On the Role of Interfacial Defect Sites During Solid Phase Epitaxial Regrowth of Implantation Amorphized Silicon

1988 ◽  
Vol 100 ◽  
Author(s):  
W. O. Adekoya ◽  
M. Hage-Ali ◽  
J. C. Muller ◽  
P. Siffert
Keyword(s):  
Thermal Annealing ◽  
Rapid Thermal Annealing ◽  
Solid Phase ◽  
Rutherford Backscattering ◽  
Temperature Range ◽  
Interfacial Defect ◽  
A Value ◽  
Epitaxial Regrowth ◽  
Defect Sites

ABSTRACTWe have studied the solid phase epitaxial regrowth (SPER) of implantation (31P+11B+ (73Ge+ preamorphized)) amorphized silicon in the temperature range 500–600°C induced by Rapid Thermal Annealing (RTA) using Rutherford Backscattering and channeling measurements (RBS). Our results show rate enhancements (≃ 3.5–6.5) of the velocities of regrowth in all studied cases with respect to literature-reported values for furnace-induced SPER. Also, the ratio VB/VP (velocity of regrowth in the presence of boron with respect to phosphorus) gives a value of approximately 3 in both RTA and furnace-induced kinetics. These results are explained by a model which takes into account the role of electrically-active interfacial defect sites during SPER.

Solid-Phase Epitaxial Regrowth of Ion-Implanted Silicon on Sapphire Using Rapid Thermal Annealing

1984 ◽  
Vol 35 ◽  
Author(s):  
A M Hodge ◽  
A G Cullis ◽  
N G Chew
Keyword(s):  
Thermal Annealing ◽  
Rapid Thermal Annealing ◽  
Solid Phase ◽  
Silicon Film ◽  
Silicon On Insulator ◽  
Full Potential ◽  
Cross Sectional ◽  
Epitaxial Regrowth ◽  
Transmission Electron ◽  
Device Processing

ABSTRACTSolid phase epitaxial regrowth of silicon on sapphire is used to improve the quality of as-received silicon films prior to conventional device processing. It has been shown that this is necessary, especially for layers of 0.3μm and thinner, if the full potential of this particular silicon on insulator technology is to be realised. Si+ ions are implanted at an energy and dose such that all but the surface of the silicon film is rendered amorphous. In this study, the layer is regrown using a rapid thermal annealer operated in the multi-second regime. A second shallower implant followed by rapid thermal annealing produces a further improvement. Characterisation of the material has been principally by cross-sectional transmission electron microscopy. The structures observed after different implant and regrowth treatments are discussed.

Si-On-Sapphire and Si Implanted with Zr Ions: Lattice Location, Solid Phase Epitaxial Regrowth, and Electrical Properties

1982 ◽  
Vol 14 ◽  
Author(s):  
I. Golecki ◽  
I. Suni
Keyword(s):  
Electrical Properties ◽  
Surface Segregation ◽  
Solid Phase ◽  
Rutherford Backscattering ◽  
Lattice Location ◽  
Temperature Range ◽  
Epitaxial Regrowth ◽  
Amorphous Si ◽  
Solid Phase Regrowth

ABSTRACTZr ions have been implanted at 300 keV (Rp= 1400Å) and doses of 3×1012 − 3×l015 Zr/cm2 into Si-implanted, amorphous Sip layers on (100) bulk Si and Sion- sapphire. Rutherford backscattering and channeling spectrometry was used to study the Zr distribution and lattice location during solid-phase regrowth of the Si layers. The regrowth at 500—550°C stops at 3.4хl020 Zr/cm3, and Zr exhibits interface trapping and surface segregation effects. In this temperature range, Zr is essentially non-substitutional, and inactive electrically.

Improved SOS by rapid thermal annealing and solid phase epitaxial regrowth

2003 ◽  
Author(s):  
P. Rai-Choudhury ◽  
P.K. Vasudev ◽  
J.M. Phillips
Keyword(s):  
Thermal Annealing ◽  
Rapid Thermal Annealing ◽  
Solid Phase ◽  
Epitaxial Regrowth

Solid-Phase Epitaxial Regrowth and Dopant Activation of Arsenic. Implanted Metastable Pseudomorphic Ge0.08Si0.92 AND GeO.16SiO.84 ON Si(100)

1995 ◽  
Vol 379 ◽  
Author(s):  
D.Y.C. Lie ◽  
J.H. Song ◽  
M.-A. Nicolet ◽  
N.D. Theodore ◽  
J. Candelaria ◽  
...  
Keyword(s):  
Thermal Annealing ◽  
Rapid Thermal Annealing ◽  
Room Temperature ◽  
Solid Phase ◽  
Strain Relaxation ◽  
Chemical Vapor ◽  
Layer By Layer ◽  
Solid Phase Epitaxy ◽  
Epitaxial Regrowth ◽  
Control Samples

ABSTRACTMetastable pseudomorphic GexSi1−x (x=8%,16%) films were deposited on p-Si(100) substrates by chemical-vapor-deposition and then implanted at room temperature with 90 keV arsenic ions to a dose of 1.5×1015/cm2. The implantation amorphizes approximately the top 125 nm of the 145 nm-thick GeSi layers. The Si-GeSi interfaces remain sharp after implantation. Implanted and non-implanted GeSi samples, together with implanted Si control samples, were subsequently annealed simultaneously by rapid thermal annealing in a nitrogen ambient at 600,700,800 × for 10,20,40s at each temperature. The implanted samples undergo layer-by-layer solid-phase epitaxial regrowth during annealing at or above 600 ×C. The amorphized and regrown GeSi layers are always fully relaxed with a very high density of dislocations (1010-1011/cm2). At a fixed annealing temperature, strain relaxation of an implanted GeSi film is substantially more extensive than that of a non-implanted one. About 50-90% of the implanted arsenic ions become electrically active after the completion of solid-phase epitaxy. The percentages of arsenic ions that are activated in the Si control samples are generally higher than those in GeSi. The room-temperature sheet electron mobility in GeSi is roughly 30% lower than that in Si for a given sheet electron concentration. We conclude that metastable GeSi on Si(100) amorphized by arsenic ions and recrystallized by solid-phase epitaxy cannot recover both its crystallinity and its pseudomorphic strain under rapid thermal annealing.

scholarly journals Synthesis of Ge1−xSnx Alloy Thin Films by Rapid Thermal Annealing of Sputtered Ge/Sn/Ge Layers on Si Substrates

Materials ◽  
2018 ◽  
Vol 11 (11) ◽  
pp. 2248 ◽  
Author(s):  
Hadi Mahmodi ◽  
Md Hashim ◽  
Tetsuo Soga ◽  
Salman Alrokayan ◽  
Haseeb Khan ◽  
...  
Keyword(s):  
Thermal Annealing ◽  
Rapid Thermal Annealing ◽  
Near Infrared ◽  
Annealing Temperature ◽  
Solid Phase ◽  
Infrared Region ◽  
Alloy Formation ◽  
Phase Mixing ◽  
Si Substrates ◽  
Msm Photodetector

In this work, nanocrystalline Ge1−xSnx alloy formation from a rapid thermal annealed Ge/Sn/Ge multilayer has been presented. The multilayer was magnetron sputtered onto the Silicon substrate. This was followed by annealing the layers by rapid thermal annealing, at temperatures of 300 °C, 350 °C, 400 °C, and 450 °C, for 10 s. Then, the effect of thermal annealing on the morphological, structural, and optical characteristics of the synthesized Ge1−xSnx alloys were investigated. The nanocrystalline Ge1−xSnx formation was revealed by high-resolution X-ray diffraction (HR-XRD) measurements, which showed the orientation of (111). Raman results showed that phonon intensities of the Ge-Ge vibrations were improved with an increase in the annealing temperature. The results evidently showed that raising the annealing temperature led to improvements in the crystalline quality of the layers. It was demonstrated that Ge-Sn solid-phase mixing had occurred at a low temperature of 400 °C, which led to the creation of a Ge1−xSnx alloy. In addition, spectral photo-responsivity of a fabricated Ge1−xSnx metal-semiconductor-metal (MSM) photodetector exhibited its extending wavelength into the near-infrared region (820 nm).

Impact of rapid thermal annealing and hydrogenation on the doping concentration and carrier mobility in solid phase crystallized poly-Si thin films

2011 ◽  
Vol 1321 ◽  
Author(s):  
A. Kumar ◽  
P.I. Widenborg ◽  
H. Hidayat ◽  
Qiu Zixuan ◽  
A.G. Aberle
Keyword(s):  
Thin Films ◽  
Electronic Properties ◽  
Thermal Annealing ◽  
Rapid Thermal Annealing ◽  
Carrier Mobility ◽  
Crystalline Silicon ◽  
Solid Phase ◽  
Dopant Activation ◽  
Hall Effect Measurements ◽  
Probe Measurements

ABSTRACTThe effect of the rapid thermal annealing (RTA) and hydrogenation step on the electronic properties of the n+ and p+ solid phase crystallized (SPC) poly-crystalline silicon (poly-Si) thin films was investigated using Hall effect measurements and four-point-probe measurements. Both the RTA and hydrogenation step were found to affect the electronic properties of doped poly-Si thin films. The RTA step was found to have the largest impact on the dopant activation and majority carrier mobility of the p+ SPC poly-Si thin films. A very high Hall mobility of 71 cm2/Vs for n+ poly-Si and 35 cm2/Vs for p+ poly-Si at the carrier concentration of 2×1019 cm-3 and 4.5×1019 cm-3, respectively, were obtained.

Uniform Poly-Si TFTs for AMOLEDs Using Field-Enhanced Rapid Thermal Annealing

2007 ◽  
Vol 124-126 ◽  
pp. 447-450 ◽  
Author(s):  
Hyoung June Kim
Keyword(s):  
Thermal Annealing ◽  
Rapid Thermal Annealing ◽  
Thin Film Transistors ◽  
Solid Phase ◽  
Radiative Heating ◽  
Solid Phase Crystallization ◽  
Glass Substrates ◽  
Grain Structures ◽  
Amorphous Si ◽  
Si Thin Film

Polycrystalline Si thin film transistors (TFTs) have been fabricated through solid phase crystallization using field-enhanced rapid thermal annealing (FE-RTA) system. The system consists of inline furnace modules for preheating and cooling of the glass substrates and a process module for rapid radiative heating combined with alternating magnetic field induction. The FE-RTA system enables crystallization of amorphous Si at high throughputs without any glass damages. While the typical grain structures of poly-Si by FE-RTA are similar to those of solid phase crystallization, the residual amorphous Si and intragranular defects are reduced.

Solid-Phase Amorphization in Layered Metal/Silicon thin Films

1987 ◽  
Vol 103 ◽  
Author(s):  
Menachem Nathan
Keyword(s):  
Thin Films ◽  
Free Energy ◽  
Thermal Annealing ◽  
Rapid Thermal Annealing ◽  
Glassy Phase ◽  
Solid Phase ◽  
General Scheme ◽  
Crystalline Compound ◽  
Nucleation Kinetics ◽  
Silicon Thin Films

ABSTRACTA general scheme for determining which metal-Si systems undergo solidphase amorphization (SPA) upon rapid thermal annealing is presented and used to investigate Ni-Si, Ti-Si, V-Si, Co-Si and Cr-Si reactions. SPA occurs only in the first three systems. With the glaring exception of Co-Si, the results agree with the thermodynamic predictions of SPA in systems in which the free energy of a glassy phase is significantly lower than the free energy of the separate components. The amorphization may also be influenced by the diffusing species and contamination. Following SPA, the first crystalline compound is determined by nucleation kinetics.

Rapid Thermal Annealing of Neutron Transmutation Toped Czochralski Silicon

1992 ◽  
Vol 262 ◽  
Author(s):  
G. M. Berezina ◽  
F. P. Kdrshunov ◽  
N. A. Sobolev ◽  
A. V. Voevodova ◽  
A. A. Stuk
Keyword(s):  
Thermal Annealing ◽  
Rapid Thermal Annealing ◽  
Neutron Irradiation ◽  
Irradiation Temperature ◽  
Electrical Parameters ◽  
Furnace Annealing ◽  
Annealing Behaviour ◽  
Czochralski Silicon ◽  
Neutron Transmutation

ABSTRACTThe influence of the rapid thermal annealing (RTA) in comparison with that of the standard furnace annealing (FA) on the electrical parameters and photoluminescence (PL) of Czochralski silicon (Cz Si) subjected to neutron irradiation at various temperatures has been studied. The role of the irradiation temperature on the annealing behaviour of electrical parameters in Cz Si has been established. The possibility of getting neutron transmutation doped (NTD) Cz Si having the calculated resistivity by means of the RTA is shown.

Sign in / Sign up

Export Citation Format

Share Document