scholarly journals EFFECT OF DIFFERENT TYPES OF EMITTERS AND IRRIGATION INTERVALS ON THE PRODUCTIVITY AND QUALITY OF SQUASH UNDER THE NILE DELTA CONDITIONS

2021 ◽  
Vol 0 (0) ◽  
pp. 0-0
Author(s):  
Asaad A. Derbala ◽  
Doaa H. Elwan ◽  
Mayie Amer
Keyword(s):  
Nile Delta ◽  
Different Types

Enumeration of Cryptosporidium oocysts from surface water concentrates by laser-scanning cytometry

2000 ◽  
Vol 41 (7) ◽  
pp. 197-202 ◽  
Author(s):  
F. Zanelli ◽  
B. Compagnon ◽  
J. C. Joret ◽  
M. R. de Roubin
Keyword(s):  
Surface Water ◽  
Water Samples ◽  
Laser Scanning ◽  
Immunomagnetic Separation ◽  
Entire Surface ◽  
Cryptosporidium Oocysts ◽  
Different Types ◽  
Laser Scanning Cytometry ◽  
Direct Microscopic Observation

The utilization of the ChemScan® RDI was tested for different types of water concentrates. Concentrates were prepared by cartridge filtration or flocculation, and analysed either without purification, or after Immunomagnetic separation (IMS) or flotation on percoll-sucrose gradients. Theenumeration of the oocysts was subsequently performed using the ChemScan® RDI Cryptosporidium application. Enumeration by direct microscopic observation of the entire surface of the membrane was carried out as a control, and recoveries were calculated as a ratio between the ChemScan® RDI result and the result obtained with direct microscopic enumeration. The Chemscan enumeration technique proved reliable, with recoveries yielding close to 100% in most cases (average 125%, range from 86 to 467%) for all the concentration/purification techniques tested. The quality of the antibodies was shown to be critical, with antibodies from some suppliers yielding recoveries a low as 10% in some cases. This difficulty could, however, be overcome by the utilization of the antibody provided by Chemunex. These data conclusively prove that laser scanning cytometry, which greatly facilitates the microscopic enumeration of Cryptosporidium oocysts from water samples and decreases the time of observation by four to six times, can be successfully applied to water concentrates prepared from a variety of concentration/purification techniques.

Different Types of Auricular Keloids and Treatment by Intralesional Cryosurgery: Best Practice for Obtaining Long-Lasting Clinical Results

Dermatology ◽  
2021 ◽  
pp. 1-10
Author(s):  
Yaron Har-Shai ◽  
Lior Har-Shai ◽  
Viktor A. Zouboulis ◽  
Christos C. Zouboulis
Keyword(s):  
Quality Of Life ◽  
Body Image ◽  
Recurrence Rate ◽  
Best Practice ◽  
Clinical Results ◽  
Psychosocial Impact ◽  
Aesthetic Outcome ◽  
The Past ◽  
Different Types

<b><i>Background:</i></b> Auricular keloids belong to the most perplexing medical conditions, which have significant psychosocial impact on the patient’s body image and quality of life. <b><i>Summary:</i></b> The article is purposed to provide dermatologists and plastic surgeons with the best proven practice using intralesional cryosurgery for the treatment of the different auricular keloid types in order to obtain superior clinical results by minimizing the probability of recurrence. In the past 20 years, the authors have developed novel procedures in order to increase the effectiveness of intralesional cryosurgery on auricular keloids, including hydrodissection, warm gauze technique, and excision of dangling skin. Long-lasting clinical results with a low recurrence rate and a satisfactory aesthetic outcome are achieved with no deformation of the ear framework.

scholarly journals Threat or Corrective? Assessing the Impact of Populist Parties in Government on the Qualities of Democracy: A 19-Country Comparison

2021 ◽  
pp. 1-21
Author(s):  
Davide Vittori
Keyword(s):  
Negative Impact ◽  
Quality Of Democracy ◽  
Clear Cut ◽  
Liberal Democratic ◽  
Country Comparison ◽  
Democratic Regimes ◽  
Different Types ◽  
The Impact

Abstract Scholars have long debated whether populism harms or improves the quality of democracy. This article contributes to this debate by focusing on the impact of populist parties in government. In particular, it inquires: (1) whether populists in government are more likely than non-populists to negatively affect the quality of democracies; (2) whether the role of populists in government matters; and (3) which type of populism is expected to negatively affect the quality of liberal-democratic regimes. The results find strong evidence that the role of populists in government affects several qualities of democracy. While robust, the findings related to (2) are less clear-cut than those pertaining to (1). Finally, regardless of their role in government, different types of populism have different impacts on the qualities of democracy. The results show that exclusionary populist parties in government tend to have more of a negative impact than other forms of populism.

scholarly journals Downregulation of exosomal let-7d and miR-16 in idiopathic pulmonary fibrosis

2021 ◽  
Vol 21 (1) ◽  
Author(s):  
Donato Lacedonia ◽  
Giulia Scioscia ◽  
Piera Soccio ◽  
Massimo Conese ◽  
Lucia Catucci ◽  
...  
Keyword(s):  
Idiopathic Pulmonary Fibrosis ◽  
Pulmonary Fibrosis ◽  
Therapy Response ◽  
Down Regulation ◽  
Cross Sectional ◽  
Exosomal Mirnas ◽  
Different Types ◽  
Sectional Analysis ◽  
Made In

Abstract Background Idiopathic Pulmonary Fibrosis (IPF) is a degenerative interstitial lung disease with both a poor prognosis and quality of life once the diagnosis is made. In the last decade many features of the disease have been investigated to better understand the pathological steps that lead to the onset of the disease and, moreover, different types of biomarkers have been tested to find valid diagnostic, prognostic and therapy response predictive ones. In the complexity of IPF, microRNA (miRNAs) biomarker investigation seems to be promising. Methods We analysed the expression of five exosomal miRNAs supposed to have a role in the pathogenesis of the disease from serum of a group of IPF patients (n = 61) and we compared it with the expression of the same miRNAs in a group of healthy controls (n = 15). Results In the current study what emerged is let-7d down-regulation and, unexpectedly, miR-16 significant down-regulation. Moreover, through a cross-sectional analysis, a clustering of the expression of miR-16, miR-21 and miR-26a was found. Conclusions These findings could help the individuation of previously unknown key players in the pathophysiology of IPF and, most interestingly, more specific targets for the development of effective medications.

scholarly journals Investigation of Color Reproduction on Linen Fabrics when Printing with Mimaki TX400-1800D Inkjet with Pigment TP250 Dyes

Coatings ◽  
2021 ◽  
Vol 11 (3) ◽  
pp. 354
Author(s):  
Tim Tofan ◽  
Rimantas Stonkus ◽  
Raimondas Jasevičius
Keyword(s):  
Mechanical Properties ◽  
Color Reproduction ◽  
Related Effect ◽  
Color Characteristics ◽  
Fabric Density ◽  
Different Types ◽  
The Difference ◽  
Printing Parameters ◽  
Linen Fabric

The aim of this research is to investigate related effect of dyeability to linen textiles related to different printing parameters. The study investigated the change in color characteristics when printing on linen fabrics with an inkjet MIMAKI Tx400-1800D printer with pigmented TP 250 inks. The dependence of color reproduction on linen fabrics on the number of print head passes, number of ink layers to be coated, linen fabric density, and different types of linen fabric was investigated. All this affects the quality of print and its mechanical properties. The change in color characteristics on different types of linen fabrics was determined experimentally. We determine at which print settings the most accurate color reproduction can be achieved on different linen fabrics. The difference between the highest and the lowest possible number of head passages was investigated. The possibilities of reproducing different linen fabric colors were determined.

scholarly journals Not all biases are bad: equitable and inequitable biases in machine learning and radiology

2021 ◽  
Vol 12 (1) ◽  
Author(s):  
Mirjam Pot ◽  
Nathalie Kieusseyan ◽  
Barbara Prainsack
Keyword(s):  
Machine Learning ◽  
Human Error ◽  
Technical Problem ◽  
Social Dimension ◽  
Patient Treatment ◽  
Technical Solution ◽  
Negative Effects ◽  
Different Types ◽  
Human Decision

AbstractThe application of machine learning (ML) technologies in medicine generally but also in radiology more specifically is hoped to improve clinical processes and the provision of healthcare. A central motivation in this regard is to advance patient treatment by reducing human error and increasing the accuracy of prognosis, diagnosis and therapy decisions. There is, however, also increasing awareness about bias in ML technologies and its potentially harmful consequences. Biases refer to systematic distortions of datasets, algorithms, or human decision making. These systematic distortions are understood to have negative effects on the quality of an outcome in terms of accuracy, fairness, or transparency. But biases are not only a technical problem that requires a technical solution. Because they often also have a social dimension, the ‘distorted’ outcomes they yield often have implications for equity. This paper assesses different types of biases that can emerge within applications of ML in radiology, and discusses in what cases such biases are problematic. Drawing upon theories of equity in healthcare, we argue that while some biases are harmful and should be acted upon, others might be unproblematic and even desirable—exactly because they can contribute to overcome inequities.

Comparative Surface Imaging Study of Multifocal Diffractive Intraocular Lenses

2021 ◽  
Author(s):  
Hyeck Soo Son ◽  
Jung Min Lee ◽  
Ramin Khoramnia ◽  
Chul Young Choi
Keyword(s):  
Imaging Study ◽  
The Other ◽  
Intraocular Lenses ◽  
Optical Surface ◽  
Diffractive Optic ◽  
Atomic Force ◽  
Acceptable Range ◽  
Different Types ◽  
Concentric Pattern

Abstract Purpose To analyse and compare the surface topography and roughness of three different types of diffractive multifocal IOLs. Methods Using scanning electron microscope (SEM, Inspect F, 5.0 KV, maximum magnification up to 20,000) and atomic force microscope (AFM, Park Systems, XE-100, non-contact, area profile comparison, 10 × 10 µm, 40 × 40 µm), the surface quality of the following diffractive IOLs was studied: the AcrySof IQ PanOptix (Alcon, USA), the AT LARA 829MP (Carl Zeiss Meditec, Germany), and Tecnis Symfony (Johnson&Johnson Vision, USA). The measurements were made over three representative areas (central non-diffractive optic, central diffractive optic, and diffractive step) of each IOL. Roughness profile in terms of mean arithmetic roughness (Ra) and root-mean-squared roughness (Rq) values were obtained and compared statistically. Results In SEM examination, all IOLs showed a smooth optical surface without any irregularities at low magnification. At higher magnification, Tecnis Symfony showed unique highly regular, concentric, and lineate structures in the diffractive optic area which could not be seen in the other studied diffractive IOLs. The differences in the measured Ra and Rq values of the Tecnis Symfony were statistically significant compared to the other models (p < 0.05). Conclusion Various different topographical traits were observed in three diffractive multifocal IOLs. The Ra values of all studied IOLs were within an acceptable range. Tecnis Symfony showed statistically significant higher surface Ra values at both central diffractive optic and diffractive step areas. Furthermore, compared to its counterparts, Tecnis Symfony demonstrated highly ordered, concentric pattern in its diffractive surfaces.

Sign in / Sign up

Export Citation Format

Share Document