HIGH FREQUENCY CIRCUITS BASED ON GaAs PHEMT TECHNOLOGY FOR MODERN SENSOR AND COMMUNICATION SYSTEMS

2000 ◽  
Vol 10 (01) ◽  
pp. 393-411 ◽  
Author(s):  
M. SCHLECHTWEG
Keyword(s):  
Integrated Circuits ◽  
Communication Systems ◽  
High Speed ◽  
Coplanar Waveguide ◽  
High Gain ◽  
Low Noise ◽  
Phase Shifters ◽  
60 Ghz ◽  
Sensor Applications ◽  
High Speed Data

For sensor and communication system applications, monolithic microwave integrated circuits (MMICs) feature performance, functionality, reliability, and competitive price. In this paper, the potential of PHEMT ICs for communication and sensor applications up to 100 GHz is discussed. Specifically, I will address the application of coplanar waveguide technology for rf ICs, millimeter-wave multifunctional ICs and power amplifiers, as well as mixed-signal ICs and OEICs. A 77-GHz transceiver MMIC designed for automotive collision avoidance radar is presented as an example of a very compact, multifunctional mm-wave chip. A chip set for active and passive imaging at 94 GHz includes low noise and high gain amplifiers, low phase noise oscillators, and phase shifters. An FMCW module is conceived for material characterization. A family of coplanar power amplifier MMICs for wireless communication in the range of 20 to 60 GHz with output powers up to 1 W is presented. Finally, integrated circuits for high-speed data transmission at 40 Gbit/s will be discussed.

Hardware efficient receiver for low-cost ultra-high rate 60 GHz wireless communications

2011 ◽  
Vol 3 (2) ◽  
pp. 121-129 ◽  
Author(s):  
Ahmet Çağrı Ulusoy ◽  
Gang Liu ◽  
Andreas Trasser ◽  
Hermann Schumacher
Keyword(s):  
Communication Systems ◽  
High Speed ◽  
Low Cost ◽  
Intermediate Frequency ◽  
Low Noise ◽  
High Rate ◽  
Low Noise Amplifiers ◽  
Range Data ◽  
60 Ghz ◽  
5 Ghz

This paper presents a hardware efficient receiver architecture, to be used in low-cost, ultra-high rate 60 GHz wireless communication systems. The receiver utilizes a simple, feed-forward carrier recovery concept, performing phase and frequency synchronization in the analog domain. This enables 1-bit baseband processing without a need of ultra-high speed and high precision analog-to-digital conversion, offering a strong simplification of the system architecture and comparatively low power consumption. In a first prototype implementation, the receiver is realized in a low-cost SiGe technology as two separate ICs: the 60 GHz/5 GHz downconverter, and the intermediate frequency synchronous demodulator. The simple synchronous reception concept is experimentally validated for up to 3.5 Gbit/s data rate, which constituted the limit of the existing experimental setup. Furthermore, the downconverter demonstrates that low-cost technologies (fop/fmax ~ 0.75) can be used to realize short-range data links at 60 GHz, with low-noise amplifiers in a more performant technology as needed.

scholarly journals A 60 GHz fully differential LNA in 90 nm CMOS technology

2013 ◽  
Vol 6 (2) ◽  
pp. 109-113 ◽  
Author(s):  
Andrea Malignaggi ◽  
Amin Hamidian ◽  
Georg Boeck
Keyword(s):  
Power Consumption ◽  
Low Power ◽  
Transmission Lines ◽  
Noise Figure ◽  
Design Procedure ◽  
Cmos Technology ◽  
High Gain ◽  
Low Noise ◽  
60 Ghz ◽  
Fully Differential

The present paper presents a fully differential 60 GHz four stages low-noise amplifier for wireless applications. The amplifier has been optimized for low-noise, high-gain, and low-power consumption, and implemented in a 90 nm low-power CMOS technology. Matching and common-mode rejection networks have been realized using shielded coplanar transmission lines. The amplifier achieves a peak small-signal gain of 21.3 dB and an average noise figure of 5.4 dB along with power consumption of 30 mW and occupying only 0.38 mm2pads included. The detailed design procedure and the achieved measurement results are presented in this work.

scholarly journals Fuzzy Based Network Assignment and Link-Switching Analysis in Hybrid OCC/LiFi System

2018 ◽  
Vol 2018 ◽  
pp. 1-15 ◽  
Author(s):  
Moh. Khalid Hasan ◽  
Mostafa Zaman Chowdhury ◽  
Md. Shahjalal ◽  
Yeong Min Jang
Keyword(s):  
Hybrid System ◽  
Communication Systems ◽  
High Speed ◽  
Light Emitting Diode ◽  
Flow Analysis ◽  
Optical Wireless Communications ◽  
Light Emitting ◽  
High Speed Data ◽  
Transmission Capability ◽  
Time Division

In recent times, optical wireless communications (OWC) have become attractive research interest in mobile communication for its inexpensiveness and high-speed data transmission capability and it is already recognized as complementary to radio-frequency (RF) based technologies. Light fidelity (LiFi) and optical camera communication (OCC) are two promising OWC technologies that use a photo detector (PD) and a camera, respectively, to receive optical pulses. These communication systems can be implemented in all kinds of environments using existing light-emitting diode (LED) infrastructures to transmit data. However, both networking layers suffer from several limitations. An excellent solution to overcoming these limitations is the integration of OCC and LiFi. In this paper, we propose a hybrid OCC and LiFi architecture to improve the quality-of-service (QoS) of users. A network assignment mechanism is developed for the hybrid system. A dynamic link-switching technique for efficient handover management between networks is proposed afterward which includes switching provisioning based on user mobility and detailed network switching flow analysis. Fuzzy logic (FL) is used to develop the proposed mechanisms. A time-division multiple access (TDMA) based approach, called round-robin scheduling (RRS), is also adopted to ensure fairness in time resource allocation while serving multiple users using the same LED in the hybrid system. Furthermore, simulation results are presented taking different practical application scenarios into consideration. The performance analysis of the network assignment mechanism, which is provided at the end of the paper, demonstrates the importance and feasibility of the proposed scheme.

Train-mounted Broadband Monopole Antenna for 5G Communication

2021 ◽  
Vol 36 (7) ◽  
pp. 879-884
Author(s):  
Hao Li ◽  
Lu Xu ◽  
Feng Qian ◽  
Yong Zhou
Keyword(s):  
Mobile Communication ◽  
Communication Systems ◽  
High Speed ◽  
High Gain ◽  
Monopole Antenna ◽  
Mobile Terminals ◽  
High Speed Railway ◽  
Public Transport System ◽  
Fifth Generation ◽  
5G Mobile Communication

As a convenient and efficient public transport system, high speed railway (HSR) was rapidly deployed in China. Since the fifth generation (5G) mobile communication system is commercially applied, it is necessary for mobile terminals antennas to cover multiple operating bands to be compatible with various communication systems. Here a HSR-mounted broadband and high-gain monopole antenna is proposed. By using the meander technology and introducing the tapered structure, the proposed antenna operates over a bandwidth of 694-960 MHz and 1350-5975 MHz (VSWR<1.8), which covers both 2G-5G mobile communication and WiFi frequency bands. The dimensions of the proposed antenna are 400 mm × 330 mm × 78 mm. The measured average gain is 6.11 dBi over the entire bandwidth.

scholarly journals RF-MEMS Monolithic K and Ka Band Multi-State Phase Shifters as Building Blocks for 5G and Internet of Things (IoT) Applications

Sensors ◽  
2020 ◽  
Vol 20 (9) ◽  
pp. 2612 ◽  
Author(s):  
Jacopo Iannacci ◽  
Giuseppe Resta ◽  
Alvise Bagolini ◽  
Flavio Giacomozzi ◽  
Elena Bochkova ◽  
...  
Keyword(s):  
Internet Of Things ◽  
Communication Systems ◽  
High Speed ◽  
Phase Shifter ◽  
Satellite Communication ◽  
Rf Mems ◽  
Building Blocks ◽  
Phase Shifters ◽  
Small Cells ◽  
Mems Technology

RF-MEMS, i.e., Micro-Electro-Mechanical Systems (MEMS) for Radio Frequency (RF) passive components, exhibit interesting characteristics for the upcoming 5G and Internet of Things (IoT) scenarios, in which reconfigurable broadband and frequency-agile devices, like high-order switching units, tunable filters, multi-state attenuators, and phase shifters will be necessary to enable mm-Wave services, small cells, and advanced beamforming. In particular, satellite communication systems providing high-speed Internet connectivity utilize the K and Ka bands, which offer larger bandwidth compared to lower frequencies. This paper focuses on two design concepts of multi-state phase shifter designed and manufactured in RF-MEMS technology. The networks feature 4 switchable stages (16 states) and are developed for the K and Ka bands. The proposed phase shifters are realized in a surface micromachining RF-MEMS technology and the experimentally measured parameters are compared with Finite Element Method (FEM) multi-physical electromechanical and RF simulations. The simulated phase shifts at both the operating bands fit well the measured value, despite the measured losses (S21) are larger than 5–7 dB if compared to simulations. However, such a non-ideality has a technological motivation that is explained in the paper and that will be fixed in the manufacturing of future devices.

scholarly journals A Novel High Gain Monopole Antenna Array for 60 GHz Millimeter-Wave Communications

2020 ◽  
Vol 10 (13) ◽  
pp. 4546
Author(s):  
Tarek S. Mneesy ◽  
Radwa K. Hamad ◽  
Amira I. Zaki ◽  
Wael A. E. Ali
Keyword(s):  
Antenna Array ◽  
Communication Systems ◽  
Ground Plane ◽  
High Gain ◽  
Monopole Antenna ◽  
Impedance Bandwidth ◽  
Single Element ◽  
60 Ghz ◽  
Defected Ground Structure ◽  
Element Array

This paper presented the design and implementation of a 60 GHz single element monopole antenna as well as a two-element array made of two 60 GHz monopole antennas. The proposed antenna array was used for 5G applications with radiation characteristics that conformed to the requirements of wireless communication systems. The proposed single element was designed and optimized to work at 60 GHz with a bandwidth of 6.6 GHz (57.2–63.8 GHz) and a maximum gain of 11.6 dB. The design was optimized by double T-shaped structures that were added in the rectangular slots, as well as two external stubs in order to achieve a highly directed radiation pattern. Moreover, ring and circular slots were made in the partial ground plane at an optimized distance as a defected ground structure (DGS) to improve the impedance bandwidth in the desired band. The two-element array was fed by a feed network, thus improving both the impedance bandwidth and gain. The single element and array were fabricated, and the measured and simulated results mimicked each other in both return loss and antenna gain.

High-gain, low-noise monolithic HEMT distributed amplifiers up to 60 GHz

1990 ◽  
Vol 38 (12) ◽  
pp. 2016-2017 ◽  
Author(s):  
C. Yuen ◽  
C. Nishimoto ◽  
Y.C. Pao ◽  
M. Day ◽  
S. Bandy ◽  
...  
Keyword(s):  
High Gain ◽  
Low Noise ◽  
60 Ghz ◽  
Distributed Amplifiers

Bipolar device technology challenge and opportunity

1985 ◽  
Vol 63 (6) ◽  
pp. 683-692 ◽  
Author(s):  
H. D. Barber
Keyword(s):  
Integrated Circuits ◽  
High Speed ◽  
Low Cost ◽  
Chemical Vapor ◽  
Low Noise ◽  
Isolation Techniques ◽  
Propagation Delays ◽  
Technological Barriers ◽  
On Chip ◽  
Bipolar Device

Silicon bipolar device technologies provided 65% of the world's integrated circuits in 1983. Where low noise, high current, low or high voltage, high speed or low cost are required, bipolar technologies are used. This paper will review the present status of bipolar device technologies, which make possible 100-ps gate-propagation delays, 150-μm2 gate areas, 1-GHz bandwidth amplifiers, on-chip control of over 1-A, 350-V operation, 14-GHz fT's and 10-ns. analogue-to-8-bit digital conversion. These devices are realized because of advances in isolation techniques, chemical-vapor deposition, photolithography, diffusion, ion implantation, conductor–contact interconnection technology, etching processes, and materials preparation. This paper will discuss some of the fundamental problems, modelling difficulties, and technological barriers that will impact the future development of bipolar integrated circuits.

Sign in / Sign up

Export Citation Format

Share Document