scholarly journals SIMULATED SOIL PROFILES AS A PLANT SCREENING TECHNIQUE

Author(s):  
M.E. Wedderburn ◽  
W.J. Pengelly ◽  
M.A. Tucker

A novel, simple technique for screening plants using simulated hill soil protiles is described. Three large bins were constructed and a soil profile built up in each using layers of hill subsoil and topsoil compacted to field bulk density. 2100 ryegrass plants were transplanted at 5 cm spacing in each ot the three bins. This technique has enabled controlled manipulation of soil fertility, development of simulated pure ward conditions and identification of individual plants. It has been used successfully to screen the hill ryegrass collection held at Whatawhata Research Centre for response to nitrogen and drought. Keywords: hill soils, ryegrass. nitrogen, drought, plant screening, soil profiles

Author(s):  
C. During

In this talk I intend to deal only with some of the major soils derived from volcanic ash, not with sand country or the hill soils derived from mudstone and sandstone. These volcanic soils of Taranaki suffer from two major deficiencies, phosphorus and potassium.


2015 ◽  
Vol 2 (2) ◽  
pp. 148-158
Author(s):  
Surianto

Spodosol soil of Typic Placorthod sub-group of East Barito District is one of the problem soils with the presence of hardpan layer, low fertility, low water holding capacity, acid reaction and it is not suitable for oil palm cultivation without any properly specific management of land preparation and implemented best agronomic practices. A study was carried out to evaluate the soil characteristic of a big hole (A profile) and no big hole (B profile) system and comparative oil palm productivity among two planting systems. This study was conducted in Spodosol soil at oil palm plantation (coordinate X = 0281843 and Y = 9764116), East Barito District, Central Kalimantan Province on February 2014, by surveying of placic and ortstein depth and observing soil texture and chemical properties of 2 (two) oil palm's soil profiles that have been planted in five years. Big hole system of commercial oil palm field planting on the Spodosol soil area was designed for the specific purpose of minimizing the potential of a negative effect of shallow effective planting depth for oil palms growing due to the hardpan layer (placic and ortstein) presence as deep as 0.25 - 0.50 m. The big hole system is a planting hole type which was vertical-sided with 2.00 m x 1.50 m on top and bottom side and 3.00 m depth meanwhile the 2:1 drain was vertical-sided also with 1.50 m depth and 300 m length. Oil palm production was recorded from the year 2012 up to 2014. Results indicated that the fractions both big hole profile (A profile) and no big hole profile (B profile) were dominated by sands ranged from 60% to 92% and the highest sands content of non-big hole soil profile were found in A and E horizons (92%). Better distribution of sand and clay fractions content in between layers of big hole soil profiles of A profile sample is more uniform compared to the B profile sample. The mechanical holing and material mixing of soil materials of A soil profile among the upper and lower horizons i.e. A, E, B and C horizons before planting that resulted a better distribution of both soil texture (sands and clay) and chemical properties such as acidity value (pH), C-organic, N, C/N ratio, CEC, P-available and Exchangeable Bases. Investigation showed that exchangeable cations (Ca, Mg, K), were very low in soil layers (A profile) and horizons (B profile) investigated. The low exchangeable cations due to highly leached of bases to the lower layers and horizons. Besides, the palm which was planted on the big hole system showed good adaptation and response positively by growing well of tertiary and quaternary roots that the roots were penetrable into deeper rooting zone as much as >1.00 m depth. The roots can grow well and penetrate much deeper in A profile compared to the undisturbed hardpan layer (B profile). The FFB (fresh fruit bunches) production of the non-big hole block was higher than the big hole block for the first three years of production. This might be due to the high variation of monthly rainfall in-between years of observation from 2009 to 2014. Therefore, the hardness of placic and ortstein as unpenetrable agents by roots and water to prevent water loss and retain the water in the rhizosphere especially in the drier weather. In the high rainfall condition, the 2:1 drain to prevent water saturation in the oil palm rhizosphere by moving some water into the drain. Meanwhile, the disturbed soil horizon (big hole area) was drier than un disturbance immediately due to water removal to deeper layers. We concluded that both big hole and 2:1 drain are a suitable technology for Spodosol soil land especially in preparing palms planting to minimize the negative effect of the hardpan layer for oil palm growth.


1975 ◽  
Vol 39 (6) ◽  
pp. 1220-1223
Author(s):  
K. M. Holtzclaw ◽  
J. M. Rible ◽  
P. F. Pratt
Keyword(s):  

2021 ◽  
Vol 70 (4) ◽  
pp. 369-380
Author(s):  
Marianna Ringer ◽  
◽  
Gergely Jakab ◽  
Péter Sipos ◽  
Máté Szabó ◽  
...  

This paper focuses on the vertical distribution and characterisation of pedogenic iron forms in a Gleysol- Histosol transect developed in a marshy area in the Danube-Tisza Interfluve, Hungary. Four soil profiles were investigated along a series of increasing waterlogging and spatial and temporal patterns of hydromorphic pedofeatures (characteristics of pedogenic iron forms) were recorded. Frequent and wide-range redox potential (Eh) changes caused the emergence of many types of redoximorphic iron features, including mottles, plaques and nodules. The forms of these features depended on the micro-environments determined by the vertical position in the soil profile and the presence of plant roots. The greatest iron enrichment occurred in the zone of most intensive and widest-range redox fluctuations. Increasing water saturation resulted the extension of gleyic pattern due to the existence of permanent reduction. Most of the features also showed annual variations during the varying periods of water saturation and aeration.


Author(s):  
H. Haruna

Land use changes from forest into cultivated ecosystems result in negative impact on soil structure and quality. The purpose of this study was to determine effect of land use on soil quality in Afaka forest northern guinea savannah of Nigeria. Land use systems, including natural forest and cultivated land were identified. Eighteen (18) composite disturbed and undisturbed samples were collected from depth of 0-5 and 5-10 cm for analysis of pertinent soil properties in the laboratory using grid procedure. Most physical and chemical properties show relative variations in response to land use types and geomorphic positions. Results  indicate  that the soils had  high degree of weathering potentials, low  to moderate  bulk density at 0-5cm depth values between 1.42 to 1.49 Mg m-3 in  forest and  cultivated land, bulk density of  1.34 and 1.46 1.Mg m-3at 5 -1ocm depth   for forest and  cultivated land respectively. The soil water at 0-5cm depth is from 4.20 to 2.63 cm3/cm3, while at 5-10 cm depth these values vary from 4.32 to 2.13 cm3/cm3 under forest and cultivation land use. The pH (H2O) is 6.9 to 7.16 with low electrical conductivity of 0.13 dS/m(forest) and 0.12 dS/m (cultivation). The CEC of soils is recorded as 8.60 cmol kg-1 (forest) to 8.54 cmol kg-1 (cultivated)whereas  total nitrogen content of 1.21 g kg-1 and 1.11 g kg-1 and available phosphorus of 8.78 mg kg-1 (cultivated) and 5.47 mg kg-1 (forest).. Results indicate that soil fertility parameters were moderate to low for cultivated land and at all slope positions, suggesting that soil fertility management is required in order to make agriculture sustainable on Afaka area.


Clay Minerals ◽  
1986 ◽  
Vol 21 (2) ◽  
pp. 149-157 ◽  
Author(s):  
S. Bouda ◽  
K. P. Isaac

AbstractBiotites from three peaty gleyed podzol soil profiles on ranite bedrock were examined to investigate the oxidation of the octahedral Fe during weathering. Oxidation of these biotites as determined by Mössbauer spectroscopy shows a good correlation with the in situ measured soil Eh values of the sampled horizons. In every soil profile the highest Eh measured is in the A horizon and the lowest in the C horizon. Similarly, biotites from the A horizons are the most oxidized compared with those from the lower horizons. In most of the samples the oxidation is accompanied by loss of K+ from the lattice, as demonstrated by a moderate degree of vermiculitization.


2002 ◽  
Vol 139 (4) ◽  
pp. 405-412 ◽  
Author(s):  
V. K. SINGH ◽  
B. B. SHARMA ◽  
B. S. DWIVEDI

Field experiments were conducted at the Crop Research Centre of Govind Ballabh Pant University of Agriculture and Technology, Pantnagar during 1996/97 and 1997/98. Each experiment comprised 10 crop sequences: (a) wheat–rice, (b) chickpea–rice, (c) lentil–rice, (d) pea–rice, (e) wheat–mungbean green manure–rice, (f) wheat–Sesbania green manure–rice, (g) wheat–fodder–rice, (h) chickpea–fodder–rice, (i) lentil–fodder–rice and (j) pea–fodder–rice, in a randomized block design with four replications. The crop sequences were compared in terms of economic rice equivalent yield (REY), protein production, apparent nutrient balances and effect on soil fertility status. Amongst crop sequences involving two crops each year (200% cropping intensity), chickpea–rice gave highest REY and protein production. Of the sequences involving three crops each year (300% cropping intensity), chickpea–fodder–rice and wheat–fodder–rice were superior to others. The P balances were positive for all sequences, whereas K balances were generally negative except for sequences involving green manure legumes. Green manuring with Sesbania or mungbean helped restore soil fertility, indicating the advantage of green manure for higher productivity and sustainability of rice–wheat system. Chickpea–rice and chickpea–fodder–rice appeared promising alternatives to rice–wheat crop sequence.


2011 ◽  
Vol 57 (2) ◽  
pp. 45-52
Author(s):  
Dana Kotorová ◽  
Jana Jakubová ◽  
Ladislav Kováč

Dependence of Heavy Soil Transport Function on Soil Profile DepthThe aim of this work was to quantify the effect of soil profile depth on the transport function of heavy soils. Treatments were carried out between 2006 and 2009 in Milhostov. Two variants were examined : the (conventional soil tillage and long-time no-tilled variant). Soil samples were taken in spring and autumn from soil profile depth of 0.00-0.60 m from each 0.10 m. For further evaluation the average values were used. Particle size composition, bulk density, total porosity and maximum capillary capacity were determined. Content of clay particles in soil profile was in interval 59.64-68.53% and such soils are characterised in the range from clay-loamy soil to clayey soil. The bulk density increased with the depth of soil profile and its values reached 1 184-1 646 kg m-3. The total porosity was in range 37.68-55.17% and it decreased with the depth of soil profile. The values of maximum capillary capacity were characterised for heavy soils with high content of clay particles. The depth had statistically significant effect on all observed parameters. In average, on both variants the bulk density was higher than 1 400 kg m-3, the total porosity was lower than 47% and the content of clay was higher than 30%, pointing to the possibility of soil compaction, which will result in reduced transport function of heavy soils.


2011 ◽  
Vol 50 (No. 6) ◽  
pp. 250-256 ◽  
Author(s):  
P. Prikner ◽  
F. Lachnit ◽  
F. Dvořák

The portable soil core sampler was engineered for gradual sampling of soil profile in the depth up to 0.5 m, which ensures extraction of the whole sample volume of soil profile in determinable depth. The portable soil core sampler was compared with the professional soil probe Eijkelkamp P1.31 (Eijkelkamp Agrisearch Equipment, Netherlands) in field conditions. The portable sampler was compared with the physical soil sample rings in laboratory conditions to eliminate all of possible restrictive aspects affecting the procedure of measurement. The portable soil core sampler with inner diameter 71 mm, depth 120 mmenables gradually take samples of soil profile by step of 50 mmand is able to detect possible local extremes. On the other hand a soil probe is not able to reach desired accuracy in taking of a&nbsp;soil sample. Values measured from a soil probe approximately taken by step of 150 mmare inaccurate. The values of bulk density of both sampling methods were variable at significant interval from 40 into 80 kg/m<sup>3</sup>. Different values could be caused by soil profile condition and by the use of different sampling methods. The design of a portable soil sampler should be of assistance in fast and precise soil profiling sample collection, which is required to determine bulk density of the soil, its variance depending on moisture content in soil compaction determining criteria.


Clay Minerals ◽  
1976 ◽  
Vol 11 (2) ◽  
pp. 121-135 ◽  
Author(s):  
J. Ducloux ◽  
A. Meunier ◽  
B. Velde

AbstractThree soil profiles developed on a serpentinite body (La Rochel'Abeille, near Limoges) show three stages of weathering. All soils contain iron-rich smectites and secondary chlorites. The latter are very silica-rich, more so than 14 Å chlorites from crystalline rocks. In the (B)1g horizon of the hydromorphic profile, these minerals seem to give a reaction of the type:This reaction, typical of a closed system, appears to be operative in a soil profile which is certainly, in part, open to chemical migration. The chemistry of the weathered serpentinite and the chemical composition of newly formed minerals as well as those of the serpentinite are used to indicate the chemiographic relations of clay minerals formed in the weathering profiles.


Sign in / Sign up

Export Citation Format

Share Document