Partial substitution of cement by the association of Ferronickel slags and Crepidula fornicata shells

2021 ◽  
Vol 33 ◽  
pp. 101587 ◽  
Author(s):  
Manal Bouasria ◽  
Fouzia Khadraoui ◽  
Mohammed-Hichem Benzaama ◽  
Karim Touati ◽  
Daniel Chateigner ◽  
...  
Author(s):  
M. Raghavan ◽  
J. Y. Koo ◽  
J. W. Steeds ◽  
B. K. Park

X-ray microanalysis and Convergent Beam Electron Diffraction (CBD) studies were conducted to characterize the second phase particles in two commercial aluminum alloys -- 7075 and 7475. The second phase particles studied were large (approximately 2-5μm) constituent phases and relatively fine ( ∼ 0.05-1μn) dispersoid particles, Figures 1A and B. Based on the crystal structure and chemical composition analyses, the constituent phases found in these alloys were identified to be Al7Cu2Fe, (Al,Cu)6(Fe,Cu), α-Al12Fe3Si, Mg2Si, amorphous silicon oxide and the modified 6Fe compounds, in decreasing order of abundance. The results of quantitative X-ray microanalysis of all the constituent phases are listed in Table I. The data show that, in almost all the phases, partial substitution of alloying elements occurred resulting in small deviations from the published stoichiometric compositions of the binary and ternary compounds.


2019 ◽  
Vol 4 (3) ◽  
pp. 89-99
Author(s):  
A.S. Sallam ◽  
A.H. Khalil ◽  
M.M. Mostafa ◽  
A.A. El Bedawy ◽  
Aml A. Atef

Energies ◽  
2021 ◽  
Vol 14 (6) ◽  
pp. 1539
Author(s):  
Karolina Wojtacha-Rychter ◽  
Piotr Kucharski ◽  
Adam Smolinski

The article evaluates the reduction of carbon dioxide emission due to the partial substitution of coal with alternative fuels in clinker manufacture. For this purpose, the calculations were performed for seventy waste-derived samples of alternative fuels with variable calorific value and variable share in the fuel mixture. Based on annual clinker production data of the Polish Cement Association and the laboratory analysis of fuels, it was estimated that the direct net CO2 emissions from fossil fuel combustion alone were 543 Mg of CO2 per hour. By contrast with the full substitution of coal with alternative fuels (including 30% of biomass), the emission ranged from 302 up to 438 Mg of CO2 per hour, depending on fuel properties. A reduction of 70% in the share of fossil fuels resulted in about a 23% decrease in net emissions. It was proved that the increased use of alternative fuels as an additive to the fuel mix is also of economic importance. It was determined that thanks to the combustion of 70% of alternative fuels of calorific value from 15 to 26 MJ/kg, the hourly financial profit gain due to avoided CO2 emission and saved 136 megatons of coal totaled an average of 9718 euros. The results confirmed that the co-incineration of waste in cement kilns can be an effective, long-term way to mitigate carbon emissions and to lower clinker production costs. This paper may constitute a starting point for future research activities and specific case studies in terms of reducing CO2 emissions.


Foods ◽  
2021 ◽  
Vol 10 (3) ◽  
pp. 518
Author(s):  
Vera Schmid ◽  
Jan Steck ◽  
Esther Mayer-Miebach ◽  
Diana Behsnilian ◽  
Mirko Bunzel ◽  
...  

The partial substitution of starch with dietary fiber (DF) in extruded ready-to-eat texturized (RTE) cereals has been suggested as a strategy to reduce the high glycemic index of these food products. Here, we study the impact of extrusion processing on pure chokeberry (Aronia melanocarpa) pomace powder (CPP) rich in DF and polyphenols (PP) focusing on the content and profile of the DF fractions, stability of PP, and techno-functional properties of the extrudates. Using a co-rotating twin-screw extruder, different screw speeds were applied to CPP with different water contents (cw), which resulted in specific mechanical energies (SME) in the range of 145–222 Whkg−1 and material temperatures (TM) in the range of 123–155 °C. High molecular weight soluble DF contents slightly increase with increasing thermomechanical stress up to 16.1 ± 0.8 g/100 g dm as compared to CPP (11.5 ± 1.2 g/100 g dm), but total DF (TDF) contents (58.6 ± 0.8 g/100 g dm) did not change. DF structural analysis revealed extrusion-based changes in the portions of pectic polysaccharides (type I rhamnogalacturonan) in the soluble and insoluble DF fractions. Contents of thermolabile anthocyanins decrease linearly with SME and temperature from 1.80 ± 0.09 g/100 g dm in CPP to 0.24 ± 0.06 g/100 g dm (222 Whkg−1, 155 °C), but phenolic acids and flavonoids appear to be largely unaffected. Resulting techno-functional (water absorption and water solubility) and physical properties related to the sensory characteristics (expansion, hardness, and color) of pure CPP extrudates support the expectation that granulated CPP extrudates may be a suitable food ingredient rich in DF and PP.


Foods ◽  
2021 ◽  
Vol 10 (8) ◽  
pp. 1681
Author(s):  
Carmen Botella-Martínez ◽  
Manuel Viuda-Martos ◽  
José Angel Pérez-Álvarez ◽  
Juana Fernández-López

A gelled emulsion (GE) prepared with hemp oil and buckwheat flour was used to replace pork back fat in frankfurters. Five different formulations were prepared: control (with 35% pork back fat—SC), and the following four to achieve 25%, 50%, 75%, and 100% pork back fat substitution by GE (S1, S2, S3, and S4, respectively). Nutritional, technological, and sensorial characteristics of frankfurters were evaluated. Sausages containing GE presented a lower total fat content with a higher amount of polyunsaturated fatty acids, increased omega 3 content, and reduced saturated fat by up to 55%. The incorporation of GE did not significantly modify technological properties such as emulsion stability or lipid oxidation in spite of using vegetable oils highly susceptible to oxidation. The reformulation of the frankfurters presented a greater effect on the texture and sensory properties when GE was used as total substitution for the pork back fat (S4). When GE was used only as partial substitution for the pork back fat, sausages similar to control frankfurter were obtained. So this study demonstrated that the use of GE could be a promising strategy in the reformulation of healthier meat products.


2021 ◽  
Vol 13 (11) ◽  
pp. 6277
Author(s):  
Ibrahim Sharaky ◽  
Usama Issa ◽  
Mamdooh Alwetaishi ◽  
Ahmed Abdelhafiz ◽  
Amal Shamseldin ◽  
...  

In this study, the recycled concrete aggregates and powder (RCA and RCP) prepared from basaltic concrete waste were used to replace the natural aggregate (NA) and cement, respectively. The NA (coarse and fine) was replaced by the recycled aggregates with five percentages (0%, 20%, 40%, 60% and 80%). Consequently, the cement was replaced by the RCP with four percentages (0%, 5%, 10% and 20%). Cubes with 100 mm edge length were prepared for all tests. The compressive and tensile strengths (fcu and ftu) and water absorption (WA) were investigated for all mixes at different ages. Partial substitution of NA with recycled aggregate reduced the compressive strength with different percentages depending on the type and source of recycled aggregate. After 28 days, the maximum reduction in fcu value was 9.8% and 9.4% for mixtures with coarse RCA and fine RCA (FRCA), respectively. After 56 days, the mixes with 40% FRCA reached almost the same fcu value as the control mix (M0, 99.5%). Consequently, the compressive strengths of the mixes with 10% RCA at 28 and 56 days were 99.3 and 95.2%, respectively, compared to those of M0. The mixes integrated FRCA and RCP showed higher tensile strengths than the M0 at 56 d with a very small reduction at 28 d (max = 3.4%). Moreover, the fcu and ftu values increased for the late test ages, while the WA decreased.


2021 ◽  
Vol 18 (1) ◽  
Author(s):  
Bernie Pauly ◽  
Meaghan Brown ◽  
Clifton Chow ◽  
Ashley Wettlaufer ◽  
Brittany Graham ◽  
...  

Abstract Background While there is robust evidence for strategies to reduce harms of illicit drug use, less attention has been paid to alcohol harm reduction for people experiencing severe alcohol use disorder (AUD), homelessness, and street-based illicit drinking. Managed Alcohol Programs (MAPs) provide safer and regulated sources of alcohol and other supports within a harm reduction framework. To reduce the impacts of heavy long-term alcohol use among MAP participants, cannabis substitution has been identified as a potential therapeutic tool. Methods To determine the feasibility of cannabis substitution, we conducted a pre-implementation mixed-methods study utilizing structured surveys and open-ended interviews. Data were collected from MAP organizational leaders (n = 7), program participants (n = 19), staff and managers (n = 17) across 6 MAPs in Canada. We used the Consolidated Framework for Implementation Research (CFIR) to inform and organize our analysis. Results Five themes describing feasibility of CSP implementation in MAPs were identified. The first theme describes the characteristics of potential CSP participants. Among MAP participants, 63% (n = 12) were already substituting cannabis for alcohol, most often on a weekly basis (n = 8, 42.1%), for alcohol cravings (n = 15, 78.9%,) and withdrawal (n = 10, 52.6%). Most MAP participants expressed willingness to participate in a CSP (n = 16, 84.2%). The second theme describes the characteristics of a feasible and preferred CSP model according to participants and staff. Participants preferred staff administration of dry, smoked cannabis, followed by edibles and capsules with replacement of some doses of alcohol through a partial substitution model. Themes three and four highlight organizational and contextual factors related to feasibility of implementing CSPs. MAP participants requested peer, social, and counselling supports. Staff requested education resources and enhanced clinical staffing. Critically, program staff and leaders identified that sustainable funding and inexpensive, legal, and reliable sourcing of cannabis are needed to support CSP implementation. Conclusion Cannabis substitution was considered feasible by all three groups and in some MAPs residents are already using cannabis. Partial substitution of cannabis for doses of alcohol was preferred. All three groups identified a need for additional supports for implementation including peer support, staff education, and counselling. Sourcing and funding cannabis were identified as primary challenges to successful CSP implementation in MAPs.


Sign in / Sign up

Export Citation Format

Share Document