A Green and Energy-efficient Photocatalytic Process for accelerated synthesis of Lactic Acid Esters using functionalized quantum dots

Author(s):  
Priyanka Verma ◽  
Ravinder Kumar Wanchoo ◽  
Amrit Pal Toor

Sulphonate-grafted-Titania (SO3H-TiO2) quantum dot catalyzed photochemical process offered an energy-efficient, accelerated, and safe approach to synthesize lactic acid esters at ambient temperature conditions. This low-temperature route is conceived in line...

2018 ◽  
Vol 69 (12) ◽  
pp. 1225
Author(s):  
Miao Zhang ◽  
Zhongfang Tan ◽  
Xiaojie Wang ◽  
Meiyan Cui ◽  
Yanping Wang ◽  
...  

Lactic acid bacteria (LAB) can be used as silage additives to ensure rapid and vigorous fermentation at early stages of ensiling. We predicted that the optimal LAB inoculation dosage for forage at ambient temperature (15–38°C) would be different from that at cold temperature (4°C). In this study, Lactobacillus plantarum QZ227, isolated from a wheat landrace in alpine regions of Qinghai, China, and commercial L. plantarum FG1 were used as inoculum, with sterile water as control. The effects of inoculum dosage on the fermentation quality of oat (Avena sativa L. cv. Qinghai) and wheat (Triticum aestivum L. cv. Yumai No. 1) silage at ambient temperature (15–38°C) and at 4°C were investigated in laboratory experiments. Little or no improvement in silage quality occurred upon increasing the inoculum dosage at ambient temperature. By contrast, a lower pH and NH3-N content, and a higher LAB count and lactic acid content, were observed at 4°C. Furthermore, the growth of Escherichia coli was inhibited effectively at the lower temperature, and silage quality was positively correlated with increasing inoculum dosage (P<0.05). These results suggest that increasing the inoculum dosage could improve the quality of silage at lower temperatures of 4°C, whereas an appropriate dosage was a key factor for silage at ambient temperature. In this study, oat forage could be used as raw materials for ensiling only at low temperature but was not suitable for ensiling at ambient temperature without wilting due to the high moisture content (86.55%). QZ227 isolated from the roots of wheat in alpine regions displayed superior antimicrobial properties against yeast at ambient temperature and E. coli at 4°C compared with commercial strain FG1. This is the first study to explore the effects of inoculum dosage on silage quality at low temperatures, and provides a basis for low-temperature silage technologies.


Foods ◽  
2021 ◽  
Vol 10 (4) ◽  
pp. 894
Author(s):  
Johannes Pitsch ◽  
Georg Sandner ◽  
Jakob Huemer ◽  
Maximilian Huemer ◽  
Stefan Huemer ◽  
...  

Fermentable oligo-, di-, and monosaccharides and polyols (FODMAPs) are associated with digestive disorders and with diseases such as irritable bowel syndrome. In this study, we determined the FODMAP contents of bread, bakery products, and flour and assessed the effectiveness of sourdough fermentation for FODMAP reduction. The fermentation products were analyzed to determine the DP 2–7 and DP >7 fructooligosaccharide (FOS) content of rye and wheat sourdoughs. FOSs were reduced by Acetobacter cerevisiae, Acetobacter okinawensis, Fructilactobacillus sanfranciscensis, and Leuconostoc citreum to levels below those in rye (−81%; −97%) and wheat (−90%; −76%) flours. The fermentation temperature influenced the sourdough acetic acid to lactic acid ratios (4:1 at 4 °C; 1:1 at 10 °C). The rye sourdough contained high levels of beneficial arabinose (28.92 g/kg) and mannitol (20.82 g/kg). Our study contributes in-depth knowledge of low-temperature sourdough fermentation in terms of effective FODMAP reduction and concurrent production of desirable fermentation byproducts.


Author(s):  
Yilu Lin ◽  
Han Wu ◽  
Karthik Nithyanandan ◽  
Timothy H. Lee ◽  
Chia-fon F. Lee ◽  
...  

Bio-butanol, a promising alternative transportation fuel, has its industrial-scale production hindered significantly by high cost component purification process from acetone-butanol-ethanol (ABE) broth. The purpose of this study is to investigate the possibility of using ABE-Diesel blends with high ABE percentages as an alternative transportation fuel. An optical-accessible constant volume chamber capable of controlling ambient temperature, pressure and oxygen concentration was used to mimic the environmental conditions inside a real diesel engine cylinder. ABE fuel with typical volumetric ratios of 30% acetone, 60% butanol and 10% ethanol were blended with ultra-low sulfur diesel at 80% vol. and were tested in this study. The ambient temperature was set to be at 1100K and 900K, which represents normal combustion conditions and low temperature combustion conditions respectively. The ambient oxygen concentrations were set to be at 21%, 16% and 11%, representing different EGR ratios. The in-cylinder pressure was recorded by using a pressure transducer and the time-resolved Mie-scattering image and natural flame luminosity was captured using a high-speed camera coupled with a copper vapor laser. The results show that the liquid penetration is reduced by the high percentage of ABE in the blends. At the same time, the soot formation is reduced significantly by increasing oxygen content in the ABE fuel. Even more interesting, a soot-free combustion was achieved by combining the low temperature combustion with the higher percentage ABE case. In terms of soot emission, high ABE ratio blends are a very promising alternative fuel to be directly used in diesel engines especially under low-temperature combustion conditions.


2007 ◽  
Vol 558-559 ◽  
pp. 119-124
Author(s):  
Andrey Belyakov ◽  
Kaneaki Tsuzaki ◽  
Yoshisato Kimura ◽  
Yoshinao Mishima

15%Cr ferritic stainless steel was machined in rectangular samples and then processed by multiple forging to a total cumulative strain of 7.2 at an ambient temperature. The large strain deformation resulted in almost equiaxed submicrocrystalline structure with a mean grain/subgrain size of 230 nm and about 2.2×1014 m-2 dislocation density in grain/subgrain interiors. The annealing at a relatively low temperature of 500oC did not lead to any discontinuous recrystallizations. The grain/subgrain size and the interior dislocation density slightly changed to 240 nm and 2.1×1014 m-2, respectively, after annealing for 30 min, while the Vickers hardness decreased from 3140 MPa in the as-processed state to 2900 MPa. This annealing softening was attributed to remarkable release (by 50%) of internal stresses, which are associated with a non-equilibrium character of strain-induced grain/subgrain boundaries.


1998 ◽  
Vol 37 (Part 1, No. 12B) ◽  
pp. 7158-7160 ◽  
Author(s):  
Chae-Deok Lee ◽  
Chanro Park ◽  
Hwack Joo Lee ◽  
Kyu-Seok Lee ◽  
Seong-Ju Park ◽  
...  

2018 ◽  
Vol 195 ◽  
pp. 283-289 ◽  
Author(s):  
B. Babu ◽  
A.N. Kadam ◽  
G. Thirumala Rao ◽  
Sang-Wha Lee ◽  
Chan Byon ◽  
...  

2021 ◽  
Vol 11 (1) ◽  
pp. 118-122
Author(s):  
Chuyen Phan Thi ◽  
Hang Tran Thi Thanh ◽  
Phong Pham Nam ◽  
Ha Vu Thi Thu

Au, Pt supported on graphene aerogel catalysts (PtAu/rGOA) with molar ratio of Pt and Au of 1:1, and total metal concentration of 5 % were successfully synthesized by hydrothermal method.  The obtained catalysts were characterized by Raman, XRD, XPS, HR-TEM, BET. It revealed that Au and Pt nanoparticles with average size of 3 – 5 nm were highly dispersed on aerogel graphene. The activity of these catalysts was tested  in CO oxidation. The results showed that the conversion of CO at ambient temperature was 100% during 25 minutes. Accordingly, PtAu/rGOA could be considered as a potential catalysts for CO oxidation at low temperature.


2013 ◽  
Vol 264 ◽  
pp. 17-20 ◽  
Author(s):  
K. Senthilkumar ◽  
T. Kalaivani ◽  
S. Kanagesan ◽  
V. Balasubramanian

Sign in / Sign up

Export Citation Format

Share Document