New Synthesis Method to Obtain Pd Nano-Crystals

2011 ◽  
Vol 14 ◽  
pp. 93-103 ◽  
Author(s):  
Magali Ugalde ◽  
E. Chavira ◽  
Martha T. Ochoa-Lara ◽  
Carlos Quintanar
Keyword(s):  
Electron Microscopy ◽  
Sol Gel ◽  
Synthesis Method ◽  
X Ray Diffraction ◽  
X Ray ◽  
Transmission Electron ◽  
New Synthesis ◽  
Cubic Structure ◽  
Xerogel Sample ◽  
Xrd Studies

We report a new synthesis method to obtain palladium nano-crystals by sol-gel polymerized with acrylamide. From thermogravimetric analysis (TGA) studies, we found PdO and Pd compounds in the xerogel sample, at 550 °C, and over 900 °C we detected only metallic Pd. These results were corroborated by powder X-Ray Diffraction (XRD), High Resolution Scanning Electron Microscopy (HRSEM), and Transmission Electron Microscopy (TEM). XRD studies exhibit the lines from the tetragonal structure (PDF 41-1107) of PdO compound and from the cubic structure (PDF 46-1043) of Pd metallic. HRSEM micrographs show morphologies from the sample very sensitive to heat treatment. Finally, TEM images show crystals of ~8 nm in diameter.

scholarly journals Synthesis of Ce1−xPdxO2−δ Solid Solution in Molten Nitrate

Catalysts ◽  
2020 ◽  
Vol 10 (6) ◽  
pp. 640
Author(s):  
Hideaki Sasaki ◽  
Keisuke Sakamoto ◽  
Masami Mori ◽  
Tatsuaki Sakamoto
Keyword(s):  
Electron Microscopy ◽  
Solid Solution ◽  
Solid Solutions ◽  
Photoelectron Spectroscopy ◽  
Synthesis Method ◽  
X Ray Diffraction ◽  
X Ray ◽  
Transmission Electron ◽  
Co Precipitation ◽  
Ionic States

CeO2-based solid solutions in which Pd partially substitutes for Ce attract considerable attention, owing to their high catalytic performances. In this study, the solid solution (Ce1−xPdxO2−δ) with a high Pd content (x ~ 0.2) was synthesized through co-precipitation under oxidative conditions using molten nitrate, and its structure and thermal decomposition were examined. The characteristics of the solid solution, such as the change in a lattice constant, inhibition of sintering, and ionic states, were examined using X-ray diffraction (XRD), scanning electron microscopy–energy-dispersive X-ray spectroscopy (SEM−EDS), transmission electron microscopy (TEM)−EDS, and X-ray photoelectron spectroscopy (XPS). The synthesis method proposed in this study appears suitable for the easy preparation of CeO2 solid solutions with a high Pd content.

Optimization of Green Synthesis Approach of Silver Nanoparticles Using Indonesian Wild Honey

2021 ◽  
Vol 891 ◽  
pp. 111-115
Author(s):  
Maradhana Agung Marsudi ◽  
Farah Fitria Sari ◽  
Pandu Mauliddin Wicaksono ◽  
Adinda Asmoro ◽  
Arif Basuki ◽  
...  
Keyword(s):  
Electron Microscopy ◽  
Silver Nanoparticles ◽  
Green Synthesis ◽  
Synthesis Method ◽  
X Ray Diffraction ◽  
X Ray ◽  
Particle Count ◽  
Transmission Electron ◽  
Nitrate Precursor ◽  
Synthesis Approach

In this work, silver nanoparticles have been successfully synthesized using simple and environmentally friendly ‘green synthesis’ method using Indonesian wild honey as mediator. Particle count and size can be optimized by varying the silver nitrate precursor and honey concentration, with the help of sodium hydroxide as pH regulator. Based on X-ray diffraction (XRD) result, crystalline structure of Ag has been confirmed in sample with impurities from AgCl. Based on dynamic light scattering (DLS) and transmission electron microscopy (TEM) results, it was found that the smallest average particles size of AgNPs (117.5 nm from DLS and 11.1 nm from TEM) was obtained at sample with 5% w/v of honey and 0.5 mM of AgNO3.

Dependence of the Product's Phase Composition on the Ratio of Precursors in Plasmadynamic Synthesis of Silicon Carbide

2018 ◽  
Vol 769 ◽  
pp. 114-119 ◽  
Author(s):  
Artur A. Sivkov ◽  
Artur Nassyrbayev ◽  
Maksim Gukov
Keyword(s):  
Electron Microscopy ◽  
Silicon Carbide ◽  
Synthesis Method ◽  
X Ray Diffraction ◽  
Central Electrode ◽  
X Ray ◽  
Transmission Electron ◽  
Cubic Silicon Carbide ◽  
Accelerator Channel ◽  
Coaxial Magnetoplasma Accelerator

In this work, the powder of nanoscale cubic SiC was obtained by the plasmodynamic synthesis in a coaxial magnetoplasma accelerator (CMPA) with a graphite central electrode and an accelerator channel. The synthesis method allows obtaining a product with a high content of nanoscale cubic silicon carbide. The work is aimed to study the influence of the precursor’s ratio on the product. The synthesized products were analyzed by X-ray diffraction and transmission electron microscopy.

Sol-gel processing of nanocrystalline haematite thin films

1997 ◽  
Vol 12 (6) ◽  
pp. 1441-1444 ◽  
Author(s):  
L. Armelao ◽  
A. Armigliato ◽  
R. Bozio ◽  
P. Colombo
Keyword(s):  
Electron Microscopy ◽  
Thin Films ◽  
Transmission Electron Microscopy ◽  
Raman Spectroscopy ◽  
Sol Gel ◽  
X Ray Diffraction ◽  
Single Particles ◽  
X Ray ◽  
Transmission Electron ◽  
Gel Processing

The microstructure of Fe2O3 sol-gel thin films, obtained from Fe(OCH2CH3)3, was investigated by x-ray diffraction (XRD), transmission electron microscopy (TEM), and Raman spectroscopy. Samples were nanocrystalline from 400 °C to 1000 °C, and the crystallized phase was haematite. In the coatings, the α–Fe2O3 clusters were dispersed as single particles in a network of amorphous ferric oxide.

SYNTHESIS AND PIXE CHARACTERIZATION OF CuInSe2 AND CuIn3Se5

2006 ◽  
Vol 16 (01n02) ◽  
pp. 127-136
Author(s):  
P. MALAR ◽  
TAPASH RANJAN RAUTRAY ◽  
V. VIJAYAN ◽  
S. KASIVISWANATHAN
Keyword(s):  
Electron Microscopy ◽  
Single Phase ◽  
Compositional Analysis ◽  
X Ray Diffraction ◽  
Stoichiometric Mixture ◽  
X Ray ◽  
Transmission Electron ◽  
Xrd Studies ◽  
Constituent Elements

Polycrystalline ingots of CuInSe 2 and CuIn 3 Se 5 were synthesized by melt-quench technique starting from the stoichiometric mixture of constituent elements. X-ray Diffraction (XRD) studies confirmed the single-phase nature of the materials. Compositional analysis by Particle Induced X-ray Emission (PIXE) showed that the compounds are near stoichiometric. Thin films of CuInSe 2 and CuIn 3 Se 5 were grown from pre-synthesized CuInSe 2 and CuIn 3 Se 5 powders. The films were polycrystalline, single-phase and near stoichiometric in nature, as indicated by Transmission Electron Microscopy (TEM) and PIXE studies.

An environmentally friendly method for the isolation of cellulose nano fibrils from banana rachis fibers

2016 ◽  
Vol 87 (1) ◽  
pp. 81-90 ◽  
Author(s):  
Vincent Mukwaya ◽  
Weidong Yu ◽  
Rabie AM Asad ◽  
Hajo Yagoub
Keyword(s):  
Electron Microscopy ◽  
Average Diameter ◽  
Enzyme Hydrolysis ◽  
X Ray Diffraction ◽  
X Ray ◽  
Transmission Electron ◽  
Sonic Treatment ◽  
Xrd Studies ◽  
Environmentally Friendly Method ◽  
Derivative Thermogravimetry

Cellulose nano fibrils (CNFs) were isolated from banana rachis bran using enzyme hydrolysis with subsequent ultra-sonic treatment. The CNFs and bran were characterized by particle size distribution (only the CNFs), X-ray diffraction (XRD), Thermogravimetric analysis (TGA) and Fourier-transform infrared spectroscopy; the morphology of the banana rachis fiber and CNFs was observed using scanning electron microscopy and transmission electron microscopy, respectively. The furnished nano fibrils had an average diameter of 14.02 ± 2.10 nm and length of 619.6 ± 90.7 nm. The aspect ratio of the CNFs is in the range of long fibrils, that is 44.18. XRD studies revealed that CNFs (48.83%) were more crystalline than the banana bran (27.76%). TGA and derivative thermogravimetry thermograms showed that CNFs were more thermally stable than the bran.

scholarly journals Surface Modification of LiMn2O4for Lithium Batteries by Nanostructured LiFePO4Phosphate

2012 ◽  
Vol 2012 ◽  
pp. 1-7 ◽  
Author(s):  
B. Sadeghi ◽  
R. Sarraf-Mamoory ◽  
H. R. Shahverdi
Keyword(s):  
Electron Microscopy ◽  
Sol Gel ◽  
Dip Coating ◽  
X Ray Diffraction ◽  
X Ray ◽  
Electrochemical Tests ◽  
Transmission Electron ◽  
Coating Method ◽  
Dip Coating Method ◽  
Spinel Cathode

LiMn2O4spinel cathode materials have been successfully synthesized by solid-state reaction. Surface of these particles was modified by nanostructured LiFePO4via sol gel dip coating method. Synthesized products were characterized by thermally analyzed thermogravimetric and differential thermal analysis (TG/DTA), X-ray diffraction (XRD), scanning electron microscopy (SEM), transmission electron microscopy (TEM), and energy dispersive X-ray spectroscopy (EDX). The results of electrochemical tests showed that the charge/discharge capacities improved and charge retention of battery enhanced. This improved electrochemical performance is caused by LiFePO4phosphate layer on surfaces of LiMn2O4cathode particles.

Novel synthesis of AlN nanowires with controlled diameters

2001 ◽  
Vol 16 (11) ◽  
pp. 3133-3138 ◽  
Author(s):  
Jun Liu ◽  
X. Zhang ◽  
Yingjiu Zhang ◽  
Rongrui He ◽  
Jing Zhu
Keyword(s):  
Electron Microscopy ◽  
Carbon Nanotubes ◽  
High Efficiency ◽  
Low Cost ◽  
X Ray Diffraction ◽  
Synthesis Mechanism ◽  
X Ray ◽  
Novel Synthesis ◽  
Transmission Electron ◽  
New Synthesis

A relatively low-cost, high-efficiency method is reported to synthesize AlN nanowires, using carbon nanotubes as templates. The AlN nanowires were fabricated at 1100 °C, for 60 min. The diameters of the product could be roughly controlled by the sizes of carbon nanotubes selected as starting materials. The AlN nanowires obtained were among the thinnest ever known. X-ray diffraction, selected-area diffraction, energy dispersive spectroscopy, and high-resolution transmission electron microscopy, etc. were employed to characterize the products, which were found to be single crystals with some defects. The axes of the nanowires are normal to {1010} crystal planes. A new synthesis mechanism is proposed.

scholarly journals Sol-Gel Derived Eu3+-Doped Gd2Ti2O7Pyrochlore Nanopowders

2015 ◽  
Vol 2015 ◽  
pp. 1-8 ◽  
Author(s):  
Sanja Ćulubrk ◽  
Željka Antić ◽  
Vesna Lojpur ◽  
Milena Marinović-Cincović ◽  
Miroslav D. Dramićanin
Keyword(s):  
Electron Microscopy ◽  
Transmission Electron Microscopy ◽  
Structural Changes ◽  
Sol Gel ◽  
Pyrochlore Phase ◽  
Structural Defects ◽  
X Ray Diffraction ◽  
X Ray ◽  
Transmission Electron ◽  
Sol Gel Synthesis

Herein we presented hydrolytic sol-gel synthesis and photoluminescent properties of Eu3+-doped Gd2Ti2O7pyrochlore nanopowders. According to Gd2Ti2O7precursor gel thermal analysis a temperature of 840°C is identified for the formation of the crystalline pyrochlore phase. Obtained samples were systematically characterized by powder X-ray diffraction, scanning and transmission electron microscopy, and photoluminescence spectroscopy. The powders consist of well-crystalline cubic nanocrystallites of approximately 20 nm in size as evidenced from X-ray diffraction. The scanning and transmission electron microscopy shows that investigated Eu3+-doped Gd2Ti2O7nanopowders consist of compact, dense aggregates composed entirely of nanoparticles with variable both shape and dimension. The influence of Eu3+ions concentration on the optical properties, namely, photoluminescence emission and decay time, is measured and discussed. Emission intensity as a function of Eu3+ions concentration shows that Gd2Ti2O7host can accept Eu3+ions in concentrations up to 10 at.%. On the other hand, lifetime values are similar up to 3 at.% (~2.7 ms) and experience decrease at higher concentrations (2.4 ms for 10 at.% Eu3+). Moreover, photoluminescent spectra and lifetime values clearly revealed presence of structural defects in sol-gel derived materials proposing photoluminescent spectroscopy as a sensitive tool for monitoring structural changes in both steady state and lifetime domains.

Sign in / Sign up

Export Citation Format

Share Document