Elastic response of a protein monolayer adsorbed at decorated water surface

Author(s):  
Amarjeet Singh ◽  
Oleg Konovalov
2021 ◽  
Vol 2021 ◽  
pp. 1-10
Author(s):  
Jihang Lyu ◽  
Rong Yang ◽  
Lingcai Huang

The significant dynamic response under the combined impact of aerodynamic and hydrodynamic forces could be likely to appear because of the structural flexibility, when taxiing on the water surface for amphibious aircraft. Meanwhile, the modal characteristics of the structure are also affected by the additional motion of water. These require that the influence of the structural elasticity and the coupling effect between water and structure should be considered in dynamic response analysis of water-taxiing. According to the peculiarities of the amphibious aircraft, structural dynamics model is based on the distribution of stiffness and mass, Virtual Mass Theory is utilized to solve the wet modes on the water surface, rational function approximations of unsteady aerodynamic force in time-domain are constructed by the Minimum-State Approximation Formula, and loose coupling method is employed to simulate the hydrodynamic elastic response under the encounter of amphibian with single wave and repeated waves, respectively. Analysis of dynamic characteristics during the water-taxiing of the amphibious aircraft has been achieved in this work. The results show that wet natural frequencies of the aircraft have different degrees of decline compared with the dry frequencies because of the influence of added water on the hull, and the response amplitude of dynamic loads obtained by using the wet modes have some certain extent decrease compared with the dry modes. The dynamic amplitude of different locations changes in different degree relatives to the center of gravity position, which reflects the influence of structural elasticity. Due to the excitation of single wave and repeated waves, the structural vibration amplitude will increase rapidly, but the amplitude shows a certain divergence trend under the action of repeated waves with a given oscillation frequency, which is more severe for structural strength design.


Author(s):  
K. T. Tokuyasu

During the past investigations of immunoferritin localization of intracellular antigens in ultrathin frozen sections, we found that the degree of negative staining required to delineate u1trastructural details was often too dense for the recognition of ferritin particles. The quality of positive staining of ultrathin frozen sections, on the other hand, has generally been far inferior to that attainable in conventional plastic embedded sections, particularly in the definition of membranes. As we discussed before, a main cause of this difficulty seemed to be the vulnerability of frozen sections to the damaging effects of air-water surface tension at the time of drying of the sections.Indeed, we found that the quality of positive staining is greatly improved when positively stained frozen sections are protected against the effects of surface tension by embedding them in thin layers of mechanically stable materials at the time of drying (unpublished).


Author(s):  
Dimitrij Lang

The success of the protein monolayer technique for electron microscopy of individual DNA molecules is based on the prevention of aggregation and orientation of the molecules during drying on specimen grids. DNA adsorbs first to a surface-denatured, insoluble cytochrome c monolayer which is then transferred to grids, without major distortion, by touching. Fig. 1 shows three basic procedures which, modified or not, permit the study of various important properties of nucleic acids, either in concert with other methods or exclusively:1) Molecular weights relative to DNA standards as well as number distributions of molecular weights can be obtained from contour length measurements with a sample standard deviation between 1 and 4%.


2020 ◽  
Vol 20 (3) ◽  
pp. 343-353
Author(s):  
Ngo Van He ◽  
Le Thi Thai

In this paper, a commercial CFD code, ANSYS-Fluent has been used to investigate the effect of mesh number generated in the computed domain on the CFD aerodynamic performances of a container ship. A full-scale model of the 1200TEU container ship has been chosen as a reference model in the computation. Five different mesh numbers for the same dimension domain have been used and the CFD aerodynamic performances of the above water surface hull of the ship have been shown. The obtained CFD results show a remarkable effect of mesh number on aerodynamic performances of the ship and the mesh convergence has been found. The study is an evidence to prove that the mesh number has affected the CFD results in general and the accuracy of the CFD aerodynamic performances in particular.


2019 ◽  
Vol 50 (5) ◽  
pp. 511-520
Author(s):  
Aleksey Ivanovich Arzhanov ◽  
Sergey Viktorovich Dikiy ◽  
Yuriy Fedorovich Zhuravlev ◽  
Svyatoslav Vladimirovich Kalashnikov ◽  
Nikolay Arkadievich Shulman

Sign in / Sign up

Export Citation Format

Share Document