Algorithm for quantifying the particle size distribution of non-metallic inclusions formation in steel production

When the quantitative characterization of non-metallic inclusions in steel is done and the effect of limiting factors is assessed, and based on that the possibility of reconstruction of the total content of non-metallic inclusions in steel is estimated, further considerations can be directed towards predicting the model of size distribution curve. The aim of this work is to establish relations on the basis of which it will be possible to quantify the content of non-metallic inclusions in extra-pure steels, when metallographic control is difficult or even impossible by routine procedures.

MODELLING OF VERTICAL SURFACES RADIATION IN CONNECTION WITH THE EVALUATION OF THE OBTRUSIVE LIGHT

The issue of the luminous flux radiation to the upper hemisphere is very broad and complex. The paper deals with the modelling of the vertical surface radiators. It presents an approach to unify the behaviour of these types of light sources. These will be understood as cosine radiators. If this cosine distribution curve is taken into account, then only the luminance and the light-active surface can be known to supplement the information about the radiation of such the light source. The luminance and radiated surface can be obtained relatively easily from real field measurements. The article presents the implementation of this data into lighting calculations and the creation of the distribution curves which are necessary for the radiation calculations of these surfaces. It also analyses the influence of the luminance and active areas on the radiated luminous flux and assign these values to the real radiators.

Effect of Aggregate Size on Recycled Aggregate Concrete under Equivalent Mortar Volume Mix Design

In this paper, the effect of the original aggregate size of the recycled aggregate on the mechanical properties of the recycled aggregate concrete was evaluated. A series of concretes were produced in which natural aggregates, recycled aggregates, and original aggregates in recycled aggregates were matched for a single particle size distribution curve. The replacement levels of recycled aggregate were 25% and 50%, and equivalent mortar volume mix design was applied for recycled aggregate concrete. The results show that the mechanical strength of recycled aggregate concrete increases with increasing original aggregate size. This effect was observed to be greater in concrete using recycled aggregate with a high residual mortar content.

Degradation of Red Blood Cell Deformability during Cold Storage in Blood Bags

RBC transfusions are a life-saving procedure, aiding both chronic and acute patients in restoring tissue oxygenation. The ability to store collected RBC units for prolonged periods has been one of the most transformative advances in medicine, significantly improving the reliability and the speed of access to blood. However, RBCs undergo a number of metabolic, structural, and biochemical changes during storage, collectively known as the storage lesion, that is detrimental to the quality of the RBC. A major challenge is the ability to evaluate the extent of the storage lesion, and thus the quality of the stored RBC unit directly prior to transfusion. The storage lesion can directly or indirectly reduce the ability of the RBC to deform through the small openings in the microvasculature. Rigid RBCs pose a risk of sequestration in capillaries, impeding blood flow and reducing tissue oxygenation, and are more likely to be cleared out by endothelial macrophages. Studies have shown that there is a loss in RBC deformability during storage and that the rate of RBC deformability loss is donor-dependent. Thus, RBC deformability can be a valuable and reliable biophysical marker of RBC unit quality. Currently, there is a need for a reliable measurement technique that is repeatable and sensitive enough to observe individual differences in RBC deformability in healthy donors, to enable quality control testing of RBC units. We have developed the microfluidic ratchet device, which sorts RBCs based on their deformability, allowing the measurement of both rigid and deformable sup-populations of RBCs within the sample, and generating a unique deformability curve. Here, we use this assay to predict the quality of stored RBC units. We assessed the deformability of 14 healthy donor RBC units through 8 weeks of cold storage at 4°C, which is 2 weeks beyond the Canadian Blood Services approved 6-week standard in Canada. We measured RBC deformability, standard hematological parameters (MCV, MCHC, MCH, and RDW), and hemolysis levels at the time of RBC unit manufacture (week 0), followed by weeks 2, 4, 6, and 8. The microfluidic ratchet device operates by forcing RBCs to deform and travel through rows of tapered constrictions. Constriction size changes from 7.5 to 1.5 µm and is reflective of the microvasculature and vessel opening sizes encountered by RBCs in circulation. RBCs are sorted into 12 distinct outlets based on their deformability. Distribution of RBCs in outlets 1-12 can be quantified and used to calculate the cumulative distribution curve. The cumulative distribution curve provides a distinct deformability signature of each individual RBC sample, which can be defined as rigidity score (RS). RS provides an easy metric to compare the changes in RBC deformability throughout storage (ΔRS) in a single donor as well as across multiple donors. We show that there are both donor- and sex-specific differences in the RBC deformability signatures of stored RBC units. We observed significant inter-donor variability in RBC deformability measured on the day of the RBC unit manufacture, where male donors showed a more stable RBC deformability range (n=8, RS=3.00±0.18) compared to female donors (n=6, RS= 3.29±0.48). The average RS scores were stable between weeks 0-2 (ΔRS 0.07) and showed a reduction in deformability between weeks 1-6 (ΔRS 0.35), with the greatest loss seen between weeks 6-8 (ΔRS 0.42) of cold storage. Interestingly, the response to cold storage is variable, with ΔRS 0.22 to 0.90, suggesting that some donors are more susceptible to storage related changes in RBC deformability than others. Notably, the change in RS over time was donor-specific and did not correlate with RBC deformability at week 0. The majority of RBCs from male donors (ΔRS 0.485, p<0.05), but none of the female donors (ΔRS 0.172) showed changes in deformability during cold storage, suggesting that RBCs from female donors degrade at a slower rate compared to RBCs from male donors. The ability to profile RBC deformability at the individual blood bag level may help identify more stable RBCs for use in chronic and sensitive patients, or RBC units that can be safely stored beyond the 6-week storage window. Disclosures No relevant conflicts of interest to declare.

Laser Surface Modification of Powder Metallurgy-Processed Ti-Graphite Composite Which Can Enhance Cells’ Osteo-Differentiation

The paper examines the surface functionalization of a new type of Ti-graphite composite, a dental biomaterial prepared by vacuum low-temperature extrusion of hydrogenated-dehydrogenated titanium powder mixed with graphite flakes. Two experimental surfaces were prepared by laser micromachining applying different levels of incident energy of the fiber nanosecond laser working at 1064 nm wavelength. The surface integrity of the machined surfaces was evaluated, including surface roughness parameters measurement by contact profilometry and confocal laser scanning microscopy. The chemical and phase composition were comprehensively evaluated by scanning electron microscopy, energy-dispersive X-ray spectroscopy and X-ray diffraction analyses. Finally, the in vitro tests using human mesenchymal stem cells were conducted to compare the influence of the laser processing parameters used on the cell’s cultivation and osteo-differentiation. The bioactivity results confirmed that the surface profile with positive kurtosis, platykurtic distribution curve and higher value of peaks spacing exhibited better bioactivity compared to the surface profile with negative kurtosis coefficient, leptokurtic distribution curve and lower peaks spacing.

Alternative Vaccination Politics

Background The timely implementation of the vaccination campaign and sharp rules for vaccine administration can make a difference. The paper investigates the impact of alternative policies based on scientific vaccination priorities inspired by the extended statistics on Covid-19 fatalities. Methods In the case of Covid-19 vaccination, a principal role is played by promptly adopting a reverse-order of age approach (to target first the elderly) coupled to covering the high priority categories but postponing the low priority ones. We implemented an in silico vaccination simulator capable of comparing what happened in reality with what might have happened if alternative vaccination policies had been adopted. The immunization profile and the death distribution curve allowed measuring the distance between reality and alternative policies and finally quantifying the expected number of saved lives. Results The alternative approach to vaccination was applied to Italy and Lombardy that host 60 and 10 million residents respectively. In about 100 days of vaccination based on (a) a reverse-order of age policy (from 90 + to 80–89 to 70–79 year-olds, etc.), (b) vaccination of priority categories, (c) postponement of non-priority categories and reallocation of such doses to (a) and (b), the saved lives would have been 3969 in Italy (of which 799 in Lombardy). In the same period, Italy suffered 30,911 fatalities (of which 5,613 in Lombardy). Of those fatalities, about 12.8% in Italy and 14.2% in Lombardy might have been avoided if a different approach to vaccination had been applied. Even better results would have been achieved if the elderly vaccination had been anticipated a few days (which started only 53 days after the very beginning of the Italian vaccination campaign) or if the vaccination engine had performed better in terms of daily administered doses while respecting the available delivered doses. Conclusions A different approach to the vaccination politics based on sharp and straight policies based on scientific quantitative data of Covid-19 mortality as a function of age and comorbidities would have accomplished a better quantitative effect on extinguishing the pandemic and containing the fatalities toll.