Static and dynamic properties of Josephson fluxons and their implications on critical currents, especially in cuprate superconductors

INTRODUCTIONThe prospect of performing chemical analysis of thin specimens at any desired level of resolution is particularly appealing to the materials scientist. Commercial TEM-based systems are now available which virtually provide this capability. The purpose of this contribution is to illustrate its application to problems which would have been intractable until recently, pointing out some current limitations.X-RAY ANALYSISIn an attempt to fabricate superconducting materials with high critical currents and temperature, thin Nb3Sn films have been prepared by electron beam vapor deposition [1]. Fine-grain size material is desirable which may be achieved by codeposition with small amounts of Al2O3 . Figure 1 shows the STEM microstructure, with large (∽ 200 Å dia) voids present at the grain boundaries. Higher quality TEM micrographs (e.g. fig. 2) reveal the presence of small voids within the grains which are absent in pure Nb3Sn prepared under identical conditions. The X-ray spectrum from large (∽ lμ dia) or small (∽100 Ǻ dia) areas within the grains indicates only small amounts of A1 (fig.3).

Download Full-text

The distribution of antigen on the surface of RBL-2H3 rat basophilic leukemia cells observed by back-scattered electron imaging

Proceedings, annual meeting, Electron Microscopy Society of America ◽

10.1017/s0424820100142992 ◽

1986 ◽

Vol 44 ◽

pp. 274-275

Author(s):

R.F. Stump ◽

J.R. Pfeiffer ◽

JC. Seagrave ◽

D. Huskisson ◽

J.M. Oliver

Keyword(s):

Cell Surface ◽

Dynamic Properties ◽

Leukemia Cells ◽

Antigen Binding ◽

Scattered Electron ◽

Ige Receptor ◽

Receptor Complexes ◽

Rat Basophilic Leukemia Cells ◽

Electron Imaging ◽

Basophilic Leukemia

In RBL-2H3 rat basophilic leukemia cells, antigen binding to cell surface IgE-receptor complexes stimulates the release of inflammatory mediators and initiates a series of membrane and cytoskeletal events including a transformation of the cell surface from a microvillous to a lamellar topography. It is likely that dynamic properties of the IgE receptor contribute to the activation of these responses. Fewtrell and Metzger have established that limited crosslinking of IgE-receptor complexes is essential to trigger secretion. In addition, Baird and colleagues have reported that antigen binding causes a rapid immobilization of IgE-receptor complexes, and we have demonstrated an apparent increase with time in the affinity of IgE-receptor complexes for antigen.

Download Full-text

Epitaxy and texture analysis of Bi-Sr-Ca-Cu-O thin films on (100) MgO using Transmission Electron Microscopy

Proceedings, annual meeting, Electron Microscopy Society of America ◽

10.1017/s0424820100173479 ◽

1990 ◽

Vol 48 (4) ◽

pp. 68-69

Author(s):

J. T. Sizemore ◽

D. G. Schlom ◽

Z. J. Chen ◽

J. N. Eckstein ◽

I. Bozovic ◽

...

Keyword(s):

Electron Microscopy ◽

Thin Films ◽

Transmission Electron Microscopy ◽

Critical Currents ◽

Unit Cell ◽

X Ray Diffraction ◽

Cell Axis ◽

Transmission Electron ◽

Synthesis Procedure

Investigators observe large critical currents for superconducting thin films deposited epitaxially on single crystal substrates. The orientation of these films is often characterized by specifying the unit cell axis that is perpendicular to the substrate. This omits specifying the orientation of the other unit cell axes and grain boundary angles between grains of the thin film. Misorientation between grains of YBa2Cu3O7−δ decreases the critical current, even in those films that are c axis oriented. We presume that these results are similar for bismuth based superconductors and report the epitaxial orientations and textures observed in such films.Thin films of nominally Bi2Sr2CaCu2Ox were deposited on MgO using molecular beam epitaxy (MBE). These films were in situ grown (during growth oxygen was incorporated and the films were not oxygen post-annealed) and shuttering was used to encourage c axis growth. Other papers report the details of the synthesis procedure. The films were characterized using x-ray diffraction (XRD) and transmission electron microscopy (TEM).

Download Full-text

Microstructure of YBa2Cu3O7-x thin films deposited by dc sputtering

Proceedings, annual meeting, Electron Microscopy Society of America ◽

10.1017/s0424820100152835 ◽

1989 ◽

Vol 47 ◽

pp. 172-173

Author(s):

O. Eibl ◽

G. Gieres ◽

H. Behner

Keyword(s):

Thin Films ◽

Cross Sections ◽

Intermediate Layer ◽

Amorphous State ◽

Critical Currents ◽

Dc Sputtering ◽

State Process ◽

Diffraction Patterns ◽

Film Substrate ◽

Substrate Temperatures

The microstructure of high-Tc YBa2Cu3O7-X thin films deposited by DC-sputtering on SrTiO3 substrates was analysed by TEM. Films were either (i) deposited in the amorphous state at substrate temperatures < 450°C and crystallised by a heat treatment at 900°C (process 1) or (ii) deposited at around 740°C in the crystalline state (process 2). Cross sections were prepared for TEM analyses and are especially useful for studying film substrate interdiffusion (fig.1). Films deposited in process 1 were polycristalline and the grain size was approximately 200 nm. Films were porous and the size of voids was approximately 100 nm. Between the SrTiO3 substrate and the YBa2Cu3Ox film a densly grown crystalline intermediate layer approximately 150 nm thick covered the SrTiO3 substrate. EDX microanalyses showed that the layer consisted of Sr, Ba and Ti, however, did not contain Y and Cu. Crystallites of the layer were carefully tilted in the microscope and diffraction patterns were obtained in five different poles for every crystallite. These patterns were consistent with the phase (Ba1-XSrx)2TiO4. The intermediate layer was most likely formed during the annealing at 900°C. Its formation can be understood as a diffusion of Ba from the amorphously deposited film into the substrate and diffusion of Sr from the substrate into the film. Between the intermediate layer and the surface of the film the film consisted of YBa2Cu3O7-x grains. Films prepared in process 1 had Tc(R=0) close to 90 K, however, critical currents were as low as jc = 104A/cm2 at 77 K.

Download Full-text

Quantitative structure determination of interfaces through Z-contrast imaging and electron energy loss spectroscopy

Proceedings, annual meeting, Electron Microscopy Society of America ◽

10.1017/s0424820100162983 ◽

1996 ◽

Vol 54 ◽

pp. 104-105

Author(s):

S. J. Pennycook ◽

P. D. Nellist ◽

N. D. Browning ◽

P. A. Langjahr ◽

M. Rühle

Keyword(s):

Grain Boundaries ◽

Cuprate Superconductors ◽

Structure Refinement ◽

3D Structure ◽

Real Space ◽

Contrast Imaging ◽

Coordination Polyhedra ◽

Burgers Vector ◽

Z Contrast ◽

Contrast Image

The simultaneous use of Z-contrast imaging with parallel detection EELS in the STEM provides a powerful means for determining the atomic structure of grain boundaries. The incoherent Z-contrast image of the high atomic number columns can be directly inverted to their real space arrangement, without the use of preconceived structure models. Positions and intensities may be accurately quantified through a maximum entropy analysis. Light elements that are not visible in the Z-contrast image can be studied through EELS; their coordination polyhedra determined from the spectral fine structure. It even appears feasible to contemplate 3D structure refinement through multiple scattering calculations.The power of this approach is illustrated by the recent study of a series of SrTiC>3 bicrystals, which has provided significant insight into some of the basic issues of grain boundaries in ceramics. Figure 1 shows the structural units deduced from a set of 24°, 36° and 65° symmetric boundaries, and 24° and 45° asymmetric boundaries. It can be seen that apart from unit cells and fragments from the perfect crystal, only three units are needed to construct any arbitrary tilt boundary. For symmetric boundaries, only two units are required, each having the same Burgers, vector of a<100>. Both units are pentagons, on either the Sr or Ti sublattice, and both contain two columns of the other sublattice, imaging in positions too close for the atoms in each column to be coplanar. Each column was therefore assumed to be half full, with the pair forming a single zig-zag column. For asymmetric boundaries, crystal geometry requires two types of dislocations; the additional unit was found to have a Burgers’ vector of a<110>. Such a unit is a larger source of strain, and is especially important to the transport characteristics of cuprate superconductors. These zig-zag columns avoid the problem of like-ion repulsion; they have also been seen in TiO2 and YBa2Cu3O7-x and may be a general feature of ionic materials.

Download Full-text

Nucleosome dynamics

Biochemical Society Symposium ◽

10.1042/bss0730109 ◽

2006 ◽

Vol 73 ◽

pp. 109-119 ◽

Cited By ~ 2

Author(s):

Chris Stockdale ◽

Michael Bruno ◽

Helder Ferreira ◽

Elisa Garcia-Wilson ◽

Nicola Wiechens ◽

...

Keyword(s):

High Resolution ◽

Chromatin Structure ◽

Current Knowledge ◽

Dynamic Properties ◽

Structure And Dynamics ◽

Nucleosome Dynamics ◽

Sharp Focus ◽

Recent Advances ◽

Insight Into ◽

Chromatin Structure And Dynamics

In the 30 years since the discovery of the nucleosome, our picture of it has come into sharp focus. The recent high-resolution structures have provided a wealth of insight into the function of the nucleosome, but they are inherently static. Our current knowledge of how nucleosomes can be reconfigured dynamically is at a much earlier stage. Here, recent advances in the understanding of chromatin structure and dynamics are highlighted. The ways in which different modes of nucleosome reconfiguration are likely to influence each other are discussed, and some of the factors likely to regulate the dynamic properties of nucleosomes are considered.

Download Full-text