Experimental factors affecting the phase-selective reversible anodic stripping determination of gallium from 1.0 molar ammonium thiocyanate electrolytes at 60.degree.C and collation of results with sodium thiocyanate/sodium perchlorate-based room temperature measurements

1976 ◽  
Vol 48 (4) ◽  
pp. 751-758 ◽  
Author(s):  
E. D. Moorhead ◽  
G. A. Forsberg
Author(s):  
Vlad MURESAN ◽  
Sevastita MUSTE ◽  
Emil RACOLTA ◽  
Cristina Anamaria SEMENIUC ◽  
Simona MAN ◽  
...  

Sunflower halva, popular in countries from Eastern Europe, is made of sunflower tahini, cooked sugar and soapwort root extract. Lipid fraction in traditional sunflower halva is rich in polyunsaturated fatty acids, susceptible to peroxidation. Oxidation of the lipids is one of the main causes of lipid rich food deterioration leading to formation of off-flavour that negatively affect their quality and shelf life. In this study the initially phase of oxidation in sunflower halva was assessed, using as indicator the peroxide value (PV). The protocol followed was the one described by IDF standard which uses ammonium thiocyanate as Fe(III)-complexing agent. Halva samples stored at room temperature, in open air conditions for four months, respectively ten months were analyzed. The PV of sunflower halva at 10 months of storage was ~ 2 times higher that the PV of sunflower halva at 4 months of storage. The samples of sunflower seeds used for the analysis were freshly dehulled and dehulled and then stored at room temperature in open air conditions for four months. The freshly dehulled sunflower seeds had a PV of 4.14 meq O2/Kg fat, similar values with those reported in the literature. The sunflower seeds dehulled and than stored for 4 months at room temperature in open air conditions had a PV of 89.47 meq O2/Kg fat, rancid taste being detected. Regarding the oxidative stability of sunflower halva, care must be taken on storage conditions and packaging – temperature and oxygen availability. For further studies addition of supplementary antioxidants should be considered.


Author(s):  
R. M. Anderson ◽  
T. M. Reith ◽  
M. J. Sullivan ◽  
E. K. Brandis

Thin films of aluminum or aluminum-silicon can be used in conjunction with thin films of chromium in integrated electronic circuits. For some applications, these films exhibit undesirable reactions; in particular, intermetallic formation below 500 C must be inhibited or prevented. The Al films, being the principal current carriers in interconnective metal applications, are usually much thicker than the Cr; so one might expect Al-rich intermetallics to form when the processing temperature goes out of control. Unfortunately, the JCPDS and the literature do not contain enough data on the Al-rich phases CrAl7 and Cr2Al11, and the determination of these data was a secondary aim of this work.To define a matrix of Cr-Al diffusion couples, Cr-Al films were deposited with two sets of variables: Al or Al-Si, and broken vacuum or single pumpdown. All films were deposited on 2-1/4-inch thermally oxidized Si substrates. A 500-Å layer of Cr was deposited at 120 Å/min on substrates at room temperature, in a vacuum system that had been pumped to 2 x 10-6 Torr. Then, with or without vacuum break, a 1000-Å layer of Al or Al-Si was deposited at 35 Å/s, with the substrates still at room temperature.


Author(s):  
Fumio Watari ◽  
J. M. Cowley

STEM coupled with the optical system was used for the investigation of the early oxidation on the surface of Cr. Cr thin films (30 – 1000Å) were prepared by evaporation onto the polished or air-cleaved NaCl substrates at room temperature and 45°C in a vacuum of 10−6 Torr with an evaporation speed 0.3Å/sec. Rather thick specimens (200 – 1000Å) with various preferred orientations were used for the investigation of the oxidation at moderately high temperature (600 − 1100°C). Selected area diffraction patterns in these specimens are usually very much complicated by the existence of the different kinds of oxides and their multiple twinning. The determination of the epitaxial orientation relationship of the oxides formed on the Cr surface was made possible by intensive use of the optical system and microdiffraction techniques. Prior to the formation of the known rhombohedral Cr2O3, a thin spinel oxide, probably analogous to γ -Al203 or γ -Fe203, was formed. Fig. 1a shows the distinct epitaxial growth of the spinel (001) as well as the rhombohedral (125) on the well-oriented Cr(001) surface. In the case of the Cr specimen with the (001) preferred orientation (Fig. 1b), the rings explainable by spinel structure appeared as well as the well defined epitaxial spots of the spinel (001). The microdif fraction from 20A areas (Fig. 2a) clearly shows the same pattern as Fig. Ia with the weaker oxide spots among the more intense Cr spots, indicating that the thickness of the oxide is much less than that of Cr. The rhombohedral Cr2O3 was nucleated preferably at the Cr(011) sites provided by the polycrystalline nature of the present specimens with the relation Cr2O3 (001)//Cr(011), and by further oxidation it grew into full coverage of the rest of the Cr surface with the orientation determined by the initial nucleation.


2002 ◽  
Vol 721 ◽  
Author(s):  
Monica Sorescu

AbstractWe propose a two-lattice method for direct determination of the recoilless fraction using a single room-temperature transmission Mössbauer measurement. The method is first demonstrated for the case of iron and metallic glass two-foil system and is next generalized for the case of physical mixtures of two powders. We further apply this method to determine the recoilless fraction of hematite and magnetite particles. Finally, we provide direct measurement of the recoilless fraction in nanohematite and nanomagnetite with an average particle size of 19 nm.


Author(s):  
Т.В. Никитина ◽  
А.А. Кашеварова ◽  
М.М. Гридина ◽  
А.А. Хабарова ◽  
А.Г. Мензоров ◽  
...  

Митотическая нестабильность кольцевых хромосом может приводить к появлению клеточных клонов с различной генетической структурой. В качестве модели нестабильности кольцевых хромосом в митозе мы использовали фибробласты от пациентов с r(8), r(13), r(18) и r(22) и полученные из них индуцированные плюрипотентные стволовые клетки (ИПСК). Линии ИПСК с r(22) имели относительно стабильный кариотип на протяжении десятков (до 60) пассажей и сохраняли неизменную структуру кольцевой хромосомы. Кариотип линий ИПСК с r(8) и r(18) на ранних пассажах стабильный, планируется его изучение на поздних пассажах. Наибольшее разнообразие кариотипа выявлено в линиях ИПСК с r(13), в которых наблюдали различные перестройки и выраженную клеточную гетерогенность. Определение факторов, влияющих на митотическую стабильность кольцевых хромосом, может иметь значение для консультирования пациентов. Mitotic instability of ring chromosomes can lead to the appearance of cell clones with different genetic structure. IPSCs from fibroblasts of patients with r(8), r(13), r(18), and r(22) were used as a model of ring chromosomes mitotic behavior. Karyotypes of iPSC lines with r(8) and r(18) have so far been evaluated only in the early passages, lines with r(22) have maintained a relatively stable karyotype up to 60 passages. The occurrence of rearrangements and cellular heterogeneity was found characteristic for r(13) iPSCs. The determination of factors affecting the ring chromosomes mitotic stability would be beneficial for the patient’s prognosis.


2020 ◽  
Author(s):  
Keishiro Yamashita ◽  
Kazuki Komatsu ◽  
Hiroyuki Kagi

An crystal-growth technique for single crystal x-ray structure analysis of high-pressure forms of hydrogen-bonded crystals is proposed. We used alcohol mixture (methanol: ethanol = 4:1 in volumetric ratio), which is a widely used pressure transmitting medium, inhibiting the nucleation and growth of unwanted crystals. In this paper, two kinds of single crystals which have not been obtained using a conventional experimental technique were obtained using this technique: ice VI at 1.99 GPa and MgCl<sub>2</sub>·7H<sub>2</sub>O at 2.50 GPa at room temperature. Here we first report the crystal structure of MgCl2·7H2O. This technique simultaneously meets the requirement of hydrostaticity for high-pressure experiments and has feasibility for further in-situ measurements.


Author(s):  
Nguyễn Thị Hồng Thu ◽  
Đặng Minh Nhật ◽  
Nguyễn Hoàng Dung

Sugar palm (Arenga pinnata) is a feather palm native to tropical Asia. In Vietnam, it is named Búng Báng or Đoác and grown only on the highlands in the central or northern part of Vietnam. It is utilized for many purposes, especially for Ta Vat wine production - a characteristic and unique product of Co Tu ethnic minority. However, because of the natural fermentation used in the production, the product quality is inconsistent. The purpose of this study was to examine a new procedure of using palm sap for making Ta Vat wine. Some characteristics of the sap, which was collected at Nam Giang district, Quang Nam province are determined, proving the potential of the sap for making wine product. The quality of sap changes quickly at room temperature. At low temperature (4 - 60C), the changes in sap quality are apparently slower. Examining some factors affecting its quality during the wine fermentation process, we determined the best parameters for the fermentation process as follows: inoculum size of 3% with cell density of about 1x108 cells/ml, the addition of the extract from the bark of Ceylon ironwood (Mesua ferrea L.) 4%. Keywords: Arenga pinnata, sap, Ceylon ironwood bark, Mesua ferrea L., wine fermentation.


Sign in / Sign up

Export Citation Format

Share Document