Atomic structure of stair rod misfit dislocations at the GaAs on Si(100) interface

Author(s):  
D. Gerthsen

The prospect of technical applications has induced a lot of interest in the atomic structure of the GaAs on Si(100) interface and the defects in its vicinity which are often studied by high resolution transmission electron microscopy. The interface structure is determined by the 4.1% lattice constant mismatch between GaAs and Si, the large difference between the thermal expansion coefficients and the polar/nonpolar nature of the GaAs on Si interface. The lattice constant mismatch is compensated by misfit dislocations which are characterized by a/2<110> Burgers vectors b which are oriented parallel or inclined on {111} planes with respect to the interface. Stacking faults are also frequently observed. They are terminated by partial dislocations with b = a/6<112> on {111} planes. In this report, the atomic structure of stair rod misfit dislocations is analysed which are located at the intersection line of two stacking faults at the interface.A very thin, discontinous film of GaAs has been grown by MBE on a Si(100) substrate. Fig.1.a. shows an interface section of a 27 nm wide GaAs island along [110] containing a stair rod dislocation. The image has been taken with a JEOL 2000EX with a spherical aberration constant Cs = 1 mm, a spread of focus Δz = 10 nm and an angle of beam convergence ϑ of 2 mrad.

2005 ◽  
Vol 11 (6) ◽  
pp. 534-544 ◽  
Author(s):  
Karsten Tillmann ◽  
Andreas Thust ◽  
Andreas Gerber ◽  
Martin P. Weides ◽  
Knut Urban

The structural properties of β-phase tantalum nanocrystallites prepared by room temperature magnetron sputter deposition on amorphous carbon substrates are investigated at atomic resolution. For these purposes spherical aberration-corrected high-resolution transmission electron microscopy is applied in tandem with the numerical retrieval of the exit-plane wavefunction as obtained from a through-focus series of experimental micrographs. We demonstrate that recent improvements in the resolving power of electron microscopes enable the imaging of the atomic structure of β-tantalum with column spacings of solely 0.127 nm with directly interpretable contrast features. For the first time ever, we substantiate the existence of grain boundaries of 30° tilt type in β-Ta whose formation may be well explained by atomic agglomeration processes taking place during sputter deposition.


1993 ◽  
Vol 319 ◽  
Author(s):  
Frank Ernst

AbstractThe accommodation of lattice mismatch is studied in Ge0.15Si0.85 layers grown epitaxially on {111}-oriented Si substrates by chemical vapor deposition (CVD) at 1100°C. Weak beam dark field microscopy reveals a regular misfit dislocation network, which resembles the honeycomb network of edge-type dislocations anticipated by the O-lattice theory. In contrast to the latter, however, the real network exhibits extended nodes where the misfit dislocations dissociate into misfit partial dislocations. Between the partials, high resolution transmission electron microscopy (HRTEM) reveals intrinsic and extrinsic stacking faults. Owing to the presence of these stacking faults, three different atomistic structures of the GeSi/Si interface coexist and compete for the interfacial area according to their energy. The observed configuration is shown to minimize the total energy of the interface.


1996 ◽  
Vol 441 ◽  
Author(s):  
Y. Takagi ◽  
H. Yonezu ◽  
K. Samonji ◽  
T. Tsuji ◽  
N. Ohshima

AbstractWe have investigated the generation process of crystalline defects in GaP layers grown on Si substrates (GaP/Si) by molecular beam epitaxy (MBE) and migration enhanced epitaxy (MEE). Transmission electron microscopy observations revealed that a regular network of misfit dislocations was generated in GaP/Si by MEE. On the other hand, threading dislocations as well as interfacial misfit dislocations were observed in GaP/Si by MBE. Moreover, stacking faults were generated in high density at the hetero-interface of GaP/Si by MBE. The density of stacking faults was drastically reduced by MEE.


1990 ◽  
Vol 202 ◽  
Author(s):  
Hyo-Hoon Park ◽  
Eun Soo Nam ◽  
Yong Tak Lee ◽  
El-Hang Lee ◽  
Jeong Yong Lee ◽  
...  

ABSTRACTThe microstructural degradation of a lattice-matched Ga0.28 In0.72As0.61P0.39/InP heterointerface during atomic intermixing induced by Zn diffusion has been investigated using high-resolution transmission electron microscopy and Auger electron spectroscopy. The localized interfacial stress caused by intermixing appears to create stacking faults in the Ga-mixed InP substrate, and dislocation tangles in the In-mixed GalnAsP layer. The results are attributed to the contrasted effect of tensile and compressive stresses upon the nucleation of partial dislocations from both sides of the intermixed interface. A qualitative model is proposed for the homogeneous nucleation of misfit dislocations from the locally stressed interface.


Author(s):  
J. S. Wall ◽  
J. P. Langmore ◽  
H. Isaacson ◽  
A. V. Crewe

The scanning transmission electron microscope (STEM) constructed by the authors employs a field emission gun and a 1.15 mm focal length magnetic lens to produce a probe on the specimen. The aperture size is chosen to allow one wavelength of spherical aberration at the edge of the objective aperture. Under these conditions the profile of the focused spot is expected to be similar to an Airy intensity distribution with the first zero at the same point but with a peak intensity 80 per cent of that which would be obtained If the lens had no aberration. This condition is attained when the half angle that the incident beam subtends at the specimen, 𝛂 = (4𝛌/Cs)¼


Author(s):  
David A. Ansley

The coherence of the electron flux of a transmission electron microscope (TEM) limits the direct application of deconvolution techniques which have been used successfully on unmanned spacecraft programs. The theory assumes noncoherent illumination. Deconvolution of a TEM micrograph will, therefore, in general produce spurious detail rather than improved resolution.A primary goal of our research is to study the performance of several types of linear spatial filters as a function of specimen contrast, phase, and coherence. We have, therefore, developed a one-dimensional analysis and plotting program to simulate a wide 'range of operating conditions of the TEM, including adjustment of the:(1) Specimen amplitude, phase, and separation(2) Illumination wavelength, half-angle, and tilt(3) Objective lens focal length and aperture width(4) Spherical aberration, defocus, and chromatic aberration focus shift(5) Detector gamma, additive, and multiplicative noise constants(6) Type of spatial filter: linear cosine, linear sine, or deterministic


Sign in / Sign up

Export Citation Format

Share Document