Responses of terrestrial nitrogen pools and dynamics to different patterns of freeze-thaw cycle: A meta-analysis

2018 ◽  
Vol 24 (6) ◽  
pp. 2377-2389 ◽  
Author(s):  
Decai Gao ◽  
Lei Zhang ◽  
Jun Liu ◽  
Bo Peng ◽  
Zhenzhen Fan ◽  
...  
Keyword(s):  
Meta Analysis ◽  
Freeze Thaw ◽  
Nitrogen Pools ◽  
Thaw Cycle ◽  
Freeze Thaw Cycle

Experimental investigation on combined modification for micro physicochemical characteristics of coal by compound reagents and liquid nitrogen freeze-thaw cycle

Fuel ◽  
2021 ◽  
Vol 292 ◽  
pp. 120287
Author(s):  
Weibo Han ◽  
Gang Zhou ◽  
Junpeng Wang ◽  
Wenjing Jiang ◽  
Qian Zhang ◽  
...  
Keyword(s):  
Experimental Investigation ◽  
Liquid Nitrogen ◽  
Physicochemical Characteristics ◽  
Freeze Thaw ◽  
Thaw Cycle ◽  
Freeze Thaw Cycle

The effect of freeze–thaw cycle on the low-temperature properties of asphalt fine aggregate matrix utilizing bending beam rheometer

2016 ◽  
Vol 125 ◽  
pp. 101-107 ◽  
Author(s):  
Xiangbing Gong ◽  
Pedro Romero ◽  
Zejiao Dong ◽  
Daniel Scott Sudbury
Keyword(s):  
Low Temperature ◽  
Fine Aggregate ◽  
Bending Beam Rheometer ◽  
Freeze Thaw ◽  
Thaw Cycle ◽  
Freeze Thaw Cycle ◽  
Fine Aggregate Matrix

scholarly journals Effect of freeze–thaw cycle on physical and mechanical properties and damage characteristics of sandstone

2021 ◽  
Vol 11 (1) ◽  
Author(s):  
Longxiao Chen ◽  
Kesheng Li ◽  
Guilei Song ◽  
Deng Zhang ◽  
Chuanxiao Liu
Keyword(s):  
Mechanical Properties ◽  
Shear Failure ◽  
Triaxial Compression ◽  
Physical And Mechanical Properties ◽  
Freeze Thaw ◽  
Damage Characteristics ◽  
Large Pore ◽  
Natural Rock ◽  
Thaw Cycle ◽  
Freeze Thaw Cycle

AbstractRock deterioration under freeze–thaw cycles is a concern for in-service tunnel in cold regions. Previous studies focused on the change of rock mechanical properties under unidirectional stress, but the natural rock mass is under three dimensional stresses. This paper investigates influences of the number of freeze–thaw cycle on sandstone under low confining pressure. Twelve sandstone samples were tested subjected to triaxial compression. Additionally, the damage characteristics of sandstone internal microstructure were obtained by using acoustic emission (AE) and mercury intrusion porosimetry. Results indicated that the mechanical properties of sandstone were significantly reduced by freeze–thaw effect. Sandstone’ peak strength and elastic modulus were 7.28–37.96% and 6.38–40.87% less than for the control, respectively. The proportion of super-large pore and large pore in sandstone increased by 19.53–81.19%. We attributed the reduced sandstone’ mechanical properties to the degenerated sandstone microstructure, which, in turn, was associated with increased sandstone macropores. The macroscopic failure pattern of sandstone changed from splitting failure to shear failure with an increasing of freeze–thaw cycles. Moreover, the activity of AE signal increased at each stage, and the cumulative ringing count also showed upward trend with the increase of freeze–thaw number.

Non-linear creep damage model of sandstone under freeze-thaw cycle

2021 ◽  
Vol 28 (3) ◽  
pp. 954-967
Author(s):  
Jie-lin Li ◽  
Long-yin Zhu ◽  
Ke-ping Zhou ◽  
Hui Chen ◽  
Le Gao ◽  
...  
Keyword(s):  
Damage Model ◽  
Creep Damage ◽  
Freeze Thaw ◽  
Thaw Cycle ◽  
Linear Creep ◽  
Non Linear ◽  
Freeze Thaw Cycle ◽  
Creep Damage Model

scholarly journals Strength and Microscopic Damage Mechanism of Yellow Sandstone with Holes under Freezing and Thawing

2020 ◽  
Vol 2020 ◽  
pp. 1-13 ◽  
Author(s):  
Huren Rong ◽  
Jingyu Gu ◽  
Miren Rong ◽  
Hong Liu ◽  
Jiayao Zhang ◽  
...  
Keyword(s):  
Mechanical Properties ◽  
Pore Size ◽  
Power Function ◽  
Damage Mechanism ◽  
Uniaxial Compression Test ◽  
Freezing And Thawing ◽  
Freeze Thaw ◽  
Thaw Cycle ◽  
Freeze Thaw Cycle ◽  
Microscopic Damage

In order to study the damage characteristics of the yellow sandstone containing pores under the freeze-thaw cycle, the uniaxial compression test of saturated water-stained yellow sandstones with different freeze-thaw cycles was carried out by rock servo press, the microstructure was qualitatively analyzed by Zeiss 508 stereo microscope, and the microdamage mechanism was quantitatively studied by using specific surface area and pore size analyzer. The mechanism of weakening mechanical properties of single-hole yellow sandstone was expounded from the perspective of microstructure. The results show the following. (1) The number of freeze-thaw cycles and single-pore diameter have significant effects on the strength and elastic modulus of the yellow sandstone; the more the freeze-thaw cycles and the larger the pore size, the lower the strength of the yellow sandstone. (2) The damage modes of the yellow sandstone containing pores under the freeze-thaw cycle are divided into five types, and the yellow sandstone with pores is divided into two areas: the periphery of the hole and the distance from the hole; as the number of freeze-thaw cycles increases, different regions show different microscopic damage patterns. (3) The damage degree of yellow sandstone is different with freeze-thaw cycle and pore size. Freeze-thaw not only affects the mechanical properties of yellow sandstone but also accelerates the damage process of pores. (4) The damage of the yellow sandstone by freeze-thaw is logarithmic function, and the damage of the yellow sandstone is a power function. The damage equation of the yellow sandstone with pores under the freezing and thawing is a log-power function nonlinear change law and presents a good correlation.

Studies the Properties of Polyaspartic Polyurea Coated Concrete under Coaction of Salt Fog and Freeze-Thaw

2012 ◽  
Vol 455-456 ◽  
pp. 781-785
Author(s):  
Ping Lu ◽  
Xin Mao Li ◽  
Xue Qiang Ma ◽  
Wei Bo Huang
Keyword(s):  
Elastic Modulus ◽  
Frost Resistance ◽  
Dynamic Elastic Modulus ◽  
Freeze Thaw ◽  
Decrease Rate ◽  
Thaw Cycle ◽  
Freeze Thaw Cycle ◽  
Salt Fog

. This paper mainly studied the properties of PAE polyurea coated concrete under coactions of salt fog and freeze-thaw. After exposed salt fog conditions for 200d, T3, B2, F2 and TM four coated concrete relative dynamic elastic modulus have small changes, but different coated concrete variation amplitude is different. T3 coated concrete after 100 times of freeze-thaw cycle the relative dynamic elastic modulus began to drop, 200 times freeze-thaw cycle ends, relative dynamic elastic modulus variation is the largest, decrease rate is 95%, TM concrete during 200 times freeze-thaw cycle, relative dynamic elastic modulus almost no change, B2 concrete and F2 concrete the extent of change between coating T3 and TM. After 300 times the freeze-thaw cycle coated concrete didn't appear freeze-thaw damage phenomenon. Four kinds of coating concrete relative dynamic elastic modulus variation by large to small order: T3 coated concrete > B2 coated concrete >F2 coated concrete > TM coated concrete, concrete with the same 200d rule. Frost resistance order, by contrast, TM coated concrete > B2 coated concrete > F2 coated concrete > T3 coated concrete.

Protection of osteoblastic cells from freeze/thaw cycle-induced oxidative stress by green tea polyphenol

2005 ◽  
Vol 27 (9) ◽  
pp. 655-660 ◽  
Author(s):  
Dong-Wook Han ◽  
Hak Hee Kim ◽  
Mi Hee Lee ◽  
Hyun Sook Baek ◽  
Kwon-Yong Lee ◽  
...  
Keyword(s):  
Oxidative Stress ◽  
Green Tea ◽  
Osteoblastic Cells ◽  
Tea Polyphenol ◽  
Freeze Thaw ◽  
Thaw Cycle ◽  
Green Tea Polyphenol ◽  
Freeze Thaw Cycle

The Effect of Acid Treatment and Freeze-Thaw Cycle on Textural Properties and Microstructure of Cooked Aged Rice

2018 ◽  
pp. 1800098
Author(s):  
Kamonrat Trithavisup ◽  
Sanguansri Charoenrein
Keyword(s):  
Acid Treatment ◽  
Textural Properties ◽  
Freeze Thaw ◽  
Thaw Cycle ◽  
Freeze Thaw Cycle

scholarly journals Experimental Study on the Effect of freeze-thaw cycle on Silty Clay Stress–Strain Behaviour

2017 ◽  
Vol 216 ◽  
pp. 012041
Author(s):  
Rong Chen ◽  
Nan Xue ◽  
Dong-xue Hao ◽  
Yu-cong Gao
Keyword(s):  
Experimental Study ◽  
Silty Clay ◽  
Stress Strain ◽  
Freeze Thaw ◽  
Thaw Cycle ◽  
Strain Behaviour ◽  
Freeze Thaw Cycle

scholarly journals Experimental Study on Freeze-Thaw Cycle Duration of Saturated Tuff

2020 ◽  
Vol 2020 ◽  
pp. 1-10
Author(s):  
Man Huang ◽  
Bin Tang ◽  
Jianliang Jiang ◽  
Renqiu Guan ◽  
Huajun Wang
Keyword(s):  
Phase Transition ◽  
Power Function ◽  
Melting Process ◽  
Freezing Process ◽  
Freeze Thaw ◽  
Thaw Cycle ◽  
Freeze Thaw Cycle ◽  
Initial Melting ◽  
Time Required ◽  
Ice Water

The freeze-thaw duration is one of the important factors affecting the change of rock properties. However, this factor has not formed a unified standard in the freeze-thaw cycle test. This study uses saturated tuff samples taken from eastern Zhejiang, China, as research objects to explore the change law of the time required for the rock to reach a full freeze-thaw cycle. Measured results show that the total duration of the freeze-thaw cycle presents an increasing power function with the increase in the number of freeze-thaw cycles. The freezing process is divided into three phases: initial freezing, water-ice phase transition, and deep freezing. The melting process is also divided into three phases: initial melting, ice-water phase transition, and deep melting. The time required for the ice-water phase change stage of the melting process does not change with the increase in the number of freeze-thaw cycles, while the other stages increase as a power function. The proportion of duration of each stage in the freezing process does not change with the increase in the number of cycles. By contrast, the duration proportion of the initial melting phase in the melting process decreases, and the deep melting phase increases. Experimental results of the freeze-thaw cycles of tuff demonstrate that the freeze-thaw duration of the freeze-thaw cycles within 40 times can be set to 9 h. The freezing and melting processes are 6 and 3 h, respectively.

Sign in / Sign up

Export Citation Format

Share Document