Portable linear accelerators for X-ray and electron-beam applications in civil engineering

AbstractLongitudinal phase space (LPS) provides a critical information about electron beam dynamics for various scientific applications. For example, it can give insight into the high-brightness X-ray radiation from a free electron laser. Existing diagnostics are invasive, and often times cannot operate at the required resolution. In this work we present a machine learning-based Virtual Diagnostic (VD) tool to accurately predict the LPS for every shot using spectral information collected non-destructively from the radiation of relativistic electron beam. We demonstrate the tool’s accuracy for three different case studies with experimental or simulated data. For each case, we introduce a method to increase the confidence in the VD tool. We anticipate that spectral VD would improve the setup and understanding of experimental configurations at DOE’s user facilities as well as data sorting and analysis. The spectral VD can provide confident knowledge of the longitudinal bunch properties at the next generation of high-repetition rate linear accelerators while reducing the load on data storage, readout and streaming requirements.

Download Full-text

Aspects of microanalysis in a transmission electron microscope

Proceedings, annual meeting, Electron Microscopy Society of America ◽

10.1017/s0424820100109690 ◽

1978 ◽

Vol 36 (1) ◽

pp. 510-511

Author(s):

R. Sinclair ◽

B.E. Jacobson

Keyword(s):

Grain Size ◽

Electron Beam ◽

Electron Microscope ◽

Chemical Analysis ◽

Transmission Electron Microscope ◽

Vapor Deposition ◽

Critical Currents ◽

X Ray ◽

Fine Grain ◽

Transmission Electron

INTRODUCTIONThe prospect of performing chemical analysis of thin specimens at any desired level of resolution is particularly appealing to the materials scientist. Commercial TEM-based systems are now available which virtually provide this capability. The purpose of this contribution is to illustrate its application to problems which would have been intractable until recently, pointing out some current limitations.X-RAY ANALYSISIn an attempt to fabricate superconducting materials with high critical currents and temperature, thin Nb3Sn films have been prepared by electron beam vapor deposition [1]. Fine-grain size material is desirable which may be achieved by codeposition with small amounts of Al2O3 . Figure 1 shows the STEM microstructure, with large (∽ 200 Å dia) voids present at the grain boundaries. Higher quality TEM micrographs (e.g. fig. 2) reveal the presence of small voids within the grains which are absent in pure Nb3Sn prepared under identical conditions. The X-ray spectrum from large (∽ lμ dia) or small (∽100 Ǻ dia) areas within the grains indicates only small amounts of A1 (fig.3).

Download Full-text

X-ray micro tomography in the scanning electron microscope

Proceedings, annual meeting, Electron Microscopy Society of America ◽

10.1017/s0424820100107678 ◽

1978 ◽

Vol 36 (1) ◽

pp. 106-107 ◽

Cited By ~ 1

Author(s):

W. Brünger

Keyword(s):

Electron Beam ◽

Electron Microscope ◽

Scanning Electron Microscope ◽

Target Surface ◽

The Body ◽

X Rays ◽

Cross Sectional ◽

X Ray ◽

Micro Tomography ◽

Scanning Electron

Reconstructive tomography is a new technique in diagnostic radiology for imaging cross-sectional planes of the human body /1/. A collimated beam of X-rays is scanned through a thin slice of the body and the transmitted intensity is recorded by a detector giving a linear shadow graph or projection (see fig. 1). Many of these projections at different angles are used to reconstruct the body-layer, usually with the aid of a computer. The picture element size of present tomographic scanners is approximately 1.1 mm2.Micro tomography can be realized using the very fine X-ray source generated by the focused electron beam of a scanning electron microscope (see fig. 2). The translation of the X-ray source is done by a line scan of the electron beam on a polished target surface /2/. Projections at different angles are produced by rotating the object.During the registration of a single scan the electron beam is deflected in one direction only, while both deflections are operating in the display tube.

Download Full-text

Searching for the causes why some of the paintings by Mihaly Munkacsy are darkening

Proceedings, annual meeting, Electron Microscopy Society of America ◽

10.1017/s0424820100134612 ◽

1990 ◽

Vol 48 (2) ◽

pp. 204-205

Author(s):

Imre Pozsgai ◽

Klara Erdöhalmi-Torok

Keyword(s):

Electron Beam ◽

Cross Section ◽

Polyester Resin ◽

National Gallery ◽

X Ray ◽

Art Historians ◽

Made In ◽

Grinding And Polishing

The paintings by the great Hungarian master Mihaly Munkacsy (1844-1900) made in an 8-9 years period of his activity are deteriorating. The most conspicuous sign of the deterioration is an intensive darkening. We have made an attempt by electron beam microanalysis to clarify the causes of the darkening. The importance of a study like this is increased by the fact that a similar darkening can be observed on the paintings by Munkacsy’s contemporaries e.g Courbet and Makart. A thick brown mass the so called bitumen used by Munkacsy for grounding and also as a paint is believed by the art historians to cause the darkening.For this study, paint specimens were taken from the following paintings: “Studio”, “Farewell” and the “Portrait of the Master’s Wife”, all of them are the property of the Hungarian National Gallery. The paint samples were embedded in a polyester resin “Poly-Pol PS-230” and after grinding and polishing their cross section was used for x-ray mapping.

Download Full-text

Electron Beam-Induced Mass Loss in Freeze-Dried Tissue and Protein Samples

Proceedings, annual meeting, Electron Microscopy Society of America ◽

10.1017/s042482010011917x ◽

1985 ◽

Vol 43 ◽

pp. 470-471

Author(s):

M.E. Cantino ◽

M.K. Goddard ◽

L.E. Wilkinson ◽

D.E. Johnson

Keyword(s):

Electron Beam ◽

Salivary Gland ◽

Mass Loss ◽

Counting Rate ◽

Dose Dependence ◽

X Ray ◽

Large Samples ◽

Freeze Dried ◽

Muscle Homogenate ◽

Large Muscle

Quantification in biological x-ray microanalysis depends on accurate evaluation of mass loss. Although several studies have addressed the problem of electron beam induced mass loss from organic samples (eg., 1,2). uncertainty persists as to the dose dependence, the extent of loss, the elemental constituents affected, and the variation in loss for different materials and tissues. in the work described here, we used x-ray counting rate changes to measure mass loss in albumin (used as a quantification standard), salivary gland, and muscle.In order to measure mass loss at low doses (10-4 coul/cm2 ) large samples were needed. While freeze-dried salivary gland sections of the required dimensions were available, muscle sections of this size were difficult to obtain. To simulate large muscle sections, frog or rat muscle homogenate was injected between formvar films which were then stretched over slot grids and freeze-dried. Albumin samples were prepared by a similar procedure. using a solution of bovine serum albumin in water. Samples were irradiated in the STEM mode of a JEOL 100C.

Download Full-text

Few-Cycle Infrared Pulse Evolving in FEL Oscillators and Its Application to High-Harmonic Generation for Attosecond Ultraviolet and X-ray Pulses

Atoms ◽

10.3390/atoms9010015 ◽

2021 ◽

Vol 9 (1) ◽

pp. 15

Author(s):

Ryoichi Hajima

Keyword(s):

Harmonic Generation ◽

Short Pulse ◽

High Harmonic ◽

High Harmonic Generation ◽

Pulse Generation ◽

Solid State Lasers ◽

Linear Accelerators ◽

X Ray ◽

Ultrafast Science ◽

Historical Remarks

Generation of few-cycle optical pulses in free-electron laser (FEL) oscillators has been experimentally demonstrated in FEL facilities based on normal-conducting and superconducting linear accelerators. Analytical and numerical studies have revealed that the few-cycle FEL lasing can be explained in the frame of superradiance, cooperative emission from self-bunched systems. In the present paper, we review historical remarks of superradiance FEL experiments in short-pulse FEL oscillators with emphasis on the few-cycle pulse generation and discuss the application of the few-cycle FEL pulses to the scheme of FEL-HHG, utilization of infrared FEL pulses to drive high-harmonic generation (HHG) from gas and solid targets. The FEL-HHG enables one to explore ultrafast science with attosecond ultraviolet and X-ray pulses with a MHz repetition rate, which is difficult with HHG driven by solid-state lasers. A research program has been launched to develop technologies for the FEL-HHG and to conduct a proof-of-concept experiment of FEL-HHG.

Download Full-text

Development of x-ray beam profile monitor based on in-house grown crystal and application in electron beam imaging

10.1063/5.0017842 ◽

2020 ◽

Author(s):

Mohit Tyagi ◽

P. S. Sarkar ◽

R. S. Sengar ◽

Ashwani Kumar ◽

Jagannath ◽

...

Keyword(s):

Electron Beam ◽

Grown Crystal ◽

Beam Profile ◽

X Ray ◽

Beam Profile Monitor

Download Full-text

Influence of Beam Power on Young’s Modulus and Friction Coefficient of Ti–Ta Alloys Formed by Electron-Beam Surface Alloying

Metals ◽

10.3390/met11081246 ◽

2021 ◽

Vol 11 (8) ◽

pp. 1246

Author(s):

Stefan Valkov ◽

Dimitar Dechev ◽

Nikolay Ivanov ◽

Ruslan Bezdushnyi ◽

Maria Ormanova ◽

...

Keyword(s):

Electron Beam ◽

Young’S Modulus ◽

Coefficient Of Friction ◽

Young's Modulus ◽

Beam Power ◽

Surface Alloying ◽

Surface Alloys ◽

X Ray ◽

The Coefficient Of Friction ◽

Beam Surface

In this study, we present the results of Young’s modulus and coefficient of friction (COF) of Ti–Ta surface alloys formed by electron-beam surface alloying by a scanning electron beam. Ta films were deposited on the top of Ti substrates, and the specimens were then electron-beam surface alloyed, where the beam power was varied from 750 to 1750 W. The structure of the samples was characterized by scanning electron microscopy (SEM), energy-dispersive X-ray spectroscopy (EDX), and X-ray diffraction (XRD). Young’s modulus was studied by a nanoindentation test. The coefficient of friction was studied by a micromechanical wear experiment. It was found that at 750 W, the Ta film remained undissolved on the top of the Ti, and no alloyed zone was observed. By an increase in the beam power to 1250 and 1750 W, a distinguished alloyed zone is formed, where it is much thicker in the case of 1750 W. The structure of the obtained surface alloys is in the form of double-phase α’and β. In both surface alloys formed by a beam power of 1250 and 1750 W, respectively, Young’s modulus decreases about two times due to different reasons: in the case of alloying by 1250 W, the observed drop is attributed to the larger amount of the β phase, while at 1750 W is it due to the weaker binding forces between the atoms. The results obtained for the COF show that the formation of the Ti–Ta surface alloy on the top of Ti substrate leads to a decrease in the coefficient of friction, where the effect is more pronounced in the case of the formation of Ti–Ta surface alloys by a beam power of 1250 W.

Download Full-text

Features of electron beam shaping in x-ray tubes with hot-cathodes

10.1063/5.0052830 ◽

2021 ◽

Author(s):

A. N. Darmaev ◽

S. P. Morev ◽

V. M. Sablin ◽

N. N. Potrakhov ◽

A. S. Baklin

Keyword(s):

Electron Beam ◽

Beam Shaping ◽

X Ray

Download Full-text

Synchrotron X-ray induced acoustic imaging

Scientific Reports ◽

10.1038/s41598-021-83604-3 ◽

2021 ◽

Vol 11 (1) ◽

Author(s):

Seongwook Choi ◽

Eun-Yeong Park ◽

Sinyoung Park ◽

Jong Hyun Kim ◽

Chulhong Kim

Keyword(s):

Acoustic Imaging ◽

Signal Frequency ◽

X Rays ◽

Repetition Period ◽

Linear Accelerators ◽

X Ray ◽

X Ray Computed ◽

Medical Linear Accelerators ◽

Ionizing Radiation Exposure ◽

X Ray Absorption

AbstractX-ray induced acoustic imaging (XAI) is an emerging biomedical imaging technique that can visualize X-ray absorption contrast at ultrasound resolution with less ionizing radiation exposure than conventional X-ray computed tomography. So far, medical linear accelerators or industrial portable X-ray tubes have been explored as X-ray excitation sources for XAI. Here, we demonstrate the first feasible synchrotron XAI (sXAI). The synchrotron generates X-rays, with a dominant energy of 4 to 30 keV, a pulse-width of 30 ps, a pulse-repetition period of 2 ns, and a bunch-repetition period of 940 ns. The X-ray induced acoustic (XA) signals are processed in the Fourier domain by matching the signal frequency with the bunch-repetition frequency. We successfully obtained two-dimensional XA images of various lead targets. This novel sXAI tool could complement conventional synchrotron applications.

Download Full-text