Assessment of the Impact of Applying a Non-Factory Dual-Fuel (Diesel/Natural Gas) Installation on the Traction Properties and Emissions of Selected Exhaust Components of a Road Semi-Trailer Truck Unit

Energies ◽  
2021 ◽  
Vol 14 (23) ◽  
pp. 8001
Author(s):  
Mirosław Karczewski ◽  
Marcin Wieczorek
Keyword(s):  
Natural Gas ◽  
Carbon Dioxide Emissions ◽  
Hydrocarbon Fuel ◽  
Supply System ◽  
Operating Conditions ◽  
Dual Fuel ◽  
Compressed Natural Gas ◽  
Engine Wear ◽  
The Impact ◽  
Gas Supply

Problems such as global warming and rising oil prices are driving the implementation of ideas to reduce liquid fuel consumption and greenhouse gas emissions. One of them is the use of natural gas as an energy source. It is a hydrocarbon fuel with properties that allow the reduction of CO2 (Carbon Dioxide) emissions during combustion. Solutions are being implemented that allow for the use of natural gas to means of transport, namely in trucks of various categories and intended use. These installations are used in new vehicles, but also in the form of conversion for used cars, usually several years old. The article presents the results of tests of an engine from a used semi-trailer truck with a mileage of approx. 800 thousand km, with the compressed natural gas supply system installed. This installation (hardware and software), depending on the engine operating conditions, enables the replacement of up to 80% of diesel (base fuel) with natural gas. The impact of changing the fuel supply method on the traction characteristics calculated with the use of external characteristics of both conventional and dual-fuel mode was assessed. The emissions of exhaust gas components were also determined under the conditions of the UNECE Regulation No. 49. The test results confirm that compared to conventional fueling, dual fueling allows for a significant reduction in CO2 emissions, even in a used vehicle with high mileage. The use of a non-factory installation did not significantly affect the traction properties of the vehicle, and engine wear is of greater importance in this case (comparison with factory data). The work is a valuable supplement to the results of the research in which the impact of the use of a non-factory CNG (Compressed Natural Gas) supply system on the performance of a semi-trailer truck unit equipped with such an installation was assessed compared to a semi-trailer truck unit powered in a classic way with diesel fuel.

Combustion characteristics of compressed natural gas/diesel dual-fuel turbocharged compressed ignition engine

2003 ◽  
Vol 217 (9) ◽  
pp. 833-838 ◽  
Author(s):  
Liu Shenghua ◽  
Zhou Longbao ◽  
Wang Ziyan ◽  
Ren Jiang
Keyword(s):  
Natural Gas ◽  
Ignition Delay ◽  
Combustion Characteristics ◽  
Operating Conditions ◽  
Dual Fuel ◽  
Compressed Natural Gas ◽  
Delay Effects ◽  
Low Load ◽  
Performance And Emissions ◽  
Ci Engine

The combustion characteristics of a turbocharged natural gas and diesel dual-fuelled compression ignition (CI) engine are investigated. With the measured cylinder pressures of the engine operated on pure diesel and dual fuel, the ignition delay, effects of pilot diesel and engine load on combustion characteristics are analysed. Emissions of HC, CO, NOx and smoke are measured and studied too. The results show that the quantity of pilot diesel has important effects on the performance and emissions of a dual-fuel engine at low-load operating conditions. Ignition delay varies with the concentration of natural gas. Smoke is much lower for the developed dual-fuel engine under all the operating conditions.

scholarly journals Modeling of Three-Way Catalyst Dynamics for a Compressed Natural Gas Engine during Lean–Rich Transitions

2019 ◽  
Vol 9 (21) ◽  
pp. 4610 ◽  
Author(s):  
Dario Di Maio ◽  
Carlo Beatrice ◽  
Valentina Fraioli ◽  
Pierpaolo Napolitano ◽  
Stefano Golini ◽  
...  
Keyword(s):  
Steady State ◽  
Natural Gas ◽  
Catalytic Converter ◽  
Operating Conditions ◽  
Oxygen Storage ◽  
Continuous Control ◽  
Engine Exhaust ◽  
Compressed Natural Gas ◽  
The Impact ◽  
Three Way Catalyst

The main objective of the present research activity was to investigate the effect of very fast composition transitions of the engine exhaust typical in real-world driving operating conditions, as fuel cutoff phases or engine misfire, on the aftertreatment devices, which are generally very sensitive to these changes. This phenomenon is particularly evident when dealing with engines powered by natural gas, which requires the use of a three-way catalyst (TWC). Indeed, some deviations from the stoichiometric lambda value can interfere with the catalytic converter efficiency. In this work, a numerical “quasi-steady” model was developed to simulate the chemical and transport phenomena of a specific TWC for a compressed natural gas (CNG) heavy-duty engine. A dedicated experimental campaign was performed in order to evaluate the catalyst response to a defined λ variation pattern of the engine exhaust stream, thus providing the data necessary for the numerical model validation. Tests were carried out to reproduce oxygen storage phenomena that make catalyst behavior different from the classic steady-state operating conditions. A surface reaction kinetic mechanism concerning CH4, CO, H2, oxidation and NO reduction has been appropriately calibrated at different λ values with a step-by-step procedure, both in steady-state conditions of the engine work plan and during transient conditions, through cyclical and consecutive transitions of variable frequency between rich and lean phases. The activity also includes a proper calibration of the reactions involving cerium inside the catalyst in order to reproduce oxygen storage and release dynamics. Sensitivity analysis and continuous control of the reaction rate allowed evaluating the impact of each of them on the exhaust composition in several operating conditions. The proposed model predicts tailpipe conversion/formation of the main chemical species, starting from experimental engine-out data, and provides a useful tool to evaluate the catalyst’s performance.

Development of compressed natural gas/diesel dual-fuel turbocharged compression ignition engine

2003 ◽  
Vol 217 (9) ◽  
pp. 839-845 ◽  
Author(s):  
Liu Shenghua ◽  
Wang Ziyan ◽  
Ren Jiang
Keyword(s):  
Natural Gas ◽  
Operating Conditions ◽  
Dual Fuel ◽  
Boost Pressure ◽  
Compression Ignition ◽  
Compression Ignition Engine ◽  
Compressed Natural Gas ◽  
Ci Engine ◽  
Heavy Duty Diesel ◽  
Reduce Emissions

A natural gas and diesel dual-fuel turbocharged compression ignition (CI) engine is developed to reduce emissions of a heavy-duty diesel engine. The compressed natural gas (CNG) pressure regulator is specially designed to feed back the boost pressure to simplify the fuel metering system. The natural gas bypass improves the engine response to acceleration. The modes of diesel injection are set according to the engine operating conditions. The application of honeycomb mixers changes the flowrate shape of natural gas and reduces hydrocarbon (HC) emission under low-load and lowspeed conditions. The cylinder pressures of a CI engine fuelled with diesel and dual fuel are analysed. The introduction of natural gas makes the ignition delay change with engine load. Under the same operating conditions, the emissions of smoke and NOx from the dual-fuel engine are both reduced. The HC and CO emissions for the dual-fuel engine remain within the range of regulation.

scholarly journals Instantaneous and cycle optimization of fuel usage on a dual fuel vehicle leveraging gasoline and natural gas

2017 ◽  
Vol 233 (2) ◽  
pp. 292-303
Author(s):  
Carrie M Hall ◽  
Michael Pamminger ◽  
James Sevik ◽  
Thomas Wallner
Keyword(s):  
Natural Gas ◽  
Control Strategies ◽  
Time Instant ◽  
Control Technique ◽  
Dual Fuel ◽  
Compressed Natural Gas ◽  
Engine Efficiency ◽  
Transportation Sector ◽  
Dual Fuel Engines ◽  
The Impact

Recent increases in natural gas supply have led to a desire to leverage this fuel in the transportation sector. Dual fuel engines provide a platform on which to use natural gas efficiently; these engines, however, require new hardware and new control strategies to properly utilize two fuels simultaneously. This paper explores the impact of implementing dual fuel capabilities on a sedan and demonstrates that a dual fuel E10 and compressed natural gas engine is able to improve the average engine efficiency by up to 6.5% compared to a single fuel engine on standard drive cycles. An optimal control technique is also developed, and the proposed approach allows factors including fuel cost and fuel availability to be taken into account. Optimization at each time instant is investigated and contrasted with optimization over the entire cycle. Cycle optimization is shown to have particular value for cases in which the level in one fuel tank is low.

scholarly journals Design and Experiment of Low-Pressure Gas Supply System for Dual Fuel Engine

2020 ◽  
Vol 27 (2) ◽  
pp. 76-84
Author(s):  
Xiaoyong Gu ◽  
Guohe Jiang ◽  
Zhenghua Guo ◽  
Shangzhi Ding
Keyword(s):  
Heat Exchange ◽  
Natural Gas ◽  
Low Pressure ◽  
Supply System ◽  
Dual Fuel ◽  
Exchange Area ◽  
Dual Fuel Engines ◽  
Buffer Tank ◽  
Glycol Solution ◽  
Gas Supply

AbstractA low-pressure gas supply system for dual fuel engines was designed to transport liquid natural gas from a storage tank to a dual fuel engine and gasify it during transportation. The heat exchange area and pressure drop in the spiral- wound heat exchanger, the volume of the buffer tank and the pressure drop in the pipeline of the gas supply system were calculated by programming using Python. Experiments were carried out during the process of starting and running the dual fuel engine using this gas supply system. Experimental data show that the gas supply system can supply gas stably during the process and ensure the stable operation of the dual fuel engine. The effects of the parameters of natural gas and ethylene glycol solution on the heat exchange area of the spiral-wound heat exchanger and the volume of the buffer tank in the gas supply system were studied. The results show that the heat exchange area calculated according to pure methane can adapt to the case of non-pure methane. The temperature difference between natural gas and ethylene glycol solution should be increased in order to reduce the heat exchange area. The heat exchange area selected according to the high pressure of natural gas can adapt to the low pressure of natural gas. The volume of the buffer tank should be selected according to the situation of the minimum methane content to adapt to the situation of high methane content. The main influencing factor in selecting the volume of the buffer tank is the natural gas flow. The results can provide guidance for the design of the gas supply system for dual fuel engines.

Research of pressure influence in the gas supply system on the energy consuption level of gas devices

2019 ◽  
Vol 6 (2) ◽  
pp. 56-63
Author(s):  
L. D. Pylypiv ◽  
І. І. Maslanych
Keyword(s):  
Natural Gas ◽  
Residential Buildings ◽  
Supply System ◽  
Normal Operation ◽  
Gas Combustion ◽  
Efficient Operation ◽  
Gas Consumption ◽  
Natural Gas Combustion ◽  
Gas Supply

There are investigated the influence of operating pressures in the gas supply system on the level of such energy indicators as efficiency, gas flow and gas overrun by gas equipment in residential buildings. There is established a relationship between the values of operating pressures in the gas supply system and the gas consumption level of household appliances. The causes of insufficient pressure in the gas networks of settlements are analyzed in the article. There is also developed an algorithm for calculating the change in the efficiency of gas appliances depending on the operational parameters of the gas network. It has been found that the most efficient operation of gas appliances is observed at an overpressure at the inlet of gas appliances of about 1200 Pa.To ensure the required quality of natural gas combustion among consumers and minimize gas consumption there are justified the following measures in the article: coordinating a domestic regulatory framework for assessing the quality of natural gas with international norms and standards; improving the preparation of gas coming from local wells before supplying it to gas distribution networks; auditing low pressure gas pipelines and reconstructing areas affected by corrosion; ensuring standard gas pressure in the network for the normal operation of domestic gas appliances; stating quality indicators of natural gas combustion by gas sales organizations.

Concept and principles of building an integrated system of management of activities of regional gas supply system entities Kaliningrad region

2019 ◽  
pp. 64-72
Author(s):  
G.G. Arunyants
Keyword(s):  
Control System ◽  
Natural Gas ◽  
Supply System ◽  
Integrated System ◽  
Software Complex ◽  
Geographically Distributed ◽  
Basic Solutions ◽  
Kaliningrad Region ◽  
And Control ◽  
Gas Supply

The results of analysis of problems of regulation of gas supply complex of Kaliningrad region and main ways to increase its efficiency, as well as basic solutions for creation of a software complex Т-GAZ-2 automated calculation of natural gas tariffs for ACS of gas supply system subjects, geographically distributed and information connected to the regional automated information and control system (RAIS).

Comparative assessment of engine vibration, combustion, performance and emission characteristics between single and twin-cylinder diesel engines in unifuel and dual-fuel mode

2021 ◽  
pp. 1-39
Author(s):  
Akash Chandrabhan Chandekar ◽  
Sushmita Deka ◽  
Biplab K. Debnath ◽  
Ramesh Babu Pallekonda
Keyword(s):  
Natural Gas ◽  
Alternative Fuels ◽  
Load Condition ◽  
Alternative Fuel ◽  
Dual Fuel ◽  
Cylinder Pressure ◽  
Compressed Natural Gas ◽  
Single Cylinder ◽  
Engine Vibration ◽  
Single Cylinder Engine

Abstract The persistent efforts among the researchers are being done to reduce emissions by the exploration of different alternative fuels. The application of alternative fuel is also found to influence engine vibration. The present study explores the potential connection between the change of the engine operating parameters and the engine vibration pattern. The objective is to analyse the effect of alternative fuel on engine vibration and performance. The experiments are performed on two different engines of single cylinder and twin-cylinder variants at the load range of 0 to 34Nm, with steps of 6.8Nm and at the constant speed of 1500rpm. The single cylinder engine, fuelled with only diesel mode, is tested at two compression ratios of 16.5 and 17.5. While, the twin-cylinder engine with a constant compression ratio of 16.5, is tested at both diesel unifuel and diesel-compressed natural gas dual-fuel modes. Further, in dual-fuel mode, tests are conducted with compressed natural gas substitutions of 40%, 60% and 80% for given loads and speed. The engine vibration signatures are measured in terms of root mean square acceleration, representing the amplitude of vibration. The combustion parameters considered are cylinder pressure, rate of pressure rise, heat release rate and ignition delay. At higher loads, the vibration amplitude increases along with the cylinder pressure. The maximum peak cylinder pressure of 95bar is found in the case of the single cylinder engine at the highest load condition that also produced a peak vibration of 3219m/s2.

Sign in / Sign up

Export Citation Format

Share Document