scholarly journals Corrigendum to "A new approach to mapping permafrost and change incorporating uncertainties in ground conditions and climate projections" published in The Cryosphere, 8, 2177–2194, 2014

2014 ◽  
Vol 8 (6) ◽  
pp. 2253-2253
Author(s):  
Y. Zhang ◽  
I. Olthof ◽  
R. Fraser ◽  
S. A. Wolfe

2014 ◽  
Vol 8 (6) ◽  
pp. 2177-2194 ◽  
Author(s):  
Y. Zhang ◽  
I. Olthof ◽  
R. Fraser ◽  
S. A. Wolfe

Abstract. Spatially detailed information on permafrost distribution and change with climate is important for land use planning, infrastructure development, and environmental assessments. However, the required soil and surficial geology maps in the North are coarse, and projected climate scenarios vary widely. Considering these uncertainties, we propose a new approach to mapping permafrost distribution and change by integrating remote sensing data, field measurements, and a process-based model. Land cover types from satellite imagery are used to capture the general land conditions and to improve the resolution of existing permafrost maps. For each land cover type, field observations are used to estimate the probabilities of different ground conditions. A process-based model is used to quantify the evolution of permafrost for each ground condition under three representative climate scenarios (low, medium, and high warming). From the model results, the probability of permafrost occurrence and the most likely permafrost conditions are determined. We apply this approach at 20 m resolution to a large area in Northwest Territories, Canada. Mapped permafrost conditions are in agreement with field observations and other studies. The data requirements, model robustness, and computation time are reasonable, and this approach may serve as a practical means to mapping permafrost and changes at high resolution in other regions.


2014 ◽  
Vol 8 (2) ◽  
pp. 1895-1935 ◽  
Author(s):  
Y. Zhang ◽  
I. Olthof ◽  
R. Fraser ◽  
S. A. Wolfe

Abstract. Spatially detailed information on permafrost distribution and change with climate is important for land-use planning and for environmental and ecological assessments. However, the required soil and surficial geology maps in the north are coarse, and projected climate scenarios vary widely. Considering these uncertainties, we propose a new approach to mapping permafrost distribution and change by integrating remote sensing data, field measurements, and a process-based model. Land-cover types from satellite imagery are used to capture the general land conditions and to improve the resolution of existing permafrost maps. For each land-cover type, field observations are used to estimate the probability of different ground conditions. A process-based model is used to quantify the evolution of permafrost for each ground condition under three representative climate scenarios (low, medium and high warming). From the model results, the probability of permafrost occurrence and the most likely permafrost conditions are determined. We apply this approach at 20 m resolution to a large area in Northwest Territories, Canada. Mapped permafrost conditions are in agreement with field observations and other studies. The data requirements, model robustness and computation time are reasonable, and this approach may serve as a practical means to mapping permafrost and changes at high resolution in other regions.


2014 ◽  
Vol 5 (4) ◽  
pp. 526-539 ◽  
Author(s):  
Daniel Lash ◽  
Sarah Ward ◽  
Tristan Kershaw ◽  
David Butler ◽  
Matthew Eames

Rainwater harvesting (RWH) systems are increasingly being implemented in buildings. It is common in the UK for simple RWH tank sizing methods to be utilised, and these do not consider future climate change. This paper describes the development of a tool, which integrates elements of basic and detailed sizing approaches from the British Standard for RWH, with the latest probabilistic UK Climate Projections data. The method was initially applied to the design of a university building in Cornwall, UK. The methodology utilises 3,000 equi-probable rainfall patterns for tank sizing for each time period. Results indicate that, to ensure that it is ‘likely’ that the same non-potable demand could be met in 2080 as in the present, a tank 112% larger would be required. This increases to a 225% over-sizing for a ‘very likely’ probability of meeting the same level of non-potable demand. The same RWH system design was then assessed for three further UK locations with different rainfall characteristics. From these assessments, a simplified method was developed to enable practitioners to size RWH system tanks for current and future climates. The method provides a new approach to meet present and future non-potable demands, while preventing excessive over-sizing of tanks.


1999 ◽  
Vol 173 ◽  
pp. 185-188
Author(s):  
Gy. Szabó ◽  
K. Sárneczky ◽  
L.L. Kiss

AbstractA widely used tool in studying quasi-monoperiodic processes is the O–C diagram. This paper deals with the application of this diagram in minor planet studies. The main difference between our approach and the classical O–C diagram is that we transform the epoch (=time) dependence into the geocentric longitude domain. We outline a rotation modelling using this modified O–C and illustrate the abilities with detailed error analysis. The primary assumption, that the monotonity and the shape of this diagram is (almost) independent of the geometry of the asteroids is discussed and tested. The monotonity enables an unambiguous distinction between the prograde and retrograde rotation, thus the four-fold (or in some cases the two-fold) ambiguities can be avoided. This turned out to be the main advantage of the O–C examination. As an extension to the theoretical work, we present some preliminary results on 1727 Mette based on new CCD observations.


Author(s):  
V. Mizuhira ◽  
Y. Futaesaku

Previously we reported that tannic acid is a very effective fixative for proteins including polypeptides. Especially, in the cross section of microtubules, thirteen submits in A-tubule and eleven in B-tubule could be observed very clearly. An elastic fiber could be demonstrated very clearly, as an electron opaque, homogeneous fiber. However, tannic acid did not penetrate into the deep portion of the tissue-block. So we tried Catechin. This shows almost the same chemical natures as that of proteins, as tannic acid. Moreover, we thought that catechin should have two active-reaction sites, one is phenol,and the other is catechole. Catechole site should react with osmium, to make Os- black. Phenol-site should react with peroxidase existing perhydroxide.


Author(s):  
K. Chien ◽  
R. Van de Velde ◽  
I.P. Shintaku ◽  
A.F. Sassoon

Immunoelectron microscopy of neoplastic lymphoma cells is valuable for precise localization of surface antigens and identification of cell types. We have developed a new approach in which the immunohistochemical staining can be evaluated prior to embedding for EM and desired area subsequently selected for ultrathin sectioning.A freshly prepared lymphoma cell suspension is spun onto polylysine hydrobromide- coated glass slides by cytocentrifugation and immediately fixed without air drying in polylysine paraformaldehyde (PLP) fixative. After rinsing in PBS, slides are stained by a 3-step immunoperoxidase method. Cell monolayer is then fixed in buffered 3% glutaraldehyde prior to DAB reaction. After the DAB reaction step, wet monolayers can be examined under LM for presence of brown reaction product and selected monolayers then processed by routine methods for EM and embedded with the Chien Re-embedding Mold. After the polymerization, the epoxy blocks are easily separated from the glass slides by heatingon a 100°C hot plate for 20 seconds.


Author(s):  
W. A. Chiou ◽  
N. Kohyama ◽  
B. Little ◽  
P. Wagner ◽  
M. Meshii

The corrosion of copper and copper alloys in a marine environment is of great concern because of their widespread use in heat exchangers and steam condensers in which natural seawater is the coolant. It has become increasingly evident that microorganisms play an important role in the corrosion of a number of metals and alloys under a variety of environments. For the past 15 years the use of SEM has proven to be useful in studying biofilms and spatial relationships between bacteria and localized corrosion of metals. Little information, however, has been obtained using TEM capitalizing on its higher spacial resolution and the transmission observation of interfaces. The research presented herein is the first step of this new approach in studying the corrosion with biological influence in pure copper.Commercially produced copper (Cu, 99%) foils of approximately 120 μm thick exposed to a copper-tolerant marine bacterium, Oceanospirillum, and an abiotic culture medium were subsampled (1 cm × 1 cm) for this study along with unexposed control samples.


Author(s):  
Arthur V. Jones

With the introduction of field-emission sources and “immersion-type” objective lenses, the resolution obtainable with modern scanning electron microscopes is approaching that obtainable in STEM and TEM-but only with specific types of specimens. Bulk specimens still suffer from the restrictions imposed by internal scattering and the need to be conducting. Advances in coating techniques have largely overcome these problems but for a sizeable body of specimens, the restrictions imposed by coating are unacceptable.For such specimens, low voltage operation, with its low beam penetration and freedom from charging artifacts, is the method of choice.Unfortunately the technical dificulties in producing an electron beam sufficiently small and of sufficient intensity are considerably greater at low beam energies — so much so that a radical reevaluation of convential design concepts is needed.The probe diameter is usually given by


1968 ◽  
Vol 32 (3) ◽  
pp. 279-282
Author(s):  
JI Mock ◽  
JW Grenfell ◽  
WA Richter
Keyword(s):  

1969 ◽  
Vol 34 (2) ◽  
pp. 176-176

In the November 1968 issue of this journal, Margaret M. Martyn’s name was misspelled Martin on page 315. In the same issue, page 325, column 2 (Jerger, Speaks, and Trammell, “A New Approach to Speech Audiometry”), the sentence reading “Whenever the loss is sloping, however, the PB area underestimates and the SSI area overestimates the amount of handicap” should read as follows: “Whenever the loss is sloping, however, the PB area overestimates and the SSI area underestimates the amount of the handicap.”


Sign in / Sign up

Export Citation Format

Share Document