scholarly journals The Photorefractive Response of Zn and Mo Codoped LiNbO3 in the Visible Region

Crystals ◽  
2019 ◽  
Vol 9 (5) ◽  
pp. 228 ◽  
Author(s):  
Liyun Xue ◽  
Hongde Liu ◽  
Dahuai Zheng ◽  
Shahzad Saeed ◽  
Xuying Wang ◽  
...  

We mainly investigated the effect of the valence state of photorefractive resistant elements on the photorefractive properties of codoped crystals, taking the Zn and Mo codoped LiNbO3 (LN:Mo,Zn) crystal as an example. Especially, the response time and photorefractive sensitivity of 7.2 mol% Zn and 0.5 mol% Mo codoped with LiNbO3 (LN:Mo,Zn7.2) crystal are 0.65 s and 4.35 cm/J at 442 nm, respectively. The photorefractive properties of the LN:Mo,Zn crystal are similar to the Mg and Mo codoped LiNbO3 crystal, which are better than the Zr and Mo codoped LiNbO3 crystal. The results show that the valence state of photorefractive resistant ions is an important factor for the photorefractive properties of codoped crystals and that the LN:Mo,Zn7.2 crystal is another potential material with fast response to holographic storage.

2018 ◽  
Vol 5 (2) ◽  
pp. 68-78 ◽  
Author(s):  
Intan Yuli Andhica ◽  
Dadan Irwan

ABSTRACT   One of the most frequently used server service functions is to provide a website access service, called a web server. In this study, we use two servers with Ubuntu operating system and Turnkey Linux with its objective to compare web performance to get parameters of response time value and throughput value. The test is carried out with a request rate of 10 to 100 with 1000 and 2000 connections. Based on the results obtained, Web server which uses Ubuntu Linux is better than Turnkey Linux, it is indicated by the value of small response time which means fast response and large throughput value, and this means good. A Web server that has 1000 connections generates a response time and a good throughput value, while the 2000 number of connections generates a response time value and a reduced throughput value, it is because for more than 1000 connections can affect the speed of the system.   Keywords : performance, web server, response time, thoughput     ABSTRAK   Salah satu fungsi layanan server yang sering digunakan adalah menyediakan layanan akses situs web, yang disebut sebagai web server. Dalam penelitian ini menggunakan dua server dengan sistem operasi Ubuntu dan Turnkey Linux dengan tujuan  membandingkan performa kinerja web  untuk mendapatkan parameter nilai responsese time dan nilai throughput. Pengujian dilakukan dengan request rate sebanyak 10 sampai 100 dengan jumlah 1000 koneksi dan 2000 koneksi. Berdasarkan hasil pengujian diperoleh bahwa Web server yang menggunakan Ubuntu Linux lebih baik dari Turnkey Linux yang ditunjukkan oleh nilai response time  kecil yang berarti response cepat dan nilai throughput besar yang berarti baik. Web server yang  memiliki jumlah 1000 koneksi menghasilkan nilai response time dan nilai throughput yang cukup baik, sedangkan jumlah 2000 koneksi menghasilkan nilai response time dan nilai throughput yang menurun karena jumlah koneksi yang lebih dari 1000 dapat mempengaruhi kecepatan sistem .        Kata kunci : performa, web server, response time, throughput


Nanomaterials ◽  
2021 ◽  
Vol 11 (4) ◽  
pp. 874
Author(s):  
Soyoung Bae ◽  
Youngno Kim ◽  
Jeong Min Kim ◽  
Jung Hyun Kim

MXene, a 2D material, is used as a filler to manufacture polymer electrolytes with high ionic conductivity because of its unique sheet shape, large specific surface area and high aspect ratio. Because MXene has numerous -OH groups on its surface, it can cause dehydration and condensation reactions with poly(4-styrenesulfonic acid) (PSSA) and consequently create pathways for the conduction of cations. The movement of Grotthuss-type hydrogen ions along the cation-conduction pathway is promoted and a high ionic conductivity can be obtained. In addition, when electrolytes composed of a conventional acid or metal salt alone is applied to an electrochromic device (ECD), it does not bring out fast response time, high coloration efficiency and transmittance contrast simultaneously. Therefore, dual-cation electrolytes are designed for high-performance ECDs. Bis(trifluoromethylsulfonyl)amine lithium salt (LiTFSI) was used as a source of lithium ions and PSSA crosslinked with MXene was used as a source of protons. Dual-Cation electrolytes crosslinked with MXene was applied to an indium tin oxide-free, all-solution-processable ECD. The effect of applying the electrolyte to the device was verified in terms of response time, coloration efficiency and transmittance contrast. The ECD with a size of 5 × 5 cm2 showed a high transmittance contrast of 66.7%, fast response time (8 s/15 s) and high coloration efficiency of 340.6 cm2/C.


Author(s):  
Liang-Chien Liu ◽  
Ping-Han Yang ◽  
Shih-Chi Liao ◽  
Bing-Peng Li ◽  
Fu-Cheng Wang ◽  
...  

This article presents the development of a visual-servo filming robot for dolly & truck style camera movement in filming applications. The robot was implemented with a fast-response slider as the upper stage on top of the slow-response tracked robot body as the lower stage, to improve target tracking performance. A new switching controller was developed, which controlled the stages’ motions by balancing and adjusting the weights of vision error and slider’s noncentering error of the upper stage, thus achieving tracking performance better than the traditional master–slave control strategy. The simulations were carried out to evaluate the tracking performance of the model, particularly focusing on evaluating how the dual stage improves the overall response of the model. The similar evaluation was executed experimentally as well. Both results confirm that the fast-response characteristics of the upper stage can compensate the slow dynamics of lower stage, the tracked robot which is inevitably heavy due to its composition.


2020 ◽  
Vol 8 (35) ◽  
pp. 12148-12154 ◽  
Author(s):  
Yifan Li ◽  
Yating Zhang ◽  
Tengteng Li ◽  
Xin Tang ◽  
Mengyao Li ◽  
...  

A novel self-powered NIR and THz PTE PD based on a (MAPbI3/PEDOT:PSS) composite with a rapid response time of 28 μs.


1995 ◽  
Vol 06 (05) ◽  
pp. 681-692
Author(s):  
R. ODORICO

A Neural Network trigger for [Formula: see text] events based on the SVT microvertex processor of experiment CDF at Fermilab is presented. It exploits correlations among track impact parameters and azimuths calculated by the SVT from the SVX microvertex detector data. The neural trigger is meant for implementation on the systolic Siemens microprocessor MA16, which has already been used in a neural-network trigger for experiment WA92 at CERN. A suitable set of input variables is found, which allows a viable solution for the preprocessing task using standard electronic components. The response time of the neural-network stage of the trigger, including preprocessing, can be estimated ~10 μs. Its precise value depends on the quantitative specifications of the output signals of the SVT, which is still in development. The performance of the neural-network trigger is found to be significantly better than that of a conventional trigger exclusively based on impact parameter data.


2006 ◽  
Vol 453 (1) ◽  
pp. 215-226 ◽  
Author(s):  
Sebastian Gauza ◽  
Chien-Hui Wen ◽  
Yang Zhao ◽  
Shin-Tson Wu ◽  
Anna Ziółek ◽  
...  

2016 ◽  
Vol 7 ◽  
pp. 1492-1500 ◽  
Author(s):  
Ionel Stavarache ◽  
Valentin Adrian Maraloiu ◽  
Petronela Prepelita ◽  
Gheorghe Iordache

Obtaining high-quality materials, based on nanocrystals, at low temperatures is one of the current challenges for opening new paths in improving and developing functional devices in nanoscale electronics and optoelectronics. Here we report a detailed investigation of the optimization of parameters for the in situ synthesis of thin films with high Ge content (50 %) into SiO2. Crystalline Ge nanoparticles were directly formed during co-deposition of SiO2 and Ge on substrates at 300, 400 and 500 °C. Using this approach, effects related to Ge–Ge spacing are emphasized through a significant improvement of the spatial distribution of the Ge nanoparticles and by avoiding multi-step fabrication processes or Ge loss. The influence of the preparation conditions on structural, electrical and optical properties of the fabricated nanostructures was studied by X-ray diffraction, transmission electron microscopy, electrical measurements in dark or under illumination and response time investigations. Finally, we demonstrate the feasibility of the procedure by the means of an Al/n-Si/Ge:SiO2/ITO photodetector test structure. The structures, investigated at room temperature, show superior performance, high photoresponse gain, high responsivity (about 7 AW−1), fast response time (0.5 µs at 4 kHz) and great optoelectronic conversion efficiency of 900% in a wide operation bandwidth, from 450 to 1300 nm. The obtained photoresponse gain and the spectral width are attributed mainly to the high Ge content packed into a SiO2 matrix showing the direct connection between synthesis and optical properties of the tested nanostructures. Our deposition approach put in evidence the great potential of Ge nanoparticles embedded in a SiO2 matrix for hybrid integration, as they may be employed in structures and devices individually or with other materials, hence the possibility of fabricating various heterojunctions on Si, glass or flexible substrates for future development of Si-based integrated optoelectronics.


1997 ◽  
Vol 471 ◽  
Author(s):  
J. Liu ◽  
D. C. Morton ◽  
M. R. Miller ◽  
Y. Li ◽  
E. W. Forsythe ◽  
...  

ABSTRACTZn2SiO4:Mn thin films were deposited and studied as thin film phosphors for flat panel cathodoluminescent displays. Crystallized films with improved electrical conductivity were obtained after conventional and rapid thermal annealings in a N2 environment at 850Xy11100 °C for 0.25 to 60 minutes. A maximum cathodoluminescent efficiency of 1.3 Lm/W was achieved under dc excitation at 1500 volts. The luminescent emission from these thin films was peaked around 525 nm. The decay time of these films was controlled in the range of 2 to 10 ms by varying the deposition and annealing parameters. The fast response time of these thin films overcomes the long decay limitation of the Zn2SiO4:Mn powder phosphor in practical display applications.


2021 ◽  
Author(s):  
Rashid Khogali

We synthesize online scheduling algorithms to optimally assign a set of arriving heterogeneous tasks to heterogeneous speed-scalable processors under the single threaded computing architecture. By using dynamic speed-scaling, where each processor's speed is able to dynamically change within hardware and software processing constraints, the goal of our algorithms is to minimize the total financial cost (in dollars) of response time and energy consumption (TCRTEC) of the tasks. In our work, the processors are heterogeneous in that they may differ in their hardware specifications with respect to maximum processing rate, power function parameters and energy sources. Tasks are heterogeneous in terms of computation volume, memory and minimum processing requirements. We also consider that the unit price of response time for each task is heterogeneous because the user may be willing to pay higher/lower unit prices for certain tasks, thereby increasing/decreasing their optimum processing rates. We model the overhead loading time incurred when a task is loaded by a given processor prior to its execution and assume it to be heterogeneous as well. Under the single threaded, single buffered computing architecture, we synthesize the SBDPP algorithm and its two other versions. Its first two versions allow the user to specify the unit price of energy and response time for executing each arriving task. The algorithm's second version extends the functionality of the first by allowing the user or the OS of the computing device to further modify a task's unit price of time or energy in order to achieve a linearly controlled operation point that lies somewhere in the economy-performance mode continuum of a task's execution. The algorithm's third version operates exclusively on the latter. We briefly extend the algorithm and its versions to consider migration, where an unfinished task is paused and resumed on another processor. The SBDPP algorithm is qualitatively compared against its two other versions. The SBDPP dispatcher is analytically shown to perform better than the well known Round Robin dispatcher in terms of the TCRTEC performance metric. Through simulations we deduce a relationship between the arrival rate of tasks, number of processors and response time of tasks. Under the Single threaded, multi-buffered computing architecture we have four contributions that constitute the SMBSPP algorithm. First, we propose a novel task dispatching strategy for assigning the tasks to the processors. Second, we propose a novel preemptive service discipline called Smallest remaining Computation Volume Per unit Price of response Time (SCVPPT) to schedule the tasks on the assigned processor. Third, we propose a dynamic speed-scaling function that explicitly determines the optimum processing rate of each task. Most of the simulations consider both stochastic and deterministic traffic conditions. Our simulation results show that SCVPPT outperforms the two known service disciplines, Shortest Remaining Processing Time (SRPT) and the First Come First Serve (FCFS), in terms of minimizing the TCRTEC performance metric. The results also show that the algorithm's dispatcher drastically outperforms the well known Round Robin dispatcher with cost savings exceeding 100% even when the processors are mildly heterogeneous. Finally, analytical and simulation results show that our speed scaling function performs better than a comparable speed scaling function in current literature. Under a fixed budget of energy, we synthesize the SMBAD algorithm which uses the micro-economic laws of Supply and Demand (LSD) to heuristically adjust the unit price of energy in order to extend battery life and execute more than 50% of tasks on a single processor (under the single threaded, multi buffered computing architecture). By extending all our multiprocessor algorithms to factor independent (battery) energy sources that is associated with each processor, we analytically show that load balancing effects are induced on hetergeneous parallel processors. This happens when the unit price of energy is adjusted by the battery level of each processor in accordance with LSD. Furthermore, we show that a variation of this load balancing effect also occurs when the heterogeneous processors use a single battery as long as they operate at unconstrained processing rates.


Sign in / Sign up

Export Citation Format

Share Document