Static response of fly ash columnar improved ground

2001 ◽  
Vol 38 (2) ◽  
pp. 276-286 ◽  
Author(s):  
A Porbaha ◽  
T BS Pradhan ◽  
T Kishida
Keyword(s):  
Fly Ash ◽  
Stress Concentration ◽  
Pore Water Pressure ◽  
Water Pressure ◽  
Triaxial Compression ◽  
Area Ratio ◽  
Stress Redistribution ◽  
Soft Ground ◽  
Compression Tests ◽  
Composite Ground

This study presents the results of a series of monotonic undrained triaxial compression tests on clay specimens improved by columnar reinforcement. The process of loading and stress redistribution of a fly ash – clay specimen (FCS), in comparison with a sand–clay specimen (SCS), is examined in terms of stress–strain characteristics, generation of excess pore-water pressure, effective and total earth pressures, development of stress concentration, and the normalized undrained shear strength of the improved soil. It was found, predictably, that the deviator stress of the composite specimens was influenced by the consolidation stress, replacement area ratio, and properties of the column material. The stress concentration at the top of the composite ground which depends on the loading stage reaches a peak after the consolidation state and is reduced due to stress redistribution between the column and the soft ground. In terms of improvement effects, the mean shear strengths of FCS and SCS relative to the clay specimen are three and seven times greater, respectively, for a replacement area ratio of 49%.Key words: composite ground, fly ash, soil improvement, soft ground, triaxial test.

True Shear Parameters of Saturated Clays

1973 ◽  
Vol 10 (4) ◽  
pp. 652-663
Author(s):  
A. Sridharan ◽  
S. Narasimha Rao
Keyword(s):  
Stress Level ◽  
Pore Water Pressure ◽  
Initial Conditions ◽  
Water Pressure ◽  
Triaxial Compression ◽  
Compression Tests ◽  
Strength Parameters ◽  
Test Procedures ◽  
Stress History ◽  
Triaxial Compression Tests

Ever since Hvorslev proposed a failure criterion incorporating intrinsic parameters, several test procedures have come into practice to determine these ‘true’ strength parameters. Several consolidated undrained triaxial compression tests with pore water pressure measurement were conducted on both montmorillonite and kaolinite clays and the results were analyzed using different existing methods. All the methods through which the data were analyzed fail to assign any unique true strength parameters. Even a particular method yields different values depending upon the initial conditions (stress history, water content) of the sample and stress level during testing. It has been reasoned that these variations are due to the probable differences in fabric between the samples which are involved in various methods. There seems to be a unique linear relationship between tan [Formula: see text] and Cc/pe irrespective of the sample state, stress level, and stress history in both undisturbed and remolded conditions for all the procedures adopted.

Pre- and post-cyclic behavior of mixed clayey soils

2009 ◽  
Vol 46 (2) ◽  
pp. 115-128 ◽  
Author(s):  
Abbas Soroush ◽  
Hossein Soltani-Jigheh
Keyword(s):  
Pore Water Pressure ◽  
Water Pressure ◽  
Triaxial Compression ◽  
Cyclic Strain ◽  
Cyclic Behavior ◽  
Clayey Soils ◽  
Compression Tests ◽  
Soil Structures ◽  
Number Of Cycles ◽  
Cyclic Strain Amplitude

Soil structures are often comprised or supported by soils that are mixtures of cohesive and granular geomaterials. These soils are termed as intermediate or mixed soils and are widely found in natural deposits and man-made soil structures. The objective of this paper is to study the behavior of mixed clayey soils under monotonic, cyclic, and post-cyclic monotonic loading, with the main focus on the last of these three. For this purpose, a number of strain-controlled monotonic, cyclic, and post-cyclic triaxial compression tests were carried out on “clay–sand” and “clay–gravel” mixtures in undrained conditions. The effects of sand (or gravel) contents, number of cycles, cyclic strain amplitude, consolidation pressure, and grain size on the mechanical behavior of the mixtures are evaluated. The major findings from the laboratory study are: (i) the addition of granular materials to the clayey soils increases excess pore-water pressure during strain-controlled monotonic undrained shearing and cyclic loading and (ii) during post-cyclic monotonic shearing, mixed clayey soils behave similarly to overconsolidated soils; the higher the granular material is, the higher the overconsolidation ratio would be. Based on the research results, an algorithm for estimating post-cyclic mechanical parameters of mixed clayey soils, without conducting cyclic and post-cyclic tests, is suggested.

Cyclic Response and Instability Analysis of Seabed With Cohesionless Soils Due to Surging Waves

2021 ◽  
Author(s):  
Amin Rafiei ◽  
M. A. Gabr ◽  
M. S. Rahman ◽  
Majid Ghayoomi
Keyword(s):  
Finite Element ◽  
Pore Pressure ◽  
Pore Water Pressure ◽  
Water Pressure ◽  
Triaxial Compression ◽  
Soil Liquefaction ◽  
Cyclic Behavior ◽  
Cohesionless Soil ◽  
Compression Tests ◽  
Element Analysis

Abstract Surface waves may generate significant loadings on the seabed destabilizing sediments and the supporting marine structures. This threat is more pronounced in shallower water depths where the cyclic wave loading may induce residual pore water pressure in sediments triggering soil liquefaction. In this paper, a coupled numerical framework is presented to evaluate the interaction of waves and horizontal seabed considering nonlinear cyclic behavior of the cohesionless soil. A simple experimental model is employed for concurrent simulation of nonlinear buildup of pore pressure and deformation of saturated sand subjected to the cyclic loadings. The model (in elemental scale) is incorporated into a finite element code to solve the interaction of wave and seabed. Poro-elastoplastic response of the seabed is obtained by modifying the Biot’s coupled flow-and-deformation equations by adding equivalent nodal force terms associated with residual deformations of the soil. Potential flow theory is adopted for the fluid domain to model wave-induced pressure and flow fields. The governing equations and boundary conditions are solved using finite element analysis in time domain. The numerical framework is verified against results of cyclic triaxial compression tests and analytical solutions. Parametric studies are conducted to evaluate the effects of wave characteristics on triggering the residual liquefaction. The numerical results indicate good agreements with experimental measures. The results also show that for large waves, the progressive buildup of pore pressure in sediments may become high enough, leading to residual liquefaction. The details of the numerical model and the potential of residual liquefaction within the seabed soil are discussed.

Experimental Research of Fine Sandstone Strength and Deformation Characteristics under Different Confining and Hydraulic Pressure

2013 ◽  
Vol 353-356 ◽  
pp. 562-570 ◽  
Author(s):  
Zai Bin Liu
Keyword(s):  
Rock Strength ◽  
Pore Water Pressure ◽  
Water Pressure ◽  
Triaxial Compression ◽  
Confining Pressure ◽  
Hydraulic Pressure ◽  
Compression Tests ◽  
Exponential Relationship ◽  
Sandstone Rock ◽  
Strength And Deformation

In order to study sandstone rock strength and deformation parameters under pore water pressure conditions, triaxial compression tests of different hydraulic pressure were executed. Fitting equations of fine sandstone confining pressure and hydraulic pressure coupling effects were established. This research show that fine sandstone rock strength increases with confining pressure increases. Rock mass strength and cohesion have negative exponential relationship with hydraulic pressure. When the hydraulic pressure is 3MPa, elasticity and confining pressure fit to logarithmic relationship. Fine sandstone Elasticity modulus decreases with hydraulic pressure increases. Poisson’s ration and hydraulic pressure fit to linear relationship.

scholarly journals Mechanical behaviour of calcareous waste under consolidated drained triaxial compression testing in saturated conditions

2019 ◽  
Vol 106 ◽  
pp. 01016
Author(s):  
Jakub Zięba
Keyword(s):  
Mechanical Behaviour ◽  
Pore Water Pressure ◽  
Water Pressure ◽  
Triaxial Compression ◽  
Soil Samples ◽  
Excess Pore Water Pressure ◽  
Stiffness Properties ◽  
Construction Purpose ◽  
Strength And Stiffness ◽  
Excess Pore

The article presents the mechanical behaviour of calcareous waste under consolidated and drained condition in Triaxial compression test (CD). The host material currently being considered for the construction purpose of several buildings in Poland. One of the location of calcareous waste is in Łagiewniki area (in Cracow) [1,2]. In this work, particular attention has been paid to the to ensure fully saturation for all the tested soil samples and avoid generation of unwanted excess pore water pressure during shearing stage. The saturation level of soil samples was estimated based on Skempton’s law (B>0.95). CD Triaxial test have been conducted in order to derive information on its strength and stiffness properties.

Consolidation Theory for Composite Ground with Granular Columns Based on Different Calculation Models

2011 ◽  
Vol 261-263 ◽  
pp. 1534-1538
Author(s):  
Yu Guo Zhang ◽  
Ya Dong Bian ◽  
Kang He Xie
Keyword(s):  
Pore Water ◽  
Analytical Solutions ◽  
Pore Water Pressure ◽  
Water Pressure ◽  
Vertical Flow ◽  
Excess Pore Water Pressure ◽  
Consolidation Theory ◽  
Composite Ground ◽  
Granular Column ◽  
Excess Pore

The consolidation of the composite ground under non-uniformly distributed initial excess pore water pressure along depth was studied in two models which respectively considering both the radial and vertical flows in granular column and the vertical flow only in granular column, and the corresponding analytical solutions of the two models were presented and compared with each other. It shows that the distribution of initial excess pore water pressure has obvious influence on the consolidation of the composite ground with single drainage boundary, and the rate of consolidation considering the radial-vertical flow in granular column is faster than that considering the vertical flow only in granular column.

Research to build technological procedure for soft ground improvement using sea sand-cement-fly ash column

2020 ◽  
Vol 61 (HTCS6) ◽  
pp. 1-9
Author(s):  
Thinh Duc Ta ◽  
Phuc Dinh Hoang ◽  
Thang Anh Bui ◽  
Trang Huong Thi Ngo ◽  
Diu Thi Nguyen ◽  
...  
Keyword(s):  
Fly Ash ◽  
Load Capacity ◽  
Ground Improvement ◽  
Soft Soil ◽  
Soil Reinforcement ◽  
Soft Ground ◽  
Design Calculation ◽  
Sea Sand ◽  
Composite Ground ◽  
Soft Ground Improvement

Sea sand-cement-fly ash column technology for soft soil treatment is a new technology in the process of completing the theoretical basis, the experimental basis, and the construction of the ground treatment technological procedure. The paper presents the results of scientific research on design, calculation, construction, and acceptance of sea sand-cement-fly ash column. The scientific basis for the design of column is to consider the role of the column in composite ground, that is to use the column as soft ground improvement or soft soil reinforcement. The important parameters for the column design are: cement and fly ash content; column length; column diameter; number of columns; distance among columns; load capacity and settlement of composite ground. The sequence of steps of construction and acceptance of column includes: selection of construction equipment, preparation of construction sites, trial construction, official construction, evaluation of ground quality after treatment and preparation of document for acceptance.

scholarly journals Effect of Improvement and Application of Composite Prefabricated Vertical Drain Method in Marine Soft Ground: A Case Study

2019 ◽  
Vol 2019 ◽  
pp. 1-18 ◽  
Author(s):  
Jianqing Jiang ◽  
Reqiang Liu
Keyword(s):  
High Speed ◽  
Pore Water Pressure ◽  
Water Pressure ◽  
Ground Improvement ◽  
Field Monitoring ◽  
Hyperbolic Model ◽  
Soft Ground ◽  
Prefabricated Vertical Drains ◽  
Prefabricated Vertical Drain

One of the commonly used techniques to improve marine soft ground is the drainage consolidation method by plastic board drains (PBDs). But some complex marine soft ground will cause construction inconvenience of PBDs in certain areas of these sites, thus affecting the improvement effect. An alternative possible approach to overcoming these deficiencies may be the combination of PBDs and sand wick drains (SWDs) (i.e., composite prefabricated vertical drains (CPVDs)) as vertical drainage channels in the same site. In order to verify the suitability and performance of this method in marine soft ground improvement, a case study was performed based on the field monitoring and construction of the marine soft ground of an intercity express railway project in China. The construction procedure using the CPVD system, the field monitoring instrumentation scheme, and the design of fill surcharge level were described, and the field monitoring data were presented. The settlement characteristics, dissipation features of pore water pressure, and the horizontal movement pattern were assessed. In addition, predictions of ultimate settlement, postconstruction settlement, and consolidation degree were discussed by applying a modified hyperbolic model. The results show that the marine ground improved by the CPVD system is suitable for the construction of intercity express railway and high-speed railway. The improvement construction period of complex marine soft ground will be greatly shortened by the proposed parallel construction programme. This work will provide technical supports and application reference for the improvement of the similar marine soft ground.

Sign in / Sign up

Export Citation Format

Share Document