On Research of Basalt Fiber Used in Asphalt Concrete

2013 ◽  
Vol 791-793 ◽  
pp. 456-459
Author(s):  
Jian Jun Li ◽  
Yan Chun Liu

As a new type of green material with excellent physical and chemical properties and mechanical properties. Basalt fiber are widely used in the field of civil construction. This paper focused on the use of basalt fibers to improve the mechanism of asphalt concrete, demonstrated the prospects and market value of the basalt fiber that are widely used in asphalt concrete

Author(s):  
Guili Ge ◽  
Lin Li ◽  
Dan Wang ◽  
Mingjian Chen ◽  
Zhaoyang Zeng ◽  
...  

Carbon dots (CDs) are a new type of carbon nanomaterial that have unique physical and chemical properties, good biocompatibility, low toxicity, easy surface functionalization, making them widely used in biological...


A so far unknown chlorophyll has been isolated from several strains of brown-coloured chlorobacteria and has been designated bacteriochlorophyll e . Comparison of the physical and chemical properties of the new chlorophyll with those of bacteriochlorophylls c and d ( Chlorbium chlorophylls) allows one to deduce its structural formula. The stereochemistry of the hydroxyethyl side chain of bacteriochlorophylls c, d and e can be determined by a modified Horeau analysis of these pigments, and the results thus obtained are in agreement with those derived from oxidative degradation experiments. The latter method allows one furthermore to prove the structure of bacteriochlorophylls c and d proposed by Holt, and to establish the absolute configuration at carbon atoms 7 and 8. The presence of a δ-methylsubstituent in bacteriochlorophylls c and e is unambiguously demonstrated by nuclear magnetic resonance.


2019 ◽  
Vol 6 (1) ◽  
Author(s):  
Evgenia Uglova ◽  
Eugene Eremenko ◽  
Natalya Sikachyova ◽  
Kiril Kuzin

To increase the adhesion strength (wetting ability) of bitumen, and, consequently, reduce the likelihood of premature occurrence of defects formed on asphalt concrete coatings, it is necessary to use various kinds of surfactants that increase the adhesion ability of bitumen. Adhesive additives to road bitumens increase the mobility of the organic binder, help reduce the number of uncoated grains of mineral material, which facilitates the compaction of asphalt concrete mix. One of the problems of durability of asphalt concrete pavements is the lack of strong adhesion of the bitumen film to the surface of the mineral material. To increase this strength, various adhesive additives are used, which affect not only the adhesive properties of bitumen, but also its physical and chemical properties. The main task of the work is aimed at solving the issues of the influence of adhesive additives on the physicochemical properties of organic binders used in road construction. The quality assessment of the modified bitumen was carried out according to GOST 22245-90, which, at present, is guided by the selection of the composition of the asphalt concrete mixture. As a result of the study, effective adhesive additives were identified that contribute to the minimal change in the physicochemical properties of viscous road bitumen and possess thermal stability under prolonged exposure to elevated temperatures. Studies have shown that almost all adhesive additives not only improve the adhesive properties of organic binders to mineral materials, but also can alter and even worsen the physicochemical properties of the original organic binder, which can adversely affect the properties of asphalt concrete. The study used the original bitumen from only one manufacturer and the negative effect of adhesive additives may be due to the incompatible chemical composition of the adhesive additive with the group composition of bitumen and the mineralogical composition of the mineral material.


2013 ◽  
Vol 652-654 ◽  
pp. 765-769
Author(s):  
Qing Wang Liu ◽  
Yun Hai Zhu ◽  
Guang Zhi Han ◽  
Zhen Zhong Fan ◽  
Ji Gang Wang ◽  
...  

A cationic Gemini surfactant ethane-1, 2-bis (Cetyl dimethyl brominated ammonium), denoted 16-2-16 was synthesized from ethane and Hexadecyl dimethyl amine. The properties of the product were characterized, and the physical and chemical properties were determined. The results showed that the synthetic product was the target product, and its surface tension was 3.4×10-4N/m, and the CMC was 2.2×10-4mol/L at 25°C. At the same time, its synergistic effect with common surfactants was studied; the results showed that the synthetic product had good synergic effect.


2019 ◽  
Vol 1 (1) ◽  
Author(s):  
Qing Liao ◽  
Tingting Song

In the development of modern society, many new materials and technologies have been integrated into the development of various industries. As a new type of two-dimensional carbon nanomaterials, graphene has great advantages in physical and chemical properties and is widely used in various fields of development. Among them, the electrochemical method is one of the important ways to prepare graphene materials, which has the characteristics of quickness and environmental protection, and can effectively produce a large amount of high-quality graphene and its composite materials. Based on this, the paper introduces the preparation method of graphene materials and studies the application of graphene materials in the field of electrochemistry.


2022 ◽  
Author(s):  
K.G. Pugin

Abstract. Premature destruction of asphalt concrete can be caused by the aging of bitumen, which is associated with a change in the physical and chemical properties of bitumen. The article shows that in most cases, the improvement of the characteristics of asphalt concrete is achieved through the introduction of additives that affect the basic properties of the bituminous binder, such as penetration, softening temperature, viscosity. The influence of the chemical composition of the mineral filler on the rate of bitumen aging has been experimentally proved. The obtained research data show that the increase in the rate of aging of bitumen is influenced by the compounds of silicon and aluminum. On the other hand, metals such as iron and titanium contribute to the preservation of the initial plasticity of bitumen, and the accumulation of asphaltenes in the structure of the bitumen-mineral mixture slows down.


2011 ◽  
Vol 239-242 ◽  
pp. 1376-1381 ◽  
Author(s):  
Jian Jun Li ◽  
Ying Meng ◽  
Yan Chun Liu

By deeply analyzing and studying the physical and chemical properties of Lueyang’s basalt fiber, its characteristics such as the chemical components, the crystallization’s upper limit temperature and lower limit temperature during the melting process, and the the viscosity and temperature change during melting process are verified to provide theoretical bases for the industrial production of a new type composite materials, and meanwhile to offer grounds for the development of a new generation of composite fiber materials.


1966 ◽  
Vol 24 ◽  
pp. 101-110
Author(s):  
W. Iwanowska

In connection with the spectrophotometric study of population-type characteristics of various kinds of stars, a statistical analysis of kinematical and distribution parameters of the same stars is performed at the Toruń Observatory. This has a twofold purpose: first, to provide a practical guide in selecting stars for observing programmes, second, to contribute to the understanding of relations existing between the physical and chemical properties of stars and their kinematics and distribution in the Galaxy.


2017 ◽  
pp. 31-43
Author(s):  
Berta Ratilla ◽  
Loreme Cagande ◽  
Othello Capuno

Organic farming is one of the management strategies that improve productivity of marginal uplands. The study aimed to: (1) evaluate effects of various organic-based fertilizers on the growth and yield of corn; (2) determine the appropriate combination for optimum yield; and (3) assess changes on the soil physical and chemical properties. Experiment was laid out in Randomized Complete Block Design, with 3 replications and 7 treatments, namely; T0=(0-0-0); T1=1t ha-1 Evans + 45-30-30kg N, P2O5, K2O ha-1; T2=t ha-1 Wellgrow + 45-30-30kg N, P2O5, K2O ha-1; T3=15t ha-1 chicken dung; T4=10t ha-1 chicken dung + 45-30-30kg N, P2O5, K2O ha-1; T5=15t ha-1 Vermicast; and T6=10t ha-1 Vermicast + 45-30-30kg N, P2O5, K2O ha-1. Application of organic-based fertilizers with or without inorganic fertilizers promoted growth of corn than the control. But due to high infestation of corn silk beetle(Monolepta bifasciata Horns), its grain yield was greatly affected. In the second cropping, except for Evans, any of these fertilizers applied alone or combined with 45-30-30kg N, P2O5, K2O ha-1 appeared appropriate in increasing corn earyield. Soil physical and chemical properties changed with addition of organic fertilizers. While bulk density decreased irrespective of treatments, pH, total N, available P and exchangeable K generally increased more with chicken dung application.


Sign in / Sign up

Export Citation Format

Share Document