Pumping test analysis for assessment of hydraulic parameters and aquifer system formation in hilly terrain

Groundwater conditions (GWCs) of an area depends on aquifer hydraulic parameters such as storativity () or storage coefficient (), transmissivity () and hydraulic conductivity (). It plays a key role concerning- groundwater flow modeling, well performance, solute and contaminants transports assessment and also for identification of areas for additional hydrologic testing. Specifically, the geologic formation of a regions control the porosity and permeability, however, in hilly terrain prospecting ground water potential is more challenging due to its limited extent and its occurrences that are usually confined to fractures and weathered rocks. The present study, aims at estimating the hydraulic parameters through pumping test analysis to assess aquifer system formation on hilly terrain from 16 bore wells. The aforesaid parameters were examined through a case study in some selective regions of Hamirpur district of Himachal Pradesh, India. The study area is controlled under two main geological horizons that is the post-tertiary and tertiary. The papers end with comparative results of hydraulic parameters and the aquifers system formation on different GWCs which may be helpful in the outlook of sustainable groundwater resource in the regions.

Assessment of Tube Well Pumping Test Performance on Different Geological Formation

Water supply-demand is increasing in line with the increment in population. Natural water resources are declining due to reduction of water catchment areas, river pollution and drought. This causes the raw water quantity and quality to decrease and increase water treatment costs. Groundwater usage may be able to solve this problem due to its less polluted nature which requires less treatment. The groundwater is preserved in aquifer within the geological formations, i.e., in the alluvium and fractured-rock. However, the groundwater yield of each formation is unknown unless tube well is constructed and pumping test are performed. This study aim to evaluate the tube well performance via pumping test on two different geological formations. This research focuses on the effect of transmissivity, hydraulic conductivity, and efficiency of the aquifer, which are step-drawdown test, constant-rate test and recovery test in tube well in geological formation of alluvium and fractured rock. Three well-pumping tests at each formation were conducted at IBS Universiti Malaysia Kelantan (UMK), Kelantan, Sekolah Kebangsaan Chantum, Kelantan, Sekolah Menengah Kebangsaan Agama Tok Bachok, Kelantan, FRU Wakaf Tapai, Terengganu, Kampung Dada Kering, Kuala Lipis, Pahang, and Kampung Seri Gunung Pulai, Johor, respectively. The aquifer efficiency obtained from the relationship between transmissivity and hydraulic conductivity. The suggested value of 75% efficiency is selected to present the well’s efficiency. The wells efficiency indicate that the alluvium formation has roughly uniform output between 9.39m3/h, 11.23m3/h and 23.38m3/h. Meanwhile in the fractured rock formation the efficiency was highly varied between sites, the highest is 32.33m3/h and the other two sites obtained has low output of 3.44 m3/h and 1.00m3/h respectively. The alluvium aquifer showed uniform water production compared to fractured hard rock aquifer. Meanwhile the water quantity in the fractured hard rock formation is unpredicted, which subjected to the fractured rock characteristic.

Groundwater Flow Modeling: A Case Study of the Lower Rusizi Alluvial Plain Aquifer, North-Western Burundi

The study area, in northwestern Burundi, is an alluvial plain consisting of fine clayey sands and coarse sands with mixed lithology. The aquifer of the lower Rusizi plain could be considered as confined under a clay layer. A 2D horizontal groundwater flow model was developed under steady-state conditions using the Modflow software. The study aims to determine the most productive areas of this confined alluvial aquifer and the main aquifer inflow and outflow values together with the recharge and river–aquifer interactions. The groundwater potential is dependent on the spatial distribution of hydraulic conductivity and aquifer thickness values providing the local transmissivity values. The calibrated model made it possible to assess the spatial distribution of the hydraulic conductivity values at the regional scale, which ranged from 6 × 10−6 (contact between alluvial plain and Precambrian basement) to 7.5 × 10−3 m/s (coastal barriers). The results also provided the computed groundwater flow directions, and an estimation of the groundwater levels in areas not yet investigated by drilling. The results of the computed groundwater flow budget allowed us to deduce that recharge and river–aquifer interaction constitute the main inflow while the downwards boundaries (where piezometric heads could be prescribed) are the main zones where outflows occur. The results of this model can be used in the planning of pumping test programs, locating areas with high groundwater potential to plan water supply for different private and public users. This predictive tool will contribute to the resolution of problems related to the use and integrated management of the groundwater resource in this part of Burundi.

Well Rehabilitation via the Ultrasonic Method and Evaluation of Its Effectiveness from the Pumping Test

The exploitation of groundwater reserves, especially for drinking purposes, is becoming increasingly important. This fact has created the need to maintain wells in the best possible functional condition. However, wells are subject to an ageing process during intensive use, which entails an increase in up-to-date resistances in the well itself and its immediate surroundings (the skin zone). This causes a decrease in the efficiency of the well (a decrease in the pumped quantity, a decrease in the specific yield, an increase of the drawdown in the well, and creation of the skin zone). The increased hydraulic gradient in the skin zone causes an increase in the inflow rate to the well, thereby inducing the movement of fine material towards the casing. This material can clog the well casing and injection ports, which is compounded by an increase in chemical and biological plugging of the skin zone. In cooperation with the company sonic technologies, GmbH. (Sailauf, Germany), an experimental ultrasonic technology-based well rehabilitation assembly was developed and successfully tested. This article describes the prototype development of the ultrasonic device, including its incorporation into the rehabilitation set and a demonstration of its pilot deployment in the MO-4 pumping well in Czech Republic with an evaluation of the rehabilitation effects using the authors’ software (Dtest_ULTRA). Based on visual inspection and the results of hydraulic and geophysical analysis, the high efficiency of the tested technology was demonstrated in virtually all monitored parameters, where an improvement in the range of 25–55% compared to the original condition was identified.

Investigation on Dewatering of a Deep Shaft in Strong Permeable Sandy Pebble Strata on the Bank of the Yellow River

This paper reports the dewatering scheme of a deep excavation in sandy pebble strata. The excavation is in high permeability strata and is close to the Yellow River, making the dewatering difficult during construction. At present, few researchers have specially studied the dewatering scheme of deep excavations in strong permeable strata near the water resource. Field pumping test was conducted before the excavation activity, and the permeability coefficient of the strata was obtained by reverse analysis. According to the characteristics of the project, the dewatering scheme of “ waterproof curtain + base grouting + pumping ” was proposed. The influence of vertical waterproof curtain and base grouting on dewatering was analyzed by numerical simulation. In the construction process, the field water table and ground settlement were measured. The results show that (1) the groundwater table versus permeability coefficient curve shows three different stages and (2) the dewatering scheme of “ waterproof curtain + base grouting + pumping ” is effective for deep excavation in strong permeable strata.

Hydrogeophysical Study of Sub-Basaltic Alluvial Aquifer in the Southern Part of Al-Madinah Al-Munawarah, Saudi Arabia

Groundwater is extremely important in a water-scarce country such as Saudi Arabia, where permanent surface water resources are absent. Sustainable and future developments plans are essentially relying on the clear understanding of water resources. To evaluate the water resources in arid countries, the groundwater should be quantified through either traditional or scientifically advanced techniques. Aquifer characteristics, particularly the hydraulic conductivity and transmissivity, are essential for the evaluation the aquifer properties as well as the management and development of groundwater modelling for specific aquifers. The present study aims to evaluate the sub-basaltic alluvial aquifer in the northern part of Harrat Rahat, south of Al-Madinah city, and then estimates the principal aquifer’s hydraulic parameters based on the interpreted 1D resistivity-depth models along the study area. For that, 49 Vertical Electrical Soundings (VES’s) utilizing a Schlumberger electrode array were performed along the southern part of Al-Madinah city. The resistivity of the water-bearing formation, thickness, porosity, hydraulic conductivity, and transmissivity parameters were calculated along the measured longitudinal profile from the interpreted VES data. The estimated porosity, hydraulic conductivity, and transmissivity were achieved along the whole profile with average values of 0.2, 3.5 m/day, and 369.6 m2/day, respectively. The resulting transmissivity values from the VES models were compared with those of previous pumping test measurements carried out in the area and a reasonable correlation between the two data sets was observed. These results indicate that surface geoelectrical resistivity techniques may provide an alternative, rapid, and cost-effective method of estimating the aquifer hydraulic parameters where pumping data is rare or unavailable.

Hydrogeology of Al-Hamdaniya, Northern Iraq

The current study evaluated the hydrogeological conditions and hydraulic properties of the groundwater aquifers in Qaraqosh, Karamless and Bartella areas within Al-Hamdaniya district east Mosul. The depths and water tables of groundwater for 48 well were measured in October 2019, were ranged between 5 - 45 meters and 234 - 278.5 meters, respectively. The highest water table reaches in the center of the studied area north Qaraqosh and decreases gradually in all directions. A map of the flow net was drawn, and it was found that the general direction of water movement is from north to south, with local directions resulting by pumping from the aquifer, or due to the heterogeneity of the porous media. The results of the pumping test in Karamless area shows that the transmissivity was 107.671 m2/day and 100.682 m2/day according to Theis and Cooper-Jacob methods, respectively. The hydraulic conductivity of 157.65 m saturated thickness was found to be 0.683 m/day and 0.639 m/day using Theis and Cooper-Jacob methods, respectively. While the storage coefficient using Theis and Cooper-Jacob methods was 0.0023 and 0.0020، respectively. In Qaraqosh, the transmissivity was 87.1685 m2/day and 88.1004 m2/day according to the mentioned methods, respectively. While the hydraulic conductivity of saturated thickness of 71.07 m was found to be 1.24 m/day and 1.23 m/day using Theis and Cooper-Jacob methods, respectively. The values of storage coefficient using these methods was 0.00135 and 0.00115 respectively. The total dissolved solids (TDS) measured to conclude the hydrogeological system according to the quality of the groundwater aquifers, it was found that the concentrations of total dissolved solids are more than 3500 ppm in the mid of the study area and decreased towards all directions to the limits of 250 ppm. This wide variation in salinity may be because the wells in the central area penetrate the groundwater aquifers, represented by the layers of gypsum in Al-Fat'ha formation, which is hydraulically connected with the main aquifer of the Injana formation.

Advances in the Hydraulic Interpretation of Water Wells Using Flowmeter Logs

This paper reports on the methodology developed for a new hydraulic interpretation of flowmeter logs, allowing a better characterization of continental hydrological basins. In the course of a flowmeter log, different flow stretches are established mostly corresponding to permeable layers (aquifers), among which there are other stretches mainly corresponding to less permeable layers (aquitards). In such hydrological basins of sufficient thickness, these flow stretches may not have the same hydraulic head. This fact brings about the need for a new hydraulic interpretation that provides the actual distribution of horizontal permeability throughout the aquifer at depth. The modified hydraulic interpretation developed in this study focuses on the differences of the effective pressure gradient (considered as the difference between the hydraulic head in the well and the hydraulic head of each stretch) experienced by the different flow stretches along the well, due to the existence of different hydraulic heads. The methodology has been developed starting from a water well located in a multilayered aquifer within the so-named Madrid Basin (the NW part of the continental basin of the Tajo River), located in the centre of the Iberian Peninsula. In this well, a step-drawdown pumping test was conducted, in which the pumping rate versus drawdown and the specific capacity versus drawdown showed discrepancies with Darcian behaviour and an exponent of the Jacob equation of less than 1. Flowmeter logs were then recorded for different discharge rates and pump depths; the resulting water input from deeper permeable layers did not appear to show the expected relation with respect to drawdown. With the proposed methodology the results comply with the expected linearity and the cited discrepancies are solved.