Investigation on Bioactivity of Zirconium-Calcium Coatings on Titanium Surface Obtained by Sol-Gel and Electrophoretic Deposition (EPD) Methods

2016 ◽  
Vol 687 ◽  
pp. 65-70
Author(s):  
Elżbieta Długoń ◽  
Marzena Szymańska ◽  
Magdalena Leśniak ◽  
Piotr Jeleń ◽  
Wiktor Niemiec ◽  
...  
Keyword(s):  
Raman Spectroscopy ◽  
Phase Composition ◽  
Electron Microscope ◽  
Body Fluid ◽  
Titanium Surface ◽  
Sol Gel ◽  
X Ray ◽  
Atomic Force ◽  
Scanning Electron

The aim of the study was to obtain zirconium and calcium doped zirconium coatings using sol-gel methodology and their further modification with electrophoretically deposited hydroxyapatite. Both systems phase composition was investigated using Raman spectroscopy. Their morphology and composition was studied using scanning electron microscope (SEM) with X-ray microanalysis (EDS), while their topography was observed using atomic force microscope (AFM). The osseointegrative properties of both coatings were investigated using in vitro Simulated Body Fluid (SBF) test. The resulting systems were studied using the same methods that were applied to the two coatings.

Effect of Sr on the Bioactivity of Sol-Gel Derived New Silicate Bioglass S55P4

2020 ◽  
Vol 1010 ◽  
pp. 613-619
Author(s):  
Thet Swe Thet ◽  
Hasmaliza M. Mohamad ◽  
Khairul Anuar Shariff
Keyword(s):  
Electron Microscope ◽  
Calcium Phosphate ◽  
Sol Gel ◽  
Apatite Formation ◽  
Sem Images ◽  
X Ray ◽  
Low Crystalline ◽  
Crystalline Peak ◽  
Scanning Electron

Strontium (Sr) stimulates osteoblast and inhibits osteoclast activities in-vitro and is used clinically as a treatment for osteoporosis. In this research, the effect of Sr substitution on the apatite formation of sol-gel derived bioactive glass (BG) (55.90SiO2-1.72P2O5 -21.67Na2O - (20.69-x) CaO -x SrO) (x=0, 5 and 8 mol. %) were investigated. The synthesized Sr doped BG samples were treated in Hank's Balanced Salt Solution (HBSS) for 14 days to study the bioactivity. The achieved samples were evaluated by X-ray powder diffraction (XRD) and Scanning electron microscope (SEM). In XRD, the hydroxyapatite (HA) crystalline peak for 8% Sr-BG is less compared with others. When Sr amount is increased to 8%, the low crystalline peaks of HA were detected although the same soaking duration. FTIR spectra supported the delay precipitation of calcium phosphate (CaP), especially for the specimen containing 8% Sr. After 14 days soaking, SEM images confirmed the bioactivity of the synthesized samples by the formation of apatite on the glass surface.

PENGGUNAAN TiO2 PARTIKEL NANO HASIL SINTESIS BERBASIS AIR MENGGUNAKAN METODA SOL-GEL PADA BAHAN KAPAS SEBAGAI APLIKASI UNTUK TEKSTIL ANTI UV

Arena Tekstil ◽  
2013 ◽  
Vol 28 (1) ◽  
Author(s):  
Maya Komalasari ◽  
Bambang Sunendar
Keyword(s):  
Fourier Transform ◽  
Electron Microscope ◽  
Scanning Electron Microscope ◽  
Sol Gel ◽  
Crosslinking Agent ◽  
X Ray Diffraction ◽  
Nano Tio2 ◽  
X Ray ◽  
Infra Red ◽  
Scanning Electron

Partikel nano TiO2 berbasis air dengan pH basa telah berhasil disintesis dengan menggunakan metode sol-gel dan diimobilisasi pada kain kapas dengan menggunakan kitosan sebagai zat pengikat silang. Sintesis dilakukan  dengan prekursor TiCl4 pada konsentrasi 0,3 M, 0,5 M dan 1 M, dan menggunakan templat kanji dengan proses kalsinasi pada suhu 500˚C selama 2 jam. Partikel nano TiO2 diaplikasikan ke kain kapas dengan metoda pad-dry-cure dan menggunakan kitosan sebagai crosslinking agent. Berdasarkan hasil Scanning Electron Microscope (SEM),diketahui bahwa morfologi partikel TiO2 berbentuk spherical dengan ukuran nano (kurang dari 100 nm). Karakterisasi X-Ray Diffraction (XRD) menunjukkan adanya tiga tipe struktur kristal utama, yaitu (100), (101) dan (102) dengan fasa kristal yang terbentuk adalah anatase dan rutile. Pada karakterisasi menggunakan SEM terhadap serbuk dari TiO2 yang telah diaplikasikan ke permukaan kain kapas, terlihat adanya imobilisasi partikel nano TiO2 melalui ikatan hidrogen silang dengan kitosan pada kain kapas. Hasil analisa tersebut kemudian dikonfirmasi dengan FTIR (Fourier Transform Infra Red) yang hasilnya memperlihatkan puncak serapan pada bilangan gelombang 3495 cm-1, 2546 cm-1, dan 511 cm-1,  yang masing-masing diasumsikan sebagai adanya vibrasi gugus fungsi O-H, N-H dan Ti-O-Ti. Hasil SEM menunjukkan pula bahwa kristal nano yang terbentuk diantaranya adalah fasa rutile , yang berdasarkan literatur terbukti dapatberfungsi sebagai anti UV.

Effect of Dip-Coating Cycle on Some Physical Properties of Cu2NiSnS4 Thin Films for Photovoltaic Applications

2021 ◽  
Author(s):  
Ahmed ZITI ◽  
Bouchaib HARTITI ◽  
Amine BELAFHAILI ◽  
Hicham LABRIM ◽  
Salah FADILI ◽  
...  
Keyword(s):  
Thin Films ◽  
Electron Microscope ◽  
Scanning Electron Microscope ◽  
Sol Gel ◽  
Dip Coating ◽  
Visible Spectroscopy ◽  
X Ray ◽  
Uv Visible ◽  
The Impact ◽  
Scanning Electron

Abstract Quaternary semiconductor Cu2NiSnS4 thin film was made by the sol-gel method associated to dip-coating technique on ordinary glass substrates. In this paper, we have studied the impact of dip-coating cycle at different cycles: 4, 5 and 6 on the structural, compositional, morphological, optical and electrical characteristics. CNTS thin films have been analyzed by various characterization techniques including: X-ray diffractometer (XRD), Raman measurements, scanning electron microscope (SEM), energy dispersive X-ray spectroscope (EDS), UV-visible spectroscopy and four-point probe method. XRD spectra demonstrated the formation of cubic Cu2NiSnS4 with privileged orientation at (111) plane. Crystallite size of cubic CNTS thin films increase with from 6.30 to 9.52 with dip-coating cycle augmented. Raman scattering confirmed the existence of CNTS thin films by Raman vibrational mode positioned at 332 cm− 1. EDS investigations showed near-stoichiometry of CNTS sample deposited at 5 cycles. Scanning electron microscope showed uniform surface morphologies without any crack. UV-visible spectroscopy indicated that the optical absorption values are larger than 104 cm− 1, Estimated band gap energy of CNTS absorber layers decrease from 1.64 to 1.5 eV with dip-coating cycle increased. The electrical conductivity of CNTS thin films increase from 0.19 to 4.16 (Ω cm)-1. These characteristics are suitable for solar cells applications.

scholarly journals The influence of metahalloysite addition on tobermorite formation studied by X-ray powder diffraction and scanning electron microscope

2018 ◽  
Vol 163 ◽  
pp. 05008
Author(s):  
Anna Skawińska
Keyword(s):  
Phase Composition ◽  
Electron Microscope ◽  
Scanning Electron Microscope ◽  
Hydrothermal Treatment ◽  
Powder Diffraction ◽  
Quartz Sand ◽  
Raw Material ◽  
Model Systems ◽  
X Ray ◽  
Scanning Electron

This paper presents the results of the studies carried out in the model systems and concerning the tobermorite synthesis with an addition of metahalloysite. Quartz sand and quicklime were the main raw material constituents. The mixtures in the form of slurries underwent hydrothermal treatment with an addition of metahalloysite (5%, 10%, 15%, 20% and 30%) for 4 hours and 12 hours. The resultant composites were analysed for their phase composition using X-ray powder diffraction. The microstructure was examined using the Scanning Electron Microscope. Tobermorite was the principle reaction product. When 30% metahalloysite was added to the mixture containing CaO and SiO2, the formation of katoite was found.

Synthesis and Characterization of Y2O3 Nanoflowers

2012 ◽  
Vol 465 ◽  
pp. 76-79 ◽  
Author(s):  
Shuang Zhan ◽  
Xia Li
Keyword(s):  
Fourier Transform ◽  
Phase Composition ◽  
Electron Microscope ◽  
Synthesis And Characterization ◽  
The Novel ◽  
X Ray Diffraction ◽  
Facile Hydrothermal Method ◽  
X Ray ◽  
Scanning Electron

The novel Y2O3 nanoflowers were synthesized through a facile hydrothermal method without using any catalyst or template. The phase composition and the microstructure of as-prepared products were characterized by field emission scanning electron microscope (FE-SEM), X-ray diffraction (XRD) as well as Fourier transform infrared spectrum. The formation mechanism for the Y2O3 flowers has been proposed.

Bioactive Composite Materials for Bone Tissue Applications

2006 ◽  
Vol 514-516 ◽  
pp. 985-989
Author(s):  
B.J.M. Leite Ferreira ◽  
M.G.G.M. Duarte ◽  
M. Helena Gil ◽  
Rui N. Correia ◽  
J. Román ◽  
...  
Keyword(s):  
Electron Microscopy ◽  
Bone Tissue ◽  
Tissue Repair ◽  
Body Fluid ◽  
In Vitro Bioactivity ◽  
X Ray Diffraction ◽  
X Ray ◽  
Biodegradable Composite ◽  
Scanning Electron

Two materials with potential application in bone tissue repair have been developed: 1) a non-biodegradable composite based in a new methacrylic-co-acrylic matrix; and 2) a biodegradable composite based in a chitosan (Ch) matrix. Both matrices were reinforced with glass-ceramic particles of composition (mol%) 70 SiO2 – 30 CaO. The in vitro bioactivity of composites was assessed by soaking in simulated body fluid (SBF) for periods of up to 7 days at 37º C. X-ray diffraction (XRD) and scanning electron microscopy coupled with X-ray energy dispersive spectroscopy (SEM-EDS) were used for deposit identification after different soaking periods. Calcium phosphate particulate deposits were detected after 3 days of immersion, followed by growth and maturation towards apatite.

Biomorphic SiC Prepared from Carbonized Millet by Sol-Gel and Carbothermal Reduction Processing

2010 ◽  
Vol 152-153 ◽  
pp. 1683-1686
Author(s):  
Qing Wang ◽  
Ya Hui Zhang
Keyword(s):  
Electron Microscopy ◽  
Scanning Electron Microscopy ◽  
Silicon Carbide ◽  
Phase Composition ◽  
Carbothermal Reduction ◽  
Sol Gel ◽  
X Ray Diffraction ◽  
X Ray ◽  
Carbon Template ◽  
Scanning Electron

Biomorphic silicon carbide (bioSiC) was prepared by high temperature pyrolysis and sol-gel and carbothermal reduction processing at 1600 oC. The morphology and microstructure of carbon-silica composites and purified bioSiC samples were characterized by scanning electron microscopy. The phase composition of the resulting sample was analyzed by X-ray diffraction. The results suggest that the bioSiC mainly consists of cubic ß-SiC, and principally replicates the shape and microstructure of the carbon template.

Biomorphic TiO2 Ceramics Prepared from Cotton Stalk

2012 ◽  
Vol 602-604 ◽  
pp. 526-529
Author(s):  
Qing Wang ◽  
Lin Zhang ◽  
Ya Hui Zhang
Keyword(s):  
Electron Microscopy ◽  
Scanning Electron Microscopy ◽  
Phase Composition ◽  
High Temperature ◽  
Sol Gel ◽  
Cotton Stalk ◽  
X Ray Diffraction ◽  
X Ray ◽  
Carbon Template ◽  
Scanning Electron

Biomorphic TiO2 was prepared by high temperature pyrolysis and a modified sol-gel route. The morphology and microstructure of TiO2 samples were characterized by scanning electron microscopy. The phase composition of the resulting sample was analyzed by X-ray diffraction. The results suggest that the biomorphic TiO2 mainly consists of rutile TiO2, and replicates the shape and part microstructure of the carbon template.

Sign in / Sign up

Export Citation Format

Share Document