Studying of SiO2/capron nanocomposite as a gate dielectric film for improved threshold voltage

2019 ◽  
Vol 125 (4) ◽  
Author(s):  
Ali Bahari ◽  
Mahya Ghovati ◽  
Adeleh Hashemi
2018 ◽  
Vol 924 ◽  
pp. 482-485
Author(s):  
Min Seok Kang ◽  
Kevin Lawless ◽  
Bong Mook Lee ◽  
Veena Misra

We investigated the impact of an initial lanthanum oxide (La2O3) thickness and forming gas annealing (FGA) conditions on the MOSFET performance. The FGA has been shown to dramatically improve the threshold voltage (VT) stability of 4H-SiC MOSFETs. The FGA process leads to low VTshift and high field effect mobility due to reduction of the interface states density as well as traps by passivating the dangling bonds and active traps in the Lanthanum Silicate dielectrics. By optimizing the La2O3interfacial layer thickness and FGA condition, SiC MOSFETs with high threshold voltage and high mobility while maintaining minimal VTshift are realized.


2019 ◽  
Vol 954 ◽  
pp. 133-138
Author(s):  
Ao Liu ◽  
Song Bai ◽  
Run Hua Huang ◽  
Tong Tong Yang ◽  
Hao Liu

The mechanism of threshold voltage shift was studied. It is believed that the instability in threshold voltage during gate bias stress is due to capture of electrons by the SiC/gate dielectric interface traps and the gate dielectric near interface traps. New experimental platform was designed and built successfully. When positive stress or negative stress is applied to the gate, the change of threshold voltage occur immediately. After stress removal, the recovery of the threshold voltage occur soon. The change and recovery of threshold voltage are very sensitive to time. In order to get accurate threshold voltage drift data after high-temperature gate bias experiment, test of threshold voltage must be carried out immediately after the experiment.


2012 ◽  
Vol 2012 ◽  
pp. 1-7 ◽  
Author(s):  
Chao-Te Liu ◽  
Wen-Hsi Lee ◽  
Jui-Feng Su

The nanocomposite gate insulating film of a pentacene-based thin film transistor was deposited by inkjet printing. In this study, utilizing the pearl miller to crumble the agglomerations and the dispersant to well stabilize the dispersion of nano-TiO2particles in the polymer matrix of the ink increases the dose concentration for pico-jetting, which could be as the gate dielectric film made by inkjet printing without the photography process. Finally, we realized top contact pentacene-TFTs and successfully accomplished the purpose of directly patternability and increase the performance of the device based on the nanocomposite by inkjet printing. These devices exhibited p-channel TFT characteristics with a high field-effect mobility (a saturation mobility of ̃0.58 cm2 V−1 s−1), a large current ratio (>103) and a low operation voltage (<6 V). Furthermore, we accorded the deposited mechanisms which caused the interface difference between of inkjet printing and spin coating. And we used XRD, SEM, Raman spectroscopy to help us analyze the transfer characteristics of pentacene films and the performance of OTFTs.


2007 ◽  
Vol 154 (9) ◽  
pp. H769 ◽  
Author(s):  
N. Kameda ◽  
T. Nishiguchi ◽  
Y. Morikawa ◽  
M. Kekura ◽  
H. Nonaka ◽  
...  

2014 ◽  
Vol 598 ◽  
pp. 361-364 ◽  
Author(s):  
Chih Chieh Hsu ◽  
Chien Hsun Wu

The capacitance-voltage (C–V) characteristics of inverted staggered amorphous indium–gallium–zinc-oxide thin film transistors (α-IGZO TFTs) with various dimensions are investigated by physics-based technology computer aided design (TCAD) simulation. For gate bias lower than the threshold voltage of the TFT, the electrons in the channel region are nearly fully depleted. It causes that the total gate capacitance is determined by the overlap region of gate, α-IGZO, and source/drain metals. When the applied gate bias is higher than the threshold voltage, the high electron density channel with density of ~6 × 1017 cm-3 and thickness of ~3-4 nm is observed near the interface of α-IGZO and gate dielectric. It results that the total gate capacitance is dominated by the gate to channel overlap. Quantitative analysis of the carrier distribution and energy band structures are utilized to study the physical mechanism underlying the C–V characteristics of the α-IGZO TFTs.


2001 ◽  
Vol 686 ◽  
Author(s):  
Michele L. Ostraat ◽  
Jan W. De Blauwe

AbstractA great deal of research interest is being invested in the fabrication and characterization of nanocrystal structures as charge storage memory devices. In these flash memory devices, it is possible to measure threshold voltage shifts due to charge storage of only a few electrons per nanocrystal at room temperature. Although a variety of methods exist to fabricate nanocrystals and to incorporate them into device layers, control over the critical nanocrystal dimensions, tunnel oxide thickness, and interparticle separation and isolation remains difficult to achieve. This control is vital to produce reliable and consistent devices over large wafer areas. To address these control issues, we have developed a novel two-stage ultra clean reactor in which the Si nanocrystals are generated as single crystal, nonagglomerated, spherical aerosol particles from silane decomposition at 950°C at concentrations exceeding 108 cm−3 at sizes below 10 nm. Using existing aerosol instrumentation, it is possible to control the particle size to approximately 10% on diameter. In the second reactor, particles are passivated with a high quality oxide layer with shell thickness controllable from 0.7 to 2.0 nm. The two-stage aerosol reactor is integrated to a 200 mm wafer deposition chamber such that controlled particle densities can be deposited thermophoretically. With nanocrystal deposits of 1013 cm−2, contamination of transition metals and other elements can be controlled to less than 1010 atoms cm−2.We have fabricated 0.2 μm channel length aerosol nanocrystal floating gate memory devices using conventional MOS ULSI processing on 200 mm wafers. The aerosol nanocrystal memory devices exhibit normal transistor characteristics with drive current 30 μA/μm, subthreshold slope 200 mV/dec, and drain induced barrier lowering 100 mV/V, typical values for thick gate dielectric high substrate doped nonvolatile memory devices. Uniform Fowler-Nordheim tunneling is used to program and erase these memory devices. Despite 5 nm tunnel oxides, threshold voltage shifts > 2 V have been achieved with microsecond program and millisecond erase times at moderate operating voltages. The aerosol devices also exhibit excellent endurance cyclability with no window closure observed after 105 cycles. Furthermore, reasonable disturb times and long nonvolatility are obtained, illustrating the inherent advantage of discrete nanocrystal charge storage. No drain disturb was detected even at drain biases of 4V, indicating that little or no charge conduction occurs in the nanocrystal layer. We have demonstrated promise for aerosol nanocrystal memory devices. However, numerous issues exist for the future of nanocrystal devices. These technology issues and challenges will be discussed as directions for future work.


2016 ◽  
Vol 8 (28) ◽  
pp. 18249-18255 ◽  
Author(s):  
Toan Thanh Dao ◽  
Heisuke Sakai ◽  
Hai Thanh Nguyen ◽  
Kei Ohkubo ◽  
Shunichi Fukuzumi ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document