Performance enhancement of TiSi2 coated Si nanocrystal memory device

2009 ◽  
Vol 1160 ◽  
Author(s):  
Huimei Zhou ◽  
Jianlin Liu

AbstractSelf-aligned TiSi2 coated Si nanocrystal nonvolatile memory is fabricated. This kind of MOSFET memory device is not only thermally stable, but also shows better performance in charge storage capacity, writing, erasing speed and retention characteristics. This indicates that CMOS compatible silicidation process to fabricate TiSi2 coated Si nanocrystal memory is promising in memory device applications.

2007 ◽  
Vol 997 ◽  
Author(s):  
Yan Zhu ◽  
Bei Li ◽  
Jianlin Liu

AbstractThis work describes a novel nonvolatile memory device with self-aligned TiSi2/Si hetero-nanocrystal charge storage nodes. The TiSi2/Si hetero-nanocrystals can be readily fabricated using industrial standard self-aligned silicidation technique based on Si nanocrystals deposited on ultra-thin tunnel oxide with LPCVD. As compared with a Si nanocrystal memory device, a TiSi2/Si hetero-nanocrystal memory device exhibits faster programming and erasing, and longer retention time.


2012 ◽  
Vol 52 (8) ◽  
pp. 1627-1631 ◽  
Author(s):  
Jer-Chyi Wang ◽  
Chih-Ting Lin ◽  
Chi-Hsien Huang ◽  
Chao-Sung Lai ◽  
Chin-Hsiang Liao

2008 ◽  
Vol 1071 ◽  
Author(s):  
Chia-Han Yang ◽  
Yue Kuo ◽  
Chen-Han Lin ◽  
Rui Wan ◽  
Way Kuo

AbstractSemiconducting or metallic nanocrystals embedded high-k films have been investigated. They showed promising nonvolatile memory characteristics, such as low leakage currents, large charge storage capacities, and long retention times. Reliability of four different kinds of nanocrystals, i.e., nc- Ru, -ITO, -Si and -ZnO, embedded Zr-doped HfO2 high-k dielectrics have been studied. All of them have higher relaxation currents than the non-embedded high-k film has. The decay rate of the relaxation current is in the order of nc-ZnO > nc-ITO > nc-Si > nc-Ru. When the relaxation currents of the nanocrystals embedded samples were fitted to the Curie-von Schweidler law, the n values were between 0.54 and 0.77, which are much lower than that of the non embedded high-k sample. The nanocrystals retain charges in two different states, i.e., deeply and loosely trapped. The ratio of these two types of charges was estimated. The charge storage capacity and holding strength are strongly influenced by the type of material of the embedded nanocrystals. The nc-ZnO embedded film holds trapped charges longer than other embedded films do. The ramp-relax result indicates that the breakdown of the embedded film came from the breakdown of the bulk high-k film. The type of nanocrystal material influences the breakdown strength.


2001 ◽  
Vol 686 ◽  
Author(s):  
Michele L. Ostraat ◽  
Jan W. De Blauwe

AbstractA great deal of research interest is being invested in the fabrication and characterization of nanocrystal structures as charge storage memory devices. In these flash memory devices, it is possible to measure threshold voltage shifts due to charge storage of only a few electrons per nanocrystal at room temperature. Although a variety of methods exist to fabricate nanocrystals and to incorporate them into device layers, control over the critical nanocrystal dimensions, tunnel oxide thickness, and interparticle separation and isolation remains difficult to achieve. This control is vital to produce reliable and consistent devices over large wafer areas. To address these control issues, we have developed a novel two-stage ultra clean reactor in which the Si nanocrystals are generated as single crystal, nonagglomerated, spherical aerosol particles from silane decomposition at 950°C at concentrations exceeding 108 cm−3 at sizes below 10 nm. Using existing aerosol instrumentation, it is possible to control the particle size to approximately 10% on diameter. In the second reactor, particles are passivated with a high quality oxide layer with shell thickness controllable from 0.7 to 2.0 nm. The two-stage aerosol reactor is integrated to a 200 mm wafer deposition chamber such that controlled particle densities can be deposited thermophoretically. With nanocrystal deposits of 1013 cm−2, contamination of transition metals and other elements can be controlled to less than 1010 atoms cm−2.We have fabricated 0.2 μm channel length aerosol nanocrystal floating gate memory devices using conventional MOS ULSI processing on 200 mm wafers. The aerosol nanocrystal memory devices exhibit normal transistor characteristics with drive current 30 μA/μm, subthreshold slope 200 mV/dec, and drain induced barrier lowering 100 mV/V, typical values for thick gate dielectric high substrate doped nonvolatile memory devices. Uniform Fowler-Nordheim tunneling is used to program and erase these memory devices. Despite 5 nm tunnel oxides, threshold voltage shifts > 2 V have been achieved with microsecond program and millisecond erase times at moderate operating voltages. The aerosol devices also exhibit excellent endurance cyclability with no window closure observed after 105 cycles. Furthermore, reasonable disturb times and long nonvolatility are obtained, illustrating the inherent advantage of discrete nanocrystal charge storage. No drain disturb was detected even at drain biases of 4V, indicating that little or no charge conduction occurs in the nanocrystal layer. We have demonstrated promise for aerosol nanocrystal memory devices. However, numerous issues exist for the future of nanocrystal devices. These technology issues and challenges will be discussed as directions for future work.


2007 ◽  
Vol 101 (2) ◽  
pp. 026109 ◽  
Author(s):  
Seong-Wan Ryu ◽  
Yang-Kyu Choi ◽  
Chan Bin Mo ◽  
Soon Hyung Hong ◽  
Pan Kwi Park ◽  
...  

2011 ◽  
Vol 181-182 ◽  
pp. 307-311
Author(s):  
Hong Hanh Nguyen ◽  
Ngoc Son Dang ◽  
Van Duy Nguyen ◽  
Kyungsoo Jang ◽  
Kyunghyun Baek ◽  
...  

Nonvolatile memory (NVM) devices with nitride-nitride-oxynitride (NNO) stack structure using Si-rich silicon nitride (SiNx) as charge trapping layer on glass substrate were fabricated. Amorphous silicon clusters existing in the Si-rich SiNxlayer enhance the charge storage capacity of the devices. Low temperature poly-silicon (LTPS) technology, plasma-assisted oxidation/nitridation method to form a uniform ultra-thin tunneling layer, and an optimal Si-rich SiNxcharge trapping layer were used to fabricate NNO NVM devices with different tunneling thickness 2.3, 2.6 and 2.9 nm. The increase memory window, lower voltage operation but little scarifying in retention characteristics of nitride trap NVM devices had been accomplished by reducing the tunnel oxide thickness. The fabricated NVM devices with 2.9 nm tunneling thickness shows excellent electrical properties, such as a low threshold voltage, a high ON/OFF current ratio, a low operating voltage of less than ±9 V and a large memory window of 2.7 V, which remained greater than 72% over a period of 10 years.


2003 ◽  
Vol 50 (10) ◽  
pp. 2067-2072 ◽  
Author(s):  
Jong Jin Lee ◽  
Xuguang Wang ◽  
Weiping Bai ◽  
Nan Lu ◽  
Dim-Lee Kwong

Sign in / Sign up

Export Citation Format

Share Document