scholarly journals High Performance Three-Phase Boost-Type Voltage Regulator

2000 ◽  
Vol 23 (2) ◽  
pp. 105-117
Author(s):  
T. S . Radwan
Keyword(s):  
High Performance ◽  
Voltage Regulator ◽  
Three Phase

A Design of SCR Three-Phase AC-Voltage Regulator Simplify Circuitry Based on STM32 MCU

2013 ◽  
Vol 433-435 ◽  
pp. 1271-1275 ◽  
Author(s):  
Guo Shun Zhou ◽  
Tu Ya ◽  
Shen Hua ◽  
Shu Kun Zhao
Keyword(s):  
Power Supply ◽  
Pid Control ◽  
High Performance ◽  
Field Tests ◽  
Voltage Regulation ◽  
Voltage Regulator ◽  
Isolation Technique ◽  
Three Phase ◽  
Photoelectric Isolation ◽  
Novel Design

This paper introduces a novel design of three-phase AC-voltage regulation trigger circuitry using silicon controlled rectifier (SCR), and presents its application in an energy-saving design of oil extractor control system. The design employs photoelectric isolation technique and the inter-phase of three-phase power supply itself, only three groups of triggering signals are required to control the six thyristors conducting angles. The generation of high-precision triggering signals and PID control regulator functions are realized by programming the multiple high-performance timers and the AD interface of a STM32 microprocessor. Experiments and in-field tests have shown the feasibility of the proposed scheme.

Input switched high performance three phase Buck-Boost controlled rectifier

2013 ◽  
Author(s):  
M. M. S. Khan ◽  
M. S. Arifin ◽  
M. H. Rahaman ◽  
I. K. Amin ◽  
M. R. T. Hossain ◽  
...  
Keyword(s):  
High Performance ◽  
Three Phase

scholarly journals Implementation on the dSPACE 1104 of VOC-SVM based anti-windup PI Controller of a three-phase PWM rectifier

2021 ◽  
Vol 12 (3) ◽  
pp. 1586
Author(s):  
J. Lamterkati ◽  
L. Ouboubker ◽  
M. Khafallah ◽  
A. El afia
Keyword(s):  
High Performance ◽  
Pulse Width Modulation ◽  
Control Method ◽  
Stable State ◽  
Switching Frequency ◽  
Pwm Rectifier ◽  
External Loop ◽  
Three Phase ◽  
Dspace 1104 ◽  
Controller Board

<p><span>The study made in this paper concerns the use of the voltage-oriented control (VOC) of three-phase pulse width modulation (PWM) rectifier with constant switching frequency. This control method, called voltage-oriented controlwith space vector modulation (VOC-SVM). The proposed control scheme has been founded on the transformation between stationary (α-β) and and synchronously rotating (d-q) coordinate system, it is based on two cascaded control loops so that a fast inner loop controls the grid current and an external loop DC-link voltage, while the DC-bus voltage is maintained at the desired level and ansured the unity power factor operation. So, the stable state performance and robustness against the load’s disturbance of PWM rectifiers are boths improved. The proposed scheme has been implemented and simulated in MATLAB/Simulink environment. The control system of the VOC-SVM strategy has been built based on dSPACE system with DS1104 controller board. The results obtained show the validity of the model and its control method. Compared with the conventional SPWM method, the VOC-SVM ensures high performance and fast transient response.</span></p>

scholarly journals Design and Simulation of a Capless Low Drop Out Voltage Regulator

2021 ◽  
pp. 69-75
Author(s):  
Babitha S ◽  
Mr. Hemanth Naidu K J ◽  
Mr. Ashwin Goutham G ◽  
Mr. Harshith S V
Keyword(s):  
High Performance ◽  
Primary Source ◽  
Operating Conditions ◽  
Drop Out ◽  
Voltage Regulator ◽  
Portable Devices ◽  
Current Amplifier ◽  
Power Resources ◽  
Error Amplifier ◽  
The Stability

Portable electronic devices mostly used battery as their primary source for operation hence longer running batteries or Power resources or vital for any portable device need for stable voltage supplies have led to the development of low dropout voltage regulators low dropout regulators provide stable regulated output voltage in various operating conditions which makes it useful in portable devices that design of high performance and stable low dropout voltage regulator is a challenge nowadays with decreasing device size and increasing power densities. The proposed circuit used a 5pack architecture of error amplifier. This paper proposes the study of behavior of the LDO voltage regulator with internal capacitors i.e., capless. The regulated voltage of 1.8V is obtained using the typical power supply of 2.2V obtained dropout voltage of 400mv with the delay of 12.77micro sec, power consumed 1.816W. The proposed design produced DC gain of 31.77db,with the load current variation of 0 to 20mA. The capless LDO architecture is verified in the Cadence 180nm technology. The architecture provides a stable gain and plot for both Temperature and Load Variations. The stability issues are overcome using the compensation techniques which uses a current amplifier and a capacitor in the differentiator configuration. The current amplifier implemented uses current mirror with current copying ratio of unity.

scholarly journals High Performance Multistring Converter Topology for Three-Phase Grid Tied 200 kW Photovoltaic Generating System

2017 ◽  
Vol 1 (2) ◽  
Author(s):  
Mohammad Rustam M. L. ◽  
F. Danang Wijaya
Keyword(s):  
Power Efficiency ◽  
High Performance ◽  
Reactive Power ◽  
Simulation Method ◽  
Operating Conditions ◽  
Total System ◽  
Voltage Reference ◽  
Pv System ◽  
Three Phase ◽  
Converter Topology

Under various external conditions, grid connected PV system performance is strongly affected by the topology that is used to connect a PV system with grid. This research aims to design a multistring based converter topology for three-phase grid connected 200 kW PV system that has a high performance in various operating conditions. Research was done by a simulation method using Matlab-Simulink with performance being evaluated including the generated power, efficiency, power quality in accordance with grid requirements, as well as the power flow. In the simulation, multistring converter topology was designed using two dc-dc boost multistring converters connected in parallel to a centralized of three-phase three-level NPC inverter with the size of the string being shorter and more parallel strings as well as the maximum voltage of the PV array of 273.5 V close to dc voltage reference of 500 V. Each dc-dc boost multistring converter have individual MPPT controllers. The simulation results showed that this multistring converter topology had a high performance in various operating conditions. This due to more power generated by the NPC inverter (> 190 kW) at the time of high power generation on the STC conditions (1000 W/m2, 25 oC), the lowest efficiency of the total system is 95.08 % and the highest efficiency of the total system is 99.4 %, the quality of the power generated in accordance with the requirements of grid, as well as the inverter put more active power to the grid and less reactive power to the grid. The response of the inverter slightly worse for loads with greater reactive power and unbalanced.

Sign in / Sign up

Export Citation Format

Share Document