The Waterproofing Mechanism of Arthropods

1959 ◽  
Vol 36 (2) ◽  
pp. 391-422 ◽  
Author(s):  
J. W. L. BEAMENT

1. The relationship between the temperature of the cuticle and its permeability to water has been determined for a number of different terrestrial arthropods 2. In most of these animals the waterproofing wax loses its great impermeability to water very abruptly at a particular transition temperature; that temperature varies appreciably with the individual, but appears to be characteristic of any one species at a particular age within a particular instar. No change in permeability with temperature was found in Tipula sp. taken from soil, in which the cuticle was greatly damaged; above 48° C. the permeability of the cuticle of Schistocerca nymphs changes rapidly with increasing temperature, but this change is not abrupt. 3. In the permeability/temperature curves for larvae of Pieris, Tenebrio, Calliphora and Nematus, pupae of Calliphora and adults of Schistocerca, Ixodes and Ornithodorus only one transition discontinuity is found. In all these animals the wax maintains almost constant permeability up to the point of transition, above which permeability increases very rapidly with temperature. 4. Immediately after moulting, Rhodnius nymphs and pupae of Tenebrio and Pieris also reveal only one transition point; this occurs at a comparatively low temperature. But when cement is secreted over the primary wax layer, a second and higher transition point is found which is independent of the first point. The lower transition temperature seems constant in position during the life of an instar, but the upper point occurs at progressively higher temperatures as the instar ages. The evidence suggests that these animals have two special waterproof layers of wax, the one with high transition temperature occurring on the outer surface of the cement. This outer layer could arise by the migration of wax from the primary layer (with lower transition temperature) through the cement to the outer surface, there to lose volatile components and waterproof the surface. 5. In every animal investigated a permanent increase in permeability is produced by heating a wax layer above its transition point; after such treatment no transition point can be found. 6. From calculations of the absolute permeability of the various wax layers, and from the behaviour of the wax, it is suggested that all epicuticular waxes are laid down with some special molecular arrangement and that in very waterproof insects this may extend throughout the thickness of the wax layers; in less waterproof insects only a portion of the wax layer (as in the cockroach) may be specially organized. 7. Very slight mechanical damage promotes increased transpiration through the cuticle. Stationary adsorptive dusts applied directly to a primary wax layer do not affect permeability; applied to wax above the cement, they promote rates of evaporation in excess of the value exhibited by the same cuticle having a primary wax layer alone. This phenomenon is discussed in relation to the distribution of water within the transpiring cuticle.

2012 ◽  
Vol 27 (09) ◽  
pp. 1250050 ◽  
Author(s):  
V. G. BORNYAKOV ◽  
V. K. MITRJUSHKIN

Landau gauge gluon propagators are studied numerically in the SU (3) gluodynamics as well as in the full QCD with the number of flavors nF = 2 using efficient gauge fixing technique. We compare these propagators at temperatures very close to the transition point in two phases: confinement and deconfinement. The electric mass mE has been determined from the momentum space longitudinal gluon propagator. Gribov copy effects are found to be rather strong in the gluodynamics, while in the full QCD case they are weak ("Gribov noise"). Also we analyze finite volume dependence of the transverse and longitudinal propagators.


1974 ◽  
Vol 29 (3) ◽  
pp. 445-451 ◽  
Author(s):  
W. Kessel

A method of solution of the Eliashberg equations in the theory of superconductivity is derived which uses the fact that near the transition point the energy gap is small compared to the energies over which the electron-phonon properties vary appreciably. On this basis the Eliashberg equations are converted into linear inhomogeneous integral equations. Their solution is given in operator form and provides a general formula for the transition temperature


Symmetry ◽  
2020 ◽  
Vol 12 (8) ◽  
pp. 1271
Author(s):  
Jiri Neustupa ◽  
Yvonne Nemcova

Calcifying marine green algae of genus Halimeda have siphonous thalli composed of repeated segments. Their outer surface is formed by laterally appressed peripheral utricles which often form a honeycomb structure, typically with varying degrees of asymmetry in the individual polygons. This study is focused on a morphometric analysis of the size and symmetry of these polygons in Mediterranean H. tuna. Asymmetry of surface utricles is studied using a continuous symmetry measure quantifying the deviation of polygons from perfect symmetry. In addition, the segment shapes are also captured by geometric morphometrics and compared to the utricle parameters. The area of surface utricles is proved to be strongly related to their position on segments, where utricles near the segment bases are considerably smaller than those located near the apical and lateral margins. Interestingly, this gradient is most pronounced in relatively large reniform segments. The polygons are most symmetric in the central parts of segments, with asymmetry uniformly increasing towards the segment margins. Mean utricle asymmetry is found to be unrelated to segment shapes. Systematic differences in utricle size across different positions might be related to morphogenetic patterns of segment development, and may also indicate possible small-scale variations in CaCO3 content within segments.


1977 ◽  
Vol 32 (7-8) ◽  
pp. 597-599 ◽  
Author(s):  
Alfons Radunz

Abstract The number of antibody molecules which stroma-freed chloroplasts can bind out of the mono-specific antisera to monogalactosyl diglyceride, tri-and digalactosyl diglyceride, sulfoquinovosyl diglyceride, phosphatidyl glycerol, sitosterol, plastoquinone, lutein and neoxanthin was determined. This number was compared to the number of antibody molecules which stroma-freed chloroplasts can maximally bind. The result is that the antibodies to the individual lipids cover at most 17 per cent of the accessible thylakoid membrane surface. From a serum which contains both antibodies to the proteins and lipids of the thylakoid membrane, not more antibody molecules are bound than from a serum to the proteins. This means that antibodies to proteins are able to cover up the entire accessible surface of the thylakoids whereas a mixture of antibodies to the lipids, listed above, cover only one forth of the surface. Consequently, antibodies which are bound to proteins can cover up the lipid areas entirely and in turn antibodies which are bound to lipids cover up parts of the protein areas. From this it follows that the portion of the surface, which is made up by lipids must be considerably smaller than 24 per cent. Furthermore, it follows from these experiments that the lipid areas are small and that lipids probably only fill up the gaps between the protein molecules.


1988 ◽  
Vol 43 (3) ◽  
pp. 233-238 ◽  
Author(s):  
Ataru Kobayashi ◽  
Yoshichika Yoshioka ◽  
Nobuo Nakamura ◽  
Hideaki Chihara

(NH4)2SbF5 undergoes two successive phase transitions at 169 and 292 K, both of which are of typical lambda-type and without thermal hysteresis. Proton and fluorine spin-lattice relaxation time measurements showed that the isotropic reorientation of the NH4+ ions is highly excited below the lower transition point with an activation energy of 15.5 kJ mol-1 and that the uniaxial reorientation of the square pyramidal SbF52- anion is excited above about 200 K with an activation energy of 42.0 kJ mol-1. There is strong cross relaxation between the proton and the fluorine over the whole temperature range of the measurements. The 121Sb and 123Sb nuclear quadrupole resonance frequencies show an anomalous temperature dependence; each resonance frequency assumes a minimum at around 100 K and increases on heating, reaches a maximum at the lower transition point, decreases drastically in the middle temperature phase and then fades out just below the upper transition point. The anomalous increase in the resonance frequencies stems from the reorganization of the N - H ... F type hydrogen bonds with the progress of the lower phase transition. The lower and the upper transition temperatures shift to 173.0 and 290.1 K, respectively, on deuteration of the ammonium ion.


1986 ◽  
Vol 41 (1-2) ◽  
pp. 290-293
Author(s):  
Mariusz Maćkowiak ◽  
Maria Zdanowska-Fra̧zek ◽  
Piotr Kozioł ◽  
Jan Stankowski ◽  
Alarich Weiss

The 127I NQR frequency in anilinium iodide C6H5NH3⊕I⊖ was studied at pressures up to 300 MPa and within the temperature range 77 K - 290 K. With increasing pressure the order-disorder transition point Tc is shifted to higher temperatures. The pressure coefficient of the phase transition temperature amounts to dTc/dp = 4.2 x 10-2 deg MPa-1. The pressure coefficient of the NQR frequency is negative. In addition, the 12'I nuclear quadrupole coupling constants and the respective asymmetry parameters η were evaluated as a function of pressure. The results confirm the close connection between the mechanism of the phase transition and the dynamics of the N - H⊕ ...I⊖ hydrogen bonds.


1995 ◽  
Vol 09 (07) ◽  
pp. 737-749 ◽  
Author(s):  
KEN SEKIMOTO

We briefly review the recent theoretical understanding of the first order phase transition undergone by gels with an emphasis on physical concepts, deliberately excluding details of modeling and analytic methods. The density of a gel changes discontinuously at the transition point. A variety of features of the transition result from the basic fact that the inhomogeneity of the density of the gel inevitably causes shear deformation. This deformation, on the one hand, reflects the geometry of the sample and, on the other hand, may alter the transition temperature.


2007 ◽  
Vol 345-346 ◽  
pp. 485-488
Author(s):  
Seong Min Lee

Semiconductor devices are usually formed on a single silicon wafer during a batch processing method. Individual devices are separated from the wafer during the wafer sawing or dicing step. Subsequent packaging processes are then performed on the individual devices, whose edge portions are very susceptible to mechanical damage from the sawing process. Defects formed along device edges due to the dicing saw blade often provide potential sites for serious reliability problems. If the scribing area is reduced, the number of the separated devices from a single wafer increases, which results in productivity improvement. However, the closer the scribing position of the saw blade comes to the active device pattern, the greater possibility of sawing-induced damage to the active pattern is. Thus, this work shows methods to reduce the negative impact of the saw blade while maintaining close proximity of the scribe lines to the IC devices. In particular, this work suggests that a decrease in the size of the diamond particles embedded in the saw blade and in the rotation speed of the saw blade might contribute to the prevention of sawing-induced damage to device patterns.


1978 ◽  
Vol 34 (6) ◽  
pp. 965-968 ◽  
Author(s):  
S. Haussühl

The low-temperature form of Rb2Hg(CN)4 [space group R\bar 3c, Z = 12, a 1 = 9.076, a 3 = 46.050 Å (273 K)] possesses a slightly distorted spinel structure with parameters similar to those of cubic cyanospinels. It transforms into a cubic spinel modification at ca 398 K (a = 13.140 Å at 399 K). Below the transition temperature the crystals exhibit ferroelastic properties, which allow the switching of the distortion directions into any one of four equivalent states. The critical stress is less than 1 x 10-3 kp mm-2. The resulting deformations do not exceed 2 x 10-2. Larger twinned crystals return to their primary state after the release of stress. They behave like extremely soft elastic springs. The crystals belong to the ferroelastic Aizu species m3m F\bar 3m. The transition shows a constant hysteresis of ca 12 K in all crystals investigated. The pressure derivatives of the upper and lower transition temperatures are observed to be almost equal and constant over a wide temperature range (dT/dP ≈ O. 245 K bar-l). The observed enthalpy of transformation is 1.03 J g-1 in fair agreement with the prediction of the Clapeyron-Clausius relation. Crystals of K2Hg(CN)4 exhibit similar properties; their transition temperature, hysteresis, enthalpy of transformation, and dT/dP are considerably less.


Nature ◽  
1966 ◽  
Vol 211 (5049) ◽  
pp. 627-627 ◽  
Author(s):  
H. F. ATKINSON ◽  
A. A. GRANT

Sign in / Sign up

Export Citation Format

Share Document