Study on Biohydrogen Production of Dark Fermentation with the Stimulation of Ultrasonic

2013 ◽  
Vol 479-480 ◽  
pp. 451-456
Author(s):  
Shao Yi Hsia ◽  
Ching Hsiung Wang ◽  
Yu Tuan Chou

The development and utilization of energy has played a key role in the human civilization process, and fossil fuels have become the major energy supply after Industrial Revolution. However, with the massive utilization of fossil fuels, petroleum and natural gas will be exhausted, and people will face the risk of energy shortages. For this reason, the development of clean, efficient, and renewable energy should be a priority. Hydrogen is considered a safe and secure energy source for human health and the global environment, as it does not emit any pollutants while burning. Hence, this study combines biohydrogen production of dark fermentation with ultrasonic to explore the effects of ultrasonic frequency, amplitude and exposure time on biohydrogen production of dark fermentation. The experimental results show that the largest biohydrogen production appears when the ultrasonic frequency being 1MHz and the ultrasonic exposure time is 15 min for exposure and 15 min for termination. It is therefore possible to find the optimal hydrogen production condition and to further understand the effect of ultrasonic on microorganisms.

2014 ◽  
Vol 2014 ◽  
pp. 1-11 ◽  
Author(s):  
Shao-Yi Hsia ◽  
Yu-Tuan Chou

Massive utilization of petroleum and natural gas caused fossil fuel shortages. Consequently, a large amount of carbon dioxide and other pollutants are produced and induced environmental impact. Hydrogen is considered a clean and alternative energy source. It contains relatively high amount of energy compared with other fuels and by-product is water. In this study, the combination of ultrasonic mechanical and biological effects is utilized to increase biohydrogen production from dark fermentation bacteria. The hydrogen production is affected by many process conditions. For obtaining the optimal result, experimental design is planned using the Taguchi Method. Four controlling factors, the ultrasonic frequency, energy, exposure time, and starch concentration, are considered to calculate the highest hydrogen production by the Taguchi Method. Under the best operating conditions, the biohydrogen production efficiency of dark fermentation increases by 19.11%. Results have shown that the combination of ultrasound and biological reactors for dark fermentation hydrogen production outperforms the traditional biohydrogen production method. The ultrasonic mechanical effects in this research always own different significances on biohydrogen production.


2018 ◽  
Vol 9 (1) ◽  
pp. 4-10
Author(s):  
Thi Thu Huyen Nguyen ◽  
Thi Yen Dang ◽  
Thuy Hien Lai

Limitation of fuels reserves and contribution of fossil fuels to the greenhouse effect leads to develop anew, clean and sustainable energy. Among the various options, biohydrogen appears as a promising alternative energy source. The fermentative hydrogen production process holds a great promise for commercial processes. Hydrogen production by fermentative bacteria is a very complex and greatly influenced by pH. This paper presents biohydrogen production by bacterial strain Clostridium sp. Tr2. Operational pH strongly affected its hyrogen production. Its gas production rate as well as obtained gas product were roughly increase twice under controlled pH at 6 than non-controlled condition. Dark fermentation for hydrogen production of strain Tr2 was performed under bottle as well as automatic fermenter scale under optimal nutritional and environmental conditions at 30°C, initial pH at 6.5, then pH was controlled at 6 for bioreactor scale (BioFlo 110). Bioreactor scale was much better for hydrogen production of strain Tr2. Clostridium sp. Tr2 produced 0.74 L hydro (L medium)-1 occupying 72.6 % of total gas under bottle scale while it produced 2.94 L hydro (L medium)-1 occupying 95.82 % of total gas under fermenter scale. Its maximum obtained hydrogen yield of Clostridium sp. Tr2 under bioreactor scale Bioflo 110 in optimal medium with controlled pH 6 was 2.31 mol hydro (mol glucose)-1. Dự trữ nhiên liệu có giới hạn và việc sử dụng nhiên liêu hoá thạch góp phần không nhỏ gây hiệu ứng nhà kính dẫn đến cần phải phát triển năng lượng mới, sạch và bền vững. Trong số các giải pháp, hydro sinh học xuất hiện như một nguồn năng lượng thay thế đầy hứa hẹn. Quá trình lên men sản xuất hydro có tiềm năng lớn để áp dụng trong sản xuất thương mại. Tuy nhiên qúa trình này rất phức tạp và chịu ảnh hưởng lớn bởi pH. Nghiên cứu này trình bày sản xuất hydro sinh học do chủng vi khuẩn Clostridium sp. Tr2. Quá trình sản xuất hydro của chủng này bị ảnh hưởng mạnh mẽ bởi pH thay đổi trong quá trình lên men. Tốc độ tạo khí cũng như lượng khí thu được của chủng này tăng gần gấp đôi trong môi trường có duy trì pH ở pH 6 so với môi trường không kiểm soát pH. Quá trình lên men tối sản xuất hydro của chủng Tr2 được thực hiện ở quy mô bình thí nghiệm cũng như bình lên men tự động trong điều kiện môi trường tối ưu ở 30°C, pH ban đầu 6.5, ở qui mô bình lên men tự động (BioFlo 110), pH môi trường sau đó được duy trì ổn định ở pH 6. Lên men sản xuất hdyro của chủng Tr2 trong bình lên men tự động tốt hơn rất nhiều so với lên men trong bình thí nghiệm. Clostridium sp. Tr2 chỉ tạo ra được 0,74 L hydro (L medium)-1 chiếm 72,6 % tổng thể tích khí thu được ở điều kiện lên men bình thí nghiệm trong khi chủng này sản xuất được 2,94 L hydro (L medium)-1 chiếm 95,82 % tổng thể tích khí ở điều kiện lên men tự động. Sản lượng hydro thu được lớn nhất của chủng này trong bình lên men tự động BioFlo 110 trong trong môi trường tối ưu có kiểm soát pH tại pH 6 là 2,31 mol hydro (mol glucose)-1.


2018 ◽  
Vol 1 (3) ◽  
Author(s):  
IJE Manager

In the past century, fossil fuels have dominated energy supply in Indonesia. However, concerns over emissions are likely to change the future energy supply. As people become more conscious of environmental issues, alternatives for energy are sought to reduce the environmental impacts. These include renewable energy (RE) sources such as solar photovoltaic (PV) systems. However, most RE sources like solar PV are not available continuously since they depend on weather conditions, in addition to geographical location. Bali has a stable and long sunny day with 12 hours of daylight throughout the year and an average insolation of 5.3 kWh/m2 per day. This study looks at the potential for on-grid solar PV to decarbonize energy in Bali. A site selection methodology using GIS is applied to measure solar PV potential. Firstly, the study investigates the boundaries related to environmental acceptability and economic objectives for land use in Bali. Secondly, the potential of solar energy is estimated by defining the suitable areas, given the technical assumptions of solar PV. Finally, the study extends the analysis to calculate the reduction in emissions when the calculated potential is installed. Some technical factors, such as tilting solar, and intermittency throughout the day, are outside the scope of this study. Based on this model, Bali has an annual electricity potential for 32-53 TWh from solar PV using amorphous thin-film silicon as the cheapest option. This potential amount to three times the electricity supply for the island in 2024 which is estimated at 10 TWh. Bali has an excessive potential to support its own electricity demand with renewables, however, some limitations exist with some trade-offs to realize the idea. These results aim to build a developmental vision of solar PV systems in Bali based on available land and the region’s irradiation.


2021 ◽  
Vol 11 (1) ◽  
Author(s):  
R. M. Silva ◽  
A. A. Abreu ◽  
A. F. Salvador ◽  
M. M. Alves ◽  
I. C. Neves ◽  
...  

AbstractThermophilic biohydrogen production by dark fermentation from a mixture (1:1) of C5 (arabinose) and C6 (glucose) sugars, present in lignocellulosic hydrolysates, and from Sargassum sp. biomass, is studied in this work in batch assays and also in a continuous reactor experiment. Pursuing the interest of studying interactions between inorganic materials (adsorbents, conductive and others) and anaerobic bacteria, the biological processes were amended with variable amounts of a zeolite type-13X in the range of zeolite/inoculum (in VS) ratios (Z/I) of 0.065–0.26 g g−1. In the batch assays, the presence of the zeolite was beneficial to increase the hydrogen titer by 15–21% with C5 and C6-sugars as compared to the control, and an increase of 27% was observed in the batch fermentation of Sargassum sp. Hydrogen yields also increased by 10–26% with sugars in the presence of the zeolite. The rate of hydrogen production increased linearly with the Z/I ratios in the experiments with C5 and C6-sugars. In the batch assay with Sargassum sp., there was an optimum value of Z/I of 0.13 g g−1 where the H2 production rate observed was the highest, although all values were in a narrow range between 3.21 and 4.19 mmol L−1 day−1. The positive effect of the zeolite was also observed in a continuous high-rate reactor fed with C5 and C6-sugars. The increase of the organic loading rate (OLR) from 8.8 to 17.6 kg m−3 day−1 of COD led to lower hydrogen production rates but, upon zeolite addition (0.26 g g−1 VS inoculum), the hydrogen production increased significantly from 143 to 413 mL L−1 day−1. Interestingly, the presence of zeolite in the continuous operation had a remarkable impact in the microbial community and in the profile of fermentation products. The effect of zeolite could be related to several properties, including the porous structure and the associated surface area available for bacterial adhesion, potential release of trace elements, ion-exchanger capacity or ability to adsorb different compounds (i.e. protons). The observations opens novel perspectives and will stimulate further research not only in biohydrogen production, but broadly in the field of interactions between bacteria and inorganic materials.


RSC Advances ◽  
2021 ◽  
Vol 11 (1) ◽  
pp. 87-113
Author(s):  
Rami J. Batrice ◽  
John C. Gordon

Solar energy has been used for decades for the direct production of electricity in various industries and devices. However, harnessing and storing this energy in the form of chemical bonds has emerged as a promising alternative to fossil fuels.


Polymers ◽  
2021 ◽  
Vol 13 (15) ◽  
pp. 2539
Author(s):  
Sipei Li ◽  
Yang Liu ◽  
Dana A. Wong ◽  
John Yang

Since the second industrial revolution, the use of fossil fuels has been powering the advance of human society. However, the surge in carbon dioxide (CO2) emissions has raised unsettling concerns about global warming and its consequences. Membrane separation technologies have emerged as one of the major carbon reduction approaches because they are less energy-intensive and more environmentally friendly compared to other separation techniques. Compared to pure polymeric membranes, mixed matrix membranes (MMMs) that encompass both a polymeric matrix and molecular sieving fillers have received tremendous attention, as they have the potential to combine the advantages of both polymers and molecular sieves, while cancelling out each other’s drawbacks. In this review, we will discuss recent advances in the development of MMMs for CO2 separation. We will discuss general mechanisms of CO2 separation in an MMM, and then compare the performances of MMMs that are based on zeolite, MOF, metal oxide nanoparticles and nanocarbons, with an emphasis on the materials’ preparation methods and their chemistries. As the field is advancing fast, we will particularly focus on examples from the last 5 years, in order to provide the most up-to-date overview in this area.


2019 ◽  
Vol 44 (44) ◽  
pp. 24110-24125 ◽  
Author(s):  
Tobias Weide ◽  
Elmar Brügging ◽  
Christof Wetter ◽  
Antonio Ierardi ◽  
Marc Wichern

Molecules ◽  
2021 ◽  
Vol 26 (2) ◽  
pp. 500
Author(s):  
Juan Antonio Cecilia ◽  
Daniel Ballesteros Plata ◽  
Enrique Vilarrasa García

After the industrial revolution, the increase in the world population and the consumption of fossil fuels has led to an increase in anthropogenic CO2 emissions [...]


Sign in / Sign up

Export Citation Format

Share Document