Dielectric Relaxation in Binary and Ternary Mixtures of Ethanol, Water, and Benzene or n-Hexane

1985 ◽  
Vol 40 (6) ◽  
pp. 588-595 ◽  
Author(s):  
H. Utzel ◽  
M. Stockhausen
Keyword(s):  
Dielectric Relaxation ◽  
Complex Permittivity ◽  
Lower Order ◽  
Ternary Mixtures ◽  
Main Term ◽  
Frequency Range ◽  
Binary And Ternary Mixtures ◽  
Partially Miscible ◽  
Free Molecules

The complex permittivity of the partially miscible systems ethanol-water-benzene and ethanol-water- n-hexane has been measured in the frequency range from 20 MHz to 36 GHz at 20 °C. The results are described as superposition of Debye-terms, which are considered as physically significant and are ascribed to (i) higher, ill-defined, fluctuating self- and hetero-associates (main term), (ii) associates of lower order, relaxing by rotational tumbling, (iii) free molecules. The demultimerization by benzene appears to be more effective than by hexane.

Dielectric relaxation of lithium and sodium perchlorates in 1,2-dimethoxyethane and propylene carbonate

1981 ◽  
Vol 59 (7) ◽  
pp. 1051-1060 ◽  
Author(s):  
Hubert Cachet ◽  
Mohamed Fekir ◽  
Jean-Claude Lestrade
Keyword(s):  
Dielectric Properties ◽  
Ethyl Acetate ◽  
Dielectric Relaxation ◽  
Propylene Carbonate ◽  
Complex Permittivity ◽  
Ion Pairs ◽  
Conductivity Measurements ◽  
Frequency Range ◽  
Dielectric Data

The complex permittivity of LiClO4 and NaClO4 solutions in 1,2-dimethoxyethane (DME) has been measured in the frequency range 0.140–123.2 GHz. The data have been analysed according to a model for the reorientation of ion pairs given in a previous paper. The dielectric data are supplemented by conductivity measurements in a broad concentration range (10−4–1 mol/L) which evidence the large extent of salt association. The main result is that the solvation of Li+ and Na+ by DME cannot be described as simply as in the case of other solvents, such as tetrahydrofuran or ethyl acetate, as far as the dielectric properties are concerned: while the assumption of rigidly bound solvating molecules was acceptable for the latter solvents, some freedom in the reorientation of these molecules has to be taken into account for the case of DME. LiClO4 solutions in propylene carbonate (PC) + benzene and PC + DME mixtures have also been studied. The data, for the latter, can be qualitatively interpreted under the assumption that PC molecules take the place of DME molecules in the solvation sheath, even at low PC concentration.

Energy saving technology for sintering of black bricks from high-siliceous clay

MRS Advances ◽  
2020 ◽  
Vol 5 (61) ◽  
pp. 3123-3131
Author(s):  
Mario Flores Nicolas ◽  
Marina Vlasova ◽  
Pedro Antonio Márquez Aguilar ◽  
Mykola Kakazey ◽  
Marcos Mauricio Chávez Cano ◽  
...  
Keyword(s):  
Low Temperature ◽  
Oxygen Deficiency ◽  
Glass Ceramics ◽  
Total Content ◽  
Ceramic Materials ◽  
Ternary Mixtures ◽  
High Porosity ◽  
Reducing Conditions ◽  
Binary And Ternary Mixtures ◽  
Dark Color

AbstractThe low-temperature synthesis of bricks prepared from high-siliceous clays by the method of plastic molding of blanks was used. For the preparation of brick blanks, binary and ternary mixtures of high-siliceous clays, black sand, and bottle glass cullet were used. Gray-black low-porosity and high-porosity ceramics was obtained by sintering under conditions of oxygen deficiency. It has been established that to initiate plastic in mixtures containing high-siliceous clay, it is necessary to add montmorillonite/bentonite additives, carry out low-temperature sintering, and introduce low-melting glass additives with a melting point ranging from 750 to 800 °C. The performed investigations have shown that the sintering of mixtures with a total content of iron oxide of about 5 wt% under reducing conditions at Tsint. = 800°C for 8 h leads to the formation of glass ceramics consisting of quartz, feldspars, and a phase. The main sources of the appearance of a dark color is the formation of [Fe3+O4]4- and [Fe3+O6]9- anions in the composition of the glass phase and feldspars. By changing the contents of clay, sand, and glass in sintering, it is possible to obtain two types of ceramic materials: (a) in the form of building bricks and (b) in the form of porous fillers.

Properties of Refrigerants from Cubic Equations of State

2008 ◽  
Vol 59 (5) ◽  
Author(s):  
Viorel Feroiu ◽  
Dan Geana ◽  
Catinca Secuianu
Keyword(s):  
Experimental Data ◽  
Vapor Pressure ◽  
Equations Of State ◽  
Ternary Mixtures ◽  
Volumetric Properties ◽  
Mixing Rules ◽  
Saturation Curve ◽  
Equilibrium Thermodynamic ◽  
Liquid Equilibrium ◽  
Binary And Ternary Mixtures

Vapour � liquid equilibrium, thermodynamic and volumetric properties were predicted for three pure hydrofluorocarbons: difluoromethane (R32), pentafluoroethane (R125) and 1,1,1,2 � tetrafluoroethane (R134a) as well as for binary and ternary mixtures of these refrigerants. Three cubic equations of state GEOS3C, SRK (Soave � Redlich � Kwong) and PR (Peng � Robinson) were used. A wide comparison with literature experimental data was made. For the refrigerant mixtures, classical van der Waals mixing rules without interaction parameters were used. The GEOS3C equation, with three parameters estimated by matching several points on the saturation curve (vapor pressure and corresponding liquid volumes), compares favorably to other equations in literature, being simple enough for applications.

Catalytic hydrogenation of binary and ternary mixtures of unsaturated substances in the liquid phase on platinum

1979 ◽  
Vol 44 (8) ◽  
pp. 2378-2383 ◽  
Author(s):  
Libor Červený ◽  
Radka Junová ◽  
Vlastimil Růžička
Keyword(s):  
Liquid Phase ◽  
Binary Mixtures ◽  
Silica Gel ◽  
Catalytic Hydrogenation ◽  
Ternary Systems ◽  
Ternary Mixtures ◽  
Unsaturated Alcohol ◽  
Solvent Concentration ◽  
Binary And Ternary Mixtures ◽  
Hydrogenation Selectivity

Hydrogenation of olefinic substrates in binary and ternary mixtures using 5% Pt on silica gel as the catalyst was studied in normal conditions in the liquid phase with methanol or cyclohexane or in solvent-free systems. The effect of the solvent concentration on the selectivity of hydrogenation of the unsaturated alcohol-olefin binary mixtures was investigated. In ternary systems of unsaturated substrates, the effect of each of the substrates on the selectivity of hydrogenation of the remaining two substances was examined. Another system was found in which a jump change of the hydrogenation selectivity occurred on the vanishing of the fastest reacting substance.

scholarly journals How to Improve Physico-Chemical Properties of Silk Fibroin Materials for Biomedical Applications?—Blending and Cross-Linking of Silk Fibroin—A Review

Materials ◽  
2021 ◽  
Vol 14 (6) ◽  
pp. 1510
Author(s):  
Sylwia Grabska-Zielińska ◽  
Alina Sionkowska
Keyword(s):  
Silk Fibroin ◽  
Biomedical Applications ◽  
Magnetic Particles ◽  
Chemical Properties ◽  
Ternary Mixtures ◽  
Cross Linking ◽  
Advantages And Disadvantages ◽  
Physico Chemical ◽  
Binary And Ternary Mixtures ◽  
To Receive

This review supplies a report on fresh advances in the field of silk fibroin (SF) biopolymer and its blends with biopolymers as new biomaterials. The review also includes a subsection about silk fibroin mixtures with synthetic polymers. Silk fibroin is commonly used to receive biomaterials. However, the materials based on pure polymer present low mechanical parameters, and high enzymatic degradation rate. These properties can be problematic for tissue engineering applications. An increased interest in two- and three-component mixtures and chemically cross-linked materials has been observed due to their improved physico-chemical properties. These materials can be attractive and desirable for both academic, and, industrial attention because they expose improvements in properties required in the biomedical field. The structure, forms, methods of preparation, and some physico-chemical properties of silk fibroin are discussed in this review. Detailed examples are also given from scientific reports and practical experiments. The most common biopolymers: collagen (Coll), chitosan (CTS), alginate (AL), and hyaluronic acid (HA) are discussed as components of silk fibroin-based mixtures. Examples of binary and ternary mixtures, composites with the addition of magnetic particles, hydroxyapatite or titanium dioxide are also included and given. Additionally, the advantages and disadvantages of chemical, physical, and enzymatic cross-linking were demonstrated.

High Frequency Dielectric Response of the Ionic Liquid N-Methyl-N-ethylpyrrolidinium Dicyanamide

2007 ◽  
Vol 60 (1) ◽  
pp. 6 ◽  
Author(s):  
Simon Schrödle ◽  
Gary Annat ◽  
Douglas R. MacFarlane ◽  
Maria Forsyth ◽  
Richard Buchner ◽  
...  
Keyword(s):  
Ionic Liquid ◽  
Dielectric Loss ◽  
Dielectric Relaxation ◽  
High Frequency ◽  
Dielectric Response ◽  
Room Temperature ◽  
Room Temperature Ionic Liquid ◽  
Dielectric Relaxation Spectroscopy ◽  
Frequency Range ◽  
Fast Rotation

A study of the room-temperature ionic liquid N-methyl-N-ethylpyrrolidinium dicyanamide by dielectric relaxation spectroscopy over the frequency range 0.2 GHz ≤ ν ≤ 89 GHz has revealed that, in addition to the already known lower frequency processes, there is a broad featureless dielectric loss at higher frequencies. The latter is probably due to the translational (oscillatory) motions of the dipolar ions of the IL relative to each other, with additional contributions from their fast rotation.

Sign in / Sign up

Export Citation Format

Share Document