The main motivation of this work is to design, fabricate, test, and compare an alternative, robust packaging approach for a power semiconductor current switch. Packaging a high voltage power semiconductor current switch into a single power module, compared to using separate power modules, offers cost, performance, and reliability advantages. With the advent of Wide-Bandgap (WBG) semiconductors, such as Silicon-Carbide, singular power electronic devices, where a device is denoted as a single transistor or rectifier unit on a chip, can now operate beyond 10kV–15kV levels and switch at frequencies within the kHz range. The improved voltage blocking capability reduces the number of series connected devices within the circuit, but challenges power module designers to create packages capable of managing the electrical, mechanical, and thermal stresses produced during operation. The non-sinusoidal nature of this stress punctuated with extremely fast changes in voltage and current, with respect to time, leads to non-ideal electrical and thermal performance. An optimized power semiconductor series current switch is fabricated using an IGBT (6500V/25A die) and SiC JBS Diode (6000V/10A), packaged into a 3D printed housing, to create a composite series current switch package (CSCSP). The final chosen device configuration was simulated and verified in an ANSYS software package. Also, the thermal behavior of such a composite package was simulated and verified using COMSOL. The simulated results were then compared with empirically obtained data, in order to ensure that the thermal ratings of the power devices were not exceeded; directly affecting the maximum attainable frequency of operation for the CSCSP. Both power semiconductor series current switch designs are tested and characterized under hard switching conditions. Special attention is given to ensure the voltage stress across the devices is significantly reduced.
A High Voltage Gain Step-up Resonant DC-DC Converter Topology with Reduced Switch Count
