scholarly journals Measurements of PM10 particles made in the Rosia of Jiu quarry as a result of the use of Komatsu PC4000-11 hydraulic excavator

2022 ◽  
Vol 354 ◽  
pp. 00064
Author(s):  
Bogdan Ioan Marc ◽  
Alexandra (Soica) Stanimriescu ◽  
Angela Egri

This paper studies the Roșia Jiu quarry area in Romania. This research highlights the working method of hydraulic excavators and the values of particles released into the atmosphere by them. Improving technological equipment not only helps build a better world, but also restores and preserves the environment. The measurements were made during 2020, using DSM501A sensors, which were located at four points in the quarry, namely in the north, southeast and west of the quarry.

2019 ◽  
Vol 16 (3) ◽  
pp. 202-213 ◽  
Author(s):  
G. G. Buriy ◽  
V. S. Shherbakov ◽  
S. B. Skobelev ◽  
V. F. Kovalevskiy

Introduction.Construction of engineering structures is impossible without building and road machines. The large volume of financing is allocated for such machines’ purchase. The main ways of reducing costs of the equipment consist in more rational operation of the equipment and also in decrease of equipment’s cost by constructive changes. The paper demonstrates the new design of the single-bucket hydraulic excavator with smaller cost.Materials and methods.The main ways of cost reduction for construction machines are more rational operation and depreciation of a design with the required characteristics’ maintaining. The paper describes constructive changes of the working equipment of the single-bucket hydraulic excavator, which allow decreasing the production costs.Results.The authors describe the new bucket design of the single-bucket hydraulic excavator. Moreover, the authors carry out the analysis of the existing buckets’ design. The paper also illustrates the functioning on bucket forces while digging process. The authors describe the solutions of the problem for productivity increase of the single-bucket in hydraulic excavators. In addition, the authors make the scheme of the bucket loading while digging process. Such scheme helps to reduce resistance forces of digging.Discussion and conclusions.As a result, the paper presents the design of the working equipment of the hydraulic excavator’s single-bucket, which allows reducing resistance forces of digging. Such results would help to establish buckets of bigger capacity and would lead to the productivity increase.


The stage which the question of the function of the pelvic filaments of the male Lepidosiren had reached before the researches described in this paper can be seen by reference to the paper by Carter and Beadle (1930) and that by Cunningham in the previous year. The researches of Carter and Beadle as well as those previously carried out by Graham Kerr were made in the Gran Chaco of Paraguay, in the swamps of which region Lepidosiren is rather abundant. But when direct experiments on the function of the filaments were contemplated the political conditions made it inadvisable to attempt to visit this region, and it was suggested that Lepidosiren would be found in sufficient abundance on the island of Marajó at the mouth of the River Amazon. No evidence was obtained that the fish had recently been taken in that island, but three specimens, all from the same locality, namely a “papyrus meadow” near Fazenda Dunas on the north coast of the island, were recorded in 1896 and 1898 by Dr. Goeldi, Director and founder of the Muséu Goeldi at Belem. It was therefore decided to organise and carry out an expedition to Marajó. The equipment was prepared in the Physiological Department of the London Hospital Medical College and consisted of large glass tubes from 18 inches to 30 inches in length and 1½ inches to 3 inches in diameter; and weighed quantities in hermetically sealed tubes or bottles of the reagents required for the estimation of dissolved oxygen in water, together with the necessary accessories, and a special pump for obtaining water from below the surface of swamp pools.


1925 ◽  
Vol 15 (3) ◽  
pp. 257-271 ◽  
Author(s):  
James Hendrick ◽  
George Newlands

1. Previous investigations showed that certain Scottish soils were of glacial drift origin, that they were comparatively rich in unweathered silicates and therefore in reserves of plant-food, that they showed considerable variation in such silicates and were capable of classification accordingly. Some indication was also shown that the glacial drift, and hence the resulting soil, was sometimes of local origin, its character being determined by the underlying rock. In the present investigation a more extensive survey of Scottish soils has been made in order to discover to what extent these preliminary findings might be applicable generally.2. For this purpose soils have been collected from various localities in the north, north-east, west and south of Scotland, and have been analysed mechanically and the “fine sand” fraction examined mineralogically.


1936 ◽  
Vol 16 (1) ◽  
pp. 1-7
Author(s):  
F. Cottrill

Excavations made in June 1935 for the foundations of a new sub-station of the London Passenger Transport Board at Trinity Place, Trinity Square, E.C., brought to light some remains of the Roman town wall of London. A large portion of the medieval superstructure is still standing on the east side of Trinity Place, and to the north of this the Inner Circle Railway runs in a cutting under the roadway. The construction of this cutting involved the removal of a length of 73 ft. of the wall in 1882 (R.C.H.M. Roman London, 83). The site of the discoveries to be described here was immediately behind the southern retaining wall of the cutting. Both faces of the Roman wall were exposed at this point, and could be examined in detail, and against the external face was a fragment of one of the later Roman bastions (pl. 1). These remains were investigated by the writer on behalf of this Society, and the Passenger Transport Board kindly granted all necessary facilities, and rendered every possible assistance.


Archaeologia ◽  
1925 ◽  
Vol 74 ◽  
pp. 89-102 ◽  
Author(s):  
O. M. Dalton

The dial forming the subject of this paper, acquired by the British Museum in 1923, is of gilt copper, made in the form of a book, along the edges of which are inscribed in capitals the words: Lucerna instrumentalis | intellectus directiva | sive instrumentum sciendi. The dial-plate which is fixed in the interior has a compass and two very short gnomons. It is for use in the latitudes of 42 and 45, and would serve for Rome and one of the large towns in the North Italian plain, perhaps Milan or Venice. It was made at Rome in the year 1593, as shown by the inscription on the dial-plate. On the cover is a shield of arms, barry, and in chief the letters I H S surmounted by a cross, a feature perhaps indicating that the owner was a member of the Society of Jesus; a fuller device, in which the three nails of the Passion are seen below the sacred monogram and cross, occupies the centre of the figure on the outside of the lower cover. The identification of the arms presents difficulties. They might be those of the Caraffa (gules, three bars argent), a member of which family, Vincenzio Caraffa, was general of the Jesuits in 1645.


1945 ◽  
Vol 82 (6) ◽  
pp. 267-273 ◽  
Author(s):  
W. Anderson

Formerly there were several surface brine springs in the North-East Coalfield; to-day there are none. From the many accounts of their occurrence nothing has been learned of their exact position, and very little of the composition of their waters. The earliest record, made in 1684, described the Butterby spring (Todd, 1684), and then at various times during the next two centuries brine springs at Framwellgate, Lumley, Birtley, Walker, Wallsend, Hebburn, and Jarrow were noted. In particular the Birtley salt spring is often mentioned, and on the 6-in. Ordnance map, Durham No. 13, 1862 edition, it is sited to the south-east of the village. Although no record has been found there must have been either a brine spring or well at Gateshead, for the name of the present-day suburb, Saltwell, is very old, and brine springs are still active in the coal workings of that area.


1920 ◽  
Vol 3 (2) ◽  
pp. 219-243
Author(s):  
J. Reid Moir

When visiting Mundesley, in Norfolk, in September, 1916, the present author found upon the shore, in close proximity to an exposure of clay which he now considers to be referable to the Cromer Forest Bed Series, a very finely-made and large flint flake, of human manufacture. This discovery induced him to again visit Mundesley, and during this year (1919) close upon three weeks have been spent in an examination of the stretch of cliffs and shore lying between Trimingham, to the north-west of Mundesley, and Bacton, which lies to the south-east.The author's researches have been greatly helped by the co-operation of three friends, Professor A. S. Barnes, Mr. Walter B. Nichols, and the Hon. Robert Gathorne-Hardy, who accompanied him to Mundesley, and to whom he offers his warmest thanks. He would, however, wish to make it clear that these gentlemen are in no way responsible for the statements made in this paper. For these the author is solely responsible.


Author(s):  
K. Ya. Bulakhova ◽  
S. M. Sudarikov

The results of hydrogeochemical monitoring of the Sarmat-Meotis-Pontic sediments aquifer complex of the North Sivash artesian basin have been analyzed. The analysis based on a routine observations for 16 producing wells. The observations were made in the period from 2014 to 2017 years. A correlation and regression analysis has been made for definition of dependencies between changes in the concentrations of the normalized components. The results obtained allow us to evaluate the main factors of formation of the chemical composition of groundwater. At the present stage, metamorphosed waters are pulled up from the lower strata of the complex, that leads to an increase in the amount of mineralization. The formation of sulphate waters is primarily associated with the peculiarities of the geological structure, namely, the high gypsum content of quaternary deposits and the presence of hydraulic connection with the overlying aquifers. One of the reasons for the formation of sulphate waters is the anthropogenic impact associated with the close location of the acid accumulator containing sulfur tailing. The results obtained allow us to proceed to the next stage of the survey — the creation of a natural hydrogeological model of the research area and the carrying of the thermodynamic modeling.


2008 ◽  

From the late Sixties on, industrial development in Italy evolved through the spread of small and medium sized firms, aggregated in district networks, with an elevated propensity to enterprise and the marked presence of owner-families. Installed within the local systems, the industrial districts tended to simulate large-scale industry exploiting lower costs generated by factors that were not only economic. The districts are characterised in terms of territorial location (above all the thriving areas of the North-east and Centre) and sector, since they are concentrated in the "4 As" (clothing-fashion, home-decor, agri-foodstuffs, automation-mechanics), with some overlapping with "Made in Italy". How can this model be assessed? This is the crucial question in the debate on the condition and prospects of the Italian productive system between the supporters of its capacity to adapt and the critics of economic dwarfism. A dispassionate judgement suggests that the prospects of "small is beautiful" have been superseded, but that the "declinist" view, that sees only the dangers of globalisation and the IT revolution for our SMEs is risky. The concept of irreversible crisis that prevails at present is limiting, both because it is not easy either to "invent", or to copy, a model of industrialisation, and because there is space for a strategic repositioning of the district enterprises. The book develops considerations in this direction, showing how an evolution of the district model is possible, focusing on: gains in productivity, scope economies (through diversification and expansion of the range of products), flexibility of organisation, capacity to meld tradition and innovation aiming at product quality, dimensional growth of the enterprises, new forms of financing, active presence on the international markets and valorisation of the resources of the territory. It is hence necessary to reactivate the behavioural functions of the entrepreneurs.


Author(s):  
Viktor Anatolyevich Avksentev ◽  
Boris Vladimirovich Aksiumov ◽  
Galina Dmitrievna Gritsenko

Based on the content analysis of “non-ethnic” mass media in the federal subjects of Russia in the North Caucasus, the attempt to determine the place of ethnicity in the information field of the region and the influence of these sources on the processes of politicization/depoliticization of ethnicity is made in the paper. It was revealed that the topic “historical memory” is the leading one in ethnically marked publications. The next places in the thematic classi-fier are occupied by “ethnic identity” and “ethnic traditions and values”. Along with this, the dis-course of modernization turned out to be in de-mand, which indicates that the North Caucasus is in a situation of search for an optimal balance between old and new, traditions and innovations. Only one case of the use of the concept of “nation” as a syn-onym for the Russian (“Rossiyan”) nation has been identified, however, references to the nation in the ethnic sense are extremely rare. It is concluded that the “non-ethnic” media of the North Caucasus keep ethnic and confessional issues within public dis-course, but it is not “superfluous”, i. e. the tendency to politicize ethnicity is not typical or explicit.


Sign in / Sign up

Export Citation Format

Share Document