Response Modification Factors for Earthquake Resistant Design of Short Period Buildings

1989 ◽  
Vol 5 (3) ◽  
pp. 571-590 ◽  
Author(s):  
Rafael Riddell ◽  
Pedro Hidalgo ◽  
E. Cruz
Keyword(s):  
Response Spectra ◽  
Elastic Response ◽  
Period Range ◽  
Response Modification Factor ◽  
Seismic Codes ◽  
Design Spectrum ◽  
Linear Elastic ◽  
Elastic Response Spectra ◽  
Short Period ◽  
Earthquake Resistant

Most recent seismic codes include response modification factors in the definition of the equivalent lateral forces that are used for the design of earthquake resistant buildings. The response modification factors (R) are used to reduce the linear elastic design spectrum to account for the energy dissipation capacity of the structure. The evaluation of these response modification factors for various sets of earthquake records and ductility factors is presented herein. Special attention is given to the short period range where the reduction of linear elastic response spectra is smaller than the values for intermediate and long period structures. An idealized and simple variation of the response modification factor as a function of the period of vibration, suitable for seismic codes formulation, is also presented.

Response Modification Factor for Y-Eccentric-Braced Steel Frame Structures Designed Based on Chinese Code

2014 ◽  
Vol 580-583 ◽  
pp. 1449-1457
Author(s):  
Wen Xia Yang ◽  
Qiang Gu ◽  
Ping Zhou Cao ◽  
Rong Jin Shi
Keyword(s):  
Pushover Analysis ◽  
Design Procedure ◽  
Response Spectra ◽  
Elastic Response ◽  
Base Shear ◽  
Response Modification Factor ◽  
Linear Elastic ◽  
Elastic Response Spectra ◽  
Modification Factor ◽  
Steel Frame Structures

In current seismic design procedure, structure base shear is calculated according to the linear elastic response spectra divided by the response modification factor, which accounts for ductility and overstrength of a structural system. In this paper, the response modification factors of Y-eccentric braced steel frames (YECBF) designed based on Chinese Code were evaluated by an improved pushover analysis on 12 examples with various stories and spans lengths. According to the analysis results, the effects of fundamental periods, storey numbers, and spans of frames on the behavior factor were studied. In the end, an appropriate response modification factor was proposed for YECBF designed base on Chinese Code.

NGA Ground Motion Model for the Geometric Mean Horizontal Component of PGA, PGV, PGD and 5% Damped Linear Elastic Response Spectra for Periods Ranging from 0.01 to 10 s

2008 ◽  
Vol 24 (1) ◽  
pp. 139-171 ◽  
Author(s):  
Kenneth W. Campbell ◽  
Yousef Bozorgnia
Keyword(s):  
Standard Deviation ◽  
Ground Motion ◽  
Geometric Mean ◽  
Response Spectra ◽  
Horizontal Component ◽  
Elastic Response ◽  
Motion Model ◽  
Linear Elastic ◽  
Ground Motion Model ◽  
Elastic Response Spectra

We present a new empirical ground motion model for PGA, PGV, PGD and 5% damped linear elastic response spectra for periods ranging from 0.01–10 s. The model was developed as part of the PEER Next Generation Attenuation (NGA) project. We used a subset of the PEER NGA database for which we excluded recordings and earthquakes that were believed to be inappropriate for estimating free-field ground motions from shallow earthquake mainshocks in active tectonic regimes. We developed relations for both the median and standard deviation of the geometric mean horizontal component of ground motion that we consider to be valid for magnitudes ranging from 4.0 up to 7.5–8.5 (depending on fault mechanism) and distances ranging from 0–200 km. The model explicitly includes the effects of magnitude saturation, magnitude-dependent attenuation, style of faulting, rupture depth, hanging-wall geometry, linear and nonlinear site response, 3-D basin response, and inter-event and intra-event variability. Soil nonlinearity causes the intra-event standard deviation to depend on the amplitude of PGA on reference rock rather than on magnitude, which leads to a decrease in aleatory uncertainty at high levels of ground shaking for sites located on soil.

Seismic Hazard Mapping for Italy in Terms of Broadband Displacement Response Spectra

2009 ◽  
Vol 25 (3) ◽  
pp. 515-539 ◽  
Author(s):  
Ezio Faccioli ◽  
Manuela Villani
Keyword(s):  
Seismic Hazard ◽  
Response Spectra ◽  
Elastic Response ◽  
Elastic Displacement ◽  
Hazard Mapping ◽  
Ground Acceleration ◽  
Vibration Period ◽  
Displacement Spectra ◽  
Elastic Response Spectra ◽  
Short Period

A new representation of seismic hazard is proposed for Italy based on displacement elastic response spectra in a vibration period range that extends from [Formula: see text]. This relies on an available seismotectonic zonation and earthquake catalogue, but makes use of a set of very recent, expressly developed attenuation relations. The long period picture of ground motion hazard is illustrated vis-à-vis the conventional one based on ground acceleration, and the feasibility of simple approximations of the displacement spectra, useful for design purposes, is shown. We give some foresight on the differences to be expected in hazard maps resulting from the use of a predominantly fault-based seismic source model, as opposed to the more conventional model that includes only spatially extended zones. Finally, we highlight the different hazard exposure of different regions depending on whether we represent hazard with a long or a short period parameter and we discuss the adequacy of recent code provisions regarding elastic displacement spectra.

The Vertical and Horizontal Spectra of Near-Fault Ground Motions

2012 ◽  
Vol 204-208 ◽  
pp. 3335-3339
Author(s):  
Jiang Yin ◽  
Xian Yan Zhou ◽  
Guo Jing He
Keyword(s):  
Ground Motions ◽  
Response Spectra ◽  
Vertical Acceleration ◽  
Period Range ◽  
Seismic Reliability ◽  
Design Spectrum ◽  
Near Fault ◽  
Seismic Design Code ◽  
Short Period ◽  
Near Fault Earthquakes

Based on the horizontal and vertical components of a set of 30 acceleration records obtained from 10 near-fault earthquakes, the horizontal and the vertical response spectra are established, and have been compared with each other in this study. Statistical analyses show that, for the selected 30 acceleration records, the maximum mean of vertical acceleration spectra is slightly higher than which of horizontal acceleration spectra. That means the near-fault earthquake really have significant vertical effect. Consulting the domestic and international research achievement, the normalized near-fault design spectrum adapted to Chinese seismic design Code (GB50011-2010) is established in horizontal direction. The results show that, within short period range, the horizontal near-fault design spectrum obtained in this paper is obviously higher than which derived from Chinese seismic code. Subsequently, the spectra of horizontal components for the selected 30 records are each scaled to match the horizontal near-fault design spectrum at two periodic points of 1.0 and 1.5 sec respectively, and the corresponding vertical spectra are scaled with the horizontal spectra at the same time. The scaled results reveal that the vertical spectra have much higher discretion than horizontal spectra, hence the study in this paper could initiates the research interest to a new aspect concerned with the randomness of vertical spectra for near-fault ground motions, which would affect the seismic reliability of structures significantly.

Response Modification Factor for Y-Eccentric-Braced Steel Frame Structures

2011 ◽  
Vol 250-253 ◽  
pp. 2285-2290
Author(s):  
Wen Xia Yang ◽  
Qiang Gu ◽  
Zhen Sen Song
Keyword(s):  
Seismic Design ◽  
Pushover Analysis ◽  
Steel Frames ◽  
Design Procedure ◽  
Response Spectra ◽  
Elastic Response ◽  
Base Shear ◽  
Response Modification Factor ◽  
Elastic Response Spectra ◽  
Modification Factor

In current seismic design procedure, structural base shear is calculated according to the linear elastic response spectra divided by response modification factorR. The response modification factor is important to the reliability and economy of building seismic design. In this paper, the response modification factors of Twelve Y-eccentric braced steel frames with various stories and spans lengths were evaluated by capacity spectrum method based on the global capacity envelops obtained from an improved pushover analysis and incremental dynamic analysis. According to the results, an appropriate formula of the response modification factor for the Y-eccentric braced steel frames was suggested.

scholarly journals Control Spectra for Quito

2016 ◽  
Author(s):  
Roberto Aguiar ◽  
Alicia Rivas-Medina ◽  
Pablo Caiza ◽  
Diego Quizanga
Keyword(s):  
Urban Areas ◽  
Slip Rate ◽  
Response Spectra ◽  
Elastic Response ◽  
Minimum Size ◽  
Physical Parameters ◽  
North Central ◽  
South Central ◽  
Elastic Response Spectra ◽  
Maximum Minimum

Abstract. The Metropolitan District of Quito is divided into five areas: south, south-central, central, north-central and north. It is located on or very close to segments of reverse blind faults: Puengasí, Ilumbisí-La Bota, Carcelen-El Inca, Bellavista-Catequilla and Tangahuilla as indicated in Alvarado et al. (2014), making it one of the most seismically dangerous cities in the world. For each of the urban areas of Quito, elastic response spectra are presented in this paper, which are found using some of the new models of the PEER's NGA-West2 Program, models developed by: Abrahamson et al. (2013), Campbell and Borzognia (2013), and Chiou and Youngs (2013). These spectra are calculated considering the maximum amount that could be generated by the rupture of each fault segments, and taking into account the soil type that exists in each zone according to the Norma Ecuatoriana de la Construcción 2015 (NEC-15). Subsequently, the recurrence period of earthquakes of high magnitude in each fault segment is determined from the physical parameters of the fault segments (size of the fault plane and slip rate), and considering that the fault can break in earthquakes of magnitude less than the expected maximum (minimum size 5.0 Mw). For this, the pattern of recurrence of type GR earthquakes (Gutenberg and Richter, 1944) with double truncation magnitude (Mmin and Mmax) proposed by Cosentino et al. (1977) is used.

Seismic Analysis of High Pier Three-Span Continuous Bridge

2015 ◽  
Vol 744-746 ◽  
pp. 890-893
Author(s):  
Xun Wu ◽  
Yong Lan Zhang
Keyword(s):  
Seismic Analysis ◽  
Linear Time ◽  
Time History ◽  
Response Spectra ◽  
Elastic Response ◽  
Modeling And Analysis ◽  
Continuous Beam Bridge ◽  
Comparison Results ◽  
Elastic Response Spectra ◽  
Nonlinear Time History

In this paper, SAP2000 and ANSYS software are used to modeling and analysis athree-span continuous beam bridge with high piers case study.By using differentbearing types and combinations to form different options, create two finiteelement models.Analysis dynamic characteristics ,elastic response spectra,linear time history and nonlinear time history .And focus on comparing dynamiccharacteristics of the earthquake response of the two programs .Running outputdata processing and comparison results show that the application of thedifferent parameters of the rational combination of rubber bearing basin bridgearrangement has better seismic performance.

Strong motion accelerograph records from the 1993 Napierville earthquake

1995 ◽  
Vol 22 (1) ◽  
pp. 190-196
Author(s):  
René Tinawi ◽  
André Filiatrault ◽  
Pierre Léger
Keyword(s):  
Ground Motion ◽  
Energy Content ◽  
Strong Motion ◽  
Response Spectra ◽  
High Energy ◽  
Period Range ◽  
Attenuation Relationships ◽  
Acceleration Time Histories ◽  
Short Period ◽  
Time Histories

An earthquake of magnitude ML = 4.3 occurred near Napierville, Quebec, on November 16, 1993. An accelerograph at the liquefaction, storage, and regasification plant of Gaz Metropolitain in Montreal, about 55 km from the epicentre, recorded the ground motion. Although the maximum accelerations and velocities from this event are small, the acceleration time histories do confirm the high energy content in the very short period range. The recorded ground motion and corresponding absolute acceleration response spectra are presented and various attenuation relationships, proposed for eastern North America, are utilized to compare the measured and predicted ground motion parameters. Key words: Napierville earthquake, attenuation relationships, acceleration spectra, strong motion records.

The Damage Potential of Eastern North American Earthquakes

1993 ◽  
Vol 64 (2) ◽  
pp. 119-137 ◽  
Author(s):  
Glenn L. Greig ◽  
Gail M. Atkinson
Keyword(s):  
North American ◽  
High Frequency ◽  
High Stress ◽  
Response Spectra ◽  
Elastic Response ◽  
Damage Potential ◽  
Elastic Response Spectra ◽  
Attenuation Models ◽  
Ground Motion Records ◽  
Stress Drops

Abstract We compare the damage potential of three recent eastern North American (ENA) earthquakes (Nahanni, 1985; Saguenay, 1988; and Mont Laurier, 1990) to that of the 1989 Loma Prieta, California earthquake. The Saguenay and Mont Laurier events were noteworthy due to their unusually high stress drops. The comparisons are based on synthetic ground motion records generated by the stochastic method, using source and attenuation models that were derived from actual records for each event. Damage potential is characterized by inelastic strength demand spectra, obtained by analyzing the response of nonlinear oscillators to each record. There is a strong similarity between the inelastic spectra and the more familiar elastic response spectra, although some significant differences are observed. Comparisons between events show that a moderate high-stress ENA earthquake, like Saguenay, can be as damaging to high-frequency structures as a major California earthquake.

Sign in / Sign up

Export Citation Format

Share Document