CO 2 reforming of methane over the growth of hierarchical Ni nanosheets/ Al 2 O 3 ‐MgO synthesized via the ammonia vapour diffusion impregnation

Author(s):  
Nichthima Dharmasaroja ◽  
Tanakorn Ratana ◽  
Sabaithip Tungkamani ◽  
Thana Sornchamni ◽  
David S. A. Simakov ◽  
...  

2005 ◽  
Vol 156 (3-4) ◽  
pp. 100-103
Author(s):  
Rudolf Popper ◽  
Peter Niemz ◽  
Gerhild Eberle

The water vapour diffusion resistance of timber materials were tested in a wet climate (relative humidity ranging from 100%to 65% at 20 °C) and in a dry climate (relative humidity ranging from 0% to 65% and from 0% to 35% at 20 °c) with variation by relative humidity and vapour pressure gradient. The diffusion resistance of multilayer solid wood panels lies under or within the range of the solid wood (spruce), tending even to a lower range. This can be attributed to the loosely inserted middle lamella of the used solid wood panels, which were not correctly glued by the manufacturer. The diffusion resistance of the solid wood panels increases with decreasing moisture content and decreasing panel thickness, as well as with increasing water vapour gradient from 818 to 1520 Pa. There were clear differences between the tested timber materials. The diffusion resistance of particle composites is strongly dependent on the specific gravity. Due to laminar particles OSBs(Oriented Strand Boards) have a larger diffusion resistance than chipboards. The water vapour diffusion resistance of OSBs lies within the range of plywood.



Author(s):  
Natalia Pakharukova ◽  
Minna Tuittila ◽  
Sari Paavilainen ◽  
Anton Zavialov

The attachment of many Gram-negative pathogens to biotic and abiotic surfaces is mediated by fimbrial adhesins, which are assembledviathe classical, alternative and archaic chaperone–usher (CU) pathways. The archaic CU fimbrial adhesins have the widest phylogenetic distribution, yet very little is known about their structure and mechanism of assembly. To elucidate the biogenesis of archaic CU systems, structural analysis of the Csu fimbriae, which are used byAcinetobacter baumanniito form stable biofilms and cause nosocomial infection, was focused on. The major fimbriae subunit CsuA/B complexed with the CsuC chaperone was purified from the periplasm ofEscherichia colicells co-expressing CsuA/B and CsuC, and the complex was crystallized in PEG 3350 solution using the hanging-drop vapour-diffusion method. Selenomethionine-labelled CsuC–CsuA/B complex was purified and crystallized under the same conditions. The crystals diffracted to 2.40 Å resolution and belonged to the hexagonal space groupP6422, with unit-cell parametersa=b= 94.71,c = 187.05 Å, α = β = 90, γ = 120°. Initial phases were derived from a single anomalous diffraction (SAD) experiment using the selenomethionine derivative.



2021 ◽  
pp. 152808372110142
Author(s):  
Ariana Khakpour ◽  
Michael Gibbons ◽  
Sanjeev Chandra

Porous membranes find natural application in various fields and industries. Water condensation on membranes can block pores, reduce vapour transmissibility, and diminish the porous membranes' performance. This research investigates the rate of water vapour transmission through microporous nylon and nanofibrous Gore-Tex membranes. Testing consisted of placing the membrane at the intersection of two chambers with varied initial humidity conditions. One compartment is initially set to a high ([Formula: see text]water vapour concentration and the other low ([Formula: see text], with changes in humidity recorded as a function of time. The impact of pore blockage was explored by pre-wetting the membranes with water or interposing glycerine onto the membrane pores before testing. Pore blockage was measured using image analysis for the nylon membrane. The mass flow rate of water vapour ( ṁv) diffusing through a porous membrane is proportional to both its area (A) and the difference in vapour concentration across its two faces ([Formula: see text], such that [Formula: see text] where K is defined as the moisture diffusion coefficient. Correlations are presented for the variation of K as a function of [Formula: see text]. Liquid contamination on the porous membrane has been shown to reduce the moisture diffusion rate through the membrane due to pore blockage and the subsequent reduced open area available for vapour diffusion. Water evaporation from the membrane's surface was observed to add to the mass of vapour diffusing through the membrane. A model was developed to predict the effect of membrane wetting on vapour diffusion and showed good agreement with experimental data.



Vacuum ◽  
2021 ◽  
pp. 110415
Author(s):  
Lenke Kócs ◽  
Borbála Tegze ◽  
Emőke Albert ◽  
Csaba Major ◽  
András Szalai ◽  
...  


2002 ◽  
Vol 59 (1) ◽  
pp. 194-196 ◽  
Author(s):  
Hiroaki Adachi ◽  
Kazufumi Takano ◽  
Masaaki Morikawa ◽  
Shigenori Kanaya ◽  
Masashi Yoshimura ◽  
...  


1996 ◽  
Vol 168 (1-4) ◽  
pp. 170-174 ◽  
Author(s):  
Peter Baldock ◽  
Vaughan Mills ◽  
Patrick Shaw Stewart


1976 ◽  
Vol 6 (1) ◽  
pp. 40-48 ◽  
Author(s):  
R. A. Keller ◽  
E. B. Tregunna

Measurements of relative turgidity, transpiration rates, and photosynthetic rates on sun-grown and shade-grown western hemlock (Tsugaheterophylla (Raf.) Sarg.) were used to indicate effects of varying degrees of exposure.The sun-adapted form had low photosynthetic rates but maintained its water content under conditions of high evaporative demand. The shade-adapted form desiccated under exposed conditions, and in contrast with the sun-adapted form, its water vapour diffusion resistance decreased with increasing light intensity.



Author(s):  
Yoshifumi Maeda ◽  
Daiju Doubayashi ◽  
Takumi Ootake ◽  
Masaya Oki ◽  
Bunzo Mikami ◽  
...  

Formate oxidase (FOD), which catalyzes the oxidation of formate to yield carbon dioxide and hydrogen peroxide, belongs to the glucose–methanol–choline oxidoreductase (GMCO) family. FOD fromAspergillus oryzaeRIB40, which has a modified FAD as a cofactor, was crystallized at 293 K by the hanging-drop vapour-diffusion method. The crystal was orthorhombic and belonged to space groupC2221. Diffraction data were collected from a single crystal to 2.4 Å resolution.



Author(s):  
Yaoguang Chen ◽  
Xiaocheng Huang ◽  
Rongzhi Wang ◽  
Shihua Wang ◽  
Ning Shi

A fluorobody is a manmade hybrid molecule that is composed of green fluorescent protein (GFP) and a fragment of antibody, which combines the affinity and specificity of an antibody with the visibility of a GFP. It is able to provide a real-time indication of binding while avoiding the use of tags and secondary binding reagents. Here, the expression, purification and crystal structure of a recombinant fluorobody for TLH (thermolabile haemolysin), a toxin from the lethal food-borne disease bacteriumVibrio parahaemolyticus, are presented. This is the first structure of a fluorobody to be reported. Crystals belonging to space groupP43212, with unit-cell parametersa=b= 63.35,c = 125.90 Å, were obtained by vapour diffusion in hanging drops and the structure was refined to anRfreeof 16.7% at 1.5 Å resolution. The structure shows a CDR loop of the antibody on the GFP scaffold.



Sign in / Sign up

Export Citation Format

Share Document