Ellipsometric Method of Substrate Temperature Measurement in Low-Temperature Processes of Epitaxy of InSb Layers

2019 ◽  
Vol 55 (1) ◽  
pp. 8-15
Author(s):  
V. A. Shvets ◽  
I. A. Azarov ◽  
S. V. Rykhlitskii ◽  
A. I. Toropov
2020 ◽  
Vol 315 ◽  
pp. 112341
Author(s):  
Zhaojun Liu ◽  
Bian Tian ◽  
Xu Fan ◽  
Jiangjiang Liu ◽  
Zhongkai Zhang ◽  
...  

1991 ◽  
Vol 241 ◽  
Author(s):  
Bijan Tadayon ◽  
Mohammad Fatemi ◽  
Saied Tadayon ◽  
F. Moore ◽  
Harry Dietrich

ABSTRACTWe present here the results of a study on the effect of substrate temperature, Ts, on the electrical and physical characteristics of low temperature (LT) molecular beam epitaxy GaAs layers. Hall measurements have been performed on the asgrown samples and on samples annealed at 610 °C and 850 °C. Si implantation into these layers has also been investigated.


1991 ◽  
Vol 62 (11) ◽  
pp. 2792-2794 ◽  
Author(s):  
M. V. S. Lakshmi ◽  
K. Ramkumar ◽  
M. Satyam

2021 ◽  
Vol 3 ◽  
Author(s):  
Larionette P. L. Mawlong ◽  
Ravi K. Biroju ◽  
P. K. Giri

We report on the growth of an ordered array of MoS2 nanodots (lateral sizes in the range of ∼100–250 nm) by a thermal chemical vapor deposition (CVD) method directly onto SiO2 substrates at a relatively low substrate temperature (510–560°C). The temperature-dependent growth and evolution of MoS2 nanodots and the local environment of sulfur-induced structural defects and impurities were systematically investigated by field emission scanning electron microscopy, micro-Raman spectroscopy, and X-ray photoelectron spectroscopy (XPS) techniques. At the substrate temperature of 560°C, we observed mostly few-layer MoS2, and at 510°C, multilayer MoS2 growth, as confirmed from the Raman line shape analysis. With reduced substrate temperature, the density of MoS2 nanodots decreases, and layer thickness increases. Raman studies show characteristic Raman modes of the crystalline MoS2 layer, along with two new Raman modes centered at ∼346 and ∼361 cm−1, which are associated with MoO2 and MoO3 phases, respectively. Room temperature photoluminescence (PL) studies revealed strong visible PL from MoS2 layers, which is strongly blue-shifted from the bulk MoS2 flakes. The strong visible emission centered at ∼ 658 nm signifies a free excitonic transition in the direct gap of single-layer MoS2. Position-dependent PL profiles show excellent uniformity of the MoS2 layers for samples grown at 540 and 560°C. These results are significant for the low-temperature CVD growth of a few-layer MoS2 dots with direct bandgap photoluminescence on a flexible substrate.


1990 ◽  
Vol 187 ◽  
Author(s):  
C. S. Chang ◽  
J. C. Wang ◽  
L. C. Kuo

AbstractAn electron beam evaporation method has been used to prepare tin doped indium oxide (ITO) films with 95 wt.% In2O3 and 5 wt.% SnO2 in an oxygen atmosphere. It was found that the deposition rate and oxygen pressure strongly influence the film properties when the substrate temperature was lower than 200°C. In an optimal condition, highly transparent (transmittance ˜ 90% at wavelength 570 nm) and conductive (resistivity – 3×10−4Ω-cm) films of thickness around 2000 Å at substrate temperature as low as 180°C can be obtained.


2013 ◽  
Vol 3 (2) ◽  
pp. P10-P12 ◽  
Author(s):  
Hasung Sim ◽  
Seongil Choi ◽  
Je-Geun Park ◽  
Jaewon Song ◽  
Seungwu Han ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document