scholarly journals Multiscale in modelling and validation for solar photovoltaics

2018 ◽  
Vol 9 ◽  
pp. 10 ◽  
Author(s):  
Tareq Abu Hamed ◽  
Nadja Adamovic ◽  
Urs Aeberhard ◽  
Diego Alonso-Alvarez ◽  
Zoe Amin-Akhlaghi ◽  
...  

Photovoltaics is amongst the most important technologies for renewable energy sources, and plays a key role in the development of a society with a smaller environmental footprint. Key parameters for solar cells are their energy conversion efficiency, their operating lifetime, and the cost of the energy obtained from a photovoltaic system compared to other sources. The optimization of these aspects involves the exploitation of new materials and development of novel solar cell concepts and designs. Both theoretical modeling and characterization of such devices require a comprehensive view including all scales from the atomic to the macroscopic and industrial scale. The different length scales of the electronic and optical degrees of freedoms specifically lead to an intrinsic need for multiscale simulation, which is accentuated in many advanced photovoltaics concepts including nanostructured regions. Therefore, multiscale modeling has found particular interest in the photovoltaics community, as a tool to advance the field beyond its current limits. In this article, we review the field of multiscale techniques applied to photovoltaics, and we discuss opportunities and remaining challenges.

2019 ◽  
Vol 11 (8) ◽  
pp. 113
Author(s):  
John Vourdoubas

The possibility of using fuel cells powered by solar hydrogen for energy generation in greenhouses with reference to the island of Crete, Greece has been examined. Change of fossil fuels used in greenhouses with renewable energies and sustainable energy technologies is very important for mitigation of climate change. Various renewable energy sources and low carbon emission technologies including geothermal energy, biomass, solar photovoltaics and co-generation systems have been used so far. Use of solar photovoltaics for generating electricity consumed in water electrolysis for hydrogen production has been investigated. Hydrogen feeding a proton exchange membrane fuel cell co-generating electricity and heat was used in a greenhouse located in Crete, Greece. The system could be useful in a stand-alone greenhouse with annual specific energy consumption at 150 KWh/m2. A solar photovoltaic system with nominal power at 33.33 KWp powering an electrolytic cell at 5.71 KW could produce annually 2,083 kg hydrogen. The hydrogen could feed a fuel cell at 1.71 KWel generating annually all the electricity required in a greenhouse of 1,000 m2. Co-produced heat could also cover 11.11% of the annual heat requirements in the greenhouse. It was found though that the overall electric efficiency of the system was very low at 4.5%. The low overall efficiency and the size of the solar-PV required indicate that the abovementioned energy system is not suitable in commercial agricultural greenhouses.


2021 ◽  
Vol 9 (209) ◽  
pp. 1-27
Author(s):  
Paulo Eduardo Lau de Melo ◽  
Evandro de Souza Queiroz

The growing attention to environmental and energy issues led to the search for renewable energy sources, which is gaining more and more space. In this context, photovoltaic solar energy is considered one of the most promising because it has advantages, such as ease of operation, possibility of integration in buildings, low level of proliferation during an operation and great potential for power generation in Brazil. Therefore, this work aims at a proposal to implement a photovoltaic system connected to the grid (On-grid) as an alternative to reduce the cost of energy consumption in a residence in the municipality of Palmares-PE. For the dimensioning of the photovoltaic system it was considered the monthly energy consumption of the residence and an irradiation of the place. Finally, a cost analysis was carried out to implement the system, which revealed that the use of this energy is economical and feasible. The solar generation capacity was projected at 6,27 kWp. The value of the project was R $ 32,049.98 and the payback period was 3 years and 8 months. Considering a Minimum Attractiveness Rate (TMA) of 6.5%, the NPV was R $ 225,707.88 and the Internal Rate of Return (IRR) of the system was a percentage of 43.55%.


2020 ◽  
Vol 79 (Suppl 1) ◽  
pp. 1821.1-1821
Author(s):  
M. Sukhareva ◽  
O. Egorova ◽  
B. Belov

Background:In medical practice lobular panniculitis-lipodermatosclerosis (LDS) is becoming more and more common. It is manifested by degenerative-dystrophic changes in subcutaneous fat (SCF) and occurs more often in middle-aged women affected by chronic venous insufficiency.Objectives:to evaluate the effectiveness of mesotherapy (MT) and shockwave ultrasound therapy (UST) for LDSMethods:among 539 patients referred to the V.A. Nasonova Research Institute of Rheumatology with the referral diagnoses of erythema nodosum or panniculitis 8.5% (46) of patients (44 women, 2 men) aged 18 to 82 with overweight (32) LDS with the disease duration of 11,8±6.4 months was verified. Patients were randomized into two groups of 23 patients each: group I received daily MT (10 sessions) therapy with drugs that have antioxidant, anti-inflammatory, lymphatic drainage and lipolytic effects, and 3 MHz UST of the node area twice a week (5 sessions). In group II MT was performed daily with 9% Natrii chloridum solution at a dose comparable to group I. The control methods included general clinical examination (characterization of induration on the lower legs with an assessment of the effect of pain pressing according to visual analogue scale (VAS pain), general blood and urine tests and ultrasound with elastography (USE) of the compaction. The main stages of control: initial (T0), after 14 days (T1), 1 month (T2) and 3 months (T3).Results:before treatment 38 patients with LDS demonstrated asymmetric (83%) inflammation of SCF of the lower legs (100%) on its medial surface (91%). LDS regressed faster with normal body mass index (p = 0,04). In all patients of group I, after a course of physiotherapy a positive trend was registered, that is a decrease in VAS pain intensity (T0 50±18 mm; T1 35±11 mm), decrease in diameter (T0 6±2.2 cm; T1 4.5±1, 7 mm) and color intensity of the node (p<0.002), SCF thickening which results in “lumping” with macrovascularization according to USE, and decrease in ESR and CRP. In 44% of cases the treatment effect increased to T2 (p <0.05). After 3 months of observation, 15 patients required a second course of physiotherapy. In group II a positive clinical effect was registered for T2 in 14 patients (60.8%) and for T3 in 19 patients (83%) (p<0.05). Over the entire observation period LDS recurrence was registered in 19 patients (41%), the median of recurrence was 3 [1; 6] months, mainly in patients of group I. Recurrence was associated with node fusion into conglomerates (OR 4.33, 95% CI 1.05-17.8; p = 0.037). MT and UST were tolerated well, no side effects were detected.Conclusion:the use of MT with 9% Natrii chloridum solution allowed us to achieve positive dynamics in patients with LDS, which significantly reduced the cost of treatment. Further studies are needed to evaluate the significance of these techniques.Disclosure of Interests:None declared


Energies ◽  
2021 ◽  
Vol 14 (9) ◽  
pp. 2405
Author(s):  
Samar Fatima ◽  
Verner Püvi ◽  
Ammar Arshad ◽  
Mahdi Pourakbari-Kasmaei ◽  
Matti Lehtonen

Power distribution networks are transitioning from passive towards active networks considering the incorporation of distributed generation. Traditional energy networks require possible system upgrades due to the exponential growth of non-conventional energy resources. Thus, the cost concerns of the electric utilities regarding financial models of renewable energy sources (RES) call for the cost and benefit analysis of the networks prone to unprecedented RES integration. This paper provides an evaluation of photovoltaic (PV) hosting capacity (HC) subject to economical constraint by a probabilistic analysis based on Monte Carlo (MC) simulations to consider the stochastic nature of loads. The losses carry significance in terms of cost parameters, and this article focuses on HC investigation in terms of losses and their associated cost. The network losses followed a U-shaped trajectory with increasing PV penetration in the distribution network. In the investigated case networks, increased PV penetration reduced network costs up to around 40%, defined as a ratio to the feeding secondary transformer rating. Above 40%, the losses started to increase again and at 76–87% level, the network costs were the same as in the base cases of no PVs. This point was defined as the economical PV HC of the network. In the case of networks, this level of PV penetration did not yet lead to violations of network technical limits.


Agriculture ◽  
2021 ◽  
Vol 11 (7) ◽  
pp. 598
Author(s):  
Nasrein Mohamed Kamal ◽  
Yasir Serag Alnor Gorafi ◽  
Hanan Abdeltwab ◽  
Ishtiag Abdalla ◽  
Hisashi Tsujimoto ◽  
...  

Several marker-assisted selection (MAS) or backcrossing (MAB) approaches exist for polygenic trait improvement. However, the implementation of MAB remains a challenge in many breeding programs, especially in the public sector. In MAB introgression programs, which usually do not include phenotypic selection, undesired donor traits may unexpectedly turn up regardless of how expensive and theoretically powerful a backcross scheme may be. Therefore, combining genotyping and phenotyping during selection will improve understanding of QTL interactions with the environment, especially for minor alleles that maximize the phenotypic expression of the traits. Here, we describe the introgression of stay-green QTL (Stg1–Stg4) from B35 into two sorghum backgrounds through an MAB that combines genotypic and phenotypic (C-MAB) selection during early backcross cycles. The background selection step is excluded. Since it is necessary to decrease further the cost associated with molecular marker assays, the costs of C-MAB were estimated. Lines with stay-green trait and good performance were identified at an early backcross generation, backcross two (BC2). Developed BC2F4 lines were evaluated under irrigated and drought as well as three rainfed environments varied in drought timing and severity. Under drought conditions, the mean grain yield of the most C-MAB-introgression lines was consistently higher than that of the recurrent parents. This study is one of the real applications of the successful use of C-MAB for the development of drought-tolerant sorghum lines for drought-prone areas.


2019 ◽  
Vol 137 ◽  
pp. 01007 ◽  
Author(s):  
Sebastian Lepszy

Due to the random nature of the production, the use of renewable energy sources requires the use of technologies that allow adjustment of electricity production to demand. One of the ways that enable this task is the use of energy storage systems. The article focuses on the analysis of the cost-effectiveness of energy storage from the grid. In particular, the technology was evaluated using underground hydrogen storage generated in electrolysers. Economic analyzes use historical data from the Polish energy market. The obtained results illustrate, among other things, the proportions between the main technology modules selected optimally in technical and economic terms.


2013 ◽  
Vol 687 ◽  
pp. 255-261 ◽  
Author(s):  
Sandra Cunha ◽  
José Barroso Aguiar ◽  
Victor Ferreira ◽  
António Tadeu

Increasingly in a society with a high growth rate and standards of comfort, the need to minimize the currently high energy consumption by taking advantage of renewable energy sources arises. The mortars with incorporation of phase change materials (PCM) have the ability to regulate the temperature inside buildings, contributing for an increase in the level of thermal comfort and reduction of the use of heating, ventilation and air conditioning (HVAC) equipment, using only the energy supplied by the sun. However, the incorporation of PCM in mortars modifies some of its characteristics. Therefore, the main objective of this study was the characterization of mortars doped with two different phase change materials. Specific properties of different PCM, such as particle size, shape and enthalpy were studied, as well as the properties of the fresh and hardened state of these mortars. Nine different compositions were developed which were initially doped with microcapsules of PCM A and subsequently doped with microcapsules of PCM B. It was possible to observe that the incorporation of phase change materials in mortars causes differences in properties such as compressive strength, flexural strength and shrinkage. After the study of the behaviour of these mortars with the incorporation of two different phase change materials, it was possible to select the composition with a better compromise between its aesthetic appearance, physical and mechanical characteristics.


2021 ◽  
Vol 10 (1) ◽  
Author(s):  
Yoel Sebbag ◽  
Eliran Talker ◽  
Alex Naiman ◽  
Yefim Barash ◽  
Uriel Levy

AbstractRecently, there has been growing interest in the miniaturization and integration of atomic-based quantum technologies. In addition to the obvious advantages brought by such integration in facilitating mass production, reducing the footprint, and reducing the cost, the flexibility offered by on-chip integration enables the development of new concepts and capabilities. In particular, recent advanced techniques based on computer-assisted optimization algorithms enable the development of newly engineered photonic structures with unconventional functionalities. Taking this concept further, we hereby demonstrate the design, fabrication, and experimental characterization of an integrated nanophotonic-atomic chip magnetometer based on alkali vapor with a micrometer-scale spatial resolution and a magnetic sensitivity of 700 pT/√Hz. The presented platform paves the way for future applications using integrated photonic–atomic chips, including high-spatial-resolution magnetometry, near-field vectorial imaging, magnetically induced switching, and optical isolation.


2012 ◽  
Vol 529 ◽  
pp. 371-375
Author(s):  
Lu Yao Ma ◽  
Shu Jun Yao ◽  
Yan Wang ◽  
Jing Yang ◽  
Long Hui Liu

With the distributed generation such as photovoltaic power system (PVS) is largely introduced into power grid, some significant problems such as system instability problem increase seriously. In order to make full use of PVS and make sure the voltage exceeding probability is limited within a certain range to ensure the power quality, as well as consider the cost of access device, the suitable PVS access node and capacity is important. Based on this problem, this paper establishes the probabilistic power flow model of PVS by introducing the combined Cumulants and the Gram-Charlier expansion method. Also, to solve the nonlinear combinatorial optimization problem, this paper uses PSO algorithm. Finally to get the suitable PVS access node and capacity, also calculate the solution of voltage exceeding probability.


Sign in / Sign up

Export Citation Format

Share Document