Indirect Electro-Thermal Modelling of Semiconductor Diode Using Non-Linear Behavior of Volt-Ampere Characteristic

The aim of the proposed paper is the development of an electro-thermal model of semiconductor component using an indirect modelling approach. The approach is based on the integration of the component’s electrical properties considering non-linear behavior of a V-A characteristic. In this way, the identification of semiconductor material properties considering non-linear dependencies and semiconductor volume is provided. The main aim of the presented approach is simplification of the electro–thermal interaction within finite-element modelling of the semiconductor components. In this way, it is possible to omit more complex boundary definitions and the setting of the semiconductor-based physics. The proposed methodology is presented within the development of a simulation model based on a small high-frequency rectifying diode, taking into account its geometric dimensions and the internal arrangement of its structure. Simulation was performed as a transient analysis, while the results from the steady-state operation for various operational conditions were compared to experimental measurements. Comparison between simulation and experiments is within 5% of the relative error. The achieved results represent appropriate accuracy of model behavior compared to the real operation.

Gingival depigmentation with scalpel and diode laser

Melanin, a nonhemoglobin-derived brown pigment, is the most common of the endogenous pigments and is produced by melanocytes present in the basal layer of the epithelium. Gingival hyperpigmentation is caused by excessive deposition of melanin located in the basal and suprabasal cell layers of the epithelium. Pigmentation of gingiva not just has an impact on esthetics but also creates psychological negativity. Though a wide range of techniques are available to manage this condition. Depigmentation procedures such as scalpel surgery, gingivectomy with free gingival autografting, electrosurgery, cryosurgery, chemical agents such as 90% phenol and 95% alcohol, abrasion with diamond bur, Nd: YAG laser, semiconductor diode laser, and CO laser have been employed for removal of melanin hyper pigmentation. The following case report describes two different surgical depigmentation techniques scalpel technique and lasers. Better results of depigmentation were achieved with diode laser than conventional scalpel with respect to esthetics and less postoperative discomfort.

Ion transport in a charged conical nanopore filled with viscoelastic fluids: ion current rectification

The ionic current rectification (ICR) is a non-linear current-voltage response upon switching the polarity of the potential across nanopore, similar to the I-V response in the semiconductor diode. The ICR phenomenon finds several potential applications in micro/nano-fluidics (e.g., Bio-sensors and Lab-on-Chip applications). From a biological application viewpoint, most biological fluids (e.g., blood, saliva, mucus, etc.) exhibit non-Newtonian visco-elastic behavior; their rheological properties differ from Newtonian fluids. Therefore, the resultant flow-field should show an additional dependence on the rheological material properties of viscoelastic fluids such as fluid relaxation time (λ) and fluid extensibility (ε). Despite numerous potential applications, the comprehensive investigation of the viscoelastic behavior of the fluid on ionic concentration profile and ICR phenomena has not been attempted. ICR phenomena occur when the length scale and Debye layer thickness approaches of the same order. Therefore, this work extensively investigates the effect of viscoelasticity on the flow and ionic mass transfer along with the ICR phenomena in a single conical nanopore. The Poisson-Nernst-Planck (P-N-P) model coupled with momentum equations have been solved, for a wide range of conditions Deborah number, 1 ≤ De ≤ 100, Debye length parameter, 1 ≤ κRt ≤ 50, fluid extensibility parameter, 0.05 ≤ ε ≤ 0.25, applied electric potential, −40 ≤V ≤ 40, and surface charge density σ = −10 and −50. Four distinct novel characteristics of electro-osmotic flow (EOF) in a conical nanopore have been investigated here, namely (1) detailed structure of flow field and velocity distribution in viscoelastic fluids (2) influence of Deborah number and fluid extensibility parameter on ionic current rectification (ICR) (3) volumetric flow rate calculation as a function of Deborah number and fluid extensibility parameter (4) effect of viscoelastic parameters on concentration distribution of ions in the nanopore. At high applied voltage, both the extensibility parameter and Deborah number facilitate the ICR phenomena. In addition, the ICR phenomena are observed to be more pronounced at low values of κRt than the high values of κRt . This effect is due to the overlapping of the electric double layer at low values of κRt.

Performance Analysis and Development of a Semiconductor Junction Rectifier with Multicolor Coding for Indoor Farm Applications

This paper aims to build a smart lighting system with applications such as remote for controlling power supply and optimizing heat management in the metal body of the semiconductor diode and with a printed circuit board for agriculture. The semiconductor diode strips with multiple colors are lined up and configured as a LED lamp with proper casing and heat sink. It has a driver circuit with required power regulation that is able to control the intensity of light for photosynthesis and plant growth requirements. The system uses hydroponics to plant the water, thus decreasing the usage of fertilizers. The entire system is controlled remotely using necessary communication interface application.

High-Performance Multifunctional Photodetector and THz Modulator Based on Graphene/TiO2/p-Si Heterojunction

In this paper, we have reported a multifunctional device from graphene/TiO2/p-Si heterojunction, followed by its systematical analysis of optical response in a device under ultraviolet–visible-infrared band and transmission changes of terahertz waves in the 0.3–1.0 THz band under different bias voltages. It is found that photodetector in the “back-to-back” p-n-p energy band structure has a seriously unbalanced distribution of photogenerated carriers in the vertical direction when light is irradiated from the graphene side. So this ensures a higher optical gain of the device in the form of up to 3.6 A/W responsivities and 4 × 1013 Jones detectability under 750 nm laser irradiation. Besides, the addition of TiO2 layer in this terahertz modulator continuously widens the carrier depletion region under negative bias, thereby realizing modulation of the terahertz wave, making the modulation depth up to 23% under − 15 V bias. However, almost no change is observed in the transmission of terahertz wave when a positive bias is applied. A similar of an electronic semiconductor diode is observed that only allows the passage of terahertz wave for negative bias and blocks the positive ones. Graphic Abstract

Spectral Output of Homogeneously Broadened Semiconductor Lasers

Gain, spontaneous emission, and reflectance play important roles in setting the spectral output of homogeneously broadened lasers, such as semiconductor diode lasers. This paper provides a restricted-in-scope review of the steady-state spectral properties of semiconductor diode lasers. Analytic but transcendental solutions for a simplified set of equations for propagation of modes through a homogeneously broadened gain section are used to create a Fabry–Pérot model of a diode laser. This homogeneously broadened Fabry–Pérot model is used to explain the spectral output of diode lasers without the need for guiding-enhanced capture of spontaneous emission, population beating, or non-linear interactions. It is shown that the amount of spontaneous emission and resonant enhancement of the reflectance-gain (RG) product as embodied in the presented model explains the observed spectral output. The resonant enhancement is caused by intentional and unintentional internal scattering and external feedback.

Recent Progress of Electrically Pumped AlGaN Diode Lasers in the UV-B and -C Bands

The development of electrically pumped semiconductor diode lasers emitting at the ultraviolet (UV)-B and C spectral bands has been an active area of research over the past several years, motivated by a wide range of emerging applications. III-Nitride materials and their alloys, in particular AlGaN, are the material of choice for the development of this ultrashort-wavelength laser technology. Despite significant progress in AlGaN-based light-emitting diodes (LEDs), the technological advancement and innovation in diode lasers at these spectral bands is lagging due to several technical challenges. Here, the authors review the progress of AlGaN electrically-pumped lasers with respect to very recent achievements made by the scientific community. The devices based on both thin films and nanowires demonstrated to date will be discussed in this review. The state-of-the-art growth technologies, such as molecular beam epitaxy (MBE) and metalorganic chemical vapor deposition (MOCVD); and various foreign substrates/templates used for the laser demonstrations will be highlighted. We will also outline technical challenges associated with the laser development, which must be overcome in order to achieve a critical technological breakthrough and fully realize the potential of these lasers.

High Precision Human Skin Temperature Fluctuations Measuring Instrument

This paper describes the experimental results of testing a prototype of a high precision human skin rapid temperature fluctuations measuring instrument. Based on the author’s work, an original circuit solution on a miniature semiconductor diode sensor has been designed. The proposed circuitry provides operation in the full voltage range with automatic setting and holding the operating point, as well as the necessary slope of the conversion coefficient (up to 2300 mV/°C), which makes it possible to register fast temperature oscillations from the surface of the human body and other biological objects. Simulation results in the Microcap 12 software and laboratory tests have confirmed all declared design specifications: temperature resolution of 0.01 °C, transducer thermal time constant of 0.05 s. An original thermostat and an experimental setup for the simultaneous registration of the electrocardiogram, pulse wave signals from the Biopac polygraph MP36 and a signal of temperature oscillations from the prototype thermometer have been designed for further investigations. The preliminary test results indicates that using the designed measuring instrument gives a possibility to provide an in-depth study of the relationship between micro- and macro-blood circulations manifested in skin temperature fluctuations.