Abstract. There is considerable interest in using low-cost optical particle counters (OPC) to supplement existing routine air quality networks that monitor particle mass concentrations. In order to do this, low-cost OPC data needs to be cross-comparable with particle mass reference instrumentation, and as yet, there is no widely agreed methodology. Aerosol hygroscopicity is known to be a key parameter to consider when correcting particle mass concentrations derived from a low-cost OPC, particularly at high ambient Relative Humidity (RH). Correction factors have been developed that apply κ-Köhler theory to correct for the influence of water uptake by hygroscopic aerosols. We have used datasets of co-located reference particle measurements and a low-cost OPC (OPC-N2, Alphasense), collected in four cities in three continents, to explore the performance of this correction factor. We report evidence that the elevated particle mass concentrations, reported by the low-cost OPC relative to reference instrumentation, is due to bulk aerosol hygroscopicity under different RH conditions, which is determined by aerosol composition and in particular the levels of hygroscopic aerosols (sulphate and nitrate). We exploit measurements made in volcanic plumes in Nicaragua, that are predominantly composed of sulphate aerosol, as a natural experiment to demonstrate this behaviour in the ambient atmosphere, with the observed humidogram closely resembling the calculated pure sulphuric acid humidogram. The results indicate that the particle mass concentrations derived from low-cost OPCs during periods of high RH (> 60 %) need to be corrected for aerosol hygroscopic growth. We employed a correction factor based on κ-Köhler theory and observed corrected OPC-N2 PM2.5 mass concentrations to be within 33 % of reference measurements at all sites. The results indicated that an in situ derived κ (using suitable reference instrumentation) would lead to the most accurate correction relative to co-located reference instruments. Applying literature κ in the correction factor also resulted in improved performance of OPC-N2, to be within 50 % of reference. Therefore, for areas where suitable reference instrumentation for developing a local correction factor is lacking, using a literature κ value can result in a reasonable correction. For locations with low levels of hygroscopic aerosols and RH, a simple calibration against gravimetric measurements (using suitable reference instrumentation) would likely be sufficient. Whilst this study generated correction factors specific for the Alphasense OPC-N2 sensor, the calibration methodology developed is likely amenable to other low cost PM sensors.
Statistics of a Sharp GP2Y Low-Cost Aerosol PM Sensor Output Signals