Metamaterial-based fluid sensor for identifying different types of fuel oil samples

Abstract. Studies of detailed chemical compositions in particles with different size ranges emitted from ships are in serious shortage. In this study, size-segregated distributions and characteristics of particle mass, organic carbon (OC), elemental carbon (EC), 16 EPA polycyclic aromatic hydrocarbons (PAHs) and 25 n-alkanes measured aboard 12 different vessels in China are presented. The results showed the following. (1) More than half of the total particle mass, OC, EC, PAHs and n-alkanes were concentrated in fine particles with aerodynamic diameter (Dp) < 1.1 µm for most of the tested ships. The relative contributions of OC, EC, PAH and alkanes to the size-segregated particle mass are decreasing with the increase in particle size. However, different types of ships showed quite different particle-size-dependent chemical compositions. (2) In fine particles, the OC and EC were the dominant components, while in coarse particles, OC and EC only accounted for very small proportions. With the increase in particle size, the OC / EC ratios first decreased and then increased, having the lowest values for particle sizes between 0.43 and 1.1 µm. (3) Out of the four OC fragments and three EC fragments obtained in thermal–optical analysis, OC1, OC2 and OC3 were the dominant OC fragments for all the tested ships, while EC1 and EC2 were the main EC fragments for ships running on heavy fuel oil (HFO) and marine-diesel fuel, respectively; different OC and EC fragments presented different distributions in different particle sizes. (4) The four-stroke low-power diesel fishing boat (4-LDF) had much higher PAH emission ratios than the four-stroke high-power marine-diesel vessel (4-HMV) and two-stroke high-power heavy-fuel-oil vessel (2-HHV) in fine particles, and 2-HHV had the lowest values. (5) PAHs and n-alkanes showed different profile patterns for different types of ships and also between different particle-size bins, which meant that the particle size should be considered when source apportionment is conducted. It is also noteworthy from the results in this study that the smaller the particle size, the more toxic the particle was, especially for the fishing boats in China.

Download Full-text

Thermal and catalytic degradation of structurally different types of polyethylene into fuel oil

Polymer Degradation and Stability ◽

10.1016/s0141-3910(96)00191-7 ◽

1997 ◽

Vol 56 (1) ◽

pp. 37-44 ◽

Cited By ~ 97

Author(s):

Md Azhar Uddin ◽

Kazuo Koizumi ◽

Katsuhide Murata ◽

Yusaku Sakata

Keyword(s):

Catalytic Degradation ◽

Fuel Oil ◽

Different Types

Download Full-text

Studi Microgrid System Menuju Pembangunan Desa Mandiri Energi Di Desa Temajuk Kabupaten Sambas

ELKHA ◽

10.26418/elkha.v10i1.25277 ◽

2019 ◽

Vol 10 (1) ◽

pp. 6

Author(s):

Yunando Yunando ◽

Sutriyatna Sutriyatna

Keyword(s):

Power Generation ◽

Power Plant ◽

Cost Savings ◽

Electrical Energy ◽

Fuel Oil ◽

System Study ◽

Hydro Power ◽

West Kalimantan ◽

Different Types ◽

The Village

Abstract– Temajuk Village is one of the villages in Kecamatan Paloh Sambas regency, West Kalimantan Province, which borders directly with Sarawak (Malaysia). From 1980 to 2011 Desa Temajuk has no permanent electricity yet. In 2011, the village will have electrical energy by utilizing local energy such as Micro Hydro Power Generation, by 2012, Centralized Solar Power Generation and by 2015 Diesel Power Plant, all of which will carry each load without being integrated with the same network . So it is necessary to do the study of merging a network that is connected to one another to be able to bear the same load.Microgrid System study was then created with the aim of producing a sustainable distribution network study by combining 3 different types of plants and operational savings from the use of diesel fuel oil costs as the main power plant after the network system. Keywords- Microgrid System, cost savings

Download Full-text

Dependency of the Blast Wave Pressure on the Amount of Used Booster

Symmetry ◽

10.3390/sym13101813 ◽

2021 ◽

Vol 13 (10) ◽

pp. 1813

Author(s):

Lucia Figuli ◽

Zuzana Zvaková ◽

Vladimír Kavický ◽

Tomáš Loveček

Keyword(s):

Ammonium Nitrate ◽

Blast Wave ◽

Field Tests ◽

Fuel Oil ◽

Internal Factors ◽

Wave Pressure ◽

Effective Combination ◽

Different Types ◽

Maximal Pressure ◽

External Characteristics

Most of the damage caused by an explosion is caused by a pressure effect. The magnitude of the pressure generated by the explosion is influenced by the external characteristics of the environment (surrounding objects, their arrangement, geometry, etc.) and internal characteristics (type of explosive, type of charge, booster and others). An effective combination of internal factors creates a symmetry that results in the highest possible value of pressure generated by the charge explosion. The paper focuses on the influence of the booster reaction on this symmetry. The scope of the paper is to understand the dependency of the blast wave pressure on the amount of used blaster to increase the efficacy of explosions on the environment and structures to increase the protection of affected structures. The open-air field tests were conducted using different types of explosives: trinitrotoluene and three different types of industrially made ANFO explosives (pure ammonium nitrate and fuel oil, ammonium nitrate and fuel oil plus aluminum powder, ammonium nitrate and fuel oil mixed with trinitrotoluene). The obtained data were compared with the analytical approach for setting the generated maximal pressure on the front of the blast wave.

Download Full-text

Comparison of the Efficacy of Homemade and Industrially Made ANFO Explosives as an Improvised Explosive Device Charge

Communications - Scientific letters of the University of Zilina ◽

10.26552/com.c.2018.2.23-27 ◽

2018 ◽

Vol 20 (2) ◽

pp. 23-27

Author(s):

Lucia Figuli ◽

Vladimir Kavicky ◽

Stefan Jangl ◽

Zuzana Zvakova

Keyword(s):

Ammonium Nitrate ◽

Critical Infrastructure ◽

Fuel Oil ◽

Terrorist Attacks ◽

Test Results ◽

Improvised Explosive Device ◽

Aluminium Powder ◽

Different Types ◽

Explosive Device ◽

Improvised Explosive

More than 95 % of all the terrorist attacks are carried out using the ANFO explosives. The ANFO explosives are explosives made from ammonium nitrate and fuel oil. They can be in three different variants (ammonium nitrate with oil, ammonium nitrate with oil and aluminium powder or ammonium nitrate with oil and TNT). This paper describes analysis of the field test results of ANFO explosives of different types. The efficacy of industrially made and the homemade ANFO explosives is compared and their possible usage in terrorist attacks for the treatment or the damage of critical infrastructure elements is described.

Download Full-text

The extinction time of a general birth and death process with catastrophes

Journal of Applied Probability ◽

10.1017/s0021900200116031 ◽

1986 ◽

Vol 23 (04) ◽

pp. 851-858 ◽

Cited By ~ 1

Author(s):

P. J. Brockwell

Keyword(s):

Laplace Transform ◽

Size Distribution ◽

Sufficient Conditions ◽

Necessary And Sufficient Conditions ◽

Death Process ◽

Extinction Time ◽

Birth And Death Process ◽

Different Types ◽

The Laplace Transform ◽

Necessary And Sufficient

The Laplace transform of the extinction time is determined for a general birth and death process with arbitrary catastrophe rate and catastrophe size distribution. It is assumed only that the birth rates satisfyλ0= 0,λj> 0 for eachj> 0, and. Necessary and sufficient conditions for certain extinction of the population are derived. The results are applied to the linear birth and death process (λj=jλ, µj=jμ) with catastrophes of several different types.

Download Full-text

Differentiating between different forms of moral obligations

Behavioral and Brain Sciences ◽

10.1017/s0140525x19002589 ◽

2020 ◽

Vol 43 ◽

Author(s):

Rajen A. Anderson ◽

Benjamin C. Ruisch ◽

David A. Pizarro

Keyword(s):

Moral Character ◽

Moral Obligations ◽

Different Types

Abstract We argue that Tomasello's account overlooks important psychological distinctions between how humans judge different types of moral obligations, such as prescriptive obligations (i.e., what one should do) and proscriptive obligations (i.e., what one should not do). Specifically, evaluating these different types of obligations rests on different psychological inputs and has distinct downstream consequences for judgments of moral character.

Download Full-text

Ultrastructural Investigations of the Contractile Filaments of Amoebae

Proceedings, annual meeting, Electron Microscopy Society of America ◽

10.1017/s0424820100050950 ◽

1974 ◽

Vol 32 ◽

pp. 188-189

Author(s):

P.L. Moore

Keyword(s):

Cytoplasmic Streaming ◽

Three Dimensional ◽

Freeze Fracture ◽

Amoeboid Movement ◽

Different Types ◽

Chemical Conditions ◽

Complete Interpretation

Previous freeze fracture results on the intact giant, amoeba Chaos carolinensis indicated the presence of a fibrillar arrangement of filaments within the cytoplasm. A complete interpretation of the three dimensional ultrastructure of these structures, and their possible role in amoeboid movement was not possible, since comparable results could not be obtained with conventional fixation of intact amoebae. Progress in interpreting the freeze fracture images of amoebae required a more thorough understanding of the different types of filaments present in amoebae, and of the ways in which they could be organized while remaining functional.The recent development of a calcium sensitive, demembranated, amoeboid model of Chaos carolinensis has made it possible to achieve a better understanding of such functional arrangements of amoeboid filaments. In these models the motility of demembranated cytoplasm can be controlled in vitro, and the chemical conditions necessary for contractility, and cytoplasmic streaming can be investigated. It is clear from these studies that “fibrils” exist in amoeboid models, and that they are capable of contracting along their length under conditions similar to those which cause contraction in vertebrate muscles.

Download Full-text

Study of the Molecular Architecture of Keratin Filaments by Electron Microscopy

Proceedings, annual meeting, Electron Microscopy Society of America ◽

10.1017/s0424820100053310 ◽

1982 ◽

Vol 40 ◽

pp. 118-119

Author(s):

U. Aebi ◽

P. Rew ◽

T.-T. Sun

Keyword(s):

Electron Microscopy ◽

Structural Organization ◽

Cell Types ◽

Structural Features ◽

Molecular Architecture ◽

The Past ◽

Keratin Filaments ◽

Different Types ◽

10 Nm Filaments ◽

Different Cell Types

Various types of intermediate-sized (10-nm) filaments have been found and described in many different cell types during the past few years. Despite the differences in the chemical composition among the different types of filaments, they all yield common structural features: they are usually up to several microns long and have a diameter of 7 to 10 nm; there is evidence that they are made of several 2 to 3.5 nm wide protofilaments which are helically wound around each other; the secondary structure of the polypeptides constituting the filaments is rich in ∞-helix. However a detailed description of their structural organization is lacking to date.

Download Full-text

A New Defect in Polyethylene Single Crystals

Proceedings, annual meeting, Electron Microscopy Society of America ◽

10.1017/s0424820100070795 ◽

1973 ◽

Vol 31 ◽

pp. 70-71

Author(s):

E. L. Thomas ◽

S. L. Sass

Keyword(s):

Single Crystals ◽

Screw Dislocation ◽

Small Distance ◽

Dipole Model ◽

Dislocation Dipole ◽

Chain Folding ◽

Black And White ◽

Polymer Crystal ◽

Different Types

In polyethylene single crystals pairs of black and white lines spaced 700-3,000Å apart, parallel to the [100] and [010] directions, have been identified as microsector boundaries. A microsector is formed when the plane of chain folding changes over a small distance within a polymer crystal. In order for the different types of folds to accommodate at the boundary between the 2 fold domains, a staggering along the chain direction and a rotation of the chains in the plane of the boundary occurs. The black-white contrast from a microsector boundary can be explained in terms of these chain rotations. We demonstrate that microsectors can terminate within the crystal and interpret the observed terminal strain contrast in terms of a screw dislocation dipole model.

Download Full-text