scholarly journals MORFOMETRI GISIK KAWASAN PANTAI WISATA BAHARI SARIO KOTA MANADO

2021 ◽  
Vol 9 (2) ◽  
pp. 35
Author(s):  
Zulkifli Otoluwa ◽  
Rignolda Djamaluddin ◽  
Royke M Rampengan ◽  
Jane Mamuaya ◽  
Esry T Opa ◽  
...  

Beach formation has an important role in protecting land from the action of the sea and it is useful for recreation, conservation and other uses. In “Wisata Bahari Sario” Kota Manado coastal area there is still a particular area of beach that is used for various purposes, so it is important to study its morphology. This research was conducted with the aim of describing morphology and analyzing oceanographic factors that affected the dynamic process of beach morphology. The results showed that the beach had an area of 422.69 m2, with the criteria for short slopes in the Northeast and long slopes in the Southwest. The shapes of the beach surface were in the form of gutters and shoots, their appearance was more visible towards the Southwest. In general, the deposition process took place more intensively in the Southwestern part of the beach. Keywords: Beach, Morphology, Slope, Deposition

2001 ◽  
Vol 172 (6) ◽  
pp. 723-736 ◽  
Author(s):  
Hassan El Arabi ◽  
Benali Ouahhabi ◽  
Andre Charriere

Abstract Toarcian and Aalenian deposits from south west of the Middle Atlas named "Couches du Seloum", were classically considered as a "border facies" of the Middle Atlas trough, which was extensively developed in the northern part of the folded Middle Atlas. Both studies realized on the border of the Bekrit-Timahdite syncline and the Iguer Awragh-Afennourir syncline, allow to specify the stratigraphy, the spatial distribution of deposits and to reconsider the paleogeographic organization of this "border" in the integral context of the northern Middle Atlas trough during the Toarcian and the lower Bajocian interval. A lithostratigraphic succession of the "Couches du Selloum" raised in the western part of Bekrit-Timahdite syncline shows the superposition of three units. Unit 1 is made of clay, reddish and gray marl, locally gypseous, assigned to the lower Toarcian. Unit 2 is essentially composed of a subnodular calcareous series, which consists of discontinuous, wavy and upward-thickening beds. The upper offshore is the most frequent environment. It is mainly made of crinoidal calcarenites, yielding some ammonites and brachiopods rich levels. The Middle Toarcian (Bifrons zone and Gradata zone) was identified in the lower part of this unit. Most of the upper Toarcian zones were distinguished (Speciosum zone, Meneghinii zone and Aalensis zone), they are represented in the upper part by brachiopods (Stroudithyris) and ammonites (Hammatoceras, Dumortieria and Catulloceras) rich set. On several lateral sections, the uppermost part of these pseudo nodular limestones is dated from Opalinum zone (levels with Leioceras and Tmetoceras). Unit 3 shows several facies: bioclastic calcarenites arranged in decimetrics beds, showing cross stratifications; microsparitic limestones in thick beds with silexites. The macrofauna is scarce, often represented by some crinoidal and mollusks fragments; some Zoophycos appear in the top bed of the set. The following deposits illustrate the evolution from the shoreface to the upper offshore. This unit is overlain by a sedimentary discontinuity, materialized by a boring surface, some pockets of accumulations with belemnites and a cover of ferruginous nodules. Ammonites drowned on the discontinuity surface or in the basis of the first interbedded marls which overlies this surface sign the Aalenian-Bajocian transition (top of the Concavum zone and the basis of Discites zone). Immediately above we found some index fauna of the Laeviuscula zone. The series overlaying the "Couches du Selloum" comprises thinning up alternations of limestone/marl, passing progressively to the "Marnes de Boulmane" Formation. Lateral variations and interpretations; SW to NE variations: The thickness and facies variations observed in the Bekrit-Timahdite syncline (C1 to C9), denote the existence of marine intervals generally more dilated, with some marly deposits developed towards the SW; on the contrary towards the NE, series are exclusively calcareous, reduced in thickness, and often condensed in their upper part. The same evolution is observed between the deposits of the Iguer Awragh syncline to the SW and those of Afennourir in the NE [Benshili et al., 1999]. SE to NW variations: Some observations realized in a Toarcian-Aalenian outcrop recently discovered in the sector of Outghalline (C11), shows that an uplifted area separates the marly basin of Bekrit from the Iguer Awragh one. Such variations denote a partition of the Toarcian Selloum basin, located in south west of the Middle Atlas trough, into several entities which are regrouped under the denomination of "Blocks of Selloum"; two NE-SW trending notably subsiding gutters are recognized, the Iguer Awragh-Afennourir and the Bekrit-Timahdite, separated by a shoal (ridge of Ijadrane). Paleogeographic framework of the SW border of the Middle Atlas trough: A synthesis of the geometry of the "Blocks of Selloum" and some paleogeographic and structural features of the NW border of the Middle Atlas trough, as they appear in a recent synthesis [Benshili, 1989; Elmi et al., 1989; Benshili et Elmi, 1994; Charriere, 1990; Fedan, 1993; Laadila, 1996; Sabaoui, 1998; El Arabi et al., 1999], is shown in 3 episodes from Toarcian to Aalenian. The southwestern part of the Middle Atlas studied here, does not appear in any case as a coastal area surrounding the Middle Atlas trough, but like a gulf occupied by marine deposits which is isolated from the Middle Atlas trough by the shoal areas called the "Haut-fond de Boulmane". In the Middle Atlas trough, the sequences prograde in a NE direction and show blocks tilting generally towards the same direction. On the other hand, in the "Blocks of Selloum" the tilting acts toward the SW, against the direction of the global Tethyan polarity.


Al-Albab ◽  
2016 ◽  
Vol 5 (1) ◽  
pp. 87
Author(s):  
Hermansyah Hasan Nuh

Belief and practice as part of culture which exists in society is the result of a dynamic process that is growing and developing, and affected by both internal and external aspects of the society. All of this is a manifestation of a continuity of the treasures of humanity. Derivation and transfer of a culture toward forming a new more complex culture is natural and inevitable. There is no culture and civilization in the world built without relationship and interchange with other cultures and civilizations. It is also the case with the religious life of the rural community in West Kalimantan which is the subject of the study in this article. This continuity shows that local communities have a vibrant culture passed down from one generation to the next. The existence of tradition heritage recorded in magic called ilmu in inland Islamic societies of West Kalimantan shows that their peaceful process of accepting Islam since its spread, to a certain extent, accommodates local culture. The dialectic process of Islam and local culture serves as an example of religious acceptance in a massive fashion in a region far away from the coastal area.


RSC Advances ◽  
2020 ◽  
Vol 10 (36) ◽  
pp. 21420-21426
Author(s):  
Hengli Zhang ◽  
Chunjiang Yu ◽  
Zhongyang Luo

Analysis of multiple deposits with different deposition times, piecing together the whole deposition process in 50 MW biomass CFB boiler.


Author(s):  
D.W. Susnitzky ◽  
S.R. Summerfelt ◽  
C.B. Carter

Solid-state reactions have traditionally been studied in the form of diffusion couples. This ‘bulk’ approach has been modified, for the specific case of the reaction between NiO and Al2O3, by growing NiAl2O4 (spinel) from electron-transparent Al2O3 TEM foils which had been exposed to NiO vapor at 1415°C. This latter ‘thin-film’ approach has been used to characterize the initial stage of spinel formation and to produce clean phase boundaries since further TEM preparation is not required after the reaction is completed. The present study demonstrates that chemical-vapor deposition (CVD) can be used to deposit NiO particles, with controlled size and spatial distributions, onto Al2O3 TEM specimens. Chemical reactions do not occur during the deposition process, since CVD is a relatively low-temperature technique, and thus the NiO-Al2O3 interface can be characterized. Moreover, a series of annealing treatments can be performed on the same sample which allows both Ni0-NiAl2O4 and NiAl2O4-Al2O3 interfaces to be characterized and which therefore makes this technique amenable to kinetics studies of thin-film reactions.


Author(s):  
M G. Norton ◽  
E.S. Hellman ◽  
E.H. Hartford ◽  
C.B. Carter

The bismuthates (for example, Ba1-xKxBiO3) represent a class of high transition temperature superconductors. The lack of anisotropy and the long coherence length of the bismuthates makes them technologically interesting for superconductor device applications. To obtain (100) oriented Ba1-xKxBiO3 films on (100) oriented MgO, a two-stage deposition process is utilized. In the first stage the films are nucleated at higher substrate temperatures, without the potassium. This process appears to facilitate the formation of the perovskite (100) orientation on (100) MgO. This nucleation layer is typically between 10 and 50 nm thick. In the second stage, the substrate temperature is reduced and the Ba1-xKxBiO3 is grown. Continued growth of (100) oriented material is possible at the lower substrate temperature.


Author(s):  
S.K. Streiffer ◽  
C.B. Eom ◽  
J.C. Bravman ◽  
T.H. Geballet

The study of very thin (<15 nm) YBa2Cu3O7−δ (YBCO) films is necessary both for investigating the nucleation and growth of films of this material and for achieving a better understanding of multilayer structures incorporating such thin YBCO regions. We have used transmission electron microscopy to examine ultra-thin films grown on MgO substrates by single-target, off-axis magnetron sputtering; details of the deposition process have been reported elsewhere. Briefly, polished MgO substrates were attached to a block placed at 90° to the sputtering target and heated to 650 °C. The sputtering was performed in 10 mtorr oxygen and 40 mtorr argon with an rf power of 125 watts. After deposition, the chamber was vented to 500 torr oxygen and allowed to cool to room temperature. Because of YBCO’s susceptibility to environmental degradation and oxygen loss, the technique of Xi, et al. was followed and a protective overlayer of amorphous YBCO was deposited on the just-grown films.


Author(s):  
J.B. Posthill ◽  
R.P. Burns ◽  
R.A. Rudder ◽  
Y.H. Lee ◽  
R.J. Markunas ◽  
...  

Because of diamond’s wide band gap, high thermal conductivity, high breakdown voltage and high radiation resistance, there is a growing interest in developing diamond-based devices for several new and demanding electronic applications. In developing this technology, there are several new challenges to be overcome. Much of our effort has been directed at developing a diamond deposition process that will permit controlled, epitaxial growth. Also, because of cost and size considerations, it is mandatory that a non-native substrate be developed for heteroepitaxial nucleation and growth of diamond thin films. To this end, we are currently investigating the use of Ni single crystals on which different types of epitaxial metals are grown by molecular beam epitaxy (MBE) for lattice matching to diamond as well as surface chemistry modification. This contribution reports briefly on our microscopic observations that are integral to these endeavors.


2014 ◽  
Vol 24 (1) ◽  
pp. 11-18
Author(s):  
Andrea Bell ◽  
K. Todd Houston

To ensure optimal auditory development for the acquisition of spoken language, children with hearing loss require early diagnosis, effective ongoing audiological management, well fit and maintained hearing technology, and appropriate family-centered early intervention. When these elements are in place, children with hearing loss can achieve developmental and communicative outcomes that are comparable to their hearing peers. However, for these outcomes to occur, clinicians—early interventionists, speech-language pathologists, and pediatric audiologists—must participate in a dynamic process that requires careful monitoring of countless variables that could impact the child's skill acquisition. This paper addresses some of these variables or “red flags,” which often are indicators of both minor and major issues that clinicians may encounter when delivering services to young children with hearing loss and their families.


VASA ◽  
2020 ◽  
Vol 49 (4) ◽  
pp. 333-337 ◽  
Author(s):  
Francisco Leonardo Galastri ◽  
Leonardo Guedes Moreira Valle ◽  
Breno Boueri Affonso ◽  
Marcela Juliano Silva ◽  
Rodrigo Gobbo Garcia ◽  
...  

Summary: COVID-19 is a recently identified illness that is associated with thromboembolic events. We report a case of pulmonary embolism in a patient with COVID-19, treated by catheter directed thrombectomy. A 57 year old patient presented to the emergency center with severe COVID-19 symptoms and developed massive pulmonary embolism. The patient was treated with catheter directed thrombolysis (CDT) and recovered completely. Coagulopathy associated with COVID-19 is present in all severe cases and is a dynamic process. We describe a case of massive/high risk pulmonary embolism, in a patient with COVID-19 receiving full anticoagulation, who was treated by percutaneous intervention. CDT can be an additional therapeutic option in patients with COVID-19 and pulmonary embolism that present with rapid clinical collapse.


Sign in / Sign up

Export Citation Format

Share Document