Extraction of Pb2+from dilute solution by paramagnetic Fe3O4@ SiO2@ Clpr-silica @ dithizone solid-phase nanoextractant

2013 ◽  
Vol 52 (40-42) ◽  
pp. 7898-7905 ◽  
Author(s):  
Jie Ma ◽  
Guoliang Cheng ◽  
Sergey Basov ◽  
Shuping Zhang ◽  
Tingting Ji
Keyword(s):  
Solid Phase ◽  
Dilute Solution

Optical Absorption and Light Emission of a Banana-Shaped Liquid Crystal

2010 ◽  
Vol 428-429 ◽  
pp. 212-215 ◽  
Author(s):  
Yuan Ming Huang ◽  
Bao Gai Zhai
Keyword(s):  
Liquid Crystal ◽  
Optical Absorption ◽  
White Light ◽  
Light Emission ◽  
Solid Phase ◽  
Dilute Solution ◽  
Absorption Bands

With the ultraviolet-visible spectrometer and photospectrometer, we have investigated the optical absorption and light emission from the dilute tetrahydrofuran solutions of a classical banana-shaped liquid crystal 1,3-phenylene-bis[4-(4'-nonyloxy)phenyliminomethyl]benzoate. In the dilute tetrahydrofuran solutions, three optical absorption bands were recorded for the banana-shaped compound at about 255, 290 and 355 nm, respectively. Upon the 325 nm excitation, white light emissions were recorded for the solid phase of the banana-shaped liquid crystal whereas blue-greenish emissions were observed for the banana-shaped molecules in dilute solution.

Effect of magnetic field during the liquid – solid phase transition of some thermoplastic polymers

2015 ◽  
Vol 10 (1) ◽  
pp. 2649-2662
Author(s):  
Abbas H ◽  
A.Y. Ali ◽  
M.M. El-Tonsy ◽  
H.A.G. Al Slimawi
Keyword(s):  
Magnetic Field ◽  
Phase Transition ◽  
Magnetic Fields ◽  
Field Strength ◽  
Hot Pressing ◽  
Solid Phase ◽  
Video Clip ◽  
Zigzag Chain ◽  
Dilute Solution ◽  
Spherulite Growth

Application of external fields on a polymer is common physical treatment for modifying the polymer properties. The field is applied on the final polymeric object or during synthesising or polymerization. In this work, the magnetic field from powerful permanent magnets was applied during the phase transition from liquid to solid phase, where the polymer chain inter-attraction forces are minimal. So, magnetic fields with less strength may perform valuable structural variations. It is found that magnetic field of 355 mT accelerated the spherulite growth in polyethylene glycol (PEG) films. High density polyethylene (HDPE) of zigzag chain, polypropylene (PP) of chains with side group and polystyrene (PS) as glassy polymer with ring, were magnetically treated with different field strength during their phase transition. Treated and untreated film samples were tested physically. IR- spectroscopy, X-ray diffraction, DTA, DSC and tensile stress – strain testing techniques were used in order to characterize, quantitatively, most types of the occurred variations if any. PS samples were casted by hot pressing and from dilute solution in magnetic field in order to detect the effect of solidification time on the size of the magnetic induced variations. Properties of treated HDPE showed little swinging about the untreated value in the field strength up to 160 mT. PP properties showed serious variations in the same range of field strength. PS films casted from dilute solution showed stronger variations than the films casted by hot pressing of the melted PS. All data are presented in coloured graphs. Spherulites images are extracted from a video clip that is used in measuring the rate of PEG spherulite growth in magnetic fields.

Solid-phase immunoelectron microscopy for rapid diagnosis of enteroviruses

1984 ◽  
Vol 42 ◽  
pp. 226-227 ◽  
Author(s):  
K. Pegg-Feige ◽  
F. W. Doane
Keyword(s):  
Electron Microscopy ◽  
Cell Culture ◽  
Immunoelectron Microscopy ◽  
Detection Method ◽  
Solid Phase ◽  
Protein A ◽  
Plant Viruses ◽  
Rapid Diagnosis ◽  
Virus Diagnosis ◽  
Antiviral Antibody

Immunoelectron microscopy (IEM) applied to rapid virus diagnosis offers a more sensitive detection method than direct electron microscopy (DEM), and can also be used to serotype viruses. One of several IEM techniques is that introduced by Derrick in 1972, in which antiviral antibody is attached to the support film of an EM specimen grid. Originally developed for plant viruses, it has recently been applied to several animal viruses, especially rotaviruses. We have investigated the use of this solid phase IEM technique (SPIEM) in detecting and identifying enteroviruses (in the form of crude cell culture isolates), and have compared it with a modified “SPIEM-SPA” method in which grids are coated with protein A from Staphylococcus aureus prior to exposure to antiserum.

Application of solid-phase immune electron microscopy to study physical and stability characteristics of enterically transmitted non-a, non-b hepatitis virus

1988 ◽  
Vol 46 ◽  
pp. 80-81
Author(s):  
Charles D. Humphrey ◽  
E. H. Cook ◽  
Karen A. McCaustland ◽  
Daniel W. Bradley
Keyword(s):  
Electron Microscopy ◽  
Hepatitis A ◽  
Hepatitis A Virus ◽  
Solid Phase ◽  
Etiologic Agent ◽  
World Health ◽  
Health Concern ◽  
Morphological Identification ◽  
Immune Electron Microscopy

Enterically transmitted non-A, non-B hepatitis (ET-NANBH) is a type of hepatitis which is increasingly becoming a significant world health concern. As with hepatitis A virus (HAV), spread is by the fecal-oral mode of transmission. Until recently, the etiologic agent had not been isolated and identified. We have succeeded in the isolation and preliminary characterization of this virus and demonstrating that this agent can cause hepatic disease and seroconversion in experimental primates. Our characterization of this virus was facilitated by immune (IEM) and solid phase immune electron microscopic (SPIEM) methodologies.Many immune electron microscopy methodologies have been used for morphological identification and characterization of viruses. We have previously reported a highly effective solid phase immune electron microscopy procedure which facilitated identification of hepatitis A virus (HAV) in crude cell culture extracts. More recently we have reported utilization of the method for identification of an etiologic agent responsible for (ET-NANBH).

Identification of hepatitis a virus in cell cultures by solid phase immune electron microscopy

1986 ◽  
Vol 44 ◽  
pp. 238-239
Author(s):  
C.D. Humphrey ◽  
T.L. Cromeans ◽  
E.H. Cook ◽  
D.W. Bradley
Keyword(s):  
Electron Microscopy ◽  
Liquid Phase ◽  
Cell Cultures ◽  
Rapid Detection ◽  
Hepatitis A ◽  
Hepatitis A Virus ◽  
Solid Phase ◽  
Immune Electron Microscopy ◽  
Detection And Identification

There is a variety of methods available for the rapid detection and identification of viruses by electron microscopy as described in several reviews. The predominant techniques are classified as direct electron microscopy (DEM), immune electron microscopy (IEM), liquid phase immune electron microscopy (LPIEM) and solid phase immune electron microscopy (SPIEM). Each technique has inherent strengths and weaknesses. However, in recent years, the most progress for identifying viruses has been realized by the utilization of SPIEM.

Computer averaging of lattice images of poly-4-methyl-pentene-1 (P4mp1): Noise created artifacts

1987 ◽  
Vol 45 ◽  
pp. 388-389
Author(s):  
P. Pradère ◽  
J.F. Revol ◽  
R. St. John Manley
Keyword(s):  
Low Dose ◽  
Polymer Concentration ◽  
Processing System ◽  
Limiting Factor ◽  
Dilute Solution ◽  
New Techniques ◽  
Dose Unit ◽  
Lattice Images ◽  
Dose Imaging ◽  
Imaging Conditions

Although radiation damage is the limiting factor in HREM of polymers, new techniques based on low dose imaging at low magnification have permitted lattice images to be obtained from very radiation sensitive polymers such as polyethylene (PE). This paper describes the computer averaging of P4MP1 lattice images. P4MP1 is even more sensitive than PE (total end point dose of 27 C m-2 as compared to 100 C m-2 for PE at 120 kV). It does, however, have the advantage of forming flat crystals from dilute solution and no change in d-spacings is observed during irradiation.Crystals of P4MP1 were grown at 60°C in xylene (polymer concentration 0.05%). Electron microscopy was performed with a Philips EM 400 T microscope equipped with a Low Dose Unit and operated at 120 kV. Imaging conditions were the same as already described elsewhere. Enlarged micrographs were digitized and processed with the Spider image processing system.

Dynamic studies of silicide-mediated crystallization of amorphous silicon

1992 ◽  
Vol 50 (2) ◽  
pp. 1352-1353
Author(s):  
C. Hayzelden ◽  
J. L. Batstone
Keyword(s):  
Ion Implantation ◽  
Solid Phase ◽  
Metallic Phase ◽  
Single Crystal Substrate ◽  
Free Electrons ◽  
Melt Temperature ◽  
Transmission Electron ◽  
Crystal Substrate ◽  
High Resolution Tem

Epitaxial reordering of amorphous Si(a-Si) on an underlying single-crystal substrate occurs well below the melt temperature by the process of solid phase epitaxial growth (SPEG). Growth of crystalline Si(c-Si) is known to be enhanced by the presence of small amounts of a metallic phase, presumably due to an interaction of the free electrons of the metal with the covalent Si bonds near the growing interface. Ion implantation of Ni was shown to lower the crystallization temperature of an a-Si thin film by approximately 200°C. Using in situ transmission electron microscopy (TEM), precipitates of NiSi2 formed within the a-Si film during annealing, were observed to migrate, leaving a trail of epitaxial c-Si. High resolution TEM revealed an epitaxial NiSi2/Si(l11) interface which was Type A. We discuss here the enhanced nucleation of c-Si and subsequent silicide-mediated SPEG of Ni-implanted a-Si.Thin films of a-Si, 950 Å thick, were deposited onto Si(100) wafers capped with 1000Å of a-SiO2. Ion implantation produced sharply peaked Ni concentrations of 4×l020 and 2×l021 ions cm−3, in the center of the films.

Two-stage self-seeding method for preparation of single crystals of poly(phenylene sulfide)

1989 ◽  
Vol 47 ◽  
pp. 368-369
Author(s):  
Sengshiu Chung ◽  
Peggy Cebe
Keyword(s):  
Single Crystals ◽  
High Performance ◽  
Dilute Solution ◽  
Two Stage ◽  
Annealing Behavior ◽  
High Performance Polymers ◽  
Seeding Method ◽  
Phenylene Sulfide

We are studying the crystallization and annealing behavior of high performance polymers, like poly(p-pheny1ene sulfide) PPS, and poly-(etheretherketone), PEEK. Our purpose is to determine whether PPS, which is similar in many ways to PEEK, undergoes reorganization during annealing. In an effort to address the issue of reorganization, we are studying solution grown single crystals of PPS as model materials.Observation of solution grown PPS crystals has been reported. Even from dilute solution, embrionic spherulites and aggregates were formed. We observe that these morphologies result when solutions containing uncrystallized polymer are cooled. To obtain samples of uniform single crystals, we have used two-stage self seeding and solution replacement techniques.

TEM characterization of Au/Polysilicon interactions

1990 ◽  
Vol 48 (4) ◽  
pp. 650-651
Author(s):  
N. David Theodore ◽  
Leslie H. Allen ◽  
C. Barry Carter ◽  
James W. Mayer
Keyword(s):  
Solid Phase ◽  
Single Crystal Silicon ◽  
Chemical Vapor ◽  
Electrical Contacts ◽  
Silicon Substrates ◽  
Crystal Silicon ◽  
Transmission Electron ◽  
Polysilicon Films ◽  
The Stability

Metal/polysilicon investigations contribute to an understanding of issues relevant to the stability of electrical contacts in semiconductor devices. These investigations also contribute to an understanding of Si lateral solid-phase epitactic growth. Metals such as Au, Al and Ag form eutectics with Si. reactions in these metal/polysilicon systems lead to the formation of large-grain silicon. Of these systems, the Al/polysilicon system has been most extensively studied. In this study, the behavior upon thermal annealing of Au/polysilicon bilayers is investigated using cross-section transmission electron microscopy (XTEM). The unique feature of this system is that silicon grain-growth occurs at particularly low temperatures ∽300°C).Gold/polysilicon bilayers were fabricated on thermally oxidized single-crystal silicon substrates. Lowpressure chemical vapor deposition (LPCVD) at 620°C was used to obtain 100 to 400 nm polysilicon films. The surface of the polysilicon was cleaned with a buffered hydrofluoric acid solution. Gold was then thermally evaporated onto the samples.

New results on the solid-phase recrystallisation of ZnSe

1998 ◽  
Vol 184-185 (1-2) ◽  
pp. 1021-1025
Author(s):  
G Geoffroy
Keyword(s):  
Solid Phase
Sign in / Sign up

Export Citation Format

Share Document