scholarly journals Adsorption of Model Dyes on Recycled Silica Gel

Proceedings ◽  
2019 ◽  
Vol 48 (1) ◽  
pp. 10
Author(s):  
Fatima Sbait Wahshi ◽  
Maitha Dhaiman Alqahtani ◽  
Manhal Abdulla ◽  
Tholkappiyan Ramachandran ◽  
Fathalla Hamed ◽  
...  
Keyword(s):  
Aqueous Solutions ◽  
Silica Gel ◽  
Adsorption Process ◽  
Food Colorants ◽  
Waste Products ◽  
Optimal Procedure ◽  
Biological Stains

Silica gel was used as an adsorbent for dyes in aqueous solutions. Afterwards, the silica gel with the adsorbed dye was heated to 600 °C, at which the dye combusted, leaving behind clean silica gel. This silica gel can be reused in the adsorption process. The operation leaves behind little waste products. It is an optimal procedure for educational and other research laboratories which are working with biological stains, food colorants and some non-commercial dyes.

Sorption of Bisphenol A in Aqueous Solutions on Irradiated and as-Grown Multiwalled Carbon Nanotubes

2018 ◽  
Vol 69 (5) ◽  
pp. 1233-1239
Author(s):  
Raluca Madalina Senin ◽  
Ion Ion ◽  
Ovidiu Oprea ◽  
Rusandica Stoica ◽  
Rodica Ganea ◽  
...  
Keyword(s):  
Carbon Nanotubes ◽  
Bisphenol A ◽  
Aqueous Solutions ◽  
Adsorption Capacity ◽  
Multiwalled Carbon Nanotubes ◽  
Adsorption Process ◽  
Sorption Process ◽  
Multiwalled Carbon ◽  
Before And After ◽  
Kinetic Sorption

In this study, non-irradiated and weathered multiwalled carbon nanotubes (MWCNTs) obtained through irradiation, were studied as adsorbents for BPA, both nanomaterials being characterized before and after the adsorption process. The objectives of our investigation were to compare the characteristics of non-irradiated and irradiated MWCNTs, to evaluate the adsorption capacity of BPA by pristine and irradiated MWCNTs and to determine the variation of the kinetic, sorption and thermodynamic parameters during sorption process using both sorbents.

Fabrication of monodisperse polypyrrole/SBA-15 composite for the selective removal of Cr(Ⅵ) from aqueous solutions

2021 ◽  
Author(s):  
Liang Wang ◽  
Peng Gao ◽  
Mengxin Liu ◽  
Ziqing Huang ◽  
Shixia Lan ◽  
...  
Keyword(s):  
Aqueous Solution ◽  
Aqueous Solutions ◽  
Adsorption Process ◽  
In Situ Polymerization ◽  
Selective Removal ◽  
Factors Affecting

Monodisperse polypyrrole/SBA-15 composite (PPy/SBA-15) was fabricated by in-situ polymerization and used for Cr(Ⅵ) adsorption from aqueous solution. PPy/SBA-15 was characterized by numerous approaches. Factors affecting the Cr(Ⅵ) adsorption process included...

scholarly journals Kinetic, isotherm and thermodynamic studies with linear and non-linear fitting for cadmium(II) removal by black carbon of pine cone

2017 ◽  
Vol 76 (8) ◽  
pp. 2242-2253 ◽  
Author(s):  
Z. Yavari ◽  
M. Noroozifar
Keyword(s):  
Aqueous Solutions ◽  
Black Carbon ◽  
Adsorption Process ◽  
Order Kinetic ◽  
Cadmium Removal ◽  
Thermodynamic Studies ◽  
Linear Fitting ◽  
Pine Cone ◽  
Fitting Method ◽  
Non Linear

In this study, black carbon from pine cone (BCPC) and acidic-modified BCPC (MBCPC) powder as a popular agricultural waste in the southeast of Iran were used for cadmium removal from aqueous solutions. The effect of various factors, such as surface chemistry and dosage of adsorbent, contact time, size of particles, initial concentration of cadmium, temperature, and pH of aqueous solutions, was investigated. The results show cadmium removal with usage of the mentioned adsorbents increased after acidic modification. It was noteworthy in this work that the removal percentage of pollutant was above 90% for suggested biosorbents. The obtained experimental data for optimum conditions were selected to model the adsorption behavior of the materials with usage of six isotherm equations via non-linear fitting method and the residual root mean square error estimation for each model. The adsorption of cadmium preferably fitted Khan and Langmuir–Freundlich isotherms for BCPC and MBCPC adsorbents, respectively. The kinetic studies via linear fitting method proved the second-order kinetic was the applicable model for the adsorption process. Thermodynamic studies show the adsorption process of cadmium onto BCPC and MBCPC was spontaneous and endothermic.

Ouricuri (Syagrus coronata) fiber: a novel biosorbent to remove methylene blue from aqueous solutions

2016 ◽  
Vol 75 (1) ◽  
pp. 106-114 ◽  
Author(s):  
Lucas Meili ◽  
Társila Santos da Silva ◽  
Daniely Carlos Henrique ◽  
João Inácio Soletti ◽  
Sandra Helena Vieira de Carvalho ◽  
...  
Keyword(s):  
Methylene Blue ◽  
Experimental Design ◽  
Aqueous Solutions ◽  
Adsorption Capacity ◽  
Adsorption Process ◽  
Fiber Diameter ◽  
Aqueous Media ◽  
Process Efficiency ◽  
Maximum Adsorption Capacity ◽  
Equilibrium Studies

In this work, the potential of ouricuri (Syagrus coronata) fiber as a novel biosorbent to remove methylene blue (MB) from aqueous solutions was investigated. The fiber was prepared and characterized according to the fundamental features for adsorption. A 23 experimental design was used to evaluate the effects of adsorbent dosage (M), fiber diameter (D) and agitation (A) on the adsorption capacity. In the more adequate conditions, kinetic and equilibrium studies were performed. The experimental design results showed that M = 10 g L−1), D = 0.595 mm and A = 200 rpm were the more adequate conditions for MB adsorption. Based on the kinetic study, it was found that the adsorption process was fast, being the equilibrium was attained at about 5 min, with 90% of color removal. The isotherm was properly represented by the Sips model, and the maximum adsorption capacity was 31.7 mg g−1. In brief, it was demonstrated that ouricuri fiber is an alternative biosorbent to remove MB from aqueous media, taking into account the process efficiency and economic viewpoint.

ESR and ESEM Study of Spin Probe Aqueous Solutions Adsorbed on Silica Gel

1986 ◽  
pp. 411-424
Author(s):  
N. Romanelli ◽  
G. Martini ◽  
L. Kevan
Keyword(s):  
Aqueous Solutions ◽  
Silica Gel ◽  
Spin Probe

scholarly journals A study of adsorption isotherms for the removal of herbicide Atlantis WG from aqueous solutions by using Bentonite clay

2015 ◽  
Vol 12 (1) ◽  
pp. 148-156
Author(s):  
Baghdad Science Journal
Keyword(s):  
Aqueous Solutions ◽  
Adsorption Process ◽  
Equilibrium Concentration ◽  
Bentonite Clay ◽  
Langmuir Model ◽  
Effect Of Temperature ◽  
Isotherm Models ◽  
Sorption Data ◽  
Freundlich Model ◽  
The Subject

The subject of this research involves studying adsorption to removal herbicide Atlantis WG from aqueous solutions by bentonite clay. The equilibrium concentration have been determined spectra photometry by using UV-Vis spectrophotometer. The experimental equilibrium sorption data were analyzed by two widely, Langmuir and Freundlish isotherm models. The Langmuir model gave a better fit than Freundlich model The adsorption amount of (Atlantis WG) increased when the temperature and pH decreased. The thermodynamic parameters like ?G, ?H, and ?S have been calculated from the effect of temperature on adsorption process, is exothermic. The kinetic of adsorption process was studied depending on Lagergren ,Morris ? Weber and Rauschenberg equations.

scholarly journals Zeolites as alcohol adsorbents from aqueous solutions

2006 ◽  
pp. 83-87 ◽  
Author(s):  
Blagica Cekova ◽  
Dragi Kocev ◽  
Elena Kolcakovska ◽  
Daniela Stojanova
Keyword(s):  
Heat Treatment ◽  
Aqueous Solutions ◽  
Pore Volume ◽  
Industrial Wastewater ◽  
Organic Molecules ◽  
Adsorption Process ◽  
Aqueous Acetone ◽  
Heats Of Adsorption ◽  
Series Of Experiments ◽  
Low Costs

The potential usage of zeolites as adsorbents for the removal of organic molecules from water was investigated in a series of experiments with aqueous solutions of lower alcohols. This could represent a simple solution to the problem of cleaning up industrial wastewater as well as recovering valuable chemicals at relatively low costs. Adsorption isotherms of the Langmuir type were applied, and calculations showed that the amount of propanol adsorbed on silicalite corresponded to approximately 70% of the pore volume. The adsorption process is simple, and recovery of the more concentrated products is easily done by heat treatment and/or at lowered pressures. Adsorption experiments with aqueous acetone showed that silicalite had approximately the same adsorption capacity for acetone as for n-propanol. Heats of adsorption were determined calorimetrically.

scholarly journals Adsorption Study for Trifluralin on Iraqi ? –Alumina

2012 ◽  
Vol 9 (1) ◽  
pp. 153-159 ◽  
Author(s):  
Baghdad Science Journal
Keyword(s):  
Adsorption Isotherm ◽  
Aqueous Solutions ◽  
Contact Time ◽  
Adsorption Process ◽  
Kinetic Equations ◽  
Adsorption Study ◽  
Adsorption Capacities ◽  
Experimental Parameters ◽  
Freundlich Adsorption Isotherm ◽  
Equilibrium Adsorption Isotherm

Equilibrium adsorption isotherm for the removal of trifluralin from aqueous solutions using ? –alumina clay has been studied. The result shows that the isotherms were S3 according Giels classification. The effects of various experimental parameters such as contact time, adsorbent dosage, effect of pH and temperature of trifluralin on the adsorption capacities have been investigated. The adsorption isotherms were obtained by obeying freundlich adsorption isotherm with (R2 = 0.91249-0.8149). The thermodynamic parameters have been calculated by using the adsorption process at five different temperature, the values of ?H, ?G and ?S were (_1.0625) kj. mol-1, (7.628 - 7.831) kj.mol-1 and (_2.7966 - _2.9162) kg. k-1. mol-1 respectively. The kinetic study of adsorption process has been studied depending on three kinetic equations: 1- Allergen equation 2- Morris –weber eguation 3- Reichenberg eguation. In general, the result shows the isotherm were on ?- alumina according to Giels classification.? –alumina and thermodynamic

scholarly journals BIOSORPTION OF METAL IONS Pb(II), Cu(II), AND Cd(II) ON Sargassum duplicatum IMMOBILIZED SILICA GEL MATRIX

2010 ◽  
Vol 6 (3) ◽  
pp. 245-250 ◽  
Author(s):  
Buhani Buhani ◽  
Suharso Suharso ◽  
Zipora Sembiring
Keyword(s):  
Metal Ions ◽  
Silica Gel ◽  
Functional Group ◽  
Adsorption Process ◽  
Liquid Waste ◽  
Batch Method ◽  
Algae Biomass ◽  
Adsorbent Surface ◽  
Physical And Chemical ◽  
Matrix Series

Sargassum duplicatum algae biomass is biological material which has a potency to be used as a biosorbent adsorb metal ions from industrial liquid waste, because it has effective functional group as a ligand. However, the ability of the algae biomass in adsorbing of heavy metal ions has some problem such as; tiny size, low density, and easy to be degradated by other microorganism. In addition, algae biomass can not be used directly in adsorption column for its application as the biosorbent. In order to improve physical and chemical prpperties of algae biomass, it needs to be immobilized on silica gel matrix. Series of experiment have been done, morphology analysis of adsorbent surface was performed by using Scanning Electron Microscopy (SEM) and adsorption process to examine the effectiveness of algae biomass immobilized in adsorbing Pb(II), Cu(II), and Cd(II) was performed using batch method at 27 °C. Concentration of metal was determined by using Atomic Absorption Spectrophotometer (AAS) and identification of functional group was conducted using Spectrophotometer Infrared (IR). Data obtained showed that interacting among metal ions with algae biomass is optimum at a range of 60 minutes. Adsorption energies of metal ions resulted from the interaction of metal ions with the functional group of -C=O group from carboxyl and amide on algae biomass and -Si-OH group from silica were at a range of 21.09-25.05 kJ/mole.   Keywords: biosorption, silica gel, Sargassum duplicatum, immobilization

Possible Utilization of Silica Gel Sludge for the Removal of Phenol from Aqueous Solutions: Laboratory Studies

2003 ◽  
Vol 23 (4) ◽  
pp. 329-334 ◽  
Author(s):  
Azni Idris ◽  
Katayon Saed
Keyword(s):  
Aqueous Solutions ◽  
Silica Gel ◽  
Laboratory Studies
Sign in / Sign up

Export Citation Format

Share Document