Evaluation of pausible clocking for interfacing high speed IP cores in GALS framework

2004 ◽  
Author(s):  
J. Mekie ◽  
S. Chakraborty ◽  
D.K. Sharma
Keyword(s):  
High Speed ◽  
Ip Cores

scholarly journals High Efficiency Generalized Parallel Counters for Look-Up Table Based FPGAs

2015 ◽  
Vol 2015 ◽  
pp. 1-16 ◽  
Author(s):  
Burhan Khurshid ◽  
Roohie Naaz Mir
Keyword(s):  
Power Dissipation ◽  
High Speed ◽  
High Efficiency ◽  
Critical Path ◽  
Fir Filters ◽  
Path Delay ◽  
Look Up Table ◽  
Improved Performance ◽  
Ip Cores ◽  
Low Efficiency

Generalized parallel counters (GPCs) are used in constructing high speed compressor trees. Prior work has focused on utilizing the fast carry chain and mapping the logic onto Look-Up Tables (LUTs). This mapping is not optimal in the sense that the LUT fabric is not fully utilized. This results in low efficiency GPCs. In this work, we present a heuristic that efficiently maps the GPC logic onto the LUT fabric. We have used our heuristic on various GPCs and have achieved an improvement in efficiency ranging from 33% to 100% in most of the cases. Experimental results using Xilinx 5th-, 6th-, and 7th-generation FPGAs and Stratix IV and V devices from Altera show a considerable reduction in resources utilization and dynamic power dissipation, for almost the same critical path delay. We have also implemented GPC-based FIR filters on 7th-generation Xilinx FPGAs using our proposed heuristic and compared their performance against conventional implementations. Implementations based on our heuristic show improved performance. Comparisons are also made against filters based on integrated DSP blocks and inherent IP cores from Xilinx. The results show that the proposed heuristic provides performance that is comparable to the structures based on these specialized resources.

scholarly journals AC_ICAP: A Flexible High Speed ICAP Controller

2015 ◽  
Vol 2015 ◽  
pp. 1-15 ◽  
Author(s):  
Luis Andres Cardona ◽  
Carles Ferrer
Keyword(s):  
High Speed ◽  
Access Port ◽  
Field Programmable ◽  
Programmable Gate Arrays ◽  
Speed Up ◽  
Run Time ◽  
Ip Cores ◽  
Similar Solutions ◽  
Internal Configuration ◽  
Run Time Reconfiguration

The Internal Configuration Access Port (ICAP) is the core component of any dynamic partial reconfigurable system implemented in Xilinx SRAM-based Field Programmable Gate Arrays (FPGAs). We developed a new high speed ICAP controller, named AC_ICAP, completely implemented in hardware. In addition to similar solutions to accelerate the management of partial bitstreams and frames, AC_ICAP also supports run-time reconfiguration of LUTs without requiring precomputed partial bitstreams. This last characteristic was possible by performing reverse engineering on the bitstream. Besides, we adapted this hardware-based solution to provide IP cores accessible from the MicroBlaze processor. To this end, the controller was extended and three versions were implemented to evaluate its performance when connected to Peripheral Local Bus (PLB), Fast Simplex Link (FSL), and AXI interfaces of the processor. In consequence, the controller can exploit the flexibility that the processor offers but taking advantage of the hardware speed-up. It was implemented in both Virtex-5 and Kintex7 FPGAs. Results of reconfiguration time showed that run-time reconfiguration of single LUTs in Virtex-5 devices was performed in less than 5 μs which implies a speed-up of more than 380x compared to the Xilinx XPS_HWICAP controller.

scholarly journals Designing High-Performance Fuzzy Controllers Combining IP Cores and Soft Processors

2012 ◽  
Vol 2012 ◽  
pp. 1-11 ◽  
Author(s):  
Oscar Montiel-Ross ◽  
Jorge Quiñones ◽  
Roberto Sepúlveda
Keyword(s):  
Parallel Programming ◽  
High Speed ◽  
High Performance ◽  
Hardware Description Language ◽  
System Response ◽  
Description Language ◽  
Tuning Method ◽  
Hardware Description ◽  
Ip Cores ◽  
Fuzzy Pd

This paper presents a methodology to integrate a fuzzy coprocessor described in VHDL (VHSIC Hardware Description Language) to a soft processor embedded into an FPGA, which increases the throughput of the whole system, since the controller uses parallelism at the circuitry level for high-speed-demanding applications, the rest of the application can be written in C/C++. We used the ARM 32-bit soft processor, which allows sequential and parallel programming. The FLC coprocessor incorporates a tuning method that allows to manipulate the system response. We show experimental results using a fuzzy PD+I controller as the embedded coprocessor.

scholarly journals Implementation of Audio Effect Generator in FPGA

2015 ◽  
Vol 15 (1) ◽  
pp. 89-98
Author(s):  
Sujit Rokka Chhetri ◽  
Bikash Poudel ◽  
Sandesh Ghimire ◽  
Shaswot Shresthamali ◽  
Dinesh Kumar Sharma
Keyword(s):  
Integrated Circuit ◽  
High Speed ◽  
Mathematical Formulation ◽  
Digital Signal ◽  
Ip Core ◽  
Field Programmable ◽  
Ip Cores ◽  
Shift Effect ◽  
Effect Generator ◽  
Pitch Shift

This paper describes the theory and implementation of audio effects such as echo, distortion and pitch-shift in Field Programmable Gate Array (FPGA). At first the mathematical formulation for generation of such effects is explained and then the algorithm is described for its implementation in FPGA using Very high speed integrated circuit hardware descriptive language (VHDL). The digital system being designed, which is synthesizable and reconfigurable, offers a great flexibility and scalability in designing and prototyping in FPGAs. The system is divided into three HDL blocks, each for echo, distortion, and pitch-shift effect generation, which are multiplexed in order to share the common ADC and DAC. The audio effect generator designed in this paper was successfully implemented in Spartan-3E FPGA utilizing the resources available effectively. There has been tremendous research being carried out in the field of IP core. Efficient IP cores designed to carry out digital signal processing are implemented in every modern device using configurable logics. This trend hasn’t yet been realized in Nepal. Through the design and implementation of audio effect generator, this paper also aims at bringing the field of IP core development to limelight among scholars of Nepal.DOI: http://dx.doi.org/10.3126/njst.v15i1.12022 Nepal Journal of Science and TechnologyVol. 15, No.1 (2014) 89-98

scholarly journals Modules for Pipelined Mixed Radix FFT Processors

2016 ◽  
Vol 2016 ◽  
pp. 1-7
Author(s):  
Anatolij Sergiyenko ◽  
Anastasia Serhienko
Keyword(s):  
Fourier Transform ◽  
Fast Fourier Transform ◽  
High Speed ◽  
Sampling Frequency ◽  
Data Sampling ◽  
Clock Frequency ◽  
Ip Cores ◽  
Point Fast Fourier Transform ◽  
The Cost

A set of soft IP cores for the Winogradr-point fast Fourier transform (FFT) is considered. The cores are designed by the method of spatial SDF mapping into the hardware, which provides the minimized hardware volume at the cost of slowdown of the algorithm byrtimes. Their clock frequency is equal to the data sampling frequency. The cores are intended for the high-speed pipelined FFT processors, which are implemented in FPGA.

Microfabrication research at the National Submicron Facility

1983 ◽  
Vol 41 ◽  
pp. 86-89
Author(s):  
E.D. Wolf
Keyword(s):  
Integrated Circuits ◽  
Particle Physics ◽  
High Speed ◽  
New Technology ◽  
High Energy ◽  
High Energy Particle ◽  
New Science ◽  
Wide Range ◽  
Intermediate Domain ◽  
Circuit Function

Most microelectronics devices and circuits operate faster, consume less power, execute more functions and cost less per circuit function when the feature-sizes internal to the devices and circuits are made smaller. This is part of the stimulus for the Very High-Speed Integrated Circuits (VHSIC) program. There is also a need for smaller, more sensitive sensors in a wide range of disciplines that includes electrochemistry, neurophysiology and ultra-high pressure solid state research. There is often fundamental new science (and sometimes new technology) to be revealed (and used) when a basic parameter such as size is extended to new dimensions, as is evident at the two extremes of smallness and largeness, high energy particle physics and cosmology, respectively. However, there is also a very important intermediate domain of size that spans from the diameter of a small cluster of atoms up to near one micrometer which may also have just as profound effects on society as “big” physics.

Vacuum System to Minimize the Specimen Contamination of High-Performance EM

1977 ◽  
Vol 35 ◽  
pp. 68-69
Author(s):  
N. Yoshimura ◽  
K. Shirota ◽  
T. Etoh
Keyword(s):  
Electron Microscope ◽  
High Speed ◽  
High Performance ◽  
High Vacuum ◽  
Vacuum System ◽  
Pump System ◽  
Pumping System ◽  
Diffusion Pump ◽  
Almost All ◽  
Cascade Type

One of the most important requirements for a high-performance EM, especially an analytical EM using a fine beam probe, is to prevent specimen contamination by providing a clean high vacuum in the vicinity of the specimen. However, in almost all commercial EMs, the pressure in the vicinity of the specimen under observation is usually more than ten times higher than the pressure measured at the punping line. The EM column inevitably requires the use of greased Viton O-rings for fine movement, and specimens and films need to be exchanged frequently and several attachments may also be exchanged. For these reasons, a high speed pumping system, as well as a clean vacuum system, is now required. A newly developed electron microscope, the JEM-100CX features clean high vacuum in the vicinity of the specimen, realized by the use of a CASCADE type diffusion pump system which has been essentially improved over its predeces- sorD employed on the JEM-100C.

The on-line use of histogram data for high-speed correction and alignment of electron microscope images

1984 ◽  
Vol 42 ◽  
pp. 556-557
Author(s):  
William Krakow
Keyword(s):  
Power Spectrum ◽  
High Speed ◽  
Direct Memory Access ◽  
Digital Television ◽  
Contrast Transfer Function ◽  
The Past ◽  
High Resolution Tem ◽  
On Line ◽  
Correction Of Astigmatism ◽  
The Fourier Transform

In the past few years on-line digital television frame store devices coupled to computers have been employed to attempt to measure the microscope parameters of defocus and astigmatism. The ultimate goal of such tasks is to fully adjust the operating parameters of the microscope and obtain an optimum image for viewing in terms of its information content. The initial approach to this problem, for high resolution TEM imaging, was to obtain the power spectrum from the Fourier transform of an image, find the contrast transfer function oscillation maxima, and subsequently correct the image. This technique requires a fast computer, a direct memory access device and even an array processor to accomplish these tasks on limited size arrays in a few seconds per image. It is not clear that the power spectrum could be used for more than defocus correction since the correction of astigmatism is a formidable problem of pattern recognition.

Sign in / Sign up

Export Citation Format

Share Document