scholarly journals Intraoperative Activation of Very Wide Range Cold Agglutinins during a Cardiac Bypass Case

2020 ◽  
Vol 7 (2) ◽  
Author(s):  
Shah Saurin J ◽  
Mora Juan C ◽  
Shettar Shashank S ◽  
Pirris John P
Keyword(s):  
Cold Agglutinins ◽  
Wide Range ◽  
Cardiac Bypass

scholarly journals Placental compliance during fetal extracorporeal circulation

2001 ◽  
Vol 90 (5) ◽  
pp. 1882-1886 ◽  
Author(s):  
R. S. Assad ◽  
F. Y. Lee ◽  
F. L. Hanley
Keyword(s):  
Extracorporeal Circulation ◽  
Umbilical Artery ◽  
Volume Changes ◽  
Fetal Circulation ◽  
Absolute Volume ◽  
Wide Range ◽  
Cardiac Bypass ◽  
Pressure Changes ◽  
System Volume

The fetus requires large amounts of volume when weaning from cardiac bypass. This suggests that placental vasculature can act as a large capacitor in the fetal circulation. To assess placental compliance of fetal lambs, seven isolated in situ lamb placentas were placed on extracorporeal circulation. Umbilical artery blood flow was varied from 0 to 350 ml · min−1· kg fetal wt−1. Because the extracorporeal circuit is a closed system, volume changes in the placenta induced by umbilical artery pressure changes were measured from reciprocal volume changes in the reservoir. There was a wide range of change in absolute volume of blood within the fetal placental compartment (216.4 ± 29.3 ml). Placental compliance was linear over the entire range of pressure changes exerted on the placental vasculature ( r2= 0.83, P = 0.0001). This indicates that the placenta is a unique and sensitive capacitor in the fetal circulation. This information is important clinically because it establishes that aggressive resuscitation of the fetus using volume may be necessary when weaning the fetus from cardiac bypass.

Recent Applications of High Resolution Electron Microscopy to Crystalline Arrays of Virus Particles

1978 ◽  
Vol 36 (3) ◽  
pp. 470-482 ◽  
Author(s):  
R.W. Horne
Keyword(s):  
Electron Microscopy ◽  
Image Processing ◽  
Analytical Techniques ◽  
Staining Technique ◽  
High Resolution Electron Microscopy ◽  
Optical Diffraction ◽  
Full Potential ◽  
Virus Particles ◽  
Resolution Electron ◽  
Wide Range

The technique of surrounding virus particles with a neutralised electron dense stain was described at the Fourth International Congress on Electron Microscopy, Berlin 1958 (see Home & Brenner, 1960, p. 625). For many years the negative staining technique in one form or another, has been applied to a wide range of biological materials. However, the full potential of the method has only recently been explored following the development and applications of optical diffraction and computer image analytical techniques to electron micrographs (cf. De Hosier & Klug, 1968; Markham 1968; Crowther et al., 1970; Home & Markham, 1973; Klug & Berger, 1974; Crowther & Klug, 1975). These image processing procedures have allowed a more precise and quantitative approach to be made concerning the interpretation, measurement and reconstruction of repeating features in certain biological systems.

Microfabrication research at the National Submicron Facility

1983 ◽  
Vol 41 ◽  
pp. 86-89
Author(s):  
E.D. Wolf
Keyword(s):  
Integrated Circuits ◽  
Particle Physics ◽  
High Speed ◽  
New Technology ◽  
High Energy ◽  
High Energy Particle ◽  
New Science ◽  
Wide Range ◽  
Intermediate Domain ◽  
Circuit Function

Most microelectronics devices and circuits operate faster, consume less power, execute more functions and cost less per circuit function when the feature-sizes internal to the devices and circuits are made smaller. This is part of the stimulus for the Very High-Speed Integrated Circuits (VHSIC) program. There is also a need for smaller, more sensitive sensors in a wide range of disciplines that includes electrochemistry, neurophysiology and ultra-high pressure solid state research. There is often fundamental new science (and sometimes new technology) to be revealed (and used) when a basic parameter such as size is extended to new dimensions, as is evident at the two extremes of smallness and largeness, high energy particle physics and cosmology, respectively. However, there is also a very important intermediate domain of size that spans from the diameter of a small cluster of atoms up to near one micrometer which may also have just as profound effects on society as “big” physics.

Application of TEM to Deformation, Wear, and Fracture of Ceramics

1974 ◽  
Vol 32 ◽  
pp. 472-473
Author(s):  
B. J. Hockey
Keyword(s):  
Wear Resistance ◽  
High Temperature ◽  
Mechanical Behavior ◽  
Brittle Materials ◽  
High Temperature Strength ◽  
Wide Range ◽  
Corrosive Environments ◽  
Further Development

Ceramics, such as Al2O3 and SiC have numerous current and potential uses in applications where high temperature strength, hardness, and wear resistance are required often in corrosive environments. These materials are, however, highly anisotropic and brittle, so that their mechanical behavior is often unpredictable. The further development of these materials will require a better understanding of the basic mechanisms controlling deformation, wear, and fracture.The purpose of this talk is to describe applications of TEM to the study of the deformation, wear, and fracture of Al2O3. Similar studies are currently being conducted on SiC and the techniques involved should be applicable to a wide range of hard, brittle materials.

Observation of Atom Rows in Thorium Pyromellitate Using a Field Emission STEM

1977 ◽  
Vol 35 ◽  
pp. 80-81
Author(s):  
H. Todokoro ◽  
S. Nomura ◽  
T. Komoda
Keyword(s):  
Field Emission ◽  
Amorphous Carbon ◽  
Carbon Film ◽  
Dark Field Image ◽  
Dark Field ◽  
Amorphous Carbon Film ◽  
Atomic Size ◽  
Wide Range ◽  
A Chain

It is interesting to observe polymers at atomic size resolution. Some works have been reported for thorium pyromellitate by using a STEM (1), or a CTEM (2,3). The results showed that this polymer forms a chain in which thorium atoms are arranged. However, the distance between adjacent thorium atoms varies over a wide range (0.4-1.3nm) according to the different authors.The present authors have also observed thorium pyromellitate specimens by means of a field emission STEM, described in reference 4. The specimen was prepared by placing a drop of thorium pyromellitate in 10-3 CH3OH solution onto an amorphous carbon film about 2nm thick. The dark field image is shown in Fig. 1A. Thorium atoms are clearly observed as regular atom rows having a spacing of 0.85nm. This lattice gradually deteriorated by successive observations. The image changed to granular structures, as shown in Fig. 1B, which was taken after four scanning frames.

Development of a conical anode Fe-gun for low voltage SEM

1988 ◽  
Vol 46 ◽  
pp. 978-979
Author(s):  
T. Miyokawa ◽  
S. Norioka ◽  
S. Goto
Keyword(s):  
High Resolution ◽  
Field Emission ◽  
Low Voltage ◽  
Irradiation Damage ◽  
Cold Cathode ◽  
Virtual Source ◽  
Source Position ◽  
Electrostatic Lens ◽  
Electrostatic Lenses ◽  
Wide Range

Field emission SEMs (FE-SEMs) are becoming popular due to their high resolution needs. In the field of semiconductor product, it is demanded to use the low accelerating voltage FE-SEM to avoid the electron irradiation damage and the electron charging up on samples. However the accelerating voltage of usual SEM with FE-gun is limited until 1 kV, which is not enough small for the present demands, because the virtual source goes far from the tip in lower accelerating voltages. This virtual source position depends on the shape of the electrostatic lens. So, we investigated several types of electrostatic lenses to be applicable to the lower accelerating voltage. In the result, it is found a field emission gun with a conical anode is effectively applied for a wide range of low accelerating voltages.A field emission gun usually consists of a field emission tip (cold cathode) and the Butler type electrostatic lens.

Comparison of Deterministic and Linear Cosine Spatial Filtering of Transmission Electron Micrographs

1972 ◽  
Vol 30 ◽  
pp. 596-597
Author(s):  
David A. Ansley
Keyword(s):  
Spherical Aberration ◽  
Focal Length ◽  
Chromatic Aberration ◽  
Spatial Filter ◽  
Operating Conditions ◽  
Objective Lens ◽  
List Type ◽  
Spatial Filters ◽  
Transmission Electron ◽  
Wide Range

The coherence of the electron flux of a transmission electron microscope (TEM) limits the direct application of deconvolution techniques which have been used successfully on unmanned spacecraft programs. The theory assumes noncoherent illumination. Deconvolution of a TEM micrograph will, therefore, in general produce spurious detail rather than improved resolution.A primary goal of our research is to study the performance of several types of linear spatial filters as a function of specimen contrast, phase, and coherence. We have, therefore, developed a one-dimensional analysis and plotting program to simulate a wide 'range of operating conditions of the TEM, including adjustment of the:(1) Specimen amplitude, phase, and separation(2) Illumination wavelength, half-angle, and tilt(3) Objective lens focal length and aperture width(4) Spherical aberration, defocus, and chromatic aberration focus shift(5) Detector gamma, additive, and multiplicative noise constants(6) Type of spatial filter: linear cosine, linear sine, or deterministic

Mechanical Properties and Dislocation Structure of Single Crystal Cdte Deformed in Compression at 300°C

1976 ◽  
Vol 34 ◽  
pp. 592-593
Author(s):  
Ernest L. Hall ◽  
J. B. Vander Sande
Keyword(s):  
Mechanical Properties ◽  
Single Crystal ◽  
Dislocation Structure ◽  
Room Temperature ◽  
Elevated Temperatures ◽  
Strain Curve ◽  
Optical Devices ◽  
Semiconductor Compound ◽  
Wide Range ◽  
Sample Orientation

The present paper describes research on the mechanical properties and related dislocation structure of CdTe, a II-VI semiconductor compound with a wide range of uses in electrical and optical devices. At room temperature CdTe exhibits little plasticity and at the same time relatively low strength and hardness. The mechanical behavior of CdTe was examined at elevated temperatures with the goal of understanding plastic flow in this material and eventually improving the room temperature properties. Several samples of single crystal CdTe of identical size and crystallographic orientation were deformed in compression at 300°C to various levels of total strain. A resolved shear stress vs. compressive glide strain curve (Figure la) was derived from the results of the tests and the knowledge of the sample orientation.

Luminescence from individual dislocations in II-VI and III-V semiconductors

1991 ◽  
Vol 49 ◽  
pp. 834-835
Author(s):  
J W Steeds
Keyword(s):  
Group Iv ◽  
Luminescence Properties ◽  
Carrier Recombination ◽  
Transmission Electron ◽  
Wide Range ◽  
Basic Physics ◽  
Semiconducting Compounds ◽  
Diamond Group ◽  
Non Destructive ◽  
Technological Significance

There is a wide range of experimental results related to dislocations in diamond, group IV, II-VI, III-V semiconducting compounds, but few of these come from isolated, well-characterized individual dislocations. We are here concerned with only those results obtained in a transmission electron microscope so that the dislocations responsible were individually imaged. The luminescence properties of the dislocations were studied by cathodoluminescence performed at low temperatures (~30K) achieved by liquid helium cooling. Both spectra and monochromatic cathodoluminescence images have been obtained, in some cases as a function of temperature.There are two aspects of this work. One is mainly of technological significance. By understanding the luminescence properties of dislocations in epitaxial structures, future non-destructive evaluation will be enhanced. The second aim is to arrive at a good detailed understanding of the basic physics associated with carrier recombination near dislocations as revealed by local luminescence properties.

Optical Properties of HVEM Accelerators

1975 ◽  
Vol 33 ◽  
pp. 180-181
Author(s):  
A. Strojnik ◽  
J.W. Scholl ◽  
V. Bevc
Keyword(s):  
Optical Properties ◽  
Electron Accelerator ◽  
Systematic Investigation ◽  
Electron Source ◽  
High Brightness ◽  
The Past ◽  
Wide Range ◽  
Optical Behavior

The electron accelerator, as inserted between the electron source (injector) and the imaging column of the HVEM, is usually a strong lens and should be optimized in order to ensure high brightness over a wide range of accelerating voltages and illuminating conditions. This is especially true in the case of the STEM where the brightness directly determines the highest resolution attainable. In the past, the optical behavior of accelerators was usually determined for a particular configuration. During the development of the accelerator for the Arizona 1 MEV STEM, systematic investigation was made of the major optical properties for a variety of electrode configurations, number of stages N, accelerating voltages, 1 and 10 MEV, and a range of injection voltages ϕ0 = 1, 3, 10, 30, 100, 300 kV).

Sign in / Sign up

Export Citation Format

Share Document