Organic-rich sediment alteration: an experimental and theoretical study at elevated temperatures and pressures

1990 ◽  
Vol 5 (1-2) ◽  
pp. 193-209 ◽  
Author(s):  
Jeffrey S. Seewald ◽  
William E. Seyfried ◽  
Edward C. Thornton
1992 ◽  
Vol 6 ◽  
pp. 172-172
Author(s):  
Mervin Kontrovitz ◽  
Jerry Marie Slack ◽  
Nigel R. Ainsworth ◽  
Richard D. Burnett

Interpretations of geologic history would be enhanced if taphonomic processes, including color changes in shells, were better known. This study deals with the origins and alteration of post-mortem colors in podocopid ostracodes. Modern shells were subjected to elevated temperatures and pressures in reactor vessels with sediments, simulating some burial conditions. Fossil shells from outcrops and boreholes were heated and treated with solvents, in an attempt to identify the coloring agent(s).Modern marine shells are white to pale yellow (Munsell 5Y 8/1 – 2.5Y 8/4). Upon heating at atmosphere, up to about 650°, they became slightly redder, slightly darker, and less color saturated, but never dark (Munsell “value” less than 5). From 650-850° they became yellower and lighter, and above 850° chalky and more yellow. Shells at elevated temperatures and pressures (T-P) with organic-poor sediments and/or iron compounds developed higher color values and lower chromas; they did not become dark. Thus, modern ostracode shells subjected to elevated T-P changed colors, but alone never attained the dark colors seen in many fossils. Only those heated in matured organic-rich sediment and/or crude oils became dark (dark grays, browns, and blacks), like some fossils. Fossil ostracodes from boreholes in Mesozoic and Cenozoic sedimentary rocks showed downhole color differences similar to those from experiments. That is, the colors of fossils are different in hue, value and chroma in different thermal zones and ostracode color appears to be broadly indicative of thermal history.Fossils near igneous intrusions are dark, while the lowered values and chromas of those in metamorphics also are correlatable with paleotemperatures. Reheated dark fossils lightened at about 375-450°, eventually becoming pale yellow to white, apparently indicating that organic coloring agents were driven off. This, and the fact that modern ostracodes develop dark colors only when heated in organic-rich substances, support the contention that the dark color originates from extrinsic organic materials. Pyritized shells become weak red (Munsell 10R 4/4) upon heating; thus, they can be distinguised from those colored by organics.Therefore, ostracode colors appear to be diagnostic of T-P and present the potential for use in paleotemperature reconstructions. A wide range of fossils, including conodonts, phosphatic brachiopods, scolecodonts, and palynomorphs are known to show recognizable and useful evidence of thermal maturation and it is proposed that ostracodes be added to the list.


2015 ◽  
Vol 58 (6) ◽  
pp. 1076-1083 ◽  
Author(s):  
Ahmed Mohamed Mahmoud Ibrahim ◽  
Xiaoliang Shi ◽  
Ao Zhang ◽  
Kang Yang ◽  
Wenzheng Zhai

1994 ◽  
Vol 61 (4) ◽  
pp. 923-929
Author(s):  
J. L. Ding ◽  
Y. G. Chen

In the current study, a theoretical basis is established for interpreting and correlating the optical caustic patterns with the transition of the crack-tip stress and strain fields under high-temperature creep condition. The theory forms a foundation for a possible experimental method based on optical caustics for characterizing the time-dependent fracture at elevated temperatures. Some numerical simulations of the high-temperature caustic phenomena were also performed based on the proposed theory.


2015 ◽  
Vol 44 (9) ◽  
pp. 3044-3055 ◽  
Author(s):  
Nima Dehdashti Akhavan ◽  
Gregory Jolley ◽  
Gilberto A. Umana-Membreno ◽  
Jarek Antoszewski ◽  
Lorenzo Faraone

Author(s):  
N. M. P. Low ◽  
L. E. Brosselard

There has been considerable interest over the past several years in materials capable of converting infrared radiation to visible light by means of sequential excitation in two or more steps. Several rare-earth trifluorides (LaF3, YF3, GdF3, and LuF3) containing a small amount of other trivalent rare-earth ions (Yb3+ and Er3+, or Ho3+, or Tm3+) have been found to exhibit such phenomenon. The methods of preparation of these rare-earth fluorides in the crystalline solid form generally involve a co-precipitation process and a subsequent solid state reaction at elevated temperatures. This investigation was undertaken to examine the morphological features of both the precipitated and the thermally treated fluoride powders by both transmission and scanning electron microscopy.Rare-earth oxides of stoichiometric composition were dissolved in nitric acid and the mixed rare-earth fluoride was then coprecipitated out as fine granules by the addition of excess hydrofluoric acid. The precipitated rare-earth fluorides were washed with water, separated from the aqueous solution, and oven-dried.


Author(s):  
J. L. Brimhall ◽  
H. E. Kissinger ◽  
B. Mastel

Some information on the size and density of voids that develop in several high purity metals and alloys during irradiation with neutrons at elevated temperatures has been reported as a function of irradiation parameters. An area of particular interest is the nucleation and early growth stage of voids. It is the purpose of this paper to describe the microstructure in high purity nickel after irradiation to a very low but constant neutron exposure at three different temperatures.Annealed specimens of 99-997% pure nickel in the form of foils 75μ thick were irradiated in a capsule to a total fluence of 2.2 × 1019 n/cm2 (E > 1.0 MeV). The capsule consisted of three temperature zones maintained by heaters and monitored by thermocouples at 350, 400, and 450°C, respectively. The temperature was automatically dropped to 60°C while the reactor was down.


Author(s):  
Robert C. Rau ◽  
Robert L. Ladd

Recent studies have shown the presence of voids in several face-centered cubic metals after neutron irradiation at elevated temperatures. These voids were found when the irradiation temperature was above 0.3 Tm where Tm is the absolute melting point, and were ascribed to the agglomeration of lattice vacancies resulting from fast neutron generated displacement cascades. The present paper reports the existence of similar voids in the body-centered cubic metals tungsten and molybdenum.


Author(s):  
Ernest L. Hall ◽  
J. B. Vander Sande

The present paper describes research on the mechanical properties and related dislocation structure of CdTe, a II-VI semiconductor compound with a wide range of uses in electrical and optical devices. At room temperature CdTe exhibits little plasticity and at the same time relatively low strength and hardness. The mechanical behavior of CdTe was examined at elevated temperatures with the goal of understanding plastic flow in this material and eventually improving the room temperature properties. Several samples of single crystal CdTe of identical size and crystallographic orientation were deformed in compression at 300°C to various levels of total strain. A resolved shear stress vs. compressive glide strain curve (Figure la) was derived from the results of the tests and the knowledge of the sample orientation.


Sign in / Sign up

Export Citation Format

Share Document