scholarly journals Vertical Air Motion Retrieved from Dual-Frequency Profiler Observations

2012 ◽  
Vol 29 (10) ◽  
pp. 1471-1480 ◽  
Author(s):  
Christopher R. Williams
Keyword(s):  
Rayleigh Scattering ◽  
Warm Pool ◽  
Single Frequency ◽  
Doppler Velocity ◽  
Dual Frequency ◽  
Frequency Method ◽  
Bright Band ◽  
Northwest Territory ◽  
Downward Bias ◽  
Air Motion

Abstract The 50-MHz profiler operating near Darwin, Northwest Territory, Australia, is sensitive to both turbulent clear-air (Bragg) and hydrometeor (Rayleigh) scattering processes. Below the radar bright band, the two scattering peaks are observed as two well-separated peaks in the Doppler velocity spectra. The Bragg scattering peak corresponds to the vertical air motion and the Rayleigh scattering peak corresponds to the hydrometeor motion. Within the radar bright band, the Rayleigh scattering peak intensity increases and the downward velocity decreases causing the hydrometeor peak to overlap or merge with the air motion peak. If the overlap of the two peaks is not taken into account, then the vertical air motion estimate will be biased downward. This study describes a filtering procedure that identifies and removes the downward bias in vertical air motions caused by hydrometeor contamination. This procedure uses a second collocated profiler sensitive to hydrometeor motion to identify contamination in the 50-MHz profiler spectra. When applied to four rain events during the Tropical Warm Pool-International Cloud Experiment (TPW-ICE), this dual-frequency filtering method showed that approximately 50% of the single-frequency method vertical air motion estimates within the radar bright band were biased downward due to hydrometeor contamination.

scholarly journals An Initial Assessment of the Surface Reference Technique Applied to Data from the Dual-Frequency Precipitation Radar (DPR) on the GPM Satellite

2015 ◽  
Vol 32 (12) ◽  
pp. 2281-2296 ◽  
Author(s):  
Robert Meneghini ◽  
Hyokyung Kim ◽  
Liang Liao ◽  
Jeffrey A. Jones ◽  
John M. Kwiatkowski
Keyword(s):  
Cross Section ◽  
Radar Data ◽  
Single Frequency ◽  
Initial Assessment ◽  
Dual Frequency ◽  
Precipitation Radar ◽  
Frequency Method ◽  
Ka Band ◽  
Spaceborne Radar ◽  
Ku Band

AbstractIt has long been recognized that path-integrated attenuation (PIA) can be used to improve precipitation estimates from high-frequency weather radar data. One approach that provides an estimate of this quantity from airborne or spaceborne radar data is the surface reference technique (SRT), which uses measurements of the surface cross section in the presence and absence of precipitation. Measurements from the dual-frequency precipitation radar (DPR) on the Global Precipitation Measurement (GPM) satellite afford the first opportunity to test the method for spaceborne radar data at Ka band as well as for the Ku-band–Ka-band combination.The study begins by reviewing the basis of the single- and dual-frequency SRT. As the performance of the method is closely tied to the behavior of the normalized radar cross section (NRCS or σ0) of the surface, the statistics of σ0 derived from DPR measurements are given as a function of incidence angle and frequency for ocean and land backgrounds over a 1-month period. Several independent estimates of the PIA, formed by means of different surface reference datasets, can be used to test the consistency of the method since, in the absence of error, the estimates should be identical. Along with theoretical considerations, the comparisons provide an initial assessment of the performance of the single- and dual-frequency SRT for the DPR. The study finds that the dual-frequency SRT can provide improvement in the accuracy of path attenuation estimates relative to the single-frequency method, particularly at Ku band.

scholarly journals Conductivity tomography at two frequencies

Geophysics ◽  
2003 ◽  
Vol 68 (2) ◽  
pp. 516-522 ◽  
Author(s):  
Junxing Cao ◽  
Zhenhua He ◽  
Jieshou Zhu ◽  
Peter K. Fullagar
Keyword(s):  
Single Frequency ◽  
Dual Frequency ◽  
Frequency Range ◽  
Frequency Method ◽  
New Approach ◽  
Electromagnetic Absorption ◽  
Universal Approach ◽  
Approximate Frequency ◽  
Transmitting Antenna

We present a new approach for crosshole radio tomography. Conductivity images of the investigated area are reconstructed from the ratio of the electric field intensities measured at two similar frequencies. The method largely avoids assumptions about the radiation pattern and in‐situ intensity of the transmitting antenna, which introduce errors in conventional single‐frequency crosshole electromagnetic‐absorption tomography. Application of the method to field data achieved an improvement in resolution of anomalies over traditional single‐frequency absorption tomography. The dual‐frequency method is not a universal approach; it is suitable for moderately conductive media (<0.01 S/m) over the approximate frequency range 1–100 MHz.

Dual frequency bioelectrical impedance analysis to estimate hematocrit for prognosis of dengue fever in Indian children

2019 ◽  
Vol 64 (4) ◽  
pp. 459-469 ◽  
Author(s):  
Neelamegam Devarasu ◽  
Gnanou Florence Sudha
Keyword(s):  
Statistical Analysis ◽  
Blood Cells ◽  
Bioelectrical Impedance Analysis ◽  
Bioelectrical Impedance ◽  
Impedance Analysis ◽  
Single Frequency ◽  
Dual Frequency ◽  
Frequency Method ◽  
Indian Children ◽  
Significant Difference

Abstract A noninvasive investigation to ascertain the hematocrit (HCT) or packed cell volume (PCV) was conducted on 44 hospitalized dengue hemorrhagic fever (DHF) subjects, male and female aged between 3 and 14 years using bioelectrical impedance analysis (BIA). Among the 44 subjects, 30 subjects were confirmed to be non-structural protein-1 (NS1) positive at the time of admission, whose blood investigations such as HCT level, platelet (PLT) count, aspartate aminotransferase (AST) level and alanine aminotransferase (ALT) level were taken for the classification of risk as low risk (LR) and high risk (HR) DHF. Electrical conductivity of blood reflects a linear correlation with HCT. To provide a better and more accurate estimate of HCT, a dual frequency method is proposed to calculate the conductivities of plasma and blood cells. The resistance at 100 kHz is used to estimate the conductivity of blood cells and the impedance at 5 kHz to estimate the conductivity of plasma. Statistical analysis reveals that the HCT estimated using the proposed dual frequency method shows a significant difference with a single frequency (50 kHz) estimate of HCT and also shows a good correlation with the blood investigation results. In addition, statistical analysis of the proposed method on different fever subjects indicates a significant difference with DHF.

Characterization of Vertical Velocity and Drop Size Distribution Parameters in Widespread Precipitation at ARM Facilities

2012 ◽  
Vol 51 (2) ◽  
pp. 380-391 ◽  
Author(s):  
Scott E. Giangrande ◽  
Edward P. Luke ◽  
Pavlos Kollias
Keyword(s):  
Standard Deviation ◽  
Size Distribution ◽  
Great Plains ◽  
Rainfall Rate ◽  
Doppler Velocity ◽  
Small Scale ◽  
Drop Diameter ◽  
Dual Frequency ◽  
Raindrop Size Distribution ◽  
Air Motion

AbstractExtended, high-resolution measurements of vertical air motion and median volume drop diameter D0 in widespread precipitation from three diverse Atmospheric Radiation Measurement Program (ARM) locations [Lamont, Oklahoma, Southern Great Plains site (SGP); Niamey, Niger; and Black Forest, Germany] are presented. The analysis indicates a weak (0–10 cm−1) downward air motion beneath the melting layer for all three regions, a magnitude that is to within the typical uncertainty of the retrieval methods. On average, the hourly estimated standard deviation of the vertical air motion is 0.25 m s−1 with no pronounced vertical structure. Profiles of D0 vary according to region and rainfall rate. The standard deviation of 1-min-averaged D0 profiles for isolated rainfall rate intervals is 0.3–0.4 mm. Additional insights into the form of the raindrop size distribution are provided using available dual-frequency Doppler velocity observations at SGP. The analysis suggests that gamma functions better explain paired velocity observations and radar retrievals for the Oklahoma dataset. This study will be useful in assessing uncertainties introduced in the measurement of precipitation parameters from ground-based and spaceborne remote sensors that are due to small-scale variability.

INVESTIGATION OF THE DUAL-FREQUENCY METHOD FOR REMOTE SENSING OF SOLID AEROSOLS

2010 ◽  
Vol 69 (13) ◽  
pp. 1205-1219
Author(s):  
O. A. Voitovych ◽  
A. M. Linkova ◽  
G. I. Khlopov
Keyword(s):  
Remote Sensing ◽  
Dual Frequency ◽  
Frequency Method

scholarly journals A Dual Frequency Ultrasonic Cleaning Tank Developed by Transient Dynamic Analysis

2021 ◽  
Vol 11 (2) ◽  
pp. 699
Author(s):  
Worapol Tangsopa ◽  
Jatuporn Thongsri
Keyword(s):  
High Performance ◽  
Acoustic Pressure ◽  
Single Frequency ◽  
Response Analysis ◽  
Dual Frequency ◽  
Transient Dynamic Analysis ◽  
Ultrasonic Cleaning ◽  
Calculational Method ◽  
Successful Design ◽  
Harmonic Response Analysis

At present, development of manufacturer’s ultrasonic cleaning tank (UCT) to match the requirements from consumers usually relies on computer simulation based on harmonic response analysis (HRA). However, this technique can only be used with single-frequency UCT. For dual frequency, the manufacturer used information from empirical experiment alongside trial-and-error methods to develop prototypes, resulting in the UCT that may not be fully efficient. Thus, lack of such a proper calculational method to develop the dual frequency UCT was a problem that greatly impacted the manufacturers and consumers. To resolve this problem, we proposed a new model of simulation using transient dynamics analysis (TDA) which was successfully applied to develop the prototype of dual frequency UCT, 400 W, 18 L in capacity, eight horn transducers, 28 and 40 kHz frequencies for manufacturing. The TDA can indicate the acoustic pressure at all positions inside the UCT in transient states from the start to the states ready for proper cleaning. The calculation also reveals the correlation between the positions of acoustic pressure and the placement positions of transducers and frequencies. In comparison with the HRA at 28 kHz UCT, this TDA yielded the results more accurately than the HRA simulation, comparing to the experiments. Furthermore, the TDA can also be applied to the multifrequency UCTs as well. In this article, the step-by-step development of methodology was reported. Finally, this simulation can lead to the successful design of the high-performance dual frequencies UCT for the manufacturers.

scholarly journals Precise Point Positioning Using Dual-Frequency GNSS Observations on Smartphone

Sensors ◽  
2019 ◽  
Vol 19 (9) ◽  
pp. 2189 ◽  
Author(s):  
Qiong Wu ◽  
Mengfei Sun ◽  
Changjie Zhou ◽  
Peng Zhang
Keyword(s):  
Precise Point Positioning ◽  
Frequency Mode ◽  
Single Frequency ◽  
Dual Frequency ◽  
Static Mode ◽  
Position Errors ◽  
Point Positioning ◽  
Similar Accuracy ◽  
Positioning Algorithm ◽  
Gnss Observations

The update of the Android system and the emergence of the dual-frequency GNSS chips enable smartphones to acquire dual-frequency GNSS observations. In this paper, the GPS L1/L5 and Galileo E1/E5a dual-frequency PPP (precise point positioning) algorithm based on RTKLIB and GAMP was applied to analyze the positioning performance of the Xiaomi Mi 8 dual-frequency smartphone in static and kinematic modes. The results showed that in the static mode, the RMS position errors of the dual-frequency smartphone PPP solutions in the E, N, and U directions were 21.8 cm, 4.1 cm, and 11.0 cm, respectively, after convergence to 1 m within 102 min. The PPP of dual-frequency smartphone showed similar accuracy with geodetic receiver in single-frequency mode, while geodetic receiver in dual-frequency mode has higher accuracy. In the kinematic mode, the positioning track of the smartphone dual-frequency data had severe fluctuations, the positioning tracks derived from the smartphone and the geodetic receiver showed approximately difference of 3–5 m.

Acoustic Inversion Method for Profiling Suspended Sediment Concentration

2014 ◽  
Vol 687-691 ◽  
pp. 3980-3983
Author(s):  
Jun Xi Shi ◽  
Min Zhu ◽  
Yan Bo Wu ◽  
Xing Tao Sun
Keyword(s):  
Suspended Sediment ◽  
Suspended Sediment Concentration ◽  
Sediment Concentration ◽  
Acoustic Backscatter ◽  
Inversion Method ◽  
Dual Frequency ◽  
Frequency Method ◽  
Backscatter Signal ◽  
Size Profile ◽  
Acoustic Inversion

The concentration of suspended sediment is an important parameter for the research of sediment transport. Acoustic backscatter technique has been employed to measure the concentration of suspended sediment recently. It is an inversion problem to measure the concentration from the backscatter signal. In this paper, an improved dual-frequency method is proposed for the concentration inversion of suspension sediment. It is an explicit solution with much lower computational complexity than the commonly used iterative method and with no requirement of known and constant particle size profile compared to the basic dual-frequency method.

Sign in / Sign up

Export Citation Format

Share Document