Extraction of Aflatoxin from Peanut Products by Dialysis

1965 ◽  
Vol 48 (6) ◽  
pp. 1256-1260
Author(s):  
A Jayaraman ◽  
V Sreenivasamurthy ◽  
H A B Parpia

Abstract The dialysis with aqueous methanol of aflatoxin in natural materials has been examined. With the use of aqueous methanol of decreasing strength every two hours, high toxin values are obtained as compared with those obtained by a Soxhlet extraction with methanol. This is possibly because of partial destruction of the toxin by heating in the Soxhlet extraction.

2009 ◽  
pp. 18-31
Author(s):  
G. Rapoport ◽  
A. Guerts

In the article the global crisis of 2008-2009 is considered as superposition of a few regional crises that occurred simultaneously but for different reasons. However, they have something in common: developed countries tend to maintain a strong level of social security without increasing the real production output. On the one hand, this policy has resulted in trade deficit and partial destruction of market mechanisms. On the other hand, it has clashed with the desire of several oil and gas exporting countries to receive an exclusive price for their energy resources.


2020 ◽  
pp. 43-47
Author(s):  
S.V. Prudius ◽  
◽  
N.L. Hes ◽  
A.M. Mylin ◽  
V.V. Brei ◽  
...  

In recent years, numerous researchers have focused on the development of catalytic methods for processing of biomass-derived sugars into alkyl lactates, which are widely used as non-toxic solvents and are the starting material for obtaining monomeric lactide. In this work, the transformation of fructose into methyl lactate on Sn-containing catalyst in the flow reactor that may be of practical interest was studied. The supported Sn-containing catalyst was ob-tained by a simple impregnation method of granular γ-Al2O3. The catalytic ex-periments were performed in a flow reactor at temperatures of 160-190 °C and pressure of 3.0 MPa. The 1.6-9.5 wt.% fructose solutions in 80% aqueous methanol were used as a reaction mixture. It was found that addition to a reac-tion mixture of 0.03 wt.% potassium carbonate leads to the increase in selec-tivity towards methyl lactate on 15% at 100% conversion of fructose. Prod-ucts of the target reaction С6Н12О6 + 2СН3ОН = 2С4Н8О3 + 2Н2О were ana-lyzed using 13C NMR method. The following process conditions for obtaining of 65 mol% methyl lactate yield at 100% fructose conversion were found: use of 4.8 wt.% fructose solution in 80% methanol, 180 °С, 3.0 МПа and a load on catalyst 1.5 mmol C6H12O6/mlcat/h at contact time of 11 minutes. The cata-lyst productivity is 2.0 mmol C4H8O3/mlcat/h and the by-productі are 1,3-dihydroxyacetone dimethyl acetal (20%) and 5-hydroxymethylfurfural (10%). It should be noted that a racemic mixture of L- and D-methyl lactates has been obtained by conversion of D-fructose on the SnO2/Al2O3 catalyst. The SnO2/Al2O3 catalyst was found to be stable for 6 h while maintaining full fruc-tose conversion at 55–70% methyl lactate selectivity. After regeneration the catalyst completely restores the initial activity.


2019 ◽  
Vol 2019 (1) ◽  
pp. 153-158
Author(s):  
Lindsay MacDonald

We investigated how well a multilayer neural network could implement the mapping between two trichromatic color spaces, specifically from camera R,G,B to tristimulus X,Y,Z. For training the network, a set of 800,000 synthetic reflectance spectra was generated. For testing the network, a set of 8,714 real reflectance spectra was collated from instrumental measurements on textiles, paints and natural materials. Various network architectures were tested, with both linear and sigmoidal activations. Results show that over 85% of all test samples had color errors of less than 1.0 ΔE2000 units, much more accurate than could be achieved by regression.


2016 ◽  
Author(s):  
Maria Pina ◽  
Daniel Russo ◽  
Cristina Balistreri ◽  
Kelly O'Reilly ◽  
Luis Cendan ◽  
...  

2020 ◽  
pp. 407-410
Author(s):  
E.Yu. Krupenya ◽  
A.P. Shishkina

The essence and scope of granular organic media from natural materials in the technology for machine parts manufacturing are shown. Vibration finishing model of the parts surface by granules of stone organic media and the results of its experimental verification, features of drying and vibration wiping of parts by organic media are presented.


2017 ◽  
Vol 10 (1) ◽  
pp. 100-109
Author(s):  
Hongxia Li ◽  
Natasha Trzaskalski ◽  
R.J. Neil Emery

Objective:A simple and fast high performance liquid chromatography-electrospray tandem mass spectrometry (LC-ESI-MS/MS) method has been developed for the analysis of brassinosteroids (BRs) in plants without derivatization.Materials:The BRs (including castasterone, 24-epicastasterone, brassinolide and 24-epibrassinolide) have been extracted with ice cold 80% aqueous methanol solution.Method:Five different purification strategies have been tested for the purification and enrichment of BRs.Conclusion:This analytical method was sensitive, reliable, rapid and applicable to trace analysis in complex plant samples.


2020 ◽  
Vol 7 (1) ◽  
pp. 17-23
Author(s):  
Khadiza Fitri Shafira ◽  
Abul Kalam Azad ◽  
Zubair Khalid Labu ◽  
Abul Bashar Mohammed Helal Uddin

Background: Eugenol is the main constituent of clove essential oil. Past studies have found that clove oil has diverse uses in the pharmaceutical field due to its antioxidant, antibacterial and anesthetic properties. Objective: This work compares the performance of different extraction methods and factors and identifies the effect of the treatments on oil yields and eugenol content. Materials and Methods: Maceration, Hydro distillation, microwave-assisted extraction (MAE), and Soxhlet were performed. The best technique was identified according to yield and content. Further studies were conducted to examine the effects of different factors, such as solvent types (ethanol and methanol) and sample-to-solvent ratio (1:10 and 1:15). HPLC UV-Vis was utilized in the analysis of eugenol concentration. Results and Discussion: Soxhlet extraction provided the highest yield (39.98%) and eugenol content (15.83%), compared to other methods. The results observed from several Soxhlet extraction factors showed that there is no significant difference between the different factors. In the meantime, methanol 1:15 provided the greatest amount of yields (57.83%) and eugenol content (22.21%). In this regard, the higher ratio resulted in higher eugenol content. Conclusion: The results obtained are less comparable because the processing time, the working solvent, and the separation technique were carried out differently for each method. In the meantime, as there is no past study that compared the selected methods and factors, this study’s findings will contribute substantially to fill the gap in this field.


Sign in / Sign up

Export Citation Format

Share Document