Probing the intensity of dilatancy of high performance shear-thickening fluids comprising silica in polyethylene glycol

2019 ◽  
Vol 6 (7) ◽  
pp. 075702 ◽  
Author(s):  
Victor Avisek Chatterjee ◽  
Puja Dey ◽  
Sanjeev Kumar Verma ◽  
Debarati Bhattacharjee ◽  
Ipsita Biswas ◽  
...  
2018 ◽  
Vol 49 (10) ◽  
pp. 1317-1333 ◽  
Author(s):  
Lijuan Wang ◽  
Kejing Yu ◽  
Diantang Zhang ◽  
Kun Qian

This paper mainly investigated the cut resistant property of shear thickening fluid enhanced organic high-performance yarn. Cut tests of neat yarn and shear thickening fluids/yarn were performed with two cutting angles. External forces involved in the cutting were analyzed. A simple theoretical relation was established based on the principle of the energy conversion. Two types of shear thickening fluids were prepared. Compared to neat yarn, the shear thickening fluids/yarn exhibited extremely high cut resistant property, especially, shear thickening fluids/yarn with graphene, indicating a synergistic effect. Fracture surfaces of fibers after yarns cut off were initially studied, which verified the cut resistant characteristics of organic high-performance yarns and shear thickening fluids/yarn.


2019 ◽  
Vol 11 (3) ◽  
pp. 340-378 ◽  
Author(s):  
Dakshitha Weerasinghe ◽  
Damith Mohotti ◽  
Jeremy Anderson

Soft armour consisting of multi-layered high-performance fabrics are a popular choice for personal protection. Extensive work done in the last few decades suggests that shear thickening fluids improve the impact resistance of woven fabrics. Shear thickening fluid–impregnated fabrics have been proven as an ideal candidate for producing comfortable, high-performance soft body armour. However, the mechanism of defeating a projectile using a shear thickening fluid–impregnated multi-layered fabric is not fully understood and can be considered as a gap in the research done on the improvement of soft armour. Even though considerable progress has been achieved on dry fabrics, limited studies have been performed on shear thickening fluid–impregnated fabrics. The knowledge of simulation of multi-layered fabric armour is not well developed. The complexity in creating the geometry of the yarns, incorporating friction between yarns and initial pre-tension between yarns due to weaving patterns make the numerical modelling a complex process. In addition, the existing knowledge in this area is widely dispersed in the published literature and requires synthesis to enhance the development of shear thickening fluid–impregnated fabrics. Therefore, this article aims to provide a comprehensive review of the current methods of modelling shear thickening fluid–impregnated fabrics with a critical analysis of the techniques used. The review is preceded by an overview of shear thickening behaviour and related mechanisms, followed by a discussion of innovative approaches in numerical modelling of fabrics. A novel state-of-the-art means of modelling shear thickening fluid–impregnated fabrics is proposed in conclusion of the review of current methods. A short case study is also presented using the proposed approach of modelling.


2021 ◽  
Author(s):  
Jakub Mikolaj Szczepanski

Great interest has aroused in developing the next generation body armour based on the incorporation of a Shear Thickening Fluid (STF) into high performance fabrics (Kevlar®, UHMWPE). This innovative technoloy allows for the production of comfortable, flexible, lightweight, stab and ballistic resistant protective garments. This innovative technology allows for the production of comfortable, flexible, lightweight, stab and ballistic resistant protective garments. The furrent research was undertaken to evaluate the stab resistance and the chemical properties of types of high performance fabrics, Kevlar and Ultra Hight Molecular Weight Polyethylene (UHMWPE), impregnated with several types of shear thickening fluids. The stab resistance properties of all samples were tested using drop tower and quasistatic testing apparatuses. Chemical compositions and microscopic structures were analyzed with Fourier Transform Infrared Spectroscopy, Scanning Electron Microscopy and Energy Dispersive Spectroscopy. The current study demonstrated the importance of incorporating Shear Thickening Fluid into woven high performance fibres. The results clearly display a significant enhancement in puncture resistance ony of Kevlar® fabrics impregnated with different combination of STFs.


2019 ◽  
Vol 49 (6) ◽  
pp. 809-832
Author(s):  
Erdem Selver

This paper attempts to show the effect of silica nanoparticles and polyethylene glycol mixture (shear thickening fluids) on tensile and flexural properties (3-point bending) of glass and carbon fibre-reinforced thermoset composite laminates. The shear thickening fluids were prepared by combination of silica nanoparticles and polyethylene glycol using various silica contents (10–20 wt%). A viscometer was used to evaluate the shear thickening characteristics and viscosity of shear thickening fluids increased by increasing the silica content. Shear thickening fluids were impregnated on the host of glass and carbon fabrics and subsequently converted to composite laminates using vacuum infusion method with an epoxy matrix. It was found that shear thickening fluids-treated carbon and glass fabric composites exhibited up to 10% and 12% higher tensile strength than neat composites whilst the tensile modulus increased about 24%. Shear thickening fluids-treated fabric composites exhibited slower damage propagation compared to brittle nature of untreated fabric composites. However, lower flexural strength with higher energy absorption (up to 27%) were obtained after using shear thickening fluids for both carbon and glass fibre composites.


2021 ◽  
Author(s):  
Jakub Mikolaj Szczepanski

Great interest has aroused in developing the next generation body armour based on the incorporation of a Shear Thickening Fluid (STF) into high performance fabrics (Kevlar®, UHMWPE). This innovative technoloy allows for the production of comfortable, flexible, lightweight, stab and ballistic resistant protective garments. This innovative technology allows for the production of comfortable, flexible, lightweight, stab and ballistic resistant protective garments. The furrent research was undertaken to evaluate the stab resistance and the chemical properties of types of high performance fabrics, Kevlar and Ultra Hight Molecular Weight Polyethylene (UHMWPE), impregnated with several types of shear thickening fluids. The stab resistance properties of all samples were tested using drop tower and quasistatic testing apparatuses. Chemical compositions and microscopic structures were analyzed with Fourier Transform Infrared Spectroscopy, Scanning Electron Microscopy and Energy Dispersive Spectroscopy. The current study demonstrated the importance of incorporating Shear Thickening Fluid into woven high performance fibres. The results clearly display a significant enhancement in puncture resistance ony of Kevlar® fabrics impregnated with different combination of STFs.


2011 ◽  
Vol 4 (1) ◽  
pp. 43-49 ◽  
Author(s):  
Jie Ding ◽  
Weihua Li ◽  
Shirley Z. Shen

2021 ◽  
pp. 002199832098424
Author(s):  
Mohsen Jeddi ◽  
Mojtaba Yazdani

Whereas most previous studies have focused on improving the penetration resistance of Shear Thickening Fluids (STFs) treated composites, in this study, the dynamic compressive response of single and multi-ply 3 D E-Glass Fiber Reinforced Polymer (GFRP) composites with the STF matrix was investigated by using a drop-weight low-velocity impact test. The experimental results revealed the STF improved the compressive and cushioning performance of the composites such that with increasing its concentration, further improvement was observed. The five-ply composite containing the STF of 30 wt% silica nanoparticles and 1 wt% carbon nanotubes (CNTs) reduced the applied peak force by 56% and 26% compared to a steel plate and five-ply neat samples, respectively. A series of repeated impacts was performed, and it was found that the performance of high-concentration composites is further decreased under this type of loading.


Nutrients ◽  
2020 ◽  
Vol 13 (1) ◽  
pp. 129
Author(s):  
Charlotte Cuerq ◽  
Claire Bordat ◽  
Charlotte Halimi ◽  
Emilie Blond ◽  
Marion Nowicki ◽  
...  

(1) Background: vitamin E is often supplemented in the form of tocopherol acetate, but it has poor bioavailability and can fail to correct blood tocopherol concentrations in some patients with severe cholestasis. In this context, α-tocopheryl polyethylene glycol succinate 1000 (TPGS) has been of value, but very little is known about the mechanisms of its absorption. The aim of our work was to evaluate the mechanisms of absorption/secretion of TPGS compared to tocopherol acetate (TAC) and α-tocopherol by human enterocyte-like Caco-2 TC7 cells. (2) Methods: two weeks post-confluence Caco-2 cells were incubated with tocopherol- or TAC- or TPGS-rich mixed micelles up to 24 h and, following lipid extraction, TAC and tocopherol amounts were measured by high performance liquid chromatography (HPLC) in apical, cellular, and basolateral compartments. (3) Results: at equivalent concentrations of tocopherol in the apical side, the amounts of tocopherol secreted at the basolateral pole of Caco-2 cells are (i) significantly greater when the tocopherol is in the free form in the micelles; (ii) intermediate when it is in the TAC form in the micelles (p < 0.001); and (iii) significantly lower with the TPGS form (p < 0.0001). Interestingly, our results show, for the first time, that Caco-2 cells secrete one or more esterified forms of the vitamin contained in TPGS at the basolateral side.


Sign in / Sign up

Export Citation Format

Share Document