Electrical Field Chamber with Dinamically Adaptable Stimuli for Myocyte Orientation During Cultivation

2021 ◽  
Author(s):  
Sergio R. Molina Ramirez ◽  
Takahiro Yamada ◽  
Akira Funahashi ◽  
Hiroaki Onoe
Keyword(s):  
Electrical Field

Principles of Low-Vacuum SEM

1992 ◽  
Vol 50 (2) ◽  
pp. 1304-1305
Author(s):  
Klaus-Ruediger Peters
Keyword(s):  
New Technologies ◽  
High Vacuum ◽  
Optical Microscope ◽  
Specimen Surface ◽  
Electrical Field ◽  
Gaseous Environment ◽  
New Information ◽  
Gas Molecules ◽  
New Interactions ◽  
Gas Pressures

Only recently it became possible to expand scanning electron microscopy to low vacuum and atmospheric pressure through the introduction of several new technologies. In principle, only the specimen is provided with a controlled gaseous environment while the optical microscope column is kept at high vacuum. In the specimen chamber, the gas can generate new interactions with i) the probe electrons, ii) the specimen surface, and iii) the specimen-specific signal electrons. The results of these interactions yield new information about specimen surfaces not accessible to conventional high vacuum SEM. Several microscope types are available differing from each other by the maximum available gas pressure and the types of signals which can be used for investigation of specimen properties.Electrical non-conductors can be easily imaged despite charge accumulations at and beneath their surface. At high gas pressures between 10-2 and 2 torr, gas molecules are ionized in the electrical field between the specimen surface and the surrounding microscope parts through signal electrons and, to a certain extent, probe electrons. The gas provides a stable ion flux for a surface charge equalization if sufficient gas ions are provided.

An ultrastructural analysis of the sympathetic innervation of the rabbit ear artery and middle cerebral artery and their branches

1992 ◽  
Vol 50 (1) ◽  
pp. 934-935
Author(s):  
John T. Dodge ◽  
John A. Bevan
Keyword(s):  
Middle Cerebral Artery ◽  
Cerebral Artery ◽  
Sympathetic Innervation ◽  
Electrical Field Stimulation ◽  
Rabbit Ear Artery ◽  
Electrical Field ◽  
Functional Differences ◽  
Ear Artery ◽  
Rabbit Ear ◽  
Vascular Beds

Unlike many peripheral vascular beds, the sympathetic nervous system exerts little control on cerebral blood flow. The contractile response of isolated rabbit middle cerebral artery (MCA) segments to electrical field stimulation of its intramural nerves is less than in a similar-sized artery from the ear. This study was undertaken to characterize and compare the perivascular neuromuscular relationships and innervation density of similar-sized arteries varying in diameter from these two different regional arterial beds to see if there were structural correlates for these functional differences.

Electrical Anisotropy of Thin Metal Films Growing on Dielectric Substrates

2002 ◽  
Vol 7 (2) ◽  
pp. 45-52
Author(s):  
L. Jakučionis ◽  
V. Kleiza
Keyword(s):  
Magnetic Field ◽  
Thin Films ◽  
Uniaxial Anisotropy ◽  
Metal Films ◽  
Thin Layers ◽  
Electrical Anisotropy ◽  
Electrical Field ◽  
Dielectric Substrates ◽  
Unequal Probability ◽  
Conductive Thin Films

Electrical properties of conductive thin films, that are produced by vacuum evaporation on the dielectric substrates, and which properties depend on their thickness, usually are anisotropic i.e. they have uniaxial anisotropy. If the condensate grow on dielectric substrates on which plane electrical field E is created the transverse voltage U⊥ appears on the boundary of the film in the direction perpendicular to E. Transverse voltage U⊥ depends on the angle γ between the applied magnetic field H and axis of light magnetisation. When electric field E is applied to continuous or grid layers, U⊥ and resistance R of layers are changed by changing γ. It means that value of U⊥ is the measure of anisotropy magnitude. Increasing voltage U0 , which is created by E, U⊥ increases to certain magnitude and later decreases. The anisotropy of continuous thin layers is excited by inequality of conductivity tensor components σ0 ≠ σ⊥. The reason of anisotropy is explained by the model which shows that properties of grain boundaries are defined by unequal probability of transient of charge carrier.

Analysis of the Bias Dependent Spectral Response of a-SiC:H p-i-n Photodiode

2002 ◽  
Vol 715 ◽  
Author(s):  
P. Louro ◽  
A. Fantoni ◽  
Yu. Vygranenko ◽  
M. Fernandes ◽  
M. Vieira
Keyword(s):  
Bias Voltage ◽  
Voltage Dependence ◽  
Spectral Response ◽  
Surface Recombination ◽  
Electrical Field ◽  
Field Reversal ◽  
Current Voltage ◽  
Voltage Dependent ◽  
And Inversion ◽  
Device Operation

AbstractThe bias voltage dependent spectral response (with and without steady state bias light) and the current voltage dependence has been simulated and compared to experimentally obtained values. Results show that in the heterostructures the bias voltage influences differently the field and the diffusion part of the photocurrent. The interchange between primary and secondary photocurrent (i. e. between generator and load device operation) is explained by the interaction of the field and the diffusion components of the photocurrent. A field reversal that depends on the light bias conditions (wavelength and intensity) explains the photocurrent reversal. The field reversal leads to the collapse of the diode regime (primary photocurrent) launches surface recombination at the p-i and i-n interfaces which is responsible for a double-injection regime (secondary photocurrent). Considerations about conduction band offsets, electrical field profiles and inversion layers will be taken into account to explain the optical and voltage bias dependence of the spectral response.

Development of an AC Electrical Field Tribochemical Polishing Technique to Promote High-Efficiency Polishing for Glass Substrates

2012 ◽  
Vol 78 (4) ◽  
pp. 316-320
Author(s):  
Hiroshi IKEDA ◽  
Yoichi AKAGAMI ◽  
Michio UNEDA ◽  
Osamu OHNISHI ◽  
Syuhei KUROKAWA ◽  
...  
Keyword(s):  
High Efficiency ◽  
Electrical Field ◽  
Glass Substrates

scholarly journals Modular Marx Generator Based on SiC-MOSFET Generating Adjustable Rectangular Pulses

Energies ◽  
2021 ◽  
Vol 14 (12) ◽  
pp. 3492
Author(s):  
Yahia Achour ◽  
Jacek Starzyński ◽  
Jacek Rąbkowski
Keyword(s):  
Silicon Carbide ◽  
Repetition Rate ◽  
Pulse Width ◽  
Biomedical Applications ◽  
Living Cells ◽  
Marx Generator ◽  
Electrical Field ◽  
Rectangular Shape ◽  
Overall Performance ◽  
Pulsed Electrical Field

The paper introduces a new design of Marx generator based on modular stages using Silicon Carbide MOSFETs (SiC-MOSFET) aimed to be used in biomedical applications. In this process, living cells are treated with intense nanosecond Pulsed Electrical Field (nsPEF). The electric field dose should be controlled by adjusting the pulse parameters such as amplitude, repetition rate and pulse-width. For this purpose, the structure of the proposed generator enables negative pulses with a quasi-rectangular shape, controllable amplitude, pulse-width and repetition-rate. A complete simulation study was conducted in ANSYS-Simplorer to verify the overall performance. A compact, modular prototype of Marx generator was designed with 1.7 kV rated SiC-MOSFETs and, finally, a set of experiments confirmed all expected features.

scholarly journals Preparation of Fe3O4-Ag Nanocomposites with Silver Petals for SERS Application

Nanomaterials ◽  
2021 ◽  
Vol 11 (5) ◽  
pp. 1288
Author(s):  
Thi Thuy Nguyen ◽  
Fayna Mammeri ◽  
Souad Ammar ◽  
Thi Bich Ngoc Nguyen ◽  
Trong Nghia Nguyen ◽  
...  
Keyword(s):  
Self Assembly ◽  
Hot Spots ◽  
Surface Enhanced Raman Spectroscopy ◽  
Electrical Field ◽  
Stabilizing Agents ◽  
Surface Enhanced ◽  
Surface Enhanced Raman ◽  
Sers Sensing ◽  
Applied Electrical Field ◽  
Positively Charged

The formation of silver nanopetal-Fe3O4 poly-nanocrystals assemblies and the use of the resulting hetero-nanostructures as active substrates for Surface Enhanced Raman Spectroscopy (SERS) application are here reported. In practice, about 180 nm sized polyol-made Fe3O4 spheres, constituted by 10 nm sized crystals, were functionalized by (3-aminopropyl)triethoxysilane (APTES) to become positively charged, which can then electrostatically interact with negatively charged silver seeds. Silver petals were formed by seed-mediated growth in presence of Ag+ cations and self-assembly, using L-ascorbic acid (L-AA) and polyvinyl pyrrolidone (PVP) as mid-reducing and stabilizing agents, respectively. The resulting plasmonic structure provides a rough surface with plenty of hot spots able to locally enhance significantly any applied electrical field. Additionally, they exhibited a high enough saturation magnetization with Ms = 9.7 emu g−1 to be reversibly collected by an external magnetic field, which shortened the detection time. The plasmonic property makes the engineered Fe3O4-Ag architectures particularly valuable for magnetically assisted ultra-sensitive SERS sensing. This was unambiguously established through the successful detection, in water, of traces, (down to 10−10 M) of Rhodamine 6G (R6G), at room temperature.

Sign in / Sign up

Export Citation Format

Share Document