Oil Degrading Bacteria: Remediation of Environmental Pollution Resulting from Petroleum Hydrocarbons

2020 ◽  
Vol 2 (10) ◽  
pp. 5-10
Author(s):  
Ishita Agrawal

It is widely known that petroleum hydrocarbons constitute one of the most hazardous pollutants that affect human and environmental health. The ongoing research on bioremediation with petroleum hydrocarbon-degrading bacteria has shown tremendous promise of the technology due to its advantages of high efficiency and eco-friendly nature. To this end, studies have been carried out to identify a large amount of bacterial species with petroleum hydrocarbon-degrading ability for applications in bioremediation. Here, we present a brief perspective of some of the notable advances in oil degrading bacteria and the remedial actions for decontamination of water and soil along with recovering the spilled materials at oil sites.

AMB Express ◽  
2020 ◽  
Vol 10 (1) ◽  
Author(s):  
Jie Tang ◽  
Dan Lei ◽  
Min Wu ◽  
Qiong Hu ◽  
Qing Zhang

Abstract Fenvalerate is a pyrethroid insecticide with rapid action, strong targeting, broad spectrum, and high efficiency. However, continued use of fenvalerate has resulted in its widespread presence as a pollutant in surface streams and soils, causing serious environmental pollution. Pesticide residues in the soil are closely related to food safety, yet little is known regarding the kinetics and metabolic behaviors of fenvalerate. In this study, a fenvalerate-degrading microbial strain, CD-9, isolated from factory sludge, was identified as Citrobacter freundii based on morphological, physio-biochemical, and 16S rRNA sequence analysis. Response surface methodology analysis showed that the optimum conditions for fenvalerate degradation by CD-9 were pH 6.3, substrate concentration 77 mg/L, and inoculum amount 6% (v/v). Under these conditions, approximately 88% of fenvalerate present was degraded within 72 h of culture. Based on high-performance liquid chromatography and gas chromatography-mass spectrometry analysis, ten metabolites were confirmed after the degradation of fenvalerate by strain CD-9. Among them, o-phthalaldehyde is a new metabolite for fenvalerate degradation. Based on the identified metabolites, a possible degradation pathway of fenvalerate by C. freundii CD-9 was proposed. Furthermore, the enzyme localization method was used to study CD-9 bacteria and determine that its degrading enzyme is an intracellular enzyme. The degradation rate of fenvalerate by a crude enzyme solution for over 30 min was 73.87%. These results showed that strain CD-9 may be a suitable organism to eliminate environmental pollution by pyrethroid insecticides and provide a future reference for the preparation of microbial degradation agents and environmental remediation.


Land ◽  
2021 ◽  
Vol 10 (8) ◽  
pp. 820
Author(s):  
Dongyang Yang ◽  
Chao Ye ◽  
Jianhua Xu

China has undergone rapid urban expansion in recent decades. At the same time, environmental pollution and its risk to public health have increased. However, the relationship between urban land-use changes and health is ambiguous and insufficiently understood. Based on a typical city-scale case—namely, Changzhou, China—this research aimed to interpret the evolution of health risks alongside land-use change during the process of urbanization. We gathered data from multiple sources, including population mortality data, socioeconomic data, remote-sensing images, data for the points of interest of enterprises, and relevant information on environmental health events and cancers. The results showed that Changzhou’s urbanization was typical insofar as it was characterized by massive growth in industry, a rapid increase in the urban population, and urban land expansion. Health risks related to environmental pollution increased considerably with urban land expansion over time, and they increased with proximity to the pollution. The results from a generalized linear model confirmed that Changzhou’s urbanization triggered increasing health risks. Our study interpreted the relationship between urban land expansion and health risks from a spatiotemporal perspective. It can be used as a reference for urban planning and policymaking with regard to urban environmental health.


2021 ◽  
Vol 766 (1) ◽  
pp. 012096
Author(s):  
Xiaona Wei ◽  
Pai Peng ◽  
Yao Meng ◽  
TingTing Li ◽  
ZhiPing Fan ◽  
...  

2018 ◽  
Vol 59 (2) ◽  
pp. 166-180
Author(s):  
Wael S. El-Sayed ◽  
Yasser Elbahloul ◽  
Mohamed E. Saad ◽  
Ahmed M. Hanafy ◽  
Abdelrahman H. Hegazi ◽  
...  

2019 ◽  
Vol 20 (1) ◽  
pp. 1
Author(s):  
Rita Susilawati

A laboratory experiment was set up to demonstrate the capability of microbe to remediate petroleum hydrocarbon contaminated beach sand. Oil contaminated soil was used as a source of inoculum for hydrocarbon degrading bacteria (HDB) while oil contaminated beach sand was used as remediation object. The growth of HDB in the inocula was enriched and stimulated through the addition of nutrient in the form of vitamin and mineral as well the addition of oil waste as a source of carbon. Experiment took place in the course of approximately five weeks. Microscopic observation clearly showed the interaction between microbe and oil contaminant both in enrichment and bioremediation samples. The result of the experiment also suggests that approximately 25% of the petroleum hydrocarbon mass in the contaminated beach sand was biodegraded over the course of one month. Overall, the results of this experiment suggest the potential of bioremediation method to treat petroleum hydrocarbon polluted environment.Keywords: bacteria, bioremediation, hydrocarbon DOI: 10.33332/jgsm.2019.v20.1.1-7


Author(s):  
Williams, Janet Olufunmilayo ◽  
Aleruchi Owhonka

This study investigated the potential of Aspergillus sydowii and Fusarium lichenicola as mixed cultures in the biodegradation of Total Petroleum Hydrocarbons TPHs in oilfield wastewater. Oilfield wastewater was collected from an onshore oil producing platform and biodegradation of total petroleum hydrocarbons was investigated using standard methods. Fungi were isolated from oilfield wastewater contaminated soils obtained from the vicinity of the oil producing platform. Experimental control set-up and treatment with mixed culture of fungal isolates were periodically analyzed on days 7 and 21 intervals for total petroleum hydrocarbon degradation using Gas Chromatography (GC). The total amount of TPHs on day 1 recorded 381. 871 mg/l.  The amount of TPHs on days 7 and 21 in the mixed culture of fungi was 108.975 mg/l and 21.105 mg/l respectively while TPHs in control was 342.891 mg/l and 240.749 mg/l respectively. There was a significant difference between the mixed culture and the control on days 7 and 21 at p≤0.05. The results therefore revealed actual and significant reduction of TPHs in the mixed culture. In addition, there was clearance of n-alkanes by the mixed culture. This suggests that fungi have great potentials in biodegradation of TPHs and in remediation of TPH contaminated environments.


1987 ◽  
Vol 1987 (1) ◽  
pp. 247-253
Author(s):  
Salah M. Al-Mazidi ◽  
Omar Samhan

ABSTRACT Since the discovery of oil in Kuwait, most oil-related activities have been located along the coastline 50 km south of Kuwait City. Other related industrial activities have been developed in this area apart from oil and petroleum products export in order to diversify the national sources of income. For these reasons, the potential for large oil spills in Kuwait's marine environment is highest along the south coast, where oil refineries and exporting facilities are located. An average of 219 barrels of oil were spilled annually between 1979 and 1985, and 2,100 gallons of dispersants were used in cleanup operations. The majority of incidents involved less than 5 barrels of oil and 500 gallons of dispersants. Incidents involving more than 100 barrels of oil and 5,000 gallons of dispersants were confined to the Sea Island and Mina Al-Ahmadi North and South Piers. This distribution undoubtedly affects the concentration of petroleum residues in various components of the marine environment, resulting in an increase in tar ball density along this coast, reaching a maximum at Ras Az-Zor, and significantly higher levels of vanadium and petroleum hydrocarbons in sediments and oysters collected south of Mina Al-Ahmadi. The objective of this paper is to report on the number, volume, and frequency distribution of oil spill incidents in Kuwait and the usage of dispersants in cleanup operations. Vanadium and petroleum hydrocarbon concentrations also are described as is the sensitivity of the southern coastal environment to oil spills. Recommendations have been made on how to conduct cleanup operations for any future oil spill incidents along the southern shoreline of Kuwait.


2018 ◽  
Vol 2 (2) ◽  
pp. 35
Author(s):  
Prasetyo Handrianto

Exploitation and exploration activities will produce sewage sludge and crude oil spills that cause pollution to the environment and upgrading to the environment, biology and soil chemistry. Monitoring of oil pollution conditions on the soil can be done by detection of all hydrocarbon components, or what is called the total petroleum hydrocarbon (TPH). According to its components, this total petroleum hydrocarbon (TPH) can be classified into 3 points, aliphatic, alicyclic, and aromatic. One of the biological efforts that can be used to overcome petroleum pollution is by using bioremediation technology. There are several methods in bioremediation, one of which is the biostimulation method, where the growth of the original hydrocarbon decomposers is stimulated by adding nutrients, oxygen, pH optimization and temperature. Hydrocarbonoclastic microorganisms have characteristic not possessed by other microorganisms, namely their ability to excrete hydroxylase enzymes, which are hydrocarbon oxidizing enzymes, so that these bacteria can degrade petroleum hydrocarbons. Biodegradation can be formed if there is a structural transformation so that cahnges in molecular integrity occur. This process is a series of enzymatic or biochemical reaction that require ideal environmental conditions with the growth and proliferation of microorganisms. Something that need to be known before remediation are pollutants (organic or inorganic), degraded/ not, dangerous/ not, how many pollutants pollute the soil, the ratio of carbon (C), Nitrogen (N), and phophorus (P), soil type, soil conditions (wet dry), and how long pollutants have been deposited in these locations


Author(s):  
K R Parker

Particulate control equipment for the larger industrial processes, which can effectively collect particles in the submicrometre range, is limited to the electrostatic precipitator and bag filter as cost effective methods. To meet ever decreasing emission levels, demanded by the Regulatory Agencies, the equipment suppliers and academics are involved in ongoing research and development activities in order to obtain a better understanding of the collection process itself, such as to achieve improved performance and, equally importantly, plant reliability and availability. This paper reviews some of the activities in the electrical, microelectronics, material sciences, fluid flow and finite element analysis fields and indicates how the findings are leading to new designs that are more reliable and also how the improvements are making the equipment more cost effective while operating at a higher performance level. Finally, with the concern over the emission of ‘air toxics’, while both the electrostatic precipitator and bag filter are established technology for effectively removing solid and liquid particulates with sizings well below 1 micrometre there is now an additional requirement for collecting vapour phase materials to meet the latest regulatory emission levels. Some ideas and approaches are examined which can prove effective in collecting the majority of materials classified as ‘air toxics’, such that the equipment will meet the existing and possible future emission standards.


Sign in / Sign up

Export Citation Format

Share Document