were conducted by XRD, XRF, SEM-EDX and mercury porosimetry analysis. In vitro cytotoxicity testing of porous HA was conducted by MTT method using vero cells. Porous HA has porosity on the interval 62.79 to 69.67% and compressive strength on the interval 1.53 to 3.71 MPa. Optimal porous HA has porosity is 62.79% with compressive strength is 3.71 MPa. Mercury porosimetry analysis showed that optimal porous HA has interconnective porosity up to 88.25% with pore size on the interval 0.05-355 μm and median pore is 52.64 μm. There was no significantly difference in the death percentage of vero cells caused HA powder and optimal porous HA (p= 0.158) but concentration of optimal porous HA were significantly effect on the percentage of vero cells death (p=0.003).


2017 ◽  
Vol 28 (6) ◽  
pp. 744-748
Author(s):  
Bruna Fortes Bittencourt ◽  
John Alexis Dominguez ◽  
Luís Antonio Pinheiro ◽  
Paulo Vitor Farago ◽  
Elizabete Brasil dos Santos ◽  
...  

Abstract To examine the effect of the alternative coinitiator 4,4’bis dimethylamino benzydrol (BZN) in degree of conversion (DC), mechanical and biological properties of experimental composites. The coinitiator BZN was used in three concentrations (0.2, 0.5 and 1.2%), and the coinitiator DMAEMA was used as control at the same concentrations as above. The molar concentration of camphorquinone (CQ) and coinitiators was kept constant (1:1). The composites were manipulated and submitted to microhardness test (VHN), flexural and compressive strength (in MPa), elastic modulus (GPa), DC (FT-IR) and in vitro cytotoxicity (against 3T3 fibroblastic cells) of the experimental resins. Data were subjected to two-way ANOVA and Tukey post-test (α=0.05). The experimental composite resin with BZN showed higher DC values compared to control DMAEMA groups. For the mechanical properties, microhardness values were higher in BZN groups; flexural strength and elastic modulus were similar between all the groups. Compressive strength for groups BZN0.5 and DMAEMA0.5 were not statistically different, being the lowest values attributed to group BZN0.2. The experimental resins with BZN and DMAEMA were considered nontoxic against 3T3 fibroblasts. The inclusion of the coinitiator BZN in experimental composites was considered nontoxic against 3T3 fibroblast cells, without compromising DC and mechanical properties.


2014 ◽  
Vol 26 (1) ◽  
pp. 144 ◽  
Author(s):  
H. Hara ◽  
M. Tagiri ◽  
M. Hirabayashi ◽  
S. Hochi

During freezing, a solution changes into an amorphous phase at the glass transition temperature of the maximally freeze-concentrated phase (T′g). The solution exhibits a cake-like porous structure under the optimal freeze-drying process. However, if the product temperature is higher than theT′g during the drying phase, the glassy material will undergo viscous flow, resulting in loss of the porous structure. This is defined as the collapse phenomenon and may be related to instability of the freeze-dried products. The purpose of the present study was to investigate the effect of cake collapse on freeze-dried bull spermatozoa. One-way ANOVA was used for comparison of T′g, DNA damage, and blastocyst yield. When the ANOVA was significant, differences among means were analysed by a Tukey test. In Experiment 1, factors affecting the T′g were investigated. Using differential scanning calorimetry, theT′g of an EGTA buffer (10 mM TRIS-HCl, 50 mM EGTA, and 50 mM NaCl, pH8.0) that has been conventionally used for sperm freeze-drying was determined to be –45.0°C. Modification of the EGTA buffer composition by complete removal of NaCl and addition of 0.5 M trehalose (referred to hereafter as mEGTA buffer) resulted in an increase in theT′g up to –27.7°C. The T′g of the mEGTA buffer cooled by direct immersing into liquid nitrogen (–29.4°C) was slightly lower (P < 0.05) than that cooled slowly at 20 and 1°C min–1 (–27.6 and –27.2°C, respectively). In Experiment 2, the integrity of freeze-dried and rehydrated bull spermatozoa was investigated. Spermatozoa from a Japanese Black bull were suspended into mEGTA buffer (3 × 107 cells mL–1), cooled at 20°C min–1, and then processed for drying for 6 h at 0, –15, and –30°C (ALPHA2-4; Martin Christ Gefriertrocknungsanlagen GmbH, Osterode am Harz, Germany). Cakes were collapsed when the sperm suspension was dehydrated either at 0 or –15°C. In vitro-matured bovine oocytes were injected with rehydrated sperm, chemically activated (5 μM ionomycin, 7% ethanol, and 2 mM 6-DMAP), and then cultured for 8 days. Blastocyst yields after injection of sperm dried at 0 and –15°C, calculated from cleaved oocytes, were significantly lower than that of sperm dried at –30°C (0.7–3.7% v. 14.2%; P < 0.05). The level of DNA damage, assessed by the alkaline comet assay, was not different between the sperm populations dried at 0 and –30°C. Transmission electron microscopic observation revealed that the sperm membrane dried at 0°C was more damaged compared with that dried at –30°C (P < 0.05; chi-squared test with Bonferroni correction). In conclusion, incidence of collapse in freeze-dried cake may be a detrimental factor for maintenance of sperm integrity after freeze-drying, and can be inhibited by controlling the T′g of the buffer and drying phase temperature. H. Hara is Research Fellow of the Japan Society for the Promotion of Science (JSPS). This work was supported by a grant-in-aid for basic research from JSPS (no. 24580407) to S. Hochi.


2018 ◽  
Vol 21 (4) ◽  
pp. 262-270 ◽  
Author(s):  
Zehao Huang ◽  
Na Li ◽  
Kaifeng Rao ◽  
Cuiting Liu ◽  
Zijian Wang ◽  
...  

Background: More than 2,000 chemicals have been used in the tannery industry. Although some tannery chemicals have been reported to have harmful effects on both human health and the environment, only a few have been subjected to genotoxicity and cytotoxicity evaluations. Objective: This study focused on cytotoxicity and genotoxicity of ten tannery chemicals widely used in China. Materials and Methods: DNA-damaging effects were measured using the SOS/umu test with Salmonella typhimurium TA1535/pSK1002. Chromosome-damaging and cytotoxic effects were determined with the high-content in vitro Micronucleus test (MN test) using the human-derived cell lines MGC-803 and A549. Conclusion: The cytotoxicity of the ten tannery chemicals differed somewhat between the two cell assays, with A549 cells being more sensitive than MGC-803 cells. None of the chemicals induced DNA damage before metabolism, but one was found to have DNA-damaging effects on metabolism. Four of the chemicals, DY64, SB1, DB71 and RR120, were found to have chromosome-damaging effects. A Quantitative Structure-Activity Relationship (QSAR) analysis indicated that one structural feature favouring chemical genotoxicity, Hacceptor-path3-Hacceptor, may contribute to the chromosome-damaging effects of the four MN-test-positive chemicals.


2018 ◽  
Vol 15 (4) ◽  
pp. 564-575 ◽  
Author(s):  
Arehalli S. Manjappa ◽  
Popat S. Kumbhar ◽  
Prajakta S. Khopade ◽  
Ajit B. Patil ◽  
John I. Disouza

Sign in / Sign up

Export Citation Format

Share Document