scholarly journals Sox9+ messenger cells orchestrate large-scale skeletal regeneration in the mammalian rib

eLife ◽  
2019 ◽  
Vol 8 ◽  
Author(s):  
Stephanie T Kuwahara ◽  
Maxwell A Serowoky ◽  
Venus Vakhshori ◽  
Nikita Tripuraneni ◽  
Neel V Hegde ◽  
...  
Keyword(s):  
Bone Regeneration ◽  
Hedgehog Signaling ◽  
Large Scale ◽  
Callus Formation ◽  
Editorial Note ◽  
Scale Regeneration ◽  
Regenerative Ability ◽  
Skeletal Regeneration ◽  
Large Bone ◽  
Unknown Signal

Most bones in mammals display a limited capacity for natural large-scale repair. The ribs are a notable exception, yet the source of their remarkable regenerative ability remains unknown. Here, we identify a Sox9-expressing periosteal subpopulation that orchestrates large-scale regeneration of murine rib bones. Deletion of the obligate Hedgehog co-receptor, Smoothened, in Sox9-expressing cells prior to injury results in a near-complete loss of callus formation and rib bone regeneration. In contrast to its role in development, Hedgehog signaling is dispensable for the proliferative expansion of callus cells in response to injury. Instead, Sox9-positive lineage cells require Hh signaling to stimulate neighboring cells to differentiate via an unknown signal into a skeletal cell type with dual chondrocyte/osteoblast properties. This type of callus cell may be critical for bridging large bone injuries. Thus despite contributing to only a subset of callus cells, Sox9-positive progenitors play a major role in orchestrating large-scale bone regeneration.Editorial note: This article has been through an editorial process in which the authors decide how to respond to the issues raised during peer review. The Reviewing Editor's assessment is that all the issues have been addressed (<xref ref-type="decision-letter" rid="SA1">see decision letter</xref>).

Decellularized bone extracellular matrix in skeletal tissue engineering

2020 ◽  
Vol 48 (3) ◽  
pp. 755-764
Author(s):  
Benjamin B. Rothrauff ◽  
Rocky S. Tuan
Keyword(s):  
Tissue Engineering ◽  
Bone Regeneration ◽  
Tissue Regeneration ◽  
Animal Studies ◽  
Tumor Resection ◽  
Regenerative Capacity ◽  
Skeletal Tissue ◽  
Large Bone

Bone possesses an intrinsic regenerative capacity, which can be compromised by aging, disease, trauma, and iatrogenesis (e.g. tumor resection, pharmacological). At present, autografts and allografts are the principal biological treatments available to replace large bone segments, but both entail several limitations that reduce wider use and consistent success. The use of decellularized extracellular matrices (ECM), often derived from xenogeneic sources, has been shown to favorably influence the immune response to injury and promote site-appropriate tissue regeneration. Decellularized bone ECM (dbECM), utilized in several forms — whole organ, particles, hydrogels — has shown promise in both in vitro and in vivo animal studies to promote osteogenic differentiation of stem/progenitor cells and enhance bone regeneration. However, dbECM has yet to be investigated in clinical studies, which are needed to determine the relative efficacy of this emerging biomaterial as compared with established treatments. This mini-review highlights the recent exploration of dbECM as a biomaterial for skeletal tissue engineering and considers modifications on its future use to more consistently promote bone regeneration.

scholarly journals Potential Implantable Nanofibrous Biomaterials Combined with Stem Cells for Subchondral Bone Regeneration

Materials ◽  
2020 ◽  
Vol 13 (14) ◽  
pp. 3087
Author(s):  
Rana Smaida ◽  
Luc Pijnenburg ◽  
Silvia Irusta ◽  
Erico Himawan ◽  
Gracia Mendoza ◽  
...  
Keyword(s):  
Stem Cells ◽  
Bone Regeneration ◽  
Subchondral Bone ◽  
Therapeutic Potential ◽  
Sodium Hyaluronate ◽  
Vinyl Pyrrolidone ◽  
Regenerative Ability ◽  
Poly Vinyl Pyrrolidone

The treatment of osteochondral defects remains a challenge. Four scaffolds were produced using Food and Drug Administration (FDA)-approved polymers to investigate their therapeutic potential for the regeneration of the osteochondral unit. Polycaprolactone (PCL) and poly(vinyl-pyrrolidone) (PVP) scaffolds were made by electrohydrodynamic techniques. Hydroxyapatite (HAp) and/or sodium hyaluronate (HA) can be then loaded to PCL nanofibers and/or PVP particles. The purpose of adding hydroxyapatite and sodium hyaluronate into PCL/PVP scaffolds is to increase the regenerative ability for subchondral bone and joint cartilage, respectively. Human bone marrow-derived mesenchymal stem cells (hBM-MSCs) were seeded on these biomaterials. The biocompatibility of these biomaterials in vitro and in vivo, as well as their potential to support MSC differentiation under specific chondrogenic or osteogenic conditions, were evaluated. We show here that hBM-MSCs could proliferate and differentiate both in vitro and in vivo on these biomaterials. In addition, the PCL-HAp could effectively increase the mineralization and induce the differentiation of MSCs into osteoblasts in an osteogenic condition. These results indicate that PCL-HAp biomaterials combined with MSCs could be a beneficial candidate for subchondral bone regeneration.

scholarly journals Leucocyte- and Platelet-Rich Fibrin Block: Its Use for the Treatment of a Large Cyst with Implant-Based Rehabilitation

Medicina ◽  
2021 ◽  
Vol 57 (2) ◽  
pp. 180 ◽  
Author(s):  
Rodolfo Mauceri ◽  
Denise Murgia ◽  
Orazio Cicero ◽  
Luigi Paternò ◽  
Luca Fiorillo ◽  
...  
Keyword(s):  
Bone Regeneration ◽  
Bone Defect ◽  
Bone Healing ◽  
Bone Substitute ◽  
Alveolar Bone ◽  
Critical Size ◽  
Large Bone ◽  
Alveolar Bone Defect ◽  
Positive Results ◽  
Autologous Platelet

The management of critical-size bone defects is still demanding. Recently, autologous platelet concentrates in combination with bone substitute have been applied and reported in a few studies. Our aim is to report the healing of a critical-size alveolar bone defect treated with a new bone regeneration technique by means of L-PRF and L-PRF blocks. A 45-year-old woman presented a large cystic lesion; the extraction of three teeth, a cyst removal procedure, and bone regeneration procedures with L-PRF and L-PRF blocks were planned. The L-PRF block was prepared by mixing a bone substitute with a piece of L-PRF membrane and liquid fibrinogen. Additionally, after bone healing an implant-based rehabilitation was optimally performed. On the basis of the positive results, in terms of bone healing and tissue regeneration in a large bone defect, the application of L-PRF and L-PRF blocks, in agreement with the scarce literature, is suggested as a feasible procedure in selected cases.

scholarly journals Treatment possibilities of jaws bone defects: A case report

2010 ◽  
Vol 57 (1) ◽  
pp. 49-53
Author(s):  
Nenad Tanaskovic ◽  
Sinisa Ristic ◽  
Miroslav Lucic
Keyword(s):  
Bone Regeneration ◽  
Bone Destruction ◽  
Bone Defects ◽  
Significant Loss ◽  
Bone Augmentation ◽  
Surrounding Soft Tissue ◽  
Prosthetic Reconstruction ◽  
Previous Trauma ◽  
Large Bone ◽  
Large Bone Defects

Large bone defects in the jaws can occur as a result of previous trauma, tumor or bone destruction caused by infection. Significant loss of bone volume also may be caused by premature loss of teeth, application of inadequate extraction technique, periodontitis or trauma caused by incorrect prosthetic reconstruction. Very few of these defects are treated using materials for bone augmentation or regeneration in order to preserve the total volume of bone. Depending on the size of a defect, spontaneous bone regeneration of untreated defects is limited by proliferation of surrounding soft tissue. Bone replacement by connective tissue leads to loss of stability, reduces function and disturbs anatomical form of the jaws. The aim of the study was to present a case from clinical praxis which demonstrates bone regeneration provided by bone substitute or its combination with bone grafts.

Strategies for inclusion of growth factors into 3D printed bone grafts

2021 ◽  
Author(s):  
Alessia Longoni ◽  
Jun Li ◽  
Gabriella C.J. Lindberg ◽  
Jelena Rnjak-Kovacina ◽  
Lyn M. Wise ◽  
...  
Keyword(s):  
Growth Factors ◽  
Bone Regeneration ◽  
New Technologies ◽  
Healing Process ◽  
Bone Grafts ◽  
Biological Properties ◽  
3 Dimensional ◽  
3D Printed ◽  
Physical And Chemical ◽  
Large Bone

Abstract There remains a critical need to develop new technologies and materials that can meet the demands of treating large bone defects. The advancement of 3-dimensional (3D) printing technologies has allowed the creation of personalized and customized bone grafts, with specific control in both macro- and micro-architecture, and desired mechanical properties. Nevertheless, the biomaterials used for the production of these bone grafts often possess poor biological properties. The incorporation of growth factors (GFs), which are the natural orchestrators of the physiological healing process, into 3D printed bone grafts, represents a promising strategy to achieve the bioactivity required to enhance bone regeneration. In this review, the possible strategies used to incorporate GFs to 3D printed constructs are presented with a specific focus on bone regeneration. In particular, the strengths and limitations of different methods, such as physical and chemical cross-linking, which are currently used to incorporate GFs to the engineered constructs are critically reviewed. Different strategies used to present one or more GFs to achieve simultaneous angiogenesis and vasculogenesis for enhanced bone regeneration are also covered in this review. In addition, the possibility of combining several manufacturing approaches to fabricate hybrid constructs, which better mimic the complexity of biological niches, is presented. Finally, the clinical relevance of these approaches and the future steps that should be taken are discussed.

scholarly journals Bone Regeneration Potential of Uncalcined and Unsintered Hydroxyapatite/Poly l-lactide Bioactive/Osteoconductive Sheet Used for Maxillofacial Reconstructive Surgery: An In Vivo Study

Materials ◽  
2019 ◽  
Vol 12 (18) ◽  
pp. 2931 ◽  
Author(s):  
Quang Ngoc Dong ◽  
Takahiro Kanno ◽  
Yunpeng Bai ◽  
Jingjing Sha ◽  
Katsumi Hideshima
Keyword(s):  
Bone Regeneration ◽  
Maxillofacial Surgery ◽  
Male Rats ◽  
Regeneration Ability ◽  
Sprague Dawley ◽  
Control Groups ◽  
Critical Size Defect ◽  
Hematoxylin And Eosin ◽  
Regenerative Ability

Uncalcined and unsintered hydroxyapatite/poly l-lactide (u-HA/PLLA) material has osteoconductive characteristics and is available for use as a maxillofacial osteosynthetic reconstruction device. However, its bone regeneration ability in the maxillofacial region has not been fully investigated. This study is the first to assess the bone regenerative potential of osteoconductive u-HA/PLLA material when it is used for repairing maxillofacial bone defects. A total of 21 Sprague-Dawley male rats were divided into three groups—the u-HA/PLLA, PLLA, or sham control groups. A critical size defect of 4 mm was created in the mandible of each rat. Then, the defect was covered with either a u-HA/PLLA or PLLA sheet on the buccal side. The rats in each group were sacrificed at 2, 4, or 8 weeks. The rats’ mandibles were sampled for histological analysis with hematoxylin and eosin staining, histomorphometry, and immunohistochemistry with Runx2 and osteocalcin (OCN) antibody. The amount of newly formed bone in the u-HA/PLLA group was significantly higher than that of the PLLA group. The expression of Runx2 and OCN in the u-HA/PLLA group was also significantly higher. These results demonstrate that the u-HA/PLLA material has excellent bone regenerative ability and confirm its applicability as a reconstructive device in maxillofacial surgery.

Sign in / Sign up

Export Citation Format

Share Document